Lexus GS 2013+ :: Clicking Noise From A-pillar Occurs During Braking And Acceleration
I have a 2015 GS350 F Sport (RWD). A clicking noise occurs during braking and acceleration, but only sporadically. It seems to occur more often during heavy breaking and/or acceleration. The sound seems to be coming from the driver's side A-pillar or the driver's side dash at any rate. Sometimes the sound is a single click and sometimes it clicks up to 3 times.
View 6 RepliesSanta FE SM (2001-06) :: Brake Pedal Is Very Soft And Goes To The Floor Before Braking Occurs
Here's the short of it. 3rd time in a year the brakes on my 2005 SF (177K miles, 2.7L) have gone out.
The brake pedal is very soft and goes to the floor before braking occurs. Typical signs of a bad master cylinder.
The first time was a year ago. I bought a re-manufactured master cylinder, change it and bled the brakes. Worked like a champ and lasted 10 months.
To months ago same exact symptoms. I assume it was a bad re-man part. It's under warranty, not big deal. I do warranty exchange, bleed system, brakes return. All is good.
Less then 3 weeks later, brakes gone, same symptoms! This time I spend the difference and get a brand new OEM cylinder with reservoir. Replace, bleed, problem fixed. Brakes go out in less than a week.
I'm not leaking anywhere. Reservoir is to corect level. ABS light is NOT on. No chattering in brakes. Braking is smooth both when power brakes work and when not. No visible damage to calipers. I'm 99% sure there is no air in the system, but I'm going to try bleeding again. I have not put it up on a lift to yet to check all the lines.
Prius (2004-09) :: Squeak Occurs When Car Is Stationary With Brake Pedal Fully Depressed
I have recently purchased a 2007 Gen 2 Prius and sometimes it emits a very annoying squeak. It occurs when the car is stationary, with the brake pedal fully depressed. When inside the vehicle it seems to be coming from behind the glove box. When on the outside and facing the car it seems to be coming from below / behind the electric motor. I have made a recording of it with the noise in question being audible for a couple of seconds at 0:13, and then again at 0:22 until the end. It could be nothing I guess, but this is my first hybrid and I am not too sure what is perfectly normal and what is not.
View 14 RepliesGolf IV R32 :: Brake Pedal Making Slight Grind / Clicking Noise?
Ok so I have done a complete brake overhaul with rebuilt calipers, new pads and rotors and a new master cylinder. Brakes stop on a dime and are solid when pressed firmly. When coming to a stop at a slow speed (5 mph) pedal gives in with slight clicking grinding noise. I have exhausted searches on google and here with no soild answers any clue what causes this or how to fix it?
View 24 RepliesGolf/GTI VII :: Take Longer Time To Reach Operating Temperature?
I noticed that it seems as though my Mk7 takes longer to reach operating temp than my mk6 TDI did. My commute to work is plenty of time to warm up (25mi) but I feel like this car is slower to warm up (but faster to get cabin heat d/t the electric heater). I just find it strange as here in MA it hasn't even been that cold yet, so I'm wondering how the car will be wen the temps dip well below freezing.
View 7 RepliesGolf IV / Jetta IV :: 2002 - EPC Light Keeps Coming On / Car Goes Into Limp Mode When Reach 4000 RPM
I have a 2002 vw golf and its epc light keeps coming on and every time I reach 4000 rpm it goes into limp mode, what is the problem.
View 2 RepliesGolf IV R32 :: Erratic Shudder Occurs At Different Speeds
Well for a couple of months now I've had a really erratic shudder that occurred at different speeds and at different RPMs... I checked motor mounts, wheel balance, CV Joints, flywheel, etc. and when I took it to my mechanic, he discovered a sliced exhaust hanger in the middle of the exhaust system and nothing else.
Well after replacing this rubber hanger this vibration miraculously stopped occurring. I realized now that the movement of the exhaust which was created over certain roads with undulation caused it to flex harmonically and interrupt the workings of my Koni FSDs.
I really began to think the struts were the culprit but in the end realized the frequency from the loose exhaust was too much for the Frequency Sensing Dampers to counteract as the movements and inertia were opposite the motion of the car itself. She's now smooth as silk at highway speeds once again and only a slight vibration from the race strut bushings which were recently upgraded from stock can be felt through the steering wheel.
Golf/GTI VI :: 2012 - Thump Sound Only Occurs In First Minute Or So Of Driving
I just bought a new 2012 Golf 2.5L (base model) last weekend and noticed a THUMP THUMP THUMP sound. Only occurs in the first minute or so of driving, and only when the car starts cold (hasn't been driven for 10+ hours).
Continues to occur if I entirely stop the car (haven't tried turning engine off though...) Sounds like it comes from around the rear passenger-side suspension area. Somewhat irregular THUMP sound. Pretty loud, especially if I get out of the car and go to the rear wheel area. It doesn't occur at a constant rate, it's more like: THUMP THUMP THUMPTHUMPTHUMP THUMP THUMP ...
What's going on here?
Golf/GTI VI :: Rubbing / Humming Sound Occurs Below 10MPH And Increases Above 60MPH
So I have a 2014 VW GTI 4DR 6speed with 25,000 miles on her now and I am getting this weird noise from what i believe is the front end right wheel?
The noise is similar to a rubbing / humming sound that occurs below 10MPH and then increases with repetition at say above 60MPH. I notice a little harder of a rubbing when wheel is turned at say when i pull out from a stop sign!
ALL that i have done was put on hubcentric spacers and that i pulled off to see if noise stopped but it didn't! Could the supplied bolts be to long? I had removed dust caps on rear for clean fitment and sanded any imperfections on all hubs.
The noise isn't loud at all but is definitely noticeable with radio off and windows up!
Could this be a wheel balance issue? Tie rod or arm? Bent RIM?
Golf IV / Jetta IV :: Front End Clunk Sound Occurs While Braking And Accelerating Over Bumps
A clunk sound coming from the front end. Drivers side and Passenger side. Not really a metal on metal sound. The problem started after coilover install. The sound occurs while braking and accelerating over bumps. So what I've replaced:
-Strut Mounts and Bearings
-Lower control arm bushings (R32 bushings)
-Drivers Side CV axle
What I've checked:
-Tie rod ends have no play
-Ball joints have no play.
-I have no sway bar, so not the sway bar bushings.
-Its not the axle hitting the frame.
Could possibly be the dog bone mount but when I installed the 1' motor mounts I saw no issue but could possibly be the bushing. feel the clunk in my foot as well.
MK4 2000 Jetta 2.0 5speed With Raceland Ultimo Coilovers (Junk)
Sonata I45 (LF 2015+) :: Clicking Gas Pedal
Has felt what seems to be a potential sticking gas pedal? When I floor the gas it clicks and almost feels like it wants to catch or snag. It hasn't yet but just curious.
View 18 RepliesPassat (B7) :: Clutch Clicking When The Pedal Is Depressed
2013 tdi 6mt. I am noticing that my clutch clicks when the pedal is depressed. it does not happen when I first start driving in the morning, but it seems that once the cabin is warmed slightly it starts then clicks each and every time. It is annoying and it appears to be related to the different temps outside vs the cabin. I did not notice it during summer or early fall but it is cold here now.
View 24 RepliesFord Excursion :: AC Compressor Comes On For Approximately 1 Second And Goes Off
Well I've thrown out the situation of having low freon for discussion earlier and of course consensus is a leak. I added freon by way of one of those guage on the can deals and it seemed to be mostly ok for a while. Today it was around 90 degrees--doggy and I were on a road trip. What started off as a comfortable trip became progressively warmer. I noted the rear air was blowing warm air--not "not as cold air" like what you'd expect from the vents being in the ceiling. Got back home and hooked up my new manifold gauges I had ordered which of course, were in metric.
Long story short, I added some freon but while the low side pressure seems to be in the proper range, the high side pressure is very low, as in not much higher than the low side. The compressor comes on for approximately 1 second and goes off. Both sides have a pressure drop when it comes on-maybe the low side dips a hair below ideal but I am perplexed-or actually lacking knowledge. I know this is going to be a professional's issue for me, but what could be going on. I read a little on the expansion valve but I guess I am wondering if there is anyway to narrow down the problem--guess it comes from always trying to learn stuff.
Prius (Gen 2) :: 2004 - Clicking Sound When Brake Pedal Depressed
I have another small issue with my 2004 Prius. I just noticed yesterday that the second I very lightly depress the brake pedal, a little clicking sound is made down below. It sounds like it might be coming from the brake pedal itself or somewhere underneath the hood. It's only when I depress the pedal slightly and it makes pretty much the same sound when I release the pedal. I just had a 5000 mile service done to the car and there were no issues then.
View 14 RepliesLexus GX 2004-09 :: Clicking Under Steering Wheel Around Pedal Area?
I have noticed a randomized clicking sound coming from under my steering wheel around the pedal area. It sounds electrical, not mechanical.
View 8 RepliesAccent LC (2000-05) :: Brake Pedal Making Noise Like Clicking
My daughter has bought a 2003 4 door accent and on the way to work she lost most of the brakes. I could not see any fluid leaking and the level was ok. I did try pushing on the brake pedal with my hand and it was making a noise like a clicking? I was thinking it was just the brake light switch but not sure. The place she bought it from put new brakes on it when the driver side was getting really hot. I am thinking maybe air in the system? It sounded like a caliper was sticking when I test drove it but only a couple of times. You would have some brakes but you had to pump the peddle.It is in a parking lot right now but I can work on it unless it is some sort of different? I am going to try to bleed it in a little bit but was thinking I should ask around. I read that the piston could be sticking but can you just rebuild the master cylinder to fix it if that is what it is? I could pull the pedal back a little bit. I only looked at for 4 or 5 minutes kinda dark and no tools with me.
View 10 RepliesPassat (B5) :: 1998 - Quick Clicking Noise After Depressing Gas Pedal?
Happens when I quickly let off gas pedal and engine spools down. Just curious, hopefully no big deal but though I would ask. No maintenance lights on either.
View 6 RepliesToyota - Corolla :: 2007 - Brake Pedal Making Clicking Sound
My brake pedal clicks when depressed, only at the start of pressing down on it. (This is a 2007 Corolla CE.) It only does this when the car is cold and started doing this during the very cold below freezing weather. The brake lights are all working, nothing else seems to be a problem -- brakes work fine, no vibration, etc. Brakes were checked out two months ago.
View 4 RepliesSonata NF (2006-10) :: Clicking Or Crunching Sound When Pushing Clutch Pedal Down
M/T 2010 Sonata. I'm just out of warranty at 102,000 mi. No issues before with clutch. I noticed a clicking or crunching sound when pushing the clutch pedal down. I took a gander and noticed the pedal was traveling farther than it used to because there were indentations in the carpet. So this happens for about 3 days. Then I start the car and cant get it into gear. If I shut it off, it easily goes into gear and I can drive. Usually it is ok after that point but is getting worse. Mechanic briefly tried to bleed it but the pedal stayed on the floor. He was able to get it to its original problem but said if he replaces the master & slave cyl then might as well do a new clutch. Because I had no slippage, no pedal issues or anything prior to clicking. Is 102k miles and 6 years usual time for these components to fail?
View 2 Replies