Lexus RX 2010-15 :: Front Bumper Loose On Passenger Side
Just got the 2010 and put 100 miles on it and found the front bumper loose on the passenger side. Difficult to see but it looked loose right by the headlight housing, a little pull and it popped up. Looked like the fastener was never there.
View 14 RepliesLexus ES 2007-12 :: Front Bumper Paint Peeling Off
My front bumper has its paint peeling off very fast, I could get whole bumper painted but is there anything that I can do at home ...
Attaching pictures ...
Lexus LS 2007+ :: Front Bumper Cover Replacement?
Replacing bumper cover, is there anything I would need to replace underneath it or is it just a simple swap out?
View 4 RepliesCamry 2012+ :: SE V6 - Front Bumper Cover Loose
I have a 2012 SE v6 with 1600 miles on it. About a week ago, I noticed my bumper cover pulled away from the corner of the headlight and there was a noticeable gap. I pushed on it, and heard a click. The bumper stayed in place. After a couple days driving, it came loose again. I didnt touch it so the Service Writer would see it first hand. Of course, his first instinct was to puch on it, but I got loud quickly, so he kept his hands to himself, and heard me out. I knew if he clicked it back into place I would be SOL. He admitted something needed to be done, not just click it back.
When I picked it up, he said it was a known issue, and there is a TSB on it. He claimed they replaced a bracket. The invoice reads, "ADDED FELT TO TIGHTEN FIT". Yeah, Im sure that will hold just long enough for them to wash their hands of it.
Elantra HD (2006-10) :: Front Bumper Cover Loose On Driver Side
So I recently bought an '09 Elantra for 52K miles. Car's a beauty except the front bumper cover is loose under the headlight on the driver side(got it that way). The first two pics are from the driver side whereas the third shows it in comparison to the passenger (which is totally fine). The gap seems to be getting bigger ever so slightly. What would be the cheapest and easiest fix?
View 1 RepliesLexus LS 2007+ :: Noise From Front End / Brake Area When In Reverse Like Calipers Are Loose
Heard clunk (technicdal term) noise when you are in reverse and press the brake pedal. It is coming from the front end/brake area. I did not see a service bulletin for this.
View 10 RepliesLexus GS 2006-11 :: Rear Bumper On Driver Side Is Loose From The Main Body
The front of the rear bumper on the driver's side is loose from the main body. The clip on the bumper is ripped from where it tore. I've gone ahead and bought the clips and everything from Lexus near me, but need to know the best epoxy or glue to reconnect the clip area on the bumper so I can apply the clips.
Is the bumper on that spot (the back side of it, not the painted exterior, if that makes sense) fiberglass.
Lexus IS 2014+ :: What Sensors Are In The Front Bumper
What sensors are in the front bumper? I slid out on black ice into a snow bank and it crushed in the bottom grille and as I'm clearing out the snow I noticed a sensor dangling with a broken harness that I was wondering what it was for. I have a nonFsport bumper with LED fog lights and both fog lights are operational.
Drivers side close to the fog lights
Lexus RX 2010-15 :: How To Remove Front Bumper
I was hoping there were instructions on how to remove the 2010 RX350 front bumper cover somewhere? We had a little fender-bender, and I was planning on trying to replace some of the items myself. I'm handy, but always prefer instructions over trial/error!
View 6 RepliesLexus GS 2006-11 :: Holes On Front Bumper
I bought the car from dealer, there are now FOUR! holes on the front bumper. I don't understand why they couldn't just use the existing holes to put the license plate holder. Now I'm stuck with these holes and I'm looking for a cheap alternative to fill them. I like the clean look of the front end without the plates and don't want to spend a fortune at a body shop, but I also don't want 4 dots either. What I can do/use?
View 3 RepliesLexus GX 2004-09 :: How To Install Front Bumper Cover
Replace the front bumber cover on gx? Mine has a crack and I can get another one but wasn't sure how difficult it would be to swap it out, I guess the toughest part would seem to be the fog lights.
View 6 RepliesLexus LS 2007+ :: Bumper Removal To Access Headlights?
I know this may be kinda tacky to some but i keep seeing these audi's driving around and the headlights with the LED DRL's always catch my eye. I ordered a set of led DRL and i want to install them either inside the headlight housing or around the rim of the housing if i cant get the font plastic off. How to remove the bumper cover so i can access the bolts that holds the headlights in.
Headlight assembly without damaging the plastic lens . I've seen some other guys toss a toyota matrix assembly in the oven at 350 for 3 minutes to soften the adhesive and then pry apart the front lens off the housing. Would this work with the ls460 or would it damage some of the internals. I have hid and the movable projectors (afs i think its called)....
Gen 2 Prius :: Bumper Lower Lip Loose?
When I was spray painting my bumper lower lip. Wiggled it loose so I could tape better but it came loose. This is what it looks like after gluing back together. The issue is with the little rubber trim not wanting to stick and looking ugly. Had a few ideas.
1. Replace with factory parts and repaint.
2. Wide pin striping along the line,blue or black.
3. Reflective tape square.
4. Euro fog lights
5. Long LED strip,either red or white
6. New blinker/reflector
7. Putty/bondo the bumper to look like one piece then paint.
Lexus LS 2007+ :: 2010 - Bumper Cover Not Fitting Properly?
I had a low impact accident with my 2010 LS460 where the body shop replaced the bumper cover, collision cushion behind the bumper and a new grill. Below are the picture from their finished work, however I know my car should look better than this. What could be wrong/missing to cause the grill and bumper to not align correctly with my car?
View 7 RepliesLexus IS 2014+ :: Front Bumper Got Stuck On The Parking Divider And Came Off Partially
So my gf parked at the mall and when she pulled out the front bumper got stuck on the parking divider and came off on the left side. One of the fastening holes appears to be torn and it appears the bumper just needs to be put back in place.
View 8 RepliesLexus ES 2013+ :: Water / Moisture In Fog Lights After Reinstalling New Front Bumper
Dealer did repair work on front bumper. Now, after reinstalling a new front bumper, I noticed water starting to form inside the fog light assembly after it has rained. Dealer says this is normal due to our tropical weather. This has never happened prior to the repair work that was done.
View 12 RepliesLexus GS 2013+ :: Wrapping Front Bumper Mid-section Parking Sensors
So I've seen a lot of people on here wrapping the mid section of the front bumper black to give it a more aggressive look.
For those that have done this, will I need to cut a hole for the sensors or will the sensors still work with the wrap covering them?
Lexus LS 2007+ :: Backup Camera Shows Part Of The Rear Bumper
I just noticed today that my backup camera now shows part of the rear bumper and perhaps some of the chrome. There's also a strange, small, somewhat circular thing in the upper right corner of the screen. With my Matador Red exterior, I'm sure I would have noticed it before today on the backup camera.
View 8 RepliesLexus LS 2007+ :: Bolts To Back Bumper Underneath Spinning Freely?
I was cleaning the underside of my trunk area and noticed the bolts to the back bumper underneath were spinning freely. Not being mechanically inclined, I thought they needed to be tightened. They didn't tighten. Well that got me checking other panels and low and behold I found a few loose ones.
So, is this a DIY project, or one I should take to the dealership? Since it's out of warranty, I'm fine with paying if need be to get everything tight on the outside of the car. But if it's not too difficult, I'd be willing to try.
If it's a DIY, then what are the steps? I looked around the internet but haven't seen anything.