Ford Ranger / B-Series :: 2002 - Rough Idle Codes / Cylinder 2 And 3 Misfiring
I have an 02 ranger xlt 3.0, it started having a rough idle, codes say cylinder #2&3 misfiring, changed plugs, wires, coil pack, didn't work, still same code, checked injectors on right side, all 3 had ohm reading of 15.8-16.5, the injectors were clicking like they are supposed to, sprayed carb cleaner around the intake ports, didn't change the idle at all,what else can I check or do? with out tearing the engine apart, unless of course I have to, the truck has been very good to me, it's got 205,000 miles on it, I need it to last at least another year...
View 4 RepliesGolf IV R32 :: Misfiring On Cylinder 2 And 5
Happened a few times on me lately. While pulling towards the top of 5th, I'll start to see the check engine light briefly blink as if the car wasn't sure, then at the top of 5th, she'll start misfiring on cyl 2 and 5. It's only during the long haul pulls that this occurs. My plugs and coils were all changed about 1k miles ago.
View 17 RepliesGolf IV / Jetta IV :: CEL Flashing Saying Cylinder One Is Misfiring
I have a 2001 golf with a 2.0 AVH engine. I recently replaced the coil-pack and was very pleased that the engine was running better, the only problem was the mpg was still kinda low in the 24-5 range when it used to be 29.
I tried to do a compression test but I didn't prepare properly, I thought you left the coil pack plugged in and the fuel fuse. Now I have a CEL that *was* flashing saying cylinder one is misfiring though it has stopped flashing. I drove it 13 miles home and it did improve but its still running rough. Very reminiscent of when my bad coil pack was still in there, a real lack of power.
So I have to ask, what can I do from here? Have I damaged my coil pack or cylinders? Will this likely go away on its own? Is there anything I should do?
Golf IV / Jetta IV :: 2000 VW VR6 Misfiring In Cylinder 1
I recently bought a 2000 jetta vr6 MK4 and since i have had it its had a misfire problem. So its saying that its misfiring in "cylinder 1" and sometimes when I clear the code it will stay off for the whole day. I did everything I could think of. I replaced all the spark plugs. I replaces the plug wires. Then i bought I new coilpack. and its still misfiring.
View 10 RepliesGolf IV / Jetta IV :: 2004 - CEL Came On - Cylinder 2 Misfiring
CEL came on and the report says #2 cylinder misfiring. Changed plugs, wires and coil. Last step was to change the #2 fuel injector. I changed the 2nd injector from the left but I'm still getting the same message. I was wondering if maybe they aren't numbered that way. It's a 2004 Jetta with Car engine: 2.0L L4 SOHC 8V. Did I change the wrong injector?
View 1 RepliesGolf IV / Jetta IV :: Again Cylinder Misfiring - Flashing MIL Light?
So a few days ago my engine developed a misfire, flashing MIL light etc...long story short it was cylinder 5's ignition coil. When we scanned it, we picked up a misfire on cylinder 5, and a slight misfire on cylinder 1. Replaced the coil, as well as new spark plugs, cleared the codes, and everything was peachy.
NOW, driving home today.....once again. Misfire, MIL light etc. I'm not a mechanic so I am wondering if it is common for all the coils to go around the same time, or if this is probably just cylinder 1 now going. I'm going to once again get it scanned, but before then...is there anything that could cause ignition coils to just start going bad, other than age.
Golf/GTI VI :: CEL Turned On And Misfiring On One Cylinder After Forge Wintake Install
So I installed a Forge Wintake yesterday and my car responded well to it yesterday. Everything was working great and then on my way to work this morning a CEL turned on and it is misfiring on at least one cylinder. I checked all of the connections to my coils, the MAF and my First O2 sensor. Everything looks fine. My Car is a 2012 GTI. I also have a APR stage 2 flash and a Raceland Catless down pipe.
View 14 RepliesGolf IV R32 :: Misfiring At Idle After Startup
Car has been running flawlessly up until about 3 days ago. One morning got in started up and started misfiring at idle. Didn't think much of it as it does that on cold start. Driving down the highway when I apply 5-10% light throttle the car bucks and doesn't feel smooth. WOT is fine. Pulled into a gas station to fill up and it stalled as soon as I put it in neutral. When I tried to start it back up it started for a second then stalled out again. Finally I gave it some gas while I started it up and got it to idle on its own (idled around 600 rpm, down from my usual 800 rpm).
At this point I am thinking boost/vacuum leak. I leave the gas station and get caught in traffic. Car is not overheating. All of the sudden I notice a bunch of white smoke coming from the tail pipes. I pull over pop the hood to check coolant. No leaks and bottle is full. The white smoke smells like burnt oil. finally notice a VERY small oil leak at my turbo oil feed line. I checked the oil level and it was still exactly where it needs to be.
I have my buddy at the dealership looking over it now but I am really worried that I might have blew the turbo..
LS / MKZ :: 2001 V8 Shuddering And Misfiring On Cylinder 2
Going up a hill this LS started shuddering and misfiring and set the po302 code. A small push on the accelerator sometimes seems to temporarily remedy the issue. This started about a week ago. fuel mileage : 26 mpg highway
Here's the readings I got at idle:
Fuel pressure is KOEO - 0 (That's what it read.); KOER - 30.
MAF - about 70
LT FUEL TRIM 1 - 5.5
ST FUEL TRIM 1 - STAYS NEGATIVE
LT FUEL TRIM 2 - STAYS NEGATIVE
ST FUEL TRIM 2 - STAYS NEGATIVE
ST FUEL TRIM 11 - STAYS NEGATIVE
ST FUEL TRIM 21 - STAYS NEGATIVE
O2 1 - NORMAL FLUCTUATES PROPERLY
O2 S12 - STAYS ABOVE .500
O2 S21 - NORMAL FLUCTUATES PROPERLY
O2 S22 - STAYS ABOVE .500
Not familiar with this vehicle...
Touareg :: Put In All New Plugs / Cylinder 5 Is Misfiring
I have a 2008 Touareg 2, V8, 4.2L.
I bought it used (~95k miles) and almost immediately had an issue. #5 is misfiring. Since then, it has been in the shop 10-12 times with no resolution. Here is what I have done so far:
Put in all new plugs/coils sent the ECU to SIA electronics in Chicago for testing - no errors replaced the injector with a new injector on #5swapped #1 for #5 (plugs/coils)checked the harness (dealership said they did this, but not sure if they did or are just tired of me)
Through all this, #5 is still misfiring. The dealership is out of options, suggesting that the ECU is faulty and needs to be replaced ($1600) or they need to swap the #5 injector with #1 to see if that is the issue (~$1000+). Neither of these options sound reasonable because a) the ECU was already tested and b) the injector is brand new, yet the exact problem (#5 misfire) has persisted before and after the injector replacement.
Passat (B6) :: 2006 2.0T - CEL On And Cylinder 3 Misfiring
My dad has 2006 passat 2.0T. In December 2010 he went overseas. During his absence the car was parked in garage and not in use.
So one day I decided to start the car and as soon as I turned it on the car made this noise and check engine light came on. Took the car to a private repair shop and found out the cylinder #3 was misfiring. The tune up for this car was due so I had all four spark plugs changed and the car ran fine for few days. Then couple of days later it started making the same sound and this time around the coil for cylinder #3 was replaced.
A few days after that check engine light came back and this time it was blinking and the engine was struggling to run, took it again to the workshop yesterday and this time another coil not sure which cylinder was replaced. (all this is done at a private workshop). I have a hunch that the car is going to run fine for a day or so and the problem is going to come back
I never had any major issues with it up until now. Bought this car new in 2006 from dealer. I am afraid that this might be a start of a downhill roll from here on I will drive the car tomorrow and see how it reacts.
Passat (B5) :: 1999 - Misfiring At Cylinder 3
I've done just about everything me or my mechanic cannot figure out why cylinder #3 is misfiring has new plugs coilpacks checked wires etc. I love this car and will not put it to sleep!!
View 2 RepliesDodge - Caravan :: Cylinder 4 And 6 Misfiring
I just had all 6 fuel injectors changed as they were rusted. But the 4 and 6 are still miss firing. I am going through gas more than I should. I had the EGR replaced as it was stuck open. I do not want to pour more big money into this thing. What can I do. Sea foam is not working. Could it be another problem. I am starting not to trust the mechanics.
View 12 RepliesGolf IV / Jetta IV :: Misfire On Cylinder 1 At Idle
Alright Ive had a misfire on cylinder 1 for far too long. I've replaced all ignition coils and plugs with oem parts. Also replaced fuel pump and filter with oem. As well as 2 injectors. Before I would misfire under load, now I misfire at idle..wiring looks good and not cracked from what I can see. Only codes I reciece are random multiple misfire, misfire cylinder 1. And diverter valve mis function because of my BOV. So what do I do now vortex?
View 1 RepliesVolvo :: 1988 240DL - Cylinder 4 Misfiring
My 1988 240DL is miss firing #4 cylinder. I cannot get it to fire. this is what I have done:
Swapped plug wires with the #3 wire. Miss fire does not follow the wire
Swapped plugs with #1 plug. Miss fire does not follow the plug
Tested injector power with a tester and it lights up properly
Replaces #4 injector with a new one, still miss fires.
Replaced cap and rotor
Compression test shows 150 LB in #4
sworn and thrown a few tools, still miss fires.
Spark seems good with the plug out and grounded on the block. What else should I test and or try...
Jaguar - Xj6 :: Misfiring Cylinder 5 / Car Started Shaking With CEL Came On
I used fuel injector cleaner in two different gas tanks; the car started shaking and the check engine light came on. The mechanic changed a sensor but the car was doing the same; I was told that it will take 4 full gas tanks to clean the gas lines. I went to autozone and they told me that the car had a misfire on cylinder 5 and multiple misfire as well. I do not trust the mechanic any more since I had to take the car back to them several times and still is not fixed. They also did a full tune up and the check engine light still on and flashes when I am going about 55 mph.
View 3 RepliesFord - Explorer :: 2004 - Misfiring On Cylinder 3 And 6
Changed the spark plugs now I have misfire in cylinders 3 and 6. Do I change the spark plug wires or the coil pack?
View 5 RepliesFord - Ranger :: 2002 - Misfiring In Cylinder 1
Had a misfire in cylinder 1 so I put new plugs and wires. Still misfired. Changed fuel injector. Still misfired. Changed ignition coil and misfire on cylinder 1 is gone now cylinder 2 and 3 are misfiring. I double checked wires and they are properly installed.
View 11 RepliesGTI 337/20th Anniversary :: Stalling And Misfiring In Cylinder 2 And 3
This has been happening intermittently for a while now. The car has about 97k on it and I within the last 1000 miles have replace the timing belt, water pump, coolant temp sensor, tensioners, thermostat, and MAF (OEM BOSCH from ECS).
The car was overheating; all the cooling/timing related stuff was changed, no issues for a few weeks. Then it started misfiring and stalling like a madman in cyls 2 and 3. Ran ran if for the code pulled the MAF and sure enough it looks like the PO never cleaned it as there were probably 2mm of buildup on it; as preventative maintenance I went ahead and just replaced it completely.
Now, less than a week after I replaced the MAF the car will make random little popping noises under hard acceleration, and randomly will just completely stall; without showing the battery or check engine lights, similar to how it was stalling right before the MAF went bad. I live three miles from my office and it has happened going to and from every day for the past two weeks.
As far as I know the car is mostly stock (I purchased in in March). However it does have a knockoff BPV of some sort that I think could be causing the issue as the popping noise sounds like its coming from the passenger side of the car. What this might be (if it's not the BPV).