Golf IV R32 :: ABS / Traction Control Light Always On - Haldex Not Working
So yesterday we did a lot of work on my car. We accidentally pulled one of the ABS sensor wires out of place. I wasn't too surprised when the light was on, also with the traction control light on. (permanently) Going around a few turns this morning, I noticed a bit of under steer, which I thought was due to breaking in the new tires. But now that I think about it more, I don't believe my haldex is engaging at ALL! If I just replace or get the wire back in correctly (we tried, but may be in wrong...) will the haldex re-engage?
I want to get it scanned but I just started spring break and am flying back home to Minnesota on Monday. A friend (experience VW owner) will be holding her til then. I've searched and some people think the brake switch can cause the ABS light to come on with the CEL. Couldn't find anything about the Traction control light always on with the ABS light. My dash is just getting more and more lit up... The airbag fault light is because of the selt buckle resistance and the brake pad light is from the new porterfield's I put on... (i put ECS' brake loop on too but not working-do I need to get it cleared?)
Golf IV R32 :: Haldex Stopped Working Due To Wiring Harness Connector
So my haldex stopped working, I found it to be caused by the wiring harness connector on the back of the diff was internally corroded badly... I want to repair this correctly with both a new male and female connector and im going to need new pins for the wire that shorted in the connector.
View 1 RepliesPassat (B6) :: 2006 3.6 4mo - Fault Codes For Catalyst System / AWD Controller And Haldex Pump
Ok, so I scanned a 2006 Passat 3.6 4mo. I got a fault for the catalyst system, a fault for the AWD controller, and a fault for the Haldex pump. I'm guessing the catalyst code is for the oxygen sensors? What should be my next course of action on the AWD stuff?
============================================
Address 01: Engine Labels: 03H-906-032-BLV.lbl
Part No SW: 03H 997 033 M HW: Hardware No
Component: P3.6-FSI-LEV2 G00 2370
Revision: --H11--- Serial number: VWZCZ000000000
Coding: 0000175
[Code] ....
Golf IV R32 :: Loud Rattle And Oil Leak Near Haldex
Yesterday the car was fine going to work and most of the way home. It was raining pretty hard and I went through a large puddle then right after I started to hear a pretty loud noise. It sounded like it was coming from the middle of the car, more so in between the main seats and was vibrating my seat a little bit. It only happened on mediumish acceleration, during low acceleration it wasn't there at all. Also the car still felt fine. Then when I got off main road I was on a street that wasn't super wet cause of all the trees, the sound stopped.
Here is a link to the sound, you might have to turn up the volume because it is a little low. You can hear it best around 14 sec: [URL].....
So today I jacked it up to see if I could see anything and I found oil all around the haldex stuff. Here are some pics I took of the leak. There is also a bright yellow spot you can see through a hole. Not sure what that means. The haldex service was done, maybe 5-10k miles ago, I'd have to look it up to figure out exact time. In one of the pics you might notice black silicone around one of the plugs, this was because when I did get it serviced for the first time, someone before stripped the bolt so the mechanic put that around it to hold it in. It still looks like it is on there pretty well so I don't think that is the issue.
This isn't a big deal but I noticed this plastic part isn't bolted down, I really don't think the noise would be from this but posted just in case.
Golf IV R32 :: How To Remove / Install Haldex Controller
I searched but couldn't find any DIY on how to remove/install the haldex controller. Is it straight forward or any special tools needed? I know its very tight in there?
View 3 RepliesGolf IV R32 :: Where The 2 Vacuum Lines On Rear Diff / Haldex Unit Go
Top and bottom left. Where the 2 vac lines on the rear diff/haldex unit goes?
View 1 RepliesDodge - Gasoline - Pump - Relay - Dart :: 1971 - Fuel Pump Not Working?
ok, i just became the proud owner of a 71 dodge dart.. fuel pump was not working, and am converting to an electric (airtex e8016s) and am told i need a relay. airtex doesn't seem to have one, is there another i can use? fairly new at this sort of thing, but have fixed a 72 honda motorbike, so not afraid of engines or whatnot.
View 19 RepliesChevrolet :: Windshield Washer Pump Is Not Working
I just bought a 1995 S10 4x4 for my son and the windshield washer pump is not working. It doesn't make a sound and I have measured that no voltage is going to the hot side of the harness going to the pump. The ground tested fine. It was also having wipers issues where they stopped at random places when turned off and the timing was screwy. I removed and resoldered the wiper pulse board and cleaned up the contacts. Wipers are good, but still no squirter.
View 2 RepliesPassat (B5) :: Secondary Air Pump Won't Working Properly
I have had an engine code for some time claiming my auxiliary air pump is not working properly. My indy saw no obvious problem, but it could just be shot. He suggested I take it to the dealer. But from my understanding, that pump only works to achieve cleaner combustion when the engine is cold right after a start. I am tempted to continue ignoring it. Would I be making a mistake? I haven't noticed any power or mpg reduction.
I guess I can always take my car in for the under the hood seal recall and have them do a diagnostics too.
Camry :: 2009 - Fuel Pump Won't Working?
I have a 09 Camry 2.4L Installed veep core an now have no power to fuel pump . I have checked for ECM sending signal to turn on (it does)have had locksmith redo security (no luck) and will run if fuel manually induced . Has rpm signal on my diag so it's reading rpm also
View 1 RepliesDodge - Ram - 2500 :: Gauges And Fuel Pump Not Working
My 98 dodge ram 2500 was running and now the gauges don't work and the fuel pump isn't working either, I have checked and replaced fuses and relays with no luck ...
View 3 RepliesBonneville :: 1993 SE - Fuel Pump Is Not Working - Check Relay?
My 1993 Bonneville SE; fuel pump is not working. I don't know if it's the relay or not. How can I check and where is the relay. I have relays in horizontal line in center of my firewall. I am disabled and don't have any other transport.
View 1 RepliesFord - Escape :: 2003 V6 - Fuel Pump Is Working But Car Just Does Not Start
My car is almost turning on. It goes all the way but then just doesn't start. The fuel pump is working, can hear it. We checked for spark and there is. we sprayed that carburetor or whatever it is in the air intake thing too and it still didn't start. My buddy is saying that it has to be a sensor. Either O2 or crankshaft something sensor.
View 13 RepliesMustang :: 2000 V6 Won't Start / No Noise In Tank And Fuel Pump Not Working
2000 Mustang was running fine. It hasn't been driven in a couple of days, and now wont start. No noise in the tank, fuel pump not working. But when you spray gas into the throttle body it wont even try to hit. Fuses under the hood beside the battery are all good. Inerta switch is down and in place. Am I missing something? maybe a relay? I would just think no matter what, getting fuel into the opening of the throttle would cause the car to at least cough.
View 5 Replies4Runner/GX470 :: Fuel Pump Is Not Working After Changing Spark Plugs
As I say in my first thread my 2000 4 runner don't start after I change the spark plugs. I don't get any fuel pressure from the fuel pump.
View 2 RepliesKia - Sedona :: 2004 - Wiper Fluid Pump / Clock Working Intermittent
I have a 2004 Kia Sedona. The clock on the overhead console and the wiper fluid pump are both working only intermittently and they alternate working. In other words, when one works the other does not. My mechanic has checked it and has not found anything obvious.
View 1 RepliesToyota - Solara :: 2006 - Windshield Washer Pump Stopped Working
I have a 2006 Solara and overnight the windshield washer pump stopped working. I thought the problem was no washer fluid, filled it, and nothing. I checked the hose near the hood and nothing came out. The motor isn't humming like it is trying to pump, so I checked the fuse (I think I checked the right one, not sure, it was a 15a) and it appeared to be good. I checked the wires going to the pump with a multimeter and didn't get power, so is there any other "secret" fuse I am missing. I know on an older car I had, the fuses were sometimes mixed with other items and not labeled.
View 11 RepliesFord F-150 - 1997-2003 :: 2000 - A/C Pump Stopped Working After 15 Minutes?
Ok this is actually on my girls car, a 2000 Altima. But i know all newer AC systems work the same. Cus its the same set up as my 98 f150. But the AC will work great for the first 15 mins or so then i notice the pump stops working(not cycling on/off) So i turn it off for 5 mins and then it starts working again and i hear the pump engaging, but it will only work for like 5 mins now. Could it be a bad pressure cycling switch or clogged condenser and gettn the AC too hot and it shuts down.
View 3 RepliesFord F-150 - 1997-2003 :: Fuel Pump Not Working / Not Getting Voltage To Contacts On PCM And Relays
New to this site, my problem is on my 2003 4.6L fuel pump not working.My problem is that I am not getting voltage to contacts on pcm and fuel pump relays.
Getting volts to #30 fuse 30amps ok, voltage to pcm diode ok. Voltage on #30 on both relays(pcm & fuel) but I am loosing voltage across coils contacts #85 & #86, these makes hot #30 & #87 to make pump work. Inertia sw ok, Don't know if PCM is bad, ck fuse #2 ok 5 amps.