Prius (2010-12) :: Car Wouldn't Go Into Reverse After Releasing Parking Brake
Today I stopped at the post office to check my mail. I put the car in park and didn't shut off the engine - this is what I always do. When I returned a few moments later the car would not go into reverse (this was after releasing the parking brake) and the traction control symbol came on. The car would go into drive but that didn't work much as I was up against a hill (or almost against it). Shutting the car off and turning it on again solved the problem. The parking space was badly potholed; I'm assuming I had less than full contact on one wheel which caused the traction control to kick in which prevented reverse from engaging. And to be clear - it's not that it went into reverse but didn't go anywhere; reverse simply wouldn't engage (I did not try neutral),
View 13 RepliesLexus RX 2010-15 :: Parking Brake Doesn't Hold In Reverse - Getting Audible Alarm?
The other day I backed out of my garage and didn't notice that the parking brake was still engaged. The car rolled out without a problem.
Only when I put it in drive did I realize that the parking brake was on, since the car didn't roll forward. I also got an audible alarm.
Ford - Explorer :: Gear Shift Stuck Between Park And Reverse?
I was pulling into my driveway. I put the car in park, but when i went to get out of the car, it started to roll forward. When I finally got it stopped, I tried to shift it, and it wouldn't shift to any spot. Then it became stuck in between Park and Reverse. I can't move the gear shift.
View 1 RepliesFord - Explorer :: 2001 Won't Go Into Reverse But Every Other Gear Works Fine
Was going to leave the other morning and put it into reverse and nothing happened. Tried every other gear and works fine. Reverse is the only thing giving me problems right now. Tried doing some research on my own, because I can't afford a tranny rebuild. I was hoping it was either the solenoid or low/reverse band. I don't know about the band, because it works fine in low2 and low1....
View 2 RepliesSonata NF (2006-10) :: Parking Sensors Beep When Put The Gear On Reverse
When I put the gear on reverse, parking sensors beep even there is nothing behind the car! I tried to clean the surface by my finger!
The Last time that they worked pretty well was before I unplug and plug the power cable of my stereo system while battery cables were connected!
Can the problem coming from for that? How can I take the sensors out and clean them fully? Do you think disconnecting the battery for one minute can work?
Lexus ES 2007-12 :: Parking Brake - Grinding Sound In Reverse
08 ES350 with 52k miles has a grinding sound in reverse. Brake pads were inspected - ok. Suspect that parking brake shoe is worn. Any tips on teardown/replacement ?
View 2 RepliesHonda - Cr-v :: 2015 - Putting Car Into Drive Or Reverse With Parking Brake Engaged
I am a new driver and I made the following mistake twice.
Twice over the last month, after street parallel parking, engaging the foot parking brake, turning off and exiting the car, I noticed the spacing from the front and back car is a bit off so I went back inside the car to move the car slightly.
However, I forgot to disengage the parking brake first, so I put the car into R, and when the car did not move, I tapped on the accelerator. Only then did I remember to disengage the parking brake.
If I just tapped on the accelerator slightly, does it damage my car? I haven't noticed any problems yet, but I feel terrible about the screw ups.
Prius (2010-12) :: ICE Came On When Pulling Out Of Parking Spot In Reverse
I just got my new 2011 Prius a week ago and still getting used to it. Yesterday I was pulling out of a parking spot in Reverse when the ICE came on and I felt a slight jolt in the transmission when it happened. Is this normal or should I get it checked out?
View 19 RepliesFord - Explorer :: 2006 - Shifting Hard Into Reverse At First Then Stuck In High Gear Or Slipping - OBD2 Codes
Tranny started acting funny recently...shifting hard into reverse at first, then last night it was like it was stuck in high gear or slipping on the way home. Limped it home and took the following codes:
P0743 TORQUE CONVERTER CIRCUIT ELECTRICAL
P0750 SHIFT SOLENOID A MALFUNCTION
P0755 SHIFT SOLENOID B MALFUNCTION
P0760 SHIFT SOLENOID C MALFUNCTION
P0765 SHIFT SOLENOID D MALFUNCTION
P0962 PRESSURE CONTROL SOLENOID A CONTROL CIRCUIT LOW
P0966 PRESSURE CONTROL SOLENOID B CONTROL CIRCUIT LOW
P0970 PRESSURE CONTROL SOLENOID C CONTROL CIRCTUT LOW
Ford - Explorer :: 2010 - Park Aid On / Off Message In The Display When Shift Into Reverse
I bought a 2010 V8 Explorer on Monday and aside from the apparent "known issue" with the hard 2-1 shift (which I'm trying to get it to "unlearn" by driving differently), it's a really nice truck.
When I shift into reverse it says "Park Aid On/Off" in the display, and sure enough, it beeps when I get close to something. That said, there aren't the normal "dots" in the bumper that I normally associate with backup sensors.
Everything works just fine with it, I just am a guy who likes to know how things work and I don't see anything on the outside that would indicate it's a parking sensor.
Ford Transmission :: 4r70w - No Reverse When Backing Out Of Parking Space Or Shudder In Reverse
2000 F150 Lariat, XC, 2WD, 5.4L, 4R70W
I don't know if this all started right after I got back from towing a 3500# lathe + 2000# trailer back from Texas a couple weeks ago or if there might have been some slight symptoms before. I do know that this really got bad a couple days ago and I haven't driven the truck since then.
So, here's what is happening. I noticed a few days before that when I would back out of a parking space, the truck didn't seem to go right into reverse. It was as if it was in neutral, but as I was reaching to jiggle the gearshift lever, it would engage and I could back out just fine. All forward gears, and shifting, have been fine all along, including lockup. I kind of wondered if the shift linkage had somehow moved and was on the edge of being in the right spot, so I was going to have a look at it one evening soon. Then a couple days ago, I went to back out of a parking spot at work and it wouldn't go anywhere.
Just acted like it was in neutral. Put it in drive and it engaged just fine, then back to reverse and nothing for a few moments before it finally engaged. Then, as I was backing up, it acted like you might expect a limited slip that was not slipping to behave. But, that was right before I put it in drive and went home. After I got home, I tried it out some more and found that in reverse, it just wouldn't go anywhere unless the truck rolled a little bit. I don't know if the rolling really had anything to do with it or not, but the driveway is on a slight incline, so it happened, and then the transmission would engage. But, when it did start to back up, even straight, at first it acted like it was under a load, then when it started to move, it bucked really badly. Put it back in drive and all seems fine.
There are no codes set. Trans fluid is full, and doesn't smell or look bad. I've searched for reverse shudder, and other stuff, and there are threads about the TC, about no reverse at all, and a bunch of other stuff, but nothing like this that I found.
Touareg :: When Parking Brake Released In MFI Got Warning Parking Brake Fail To Release
Had my car parked outside of work for about 12 hours yesterday, and in the NYC cold front, the parking break must have stuck on slightly. When I started to move, despite the fact I'd released the parking break, I received a warning in the MFI that said PARKING BREAK FAILURE TO RELEASE. I pulled the handle again and heard it pop just a little more off. Everything worked great after that. If I hadn't received the alert I probably would have driven off with it on. I'd probably have noticed the hesitation and checked the break again, but the alert was useful. Some of the warnings in the MFI can appear to be a pain at times, but it's amazing how thorough a job VW has done monitoring the cars systems and giving real time information if something doesn't work. You just have to make sure you don't get info overload from it all!!
View 4 RepliesPassat (B6) :: Stuck In 3rd Gear After Hitting Puddle / Parking Brake Fault Light Lit Up
Hit a puddle-now car is stuck in 3rd gear... with parking brake fault light lit up. How to fix it? it happened on the highway on the way to work at 70mph . so now i either have to drive home with it the rpms at 4k or get it towed. Car is a 2006 passat with 35000 miles.
View 5 RepliesPrius (2010-12) :: Parking Brake Adjustment?
When I was at Luscious Garage earlier today for a transmission service, the technician told me that my parking brake is out of adjustment. Sure enough, I checked the factory service manual when I got home and found that the spec is 8-11 notches at 67.5lbf. My own test revealed that it was taking between 15-17 notches on mine!
View 7 RepliesElantra MD (2010-15) :: ABS / ESC And Parking Brake Lights Are All On
Suddenly all these lights came on in a 2012 Elantra . Had at the dealer and they checked wheel speed sensors, wiring to sensors and said all those are ok and the abs module is bad. I replaced the module, bled the brakes and the exact same lights are still on with the same codes coming up. Tech is confused as I am.
View 5 RepliesPrius (2010-12) :: Driven 50 Miles With Parking Brake On
I made the mistake of lending my car to my sister who drove about 50 miles with the parking brake on.... And yes it beeped at her the whole way and she didn't think anything of it..... What kind of damage could have been done? Brakes seem to work fine although the parking brake barely works now.
View 19 RepliesLexus RX 2010-15 :: Parking Brake Adjustment On 2011 RX350
What is the procedure for adjusting the parking brake shoes on a 2011 Rx 350? How many clicks from tight should it be?
View 5 RepliesPrius (2010-12) :: Parking Brake Pedal Cover Keeps Coming Off
It seems about once a week the rubber cover that goes over the food pedal for the parking brake comes off. I've been careful to replace it correctly but it still keeps happening? Btw it's a 2010 v with atp ...
View 9 RepliesFord Super Duty (1999-2016) :: 2010 F350 - Reverse Gear Signal Wire
I installed a reverse camera to my new Pioneer in-dash nav head unit this morning. I wired (at the rear of the truck) the power signal lead to the reverse wire at the trailer connector. I also need to wire a reverse signal input into the back of the head unit. I really do not want to run a power lead from the rear of the truck to the cab. Is there a wire under the dash I can tap into, or could I use the wire going to the backup alarm that’s somewhere under the dash (if I can find it). 2010 F350 deisel, crew cab, 4WD, long bed.
View 9 Replies