Silverado :: 2003 / 1500 - Parking Brake Dash Light Flashes On And Off / Audible Alarm On Constantly
Two days ago my '03 Silverado stopped recognizing when I pop the parking brake loose and now dings incessantly while I drive and the parking brake light on the dash flashes on and off.
I tried...
1.) Engaging and releasing the parking brake multiple times.
2.) Checked the brake fluid level (perfect level)
3.) Checked my owner's manual (not enough info in the manual)
Prius (2010-12) :: Car Wouldn't Go Into Reverse After Releasing Parking Brake
Today I stopped at the post office to check my mail. I put the car in park and didn't shut off the engine - this is what I always do. When I returned a few moments later the car would not go into reverse (this was after releasing the parking brake) and the traction control symbol came on. The car would go into drive but that didn't work much as I was up against a hill (or almost against it). Shutting the car off and turning it on again solved the problem. The parking space was badly potholed; I'm assuming I had less than full contact on one wheel which caused the traction control to kick in which prevented reverse from engaging. And to be clear - it's not that it went into reverse but didn't go anywhere; reverse simply wouldn't engage (I did not try neutral),
View 13 RepliesGolf IV R32 :: Minor Hesitation And Audible Thunk When Release Parking Brake
Quick background. 1+ years ago I'd sometimes get the "moo" when in reverse. It was intermittent and never enough or a persistent issue to address. Recently, no moo, but I noticed when I'd release the parking brake and move forward there'd be a minor hesitation and an audible thunk, not too pronounced, then it'd roll freely from then forward.
Replaced rear brakes a few weeks ago, noticed the right side parking brake arm doesn't reset as far free as the left. Pushing it 'home' by hand made a little thunk in the cable house up near where it bends towards the vehicle's midline. Brakes installed, and it spun freely by hand with perhaps only a very small amount of 'hiss' but not consistent for a full revolution, only periodically. Lubed both cables from the center console.
Last night installed parking brake return springs, set and released the parking brake a few times to see how it felt. Right side looks like it still does not return home 100% (maybe, 2-3mm away, same as before). Today, made a run to Napa. Got there fine, when leaving, drop the parking brake, and as I'm grabbing reverse I get a yellow dash light and a "check brake pads" warning. I drove about a block, pulled over, shut off engine, got underneath (no parking brake set) and the arm seemed to sit about where it should. I drove a few miles at low speed, pulled over (left engine running, set parking brake), checked temp of all rotors (both sides) with my finger, nothing noticeable. Drove a few more, repeated the above (engine running, brake set) and temps were still cool.
Got home, replaced fans. Started up to test fans, and the error isn't there now.
If it was going to throw an error I'd more likely expect it when leaving home, where I had cycled the parking brake handle multiple times. No error there, or en route to Napa. Leaving Napa, parking brake engaged only once, I got the error. Powering off and restarting, it was still there. Successive stops did not have the engine shut off. Once home, it cleared.
Passat (B6) :: Parking Brake Making Audible Sound When Engaged / Disengaged?
Do the parking brake make an audible sound when engaged disengaged. I noticed this for the first time but only while the drivers door was open. Sound like a motor running for about 3 seconds when you turn the break on and off. Is this normal?
View 5 RepliesFord - Explorer :: 2010 XLT - Reverse Gear And Parking Brake Taps
I am installing a Parrot Asteroid Smart into a 2010 XLT without sub or sync. I will also be hooking up a reverse camera. All wires are ran and the harness is built. I have two wires that I am having problems with to make everything function correctly.
Coming from the Parrot, I need to tap into the Reverse Gear and Park Brake. They are separate wires. Where can I tap into these wires? On the side of the shifter I do see three wires but I am not sure where they are going.
Lexus ES 2007-12 :: Parking Brake - Grinding Sound In Reverse
08 ES350 with 52k miles has a grinding sound in reverse. Brake pads were inspected - ok. Suspect that parking brake shoe is worn. Any tips on teardown/replacement ?
View 2 RepliesFord Super Duty (1999-2016) :: 2004 Parking Brake Light With Audible Warning Is Going Off
The parking brake audible warning is going off along with the parking brake light. I tried disengaging the brake multiple times and it went off once, however now it will not go off. I found some older pictures of a switch on the arm that swings with your foot when you engage the brake, but I can't find it on my 2004.
Is there a switch down there that needs to be kicked, contacts cleaned or replaced? I checked the fluid level and vacuum hoses and do not see anything obvious.
Golf IV / Jetta IV :: Pull Up Really Hard To Get Parking Brake To Hold?
I have to pull up really hard to get the parking brake to hold. If I'm on a hill forget it, I yank up really hard and then leave it in gear just in case. I have installed new cables and pads. I have also have the lever adjusted so it starts to catch when you pull it up about 2-3 inches. I've never driven another mk4 so I don't have any other reference to how well the parking brake should hold but I would think that I wouldn't have to pull up this hard to get it to habe any real holding power.
Any other vehicle I've driven with a hand brake I could easily lock up the rear tires. I'm lucky to get mine to lock while pulling so hard I think I'm going to break something. I've searched around and have only come up with threads about replacing cables and adjusting the lever. I couldn't find anything like the problem I'm having. Is this normal operation for a mk4 or is there something wrong with my calipers that needs to be addressed? My regular brakes work fine and the parking brake arms on the calipers allear to be functioning properly. They contract then spring back on their own
Ford Brakes/Suspension :: 2000 - Parking Brake Shoes Won't Hold The Truck At All?
I have a 2000 F350 4X4 with a V10 under the hood and a 5 speed manual transmission. It has a heavy western hauler bed, and a dual tired rearend. The truck has disc brakes all the way around that work great. I bought the truck used and immediately replaced all the disc brake pads as well as the seperate parking brake shoes and I had the parking brake drums turned. My problem is the parking brake shoes won't hold the truck at all and never have even when they were new. The parking brake shoes seem very small to me for a truck this size and weight. I have adjusted them as tight as I can with out causing them to drag when they are released. Is this a common problem for this type of parking brake on this type of truck? Is there something I am over looking or need to do to perhaps improve the parking brake? Would it be possible to splice some sort of "locking" valve into the brake lines going to the disc brakes to perhaps hold them engaged when I park the truck? I have a good idea how air brakes work, so I suppose this "locking" valve would work like that except basically opposite of a locking air brake valve, if that makes any sense.
View 14 RepliesPrius (2010-12) :: Turn Off Audible Interior Beeping Signal For Reverse?
Can the audible interior beeping signal for reverse be shut off in the 2010? Is it the same procedure as for the 2007?
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Parking Brake Light Doesn't On - Replace Brake Sensor?
I just had a remote start installed with a turbo timer that works off of the parking brake being engaged. No matter how hard I press it the light does not go on, however when the installer probed the sensor to ground it, it worked fine.What part this is that needs to be replaced. The stealership quoted me at 200 something for a whole parking brake assembly.
View 14 RepliesLexus IS 2014+ :: Fast Wipers Setting Doesn't Hold Up Well Against Heavy Rain
Got my IS 350 F Sport on 6/30 and I love it... but I found my first fault in the car... and I hope it can be fixed or I am wrong... The wipers just aren't that fast.... and their are very few speeds...
The FAST wipers setting (all the way down, clicking twice) doesn't hold up well against heavy ran...this setting is like Medium-High on my old 2013 Infiniti... But the Infiniti almost had a "VERY HIGH" setting and it was great for down pours... this "high" on the lexus just isn't that good... and quiet frankly IS NOT SAFE.
Also, pushing it down once for the intermediate setting where you can twist for 3 different speeds just isn't enough as well...
Video : [URL] .....
Lexus RX 2010-15 :: Parking Brake Adjustment On 2011 RX350
What is the procedure for adjusting the parking brake shoes on a 2011 Rx 350? How many clicks from tight should it be?
View 5 RepliesGolf IV / Jetta IV :: Parking Brake Alarm Came On For No Reason
I have an 03 JETTA TDI 5 SPEED WAGON with 216 on it. The parking brake alarm recently came on for no reason (as did the warning light) As soon as you move 50' it starts and wont stop until you stop the vehicle. I pulled the center console, unplugged the switch and it still did it. I jumped the 2 wires together and it still did it! I cut the wires at the point where they disappeared into the larger harness, it still did it!!! Why this is happening and if there is something besides the switch at the park brake lever that make the alarm go off?
View 1 RepliesLexus RX 2010-15 :: When Release Parking Brake It Make Loud Noise
I recently noticed that when I release the parking brake on our new 15 F-Sport it make a loud noise. It's hard to explain, but it kind of sounds like a spring being released with a clunking sound. (Sorry for the weird description).
When I press the brake to set it I am not pushing it all the way to the floor or forcing it at all. I am just using normal pressure to apply it.
Lexus GX 2010+ :: Parking Brake Stuck (Remain Applied) After Washing
The closest car wash is less than two miles from our home and we often bring the GX home directly from the car wash and park it in the garage. We've noticed that the parking brake remains applied when we start the GX the next morning, even though the foot pedal releases. Presumably, the parking brake components were wet from the car wash and enough rust/corrosion forms overnight so that the springs to release the brake can't overcome the 'stiction'.
The GX "squats and grunts" when we put it in gear, but doesn't move. Shifting into reverse solves the problem ... there's a loud 'pop' from the rear of the vehicle as the brake releases, the GX starts to move, but in reverse, which we quickly stop with the service brake, then we shift into forward and drive off ... did I mention that we back into our garage?
I may already have confessed that we are heavy parking brake users ... every time we park the vehicle, even if just temporarily while we step out of the vehicle to get the mail, etc. We use the parking brake so much that the cable stretches and every year our dealership has to re-tension.
Lexus RX 2010-15 :: Driver Seat Pushed Back / Parking Brake Not On When Stepped On Accelerator
I got into our car (2013 RX 450h) and the seat was completely pushed back. I had been the last (and only ) driver of our car and had not adjusted the seat. I managed to reach the brake pedal, started the car, pushed the L1 seating position and my seat re-adjusted. I then put the car into Drive and when I stepped on the accelerator, it would not move.
The parking brake was not on, there was nothing obstructing the car. I turned it off, turned it on again and it was then fine. I had last driven it 3 days prior, the battery was fine, the outside temperature was registered as 30 degrees, so not excessively cold. We park in a garage although it is not entirely closed off from the outside air.
Experienced this with the car no moving despite being in drive and stepping on accelerator?
Buick - Lesabre :: Parking Brake Pedal Doesn't Come Back All The Way
I have a 2000 Buick Lesabre with 226k and my parking/E-brake annoys me. The brake isn't stuck or anything, but the pedal doesn't come back all the way, at least not enough to turn off the brake light or accompanying dinging. Most of the time, the cable is disconnected from the pedal to keep the light and dinging off unless I have to use it. Is there any way to adjust the parking brake to get the pedal to fully return or is there something else wrong with the system?
View 19 RepliesGTI 337/20th Anniversary :: Parking Brake Doesn't Engage When Lever Is Pulled
So my parking brake doesn't engage when the lever is pulled. The light lights up on the dash saying the parking brake is engaged but the brake I not engaged. It hasn't been a huge problem for me since my Jetta is a 6-speed but I would like to fix it some time soon. Looking for a DIY? I did a quick search and didn't find anything really.
View 3 Replies