Windstar :: 1998 - No Vacuum To Rear Auxiliary Unit
1998 Windstar Limited. I have no vacuum to my rear Auxiliary Unit. I am considering buying a hand vacuum pump. However, I never used one. Is there a video available.
View 9 RepliesGolf IV R32 :: Rear Diff Went Bad
So i bought my car 3 weeks ago knowing it had a bad rear diff vw is wanting to charge 2500 to 3000 to replace it (and i work sales).If i've found some used ones.
View 14 RepliesGolf VI R :: Rear Diff Rubbing Through Exhaust
So I put the R up in the lift today to look for a rattle underneath and I ran into this..
View 7 RepliesGolf IV R32 :: Rear Diff Started To Whine On Deceleration
My rear diff had recently started to whine on decel, what I am looking to find out is, would replacing the stock rear diff itself with a peloquin unit be enough of a fix, or should the whole rear housing be replaced as well? I don't want to buy a peloquin rear diff and install it and still have issues because of the pinion shaft being the culprit or something else.
View 6 RepliesGolf IV R32 :: Noise From Rear Diff Like Something Rubbing Or Tire Skidding
Fixed my AWD. Needed a new Haldex pump. Did a fluid change and new Haldex filter. All using factory stuff.
AWD works great now. The problem though is when im making tight slow speed turns. I.E. backing out of a parking stall. I get a noise from the rear diff like something rubbing, or a tire skidding.
Is this normal? I bought my car from the dealership without my AWD working and just got it fixed, so I really didn't know what an AWD R32 was like.
Golf V R32 :: Rear Diff Buzzing Noise - Sport Mode
So since I added the spark cut tune, I've had this weird buzzing noise when it's down gearing. It doesn't do it in D though which is odd. What could be wrong?
View 2 RepliesGolf IV R32 :: Rear Diff Is Done / Metal Chunks Stuck To The Magnet
This problem started in Jan this year and got worse through feb, got it checked in march to find out it had metal shavings and chucks stuck to the magnet. Ive searched the forums for the last few weeks but noticed no one seemed to point out if you can drive it while its like this or is this a recipe for disaster. other than the droning/whining the car will fight me will going in reverse while turning which has happened twice. Need to get the whole rear diff/haldex replaced....
View 7 RepliesGolf V R32 :: Intermittent Spinning-like Vibration Noise From The Rear Diff Area When Accelerating
Upon moderate to hard acceleration I hear an intermittent spinning-like vibration noise from the rear diff area...is that normal?
View 1 RepliesDatsun :: 1977 - Possible To Remove Vacuum Lines From AC System
I decided to do some work on the engine bay of my '77 Datsun 280Z. I would like to know whether it is possible to remove the vacuum lines from the system, and if so, what would be the effect on the AC system? If I understand it correctly, the AC selector and mode doors are mechanically operated and vacuum lines assist in opening (i) the air intake door and (ii) the mode door?
View 10 RepliesFord F-150 - 1997-2003 :: P0401 Code - Vacuum Lines?
So here's the background. I recently bought this truck. It's a 97 Ford f150 4x4 4.6l 99w vin code. Anyway Driving it home got a p0401. No problem. I Applied vacuum from other vacuum source to EGR engine stalls. So to me passages are clean in the throttle body. I checked to verify and indeed passages are clean. No while doing so I noticed no vacuum was making its way to the dose valve thing. Strange.... So took the line that runs to the passenger fender to dose off and it was impossible to blow air through.
So I cut out the clogged section found solder in the line. I filled the gap I now created using some 5/32 vacuum line reconnected to test and to my anvil still not vacuum. So I disconnected it again. Went directly to where the yellow/orange dose vacuum line connects to at the passenger fender and to my surprise no vacuum there either. No my question is. Am i suppose to have constant vacuum to the dpse or I'm I just being an idiot. And two if I am suppose to when the vacuum line runs into the passange fender where does it go from there and could I have a major issue in my hands?
Golf IV R32 :: Rear Lines Not Stay In OEM Securing Clips?
Have these installed? The rear lines are not wanting to stay in the OEM securing clips? Used search already as I though I read about this issue before but couldn't find anything.
View 6 RepliesFord Excursion :: Vacuum Leak In The Lines Coming From Electric Pump
So, my original pump finally died and I replaced it....however upon doing so I realize there is a leak/crack in the lines as it never shuts off (explains why the factory one died).
After a bit of troubleshooting, I've discovered the leak HAS to be down in the passenger fender where the black and grey lines travel over the blower housing and go straight down up against the inner fender wall.
Where doe these come out or connect? I clearly cant get a hand down in there...does the inner fender well have to come out to access this? or is there a junction box/splitter somewhere accessible?
Ford Super Duty (1999-2016) :: Removing Hub Vacuum Lines
I have manual hubs on my truck. Can I pull those vacuum lines and plug the holes?
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: Vacuum Lines Sizes To 4WD?
Time to replace the aging vacuum lines to the 4wd and probably anywhere I can find the old rubber stuff.
What is the size of the lines and are they mostly the same?
I'd like to order a roll so I can make ones like the front hubs longer, stuff like that.
Ford Ranger / B-Series :: 2002 - IMCR Vacuum Lines - Where Hoses Go Off
Looking for a pic of where the 2 vacuum lines go off the IMCR on a 2002 ranger 2.3. Changed engines now not sure where these hoses go.
View 2 RepliesFord F-150 - 1997-2003 :: Vacuum Reservoir Lines Under Passenger Fender Broke Off
I have a 1997 4.2 and when i got it the big vacuum reservoir under the passenger fender had the lines broke off. Where these lines go or have a diagram...
View 1 RepliesFord F-150 - 1997-2003 :: Check Engine Light On - Rubber Vacuum Lines
I got a question, what is after ac hose vacuum left side on a 10 th gen 4.2l engine bay by the firewall, to the right of the blue thing, right of that on that line their is a 2 end diameter rubber vacuum line? What is that called, I need a replacement.
View 7 RepliesFord Super Duty (1999-2016) :: Removal Of Vacuum Lines For ESOF?
Truck has been neglected for a while so this upgrade/repair I installed Powerstop brake rotor, caliper, bracket and pads. New Timkin wheel bearing, Moog U-Joints, and new inner/outer axle seals. Also replaced all the brake hoses and the remaining original rusty brake lines. About a month before I replaced the failed Auto/Manual vacuum operated locking hubs with Mile Marker units, which do not need the vacuum line, the drivers side was missing. and was letting water into the wheel bearing. So I decided to plug them and remove the vacuum lines from under the hood as well.
If there is interest I can get pictures of the vacuum lines, and what I changed under the hood. That was pretty self explanatory.
Could not find a google search for the thread size of the vacuum nipple in the knuckle. It is a 3/8"-24 fine thread.
[URL]
Ford Super Duty (1999-2016) :: 4x4 - Vacuum Lines Starting To Look Brittle
I don't have any leaks at the moment, but after inspecting my vacuum lines they're starting to look brittle and I want to replace them proactively. Is there a kit to do this or should I just cut a section off and take it in to an auto parts store to match the size, and buy it by the foot?
View 2 Replies