Dodge - Intrepid :: 2002 - Overheating After Replacement Of Timing Belt / Water Pump?
I have a 2002 Intrepid ES with a 3.5L V-6 with 264,000 miles on it. I have recently had the timing belt and water pump changed. Three weeks later I am driving home and the temperature gauge starts climbing. This is the first time this car has ever overheated. Well, I call my buddy who is a certified mechanic and he tows the car to his shop. I have him check the water pump to make sure it hasn't prematurely failed. He tears the front of the engine down and inspects the pump. He finds nothing wrong with the pump but he discovers the timing belt tensioner has failed and it has caused the engine to jump time, I tell him to go ahead and replace the tensioner.
After he put the engine back together he started it and it ran cool while it was sitting at idle for about 45 minutes. Then he took it for a test drive and it overheated again. He checks the thermostat and finds that it has also failed; he replaces that also, still overheating. New radiator hoses, upper and lower, new radiator, new thermostat, new water pump and it still overheats. He put dye into the coolant to check for a blown head gasket and it tested negative for a blown gasket. The exhaust doesn’t smell of burning coolant or producing white smoke. My mechanic friend and I both have run out of solutions…
Camry :: 2004 LE Showing Code P0705 Transmission Range Sensor
I bought 2004 Toyota Camry LE 2.4 couple of months ago, Been running good with no issues , no check engine light . Today I had it detailed from the inside and got it clean at a shop , then took it and changed the transmission Oil at Jiffylube . after leaving the shop the engine light came on . I then took it to a local Auto car parts and had used a car diagnostics scanner to see what was the problem and this showed up P0705 Transmission Range Sensor . I deleted it , then while driving around town , it came back on . I live in Minnesota and it is very cold here, not sure if the cold weather have to do anything with it, but i doubt it. The car looks and seems to be running ok .
View 5 RepliesIntrepid :: 2002 Transmission Hard Shifts / Engine Hesitation
Our intrepid 3.5L with 135000 miles has been acting up a bit. Its had a couple hard shifts over the last few days/week that almost seemed like an engine hesitation, and this morning when slowing down from highway speed into a small town, it abruptly shifted down to 2nd and stayed there like its in "limp mode" ??.
Pulled over and checked fluid. Level looked good and smelled ok but has a brown tinge to the pink fluid.
Started to go again and it still wouldn't shift. Pulled over and shut car off. Checked codes P700 and P138.
Started car up and it shifted fine for the next 28 miles. Shut car off and parked it.
Sonata I45 (YF - 2011+) :: Code P0705 - Transmission Range Sensor Circuit Malfunction
This is what I get from the DTC .....
DTC P0705
Description : transmission range sensor circuit malfunction
State : History
I have done some google search on the above diagnostic trouble code P0705 and as i understood , it indicates that the Engine Control Module (ECM) has received an input error from the Transmission Range Sensor (TRS).
Since the check engine light illuminated two times (two separate occasion) then it turns off now; the ECM is actually receiving input signal from the TRS.
So that leads me to think that the TRS is actually working but the problem might be one of the following two:
1- Open or short in the TRS circuit?
2- Dirty transmission fluid.
What do you think the steps i should do first of all ? how would i check the transmission fluid since my vehicle has no transmission fluid dipstick. My driving condition would fall into "severe" category and it reached 60,000 miles now ...
Accent MC (2006-11) :: Code P0707 - Transmission Range Sensor Circuit Low Input
The MIL light came on and I noticed the shifting P-D or P-R was hard. Checked the Transmission Fluid and noticed it was low. Topped it up, but still MIL is on and shifting hard still. I bought a OBD2 Scanner and it returns P0707 "Transmission Range Sensor Circuit Low Input". Should I try clearing the DTC? It's a drag because it's my wife's car and she's driving mine.
View 1 RepliesFord F-150 - 1997-2003 :: Transmission Range Sensor Replaced - Got Code P0705?
I have replaced the transmission Range sensor (with OEM) and it is adjusted correctly, however This did not clear the. Code P0705... I am stuck ....
View 1 RepliesFord Ranger / B-Series :: 2003 - Code P0708 For Transmission Range Sensor
Got a code of p0708 on 2003 ranger flex-fuel 3.0.. Which is I believe is Transmission Range (TR) sensor. Not sure where to find that on truck...
View 1 RepliesFord 6.0L Power Stroke Diesel :: 2007 F250 - Getting Codes Abut Transmission Range Sensor Circuit
I have a 2007 f-250 6.0 liter turbo diesel. I was pulling a trailer with a golf kart on it and was not in tow haul. I was going up a hill and it shot up into 5th gear. I pulled into my house and shut it off and refired it and it acted fine. I went on a little test drive to see if it was going to do it again before I went on my trip. As soon as it shifted into third gear the tow haul light started to flash on my dash and went to 5th gear and would not down shift even if I did it on the column.
I scanned the truck with my snap on modus and it gave me these codes. P0706-transmission range sensor A circuit range/performance, P0707-transmission range sensor A circuit low input, and P1702-transmission range sensor circuit intermittent. I put a transmission harness in it and started it up and it ran fine and the codes were gone. I went for a test drive around the neighborhood and as soon as it hit 3rd gear it did the same thing as before. Today I put the old one back in and checked the codes so I could write them down and there weren't any so I went for a drive and it shifted through all the gears great and downshifted fine as well.
I pulled into my drive way to check for codes once again and there weren't any. I was gonna go for a ride in tow haul to see if it would do it and as soon I put the truck in reverse it started to idle high and the tow haul light started to flash again. I put it in drive to pull back into my drive way and it immediately shifted into 5th gear and threw the same codes...
Caravan/Voyager :: 2002 - Crankshaft Position Sensor Replacement
I need to replace the crankshaft position sensor. On my 2002 Grand Caravan Sport 3.3liter. Where it is in laymans terms.
Is it better to approach from the underside Or from the hood side? I will know it when I see it but I haven't seen it yet!!
Ford - Explorer :: 2002 XLT - O2 Sensor Replacement - Code PO136
My 02 Explorer (XLT, 4.0) decided to throw a new code today. PO136, O2 Sensor Circuit (Bank 1 Sensor 2).
While it may be a wire issue, I still plan to replace the sensor. So the question is;
Can I get to it from under the vehicle or is there an access panel under the console like on the 2nd gens?
I have the sensor on order and plan to get it done on my days off next week.
Avalon 2005-12 :: Code P0500 - Transmission Speed Sensor Replacement / Location
I have an 08 avalon w/ 281k miles. NEED to replace the transmission speed sensor (P0500 code thrown). Where is it located on the trans and what is the part #? I'm thinking about servicing the trans while I'm there but looks like a lot of "comments" regarding this transmission and the problems with servicing it!?
View 9 RepliesIntrepid :: 1998 2.7L Engine - O2 Sensor Location
i need to know what locations are these sensors at bank 1 sensor 1 and bank 2 sensor 1 what i`m asking is it at the front of the engine or the rear its a 2.7 liter engine.
View 1 RepliesDodge - Intrepid :: 1996 - Throttle Position Sensor Signal Wire Producing Voltage
Background: Check engine light indicated a problem with the throttle position sensor (unfortunately, don't have the exact code). The TPS on my model ('96 Dodge Intrepid 3.3L) is the non-adjustable type. There are three wires going to the TPS -- a power source, a signal wire, and a ground. The TPS acts as a potentiometer and depending on the throttle position, sends a voltage signal down the signal wire to the computer.
Here's my question/issue: After disconnecting the TPS, I tested the three wires with a multimeter. Power source (5V) and ground were fine. But I'm getting a voltage reading of about 4.35V on the signal wire. It's my understanding that with the TPS disconnected, I shouldn't be getting any voltage on that wire. Does that sound correct? If so, what would be causing me to get a voltage reading there? I'm assuming some type of problems with the wires, maybe an exposed wire on the signal wire somewhere?
Intrepid :: 2002 Dodge Won't Crank Over Sometimes
I have a 2002 dodge intrepid that wont crank over sometimes unless I take the key and keep moving from the start position to the off position ,then it finally engages. I have replaced the battery, but I thought if it was a starter issue, it would click more than once.
View 1 RepliesDodge - Intrepid :: Transmission Stalled Accelerating And Jerking
I recently had several parts replaced on my 02 Dodge Intrepid within the last few months, including the brake lines, motor, gas lines, sensors, spark plugs, and a few rusted parts that were busted while the motor was being replaced. I have had my car back for a week after most recently getting the gas line replaced. (My gas line froze the same day I got it back after getting the motor fixed!)I haven't had an issues until Saturday morning my engine light came on.
I drove it throughout the day no problems, then I stopped at a red light and had trouble accelerating when I went to turn, my car then jerked forward and and ran seemingly normal, but the problem continued every time I stopped or slowed down. After 5 minutes or less of this I parked my car and called my mechanic. After a half hr I restarted my car and circled the parking lot with no issue and headed to a friends nearby. The stalled accelerating and jerking began again until I couldn't accelerating at all without waiting and restarting my car, and then finally there was no moving it at all.
I had it towed this morning and was told I had no transmission fluid. After replacing the fluid my car was driven to my house without an issue, so im assuming I didn't blow my trans? Several hours later, I went to start my car and there was a large amount of red fluid under the front of the car by the bumper and it wont move once again. Obviously I have a leak, but I don't know if the leak was the cause of the initial problem or if the problem caused the leak.
Intrepid :: 2002 - Clicks Only One Time When Turning Over
I'm turning it over and it just clicks 1 time every time I turn it over it just clicks 1 time, so I changed the alternator, starter/solenoid and battery and it still just clicks that 1 time. 2002 intrepid 3.5 .....
View 1 RepliesPrius (Gen 2) :: P0A37 And P0A2B - Temperature Sensor Circuit Range / Performance
I have these two codes:
P0A37 - Generator temperature sensor circuit range/performance
P0A2B - Drive motor "A" temperature sensor circuit range/performance
Intrepid :: Check Engine Light Came On - Transmission Code P0731
My wifes 1998 Intrepids' Check Engine Light came on yesterday, and while she was turning into the driveway the car stalled. It would fire right up again, and drive normally, but when she went to pull into the driveway again it stalled.
I took it into the shop, and they read the computer and thats when the P0731 code showed up.
P0731 Incorrect gear ratio # 1
When I went to bring it home, I then noticed that the speedometer was not working, and the tranny wasn't shifting out of 1st gear. The tranny fluid is clean and not burnt.
Intrepid :: How Long To Drive A Car After Computer Reset On 2002 RT 3.5L
How long you have to drive a car after you reset computer before all the systems will respond? I have an '02 RT with a 3.5L. I had to reset to clear a check engine light on Tuesday and when I went to get an emissions test on Friday it failed because it could not get a reading from the evap or cat sensors. He said I would have to drive it a while for those to have readings but how long.
View 1 Replies