Ford F-150 (2004-2008) :: Hesitation When Accelerate From A Stop Sign
This morning as I was driving to work, my truck hesitated as I tried to accelerate from a stop sign. I pressed the pedal and nothing, almost felt like it was going to stall. After about 3 seconds it started driving again and I had no further issues. It seems to only do this in the morning when it is cold. It has done this a couple of times before, but usually it recovers almost immediately. I had no CEL come on. 2007 F150.....
View 1 RepliesFord F-150 (2004-2008) :: Knocking / Shaking At Idle When Get To Stop Sign?
So after a decent drive when I get to a redlight / stop sign / etc the truck will idle rough and shake but giving it a little bit of gas (1k RPM) seems to smooth it out however it doesn't throw any codes or the CEL. The truck is a 2008 F150 with the 5.4 and 90k miles.
I've searched quite a bit on this issue and I can't seem to find any real fixes other than swap parts out until something works and I've heard everything from filters to cam phasers or low oil pressure (I will be taking it to the mechanic to check the oil pressure)
so far I've:
Replaced the air and fuel filters
Changed the oil and oil filter (synthetic and OEM filter)
cleaned the MAF and cleaned the throttle body
also is 2008 equipped with an IAC Valve because I've read that it wasn't and I can't seem to find the IAC if it is.
Ford F-150 (2004-2008) :: Clunk / Bump When Takeoff From Dead Stop
As I said when I take off from a dead stop I can feel a clunk or a bump that feels like it is coming from the rear wheels. I can feel it more than I can hear it, although I can hear it a little. It is difficult to describe this. It is only for a second and kinda feels like the rear wheels have no traction then it bumps and takes off. If I ease into the accelerator I can avoid it, but I don't have to hit it real hard at all to get it to do it. I am sure it is not u-joints as I put a brand new drive shaft from driveshaft specialist on in the spring.
View 3 RepliesSanta FE SM (2001-06) :: 2004 - Slow Acceleration Which Is Worse After A Stop Sign Or Red Light
I have a Hyundai Santa fe 2004 6cyl 2.7 L , AWD. I am having problem of slow acceleration which is worse after a stop sign or red light. Sometimes while taking turns I feels like that I will not move and I was lucky to be not hit by a Car coming from opposite direction while taking a left turn today.
The Truck’s exhaust pipe broke recently and a auto garage welded it. But I am facing the above problem immediately after the repair of exhaust pipe. If I put more pressure on gas pedal then a mal function indicator comes and today I took it to another mechanic and he gets the error code of P0303 –engine misfire and wants to charge me ~ $600 $ to replace spark plugs and wires. The malfunction indicator goes off also while I am driving and can comes back after a while or a day. With the indicator on, the car drives erratic (minor jolts ) for few meters and then its fine. Since when I am driving on highways then I can go higher speeds without any problem. Is it still misfire issue???
Ford F-150 (2004-2008) :: Stalling Every Time Came To A Stop And Eventually Lost Oil Pressure / Knock In Bottom End
I recently bought a 2005 F150 King Ranch. I had a 900km drive to get it home but only mad it half way and am now stuck. I was stalling every time I came to a stop and eventually lost oil pressure. This is when I stopped driving and took it in. The shop said it had a knock in the lower end and stopped diagnosing it there. I can now sell it for parts and take a big hit or I can try and patch it myself.
I am assuming based on my symptoms it is a spun rod/main/thrust bearing. The mechanic was not very supportive to narrow it down to anything other than replace the motor.
How many km might I get out of this engine if I pull the motor and replace only the crank and rod/main/thrust bearings. This will not be my daily driver so if I can get another 50000-100000 km off of that, then it will last me at least 5 years.
This is of course assuming that when pull it apart I do not find an other major problems such as bent or broken pistons and rods or scoured cylinder walls. I am not that experienced of a mechanic, so I am not that confident about pulling the heads off and rebuilding the whole thing.
Ford - Explorer :: 2008 - Hard Bump When Slowing To A Stop
The boss has an 08 Sport Trac, V8, 4x4. It has the hard bump when slowing to a stop. I've read here that there is a TSB to reprogram the transmission. Called a dealer in Ft. Worth to schedule appointment. Service guy say there is no TSB. Looking for a copy or number or anything on the TSB?
View 7 RepliesGolf/GTI VI :: 2008 - Stall Out When About To Accelerate From A Stop Sign
2008 golf city... So I bought this car about 2 years ago and the last couple weeks its had trouble starting and will sometimes stall out when your about to accelerate (from a stop sign) the mechanic I go to replaced the a couple relays under the drivers side dash, however I it hasn't made it better it actually made it worse as now it won't start at all the last 2 days. It rolls over and tries to start just doesn't. Its my only car and I already missed a week of work for it ( I commute ) I need it fixed. I believe the relays where the EMC is what he said number 249 I believe.
View 3 RepliesFord - Windstar :: Oil Light Goes On When Idling At A Stop Light Or Sign
I don't drive (aren't you lucky?) but my wife and I own a '95 Ford Windstar and last summer we had issues with coolant leaking and had to have a few head gaskets replaced. Now, when we're idling at a stop light or sign, the oil light goes on but as soon as we accelerate, it goes off. The manual says the light indicated either low fluids (which isn't the case) or that the pressure within the system is low. The vehicle seems to run fine otherwise but I'm wondering if the oil light gauge has been set too sensitive?
View 7 RepliesPassat (B6) :: 2008 - Slight Idle When Sitting At A Stop Sign
I just purchased a 2008 passat, 2.0T 6spd manual last night and I noticed today, when sitting at a stop sign it has slight idle issues, (goes up about 200-400rpms) then back down to normal idle. Doesn't seem to be causing any issues, its just pretty annoying, and everyone next to me thinks I'm trying to race them.
View 24 RepliesFord Ranger / B-Series :: 1984 - Stalling When Approaching A Stop Sign Or Light
It's an oldie, 1984, but so far still kicking. 6 cyl 2.8, carb. I took a little couple hundred mile trip a few weeks ago. Rolled back into town no problems.
A few days later I took a ride and the ranger would stall when approaching a stop sign or light. I would hold the pedal down a little to keep it running but it sounded like it wanted to die if I didn't feather the pedal to rev a bit.
I drove a few days later, as I was going down the neighborhood road(25 mph), it acted like it wanted to just die. I mashed the pedal and it had no effect. It didn't stall and eventually I could rev the engine to continue.
It continues to do the same, then will all of a sudden take off like there was never a problem. If/when it does stall again, it can be hard to start until it does start and off I go again like there was never a problem. Other times, it will idle.
Another note: Sometimes when I go to start the engine it will stutter, intermittently turnover. It has done the same thing while actually driving, kind of a jerking deal.
Fuel filter, fuel pump, electrical? I'm going to first check/replace the fuel filter tomorrow.
Ford - F150 :: 1987 - Dead Spot In The Throttle And Dies When Let Off Gas At A Stop Light Or Sign
I have a 1987 ford f150 with a EFI throttle bodied 5.0L (302), and I have taken it to a mechanic multiple times because for one it has a dead spot in the throttle and it dies when you let off the gas at a stop light or sign. But the mechanic said he checked everything he knew to check and found nothing wrong with it. I also had my cousin read the computer previous to this and we couldn't pull the codes from it.
View 2 RepliesFord 6.0L Power Stroke Diesel :: Intermittent Hesitation After Stopping At Light / Stop-sign
Trying to troubleshoot a very intermittent (has happened on two different occasions during the last 1,000 miles) hesitation from a stop-light. I've been recording engine parameters (Torque application) on both instances as these have been during longer trips after a period of highway driving. 2004 Excursion, 112K miles.
This feels kind of like severe turbo hesitation (4 to 10 seconds trying to start out before it kicks in) but I don't think that's it. The turbo is a new PowerMax turbo replaced 5 months ago. VGT readings seem pretty normal. The EGR valve is new -- the first instance was with the old and the second was with the new. I've also recently replaced the EGR and Oil coolers (before this).
Here's what's interesting in the captured data though... Normally when I coast into a stop-light the indicated engine load stabilizes at about 40-50% and VGT moves to about 65% to 70% at idle. The two different times this happened (actually multiple times at stop-signs/light close to each other over 5 minutes or so for both of these), when I have coasted to the stop, the engine load increases from low values during coast-down (0% during freeway coast-down or 19-30% during other coast) up to 99.6% (or other similar high values) at idle and VGT seems to be full closed at 85%.
There is absolutely no response to the throttle in this situation for 5-10 seconds. I've either been goosing the throttle a bit or putting it neutral and revving it up first to get things going again. When it finally catches and starts accelerating with power, indicated engine load drops to 50-60% again and VGT opens up to 40-60% or so. None of the other parameters I've been capturing seem to read strangely during this that I recognize. No issues observed during cruise and power seems good. No pending DTCs or engine light.
Here's what the data points I'm capturing (once each second):
Boost
Calibration Input Volts
ECT
EOT
Fan RPM
FICM main volts
Fuel Injector pulse width
ICP
ICP Volts
IPR Duty cycle
RPM
Engine Load
MAP
Trans Temp
VGT Duty Cycle
EBP
EGR Commanded
EGR Error
Added today but not captured during these issues yet:
IAT
IAT2
Baro
Accel Pedal Position
Mass Airflow Rate
Mass Fuel Desired
Camry :: 2004 LE - Low Idle And Stalling If Come To A Stop Sign
Last week I was changing the oil on my wife's 2004 Camry (130 000 kms). I noticed quite a LOT of corrosion around the positive and negative battery terminals.. so I decided to clean them.
I removed the negative without any problems but I could not get the positive off. I decided to use a hammer to move the connector back and forth. I was surprised with how much force I had to use to break the connector free.
Once I replaced the oil I tried to start the car but it would not start. I check the voltage and I was down to 10 volts. Obviously I had damaged the battery in getting the positive terminal off. A quick ride to the auto parts store and I had a new battery.
I installed the battery and took the car out for a spin. The car drives normally but it will NOT idle after it has been warmed up. If I come to a stop sign, the car will idle low and stall.
I have already verified that the battery is at full charge and the battery is being charged when the engine is running. No 'Check Engine' light has come on.
Elantra MD (2010-15) :: Shaking At Idle On Red Light Or Stop Sign
I have noticed, in my 2012 Elantra with 32,000 miles on it, that my car is shaking at idle. I'll be at a red light or stop sign and the vibration is SUPER annoying. I have had it tested at a Hyundai Dealership. They couldn't "replicate the problem" and nothing it wrong with my car.
I may be trading this car in for the Veloster Turbo. I'm tired of how slow this car is. I know I sacrificed speed for gas mileage, but I have a question, does the Veloster have this problem as well?
Prius (2010-12) :: Shifting From D To B When Slowing Down To A Stop Sign Or Light?
Will I wear out the transmission using the engine brake to slow down faster when coming to a stop at a stop sign or light, then shifting back into D when taking off? Should I just always leave it in D unless I am driving down a steep hill?
View 12 RepliesLexus GX 2004-09 :: Brakes Catching And Slipping At A Stop Sign?
We bought the car this past summer. Notice steering wheel vibration during braking. Figured rotors were warped. Which they were. Replaced all 4 rotors and pads. Now I notice that when I brake at a stop light or sign, it feels like the brakes are catching and slipping. Jerking movement. Like you are pumping the brakes slightly. Brake pedal seems slightly mushy too. Maybe air in brake lines?
View 8 RepliesTouareg :: 2004 - Throttle Lag Only At Traffic Sign / Other Short Stop
I've read the throttle lag posts with interest. Ours only lags when performing a "California" stop where you go from the brake to the gas and look for an instant pick up. Seem to have about a second of delay before anything happens. Of course this causes all sorts of unnecessary lurching and I don't like it. Does everyone else experience this as part of their throttle lag problem?
2004 V8 Touareg
2003 GTi 1.8t
Jeep - Compass :: 2007 - Stalling When Idle At A Red Light / Stop Sign
I have a 2007 automatic jeep compass that is stalling. heres the thing, it only stalls when i am idle at a red light/stop sign. I also noticed it only stalls when its in drive. if i switch the car to neutral while stopped/idle it will not stall. i also notice this happens more frequently in the rain.
View 6 RepliesOldsmobile - Stalls - Aurora :: 1998 - Stalling When Come To A Stop Sign Or Light
3 mechanics can't find what is wrong but when I come to a stop sign or light my car stalls, not every time but a lot. Also, seems to happen more in cold or wet weather. So every time I stop and idle I have to quick put it into park.
View 2 Replies