Mazda - Protege :: 1996 - Compressor For Air Conditioner Died
1996 Mazda Protege air conditioner died today in the lovely 2nd week of Kansas heat wave of over 100 degrees each day. Was replaced in 2006.
What should be the approximate cost of the parts and labor to replace? Is it normal to have died after 8 years? It was a reconditioned one.
Mazda - Protege :: 1996 - Squeaky Sound Coming From Under The Hood
1996 Mazda Protégé, 130,000 miles, squeaky sound coming from under the hood. Happens any time, whether I am moving or not. Should I be worried? Been going on for about 2 months.
View 4 RepliesMazda - Protege :: 2001 - Getting Code P0421
I have sel code of P0421. What are the odds of the downstream sensor being bad vs a bad catalyst converter? The car runs great and I get 19+ mpg in town driving. It is a 2001 Mazda Protege, 2.0L V4 .....
View 15 RepliesMazda - Protege :: P0421 Error On 2001 LX 2.0 4 Cylinder
Would hitting the upper catalytic converter with a rubber mallet free up anything that may be causing the P0421 error and CEL to come on? I need to know if it would do any good or any harm.
View 7 RepliesMazda - Protege :: 2001 - What Does A Pink Oxygen Sensor Tip Indicate
I have a 2001 Mazda Protege LX 2.0 with 121,000 miles. I removed the front oxygen sensor today to replace an exhaust pipe, and I noticed that the tip has a red/pinkish color on one side only. What this would indicate?
The only thing I could find online is that a pink tip indicates lead in the fuel. This is impossible, since the only gas station I frequent is a Conoco which is always very busy. Plus, I haven't noticed any performance issues from bad gas, and not to mention the fact that leaded fuel has been completely phased out for 15 years. What's weirder is that the sensor tip is only pink on one side - I'm guessing it's the side that's facing the exhaust manifold.
Mazda - Protege :: 1992 - Check Engine Light Coming On - Rough And Sputter
I drive a 1992 Mazda Protege. Recently had an oil change and put in new air filter. Recently the check engine light has been coming on. Sometimes it will run rough and sputter a bit when the light flips on and then runs normal after the light flips off, sometimes it seems to run fine when the light comes on, but the light does go off and the car runs fine after it has been running for a few minutes. Shortly before I had my air filter and oil changed I did have an incident at a stop light where the car died and did not restart for a full five minutes, at which point it sputtered for a bit and then got me home.
I took into the local mazda service center and dealer (they were the only ones who had the right kind of connector to pull the error of a car this old), and they said the only code coming up was a p69 which indicated a bad thermoswitch. I have already paid for it but the parts won't be in until Saturday. I have until then to cancel the repair and just pay restock and the original diagnostic fees. Should I go through with this repair, or do the symptoms described indicate something else?
Mazda - Protege :: 2001 LX 2.0L - CEL Message Of Error Code P0421
Last year I posted my CEL problem of P0421 and replaced both upstream and downstream sensors. I passed smog because I was allowed one error message and that message was Cat not ready. I had cleared the CEL light and drove long enough before inspection to reset all but the Cat not ready message and no CEL.
Last Friday I had to clean my throttle body butterfly valve and interior housing and I also had to replace the air inlet hose that connects the air cleaner/MAF sensor to the throttle body because the hose had some splits allowing air in. I disconnected the battery before doing any work.
My new question: Could air entering freely through the splits in the inlet hose, thus bypassing the MAF sensor, and being delivered directly to the throttle body, cause an error message of P0421?
Mazda - Protege :: 2001 - OBC11 Reader Shows Cat Not Ready
2001 Mazda Protege 2.0L
In California, if my OBC11 reader shows, "Cat Not Ready" and all other systems are "Ready" will it pass the smog test for an enhanced area?
In other words, do all systems need to show, "Ready" or am I allowed one or two "Not Ready"?
I do not have CEL on.
Mazda - Protege :: 2000 - Humming Noise Coming From Passenger Side / Replace Water Pump?
I recently noticed a humming noise coming from the passenger side on my Mazda Protege 2000 ES . I suspected it was the water pump, so I took the car to my mechanic. He inspected the coolant reservoir and it was empty. He also checked the noise and the area were the pump is, and told me that the water pump had to be replaced.
My dad told me that his 1994 Sentra had the water pump replaced but none of these things had to be done and that it was unnecessary. But then I thought, every car is different.
I was in shock with how much the repair would cost, so he then gave me another quote with just the timing belt and water pump replacement for $503, but this time he said that he will not give me any warranty for the repairs because of the tensioner.
Mazda - Protege :: 2001 - Stuck Gas Pedal / Making Noise When Pushed Harder
Lately, when first starting my car and after it’s been sitting for a while the gas pedal seems to be stuck.
When I push on it slightly it doesn’t move; but if I push a little harder it will make a noise and become free and movable. No further problems until it sits for a while or the next morning. Then the same stuck pedal. Exert a little pressure and it frees up.
I tried squirting WD40 on the linkage but it does no good. What could cause it to bind up? 2001 Mazda Protege LX 2.0 ....
Mazda - Miata :: 1990 - A/C Not Working - Change Compressor?
I have a 1990 Mazda Miata, and the AC is not working. It has been switched over to R134a. I took it to a mechanic to have it recharged a few weeks ago. He said that one of the o-rings was cracked and so it was leaking around that. He filled it up and put some stop leak in it and for awhile it seemed to work fine. Then it stopped blowing cold air. I took it to a jiffy lube just to have the level of coolant (correct term?) checked. The person there told me that it was very low and was leaking around the valve stems. I tightened the valve stems and re-filled it. After 24 hours it had stopped blowing cold air again. I got a price quote on a new compressor and it is about $500.
So - my question is this - should I just put a new compressor in or is there something cheaper I could try first?
Mazda :: 2002 Protege 5 - Hesitation At 3k Rpm
Have 2002 mazda protege 5 . During acceleration at 3000 rpm the engine hesitates. Computer said o2 sensor, replaced it but that wasn't it. Drilled out both catalytic, that wasn't it. Found hole in mass air flow tube, figured that is it. I haven't replaced that yet, however I used gorilla tape thinking it would be a temporary fix but that didn't work. I know I need to replace that tube, but think that it may now be a fuel pump issue??
View 5 RepliesMazda - Protege :: 1999 - Won't Start When Hot
I have a 1999 Mazda Protege. As of last summer it started giving me problems with not wanting to start after I had driven it around town for a little while. (IE: to the grocery store, to the bank and then to my sister's house. It wouldn't give me the same problem if I just went to the grocery store and back home. It would start up fine and I'd be on my way. Only when I went somewhere and shut it off then repeated that a couple more times.) I took it to a mechanic who wholeheartedly believed it was the coil packs not allowing my car to function properly.
So we replaced those and everything seemed on the up and up. (Keep in mind that this was towards the end of summer and the temperature was dropping.) The car was perfect all throughout the fall and winter, but now that the temperature outside is starting to rise again it's beginning to do the same thing it did last summer. I don't want to take it to another mechanic that's going to have me dish out an extravagant amount of money again only for the problem to persist.
Mazda :: Protege ES 1.8L - Rattling And Knocking Front End
2000 Mazda Protege ES 1.8L
What's a good way to find whats the cause of all the rattling and knocking in the front end of my car when going over uneven terrain? It seems that noise appears only if one of the wheels is lifted up a little bit. I am attaching a picture describing the "motion" here:
Steering wheel doesn't shake when driving at high speeds and is fairly stiff, but it does pull to the right a bit, maybe because I didn't perform a front end alignment (I know this is not good) after I had most of the stuff in the suspension of the replaced; all 4 struts + boots + mounting blocks, ball joints, control arms...
Now the only part, I didn't replace was the sway bar link on the passenger side and it's being knocking for 3 years. The one on the driver side was replaced at the time the struts were replaced but I didn't have enough money to pay for the other one.
Another mechanic told me when I was quoting that sway bar links aren't really necessary as a safety feature, and a google search showed me that there are people that just take the sway bar off the car, so I left it there and just tried to live with the noise. now I am noticing the driver side is knocking as well, and I am wondering if it has to do with because I didn't replace the one in the passenger side?
I just want to rule out the possibility of another component being the cause of the noise because I am prioritizing safety over ride comfort in my attempts to save some money.
Mazda - Protege :: 1996 - A/C Isn't Blowing Cold Air
it was over 100 degrees today in Lawrence, Kansas and on the way home from work, the air conditioner stopped making cool air. Hot air now comes out. This is a different problem that the poster before me seems to have. Mazda Protégé, 1996, 128,000 plus miles on it.
A reconditioned one was installed in 2006, compressor replaced in July, 2012.
Mazda - Protege :: Loud Tire Noise Between 20 And 40 Mph
I read here that some tire noise can be caused by bad belts. How do you know if the tire belt is bad? My tires get loud between 20 and 40 mph. Mechanic says the tires are OK but to replace them to get rid of the noise.
View 7 RepliesMazda - Protege :: Brakes Stuck And Burning Up
Basically, my car (2002 Mazda Protege) has been acting like my brakes are engaged. Not all the time, though - The first time I get out and drive it, it drives smooth as silk like always. But then after I put it in park and then get back in and head out (I'm a delivery driver, so this is constant), sometimes it feels like the brakes are constantly being pressed. No, the emergency brake is not on. Most of the time it's almost not even noticeable so, like an idiot, I put it off for the past week. But today, it was very, very, very bad. I was having to press the gas to the floor to get up to speed, and then it was constantly trying to slow down. My brakes were definitely getting burned up while it was doing this, but luckily it stopped.
It may be unrelated - I know I have an oil leak, but today I saw a very unusual spot where something leaked out in my driveway. I checked my oil, and it was where I expected it to be, but this was a relatively large stain which would be very unlike my current leak.
Mazda - Protege :: Little Hesitation And Jerkiness During Acceleration
Started my car yesterday and as I was accelerating, it made a very loud noise. It sounds like normal engine acceleration noise, only ten times louder. It was present whenever I accelerated, but not when I was coasting or idling, and not when the car was in neutral. (It's a stick shift.) During acceleration, there was a little hesitation and a little jerkiness, but not horrible. The problem came on suddenly - no problems with the car before yesterday.
View 4 RepliesMazda - Protege :: Generator Or Alternator Same Thing?
My Mazda 1996 Protege appears to have no alternator, but there is something called a generator. Are they the same thing?
View 19 Replies