Golf IV R32 :: Clunking And Grinding Noise Coming Out Of The Front?
Clunking and grinding coming out of the front especially when i turn the front wheels even in neutral gears ? Really bad noise,all gears go in fine!! even when i drive strait with no gears u feel that clunking noise.
View 1 RepliesGolf IV / Jetta IV :: 2002 - Clunking Noise Coming From Front End
Ok so im going to try my best to explain this. Last week my passenger side motor mount broke the bolt snapped off and my engine fell on the ground and cracked the oil pan, too make a long story short someone put the wrong bolt in it and I fixed it with the right bolt. When the engine fell and the pan cracked i immediately shut the car off and coasted to the side of the road. I checked all bolts on the car to see if anything was loose but nothing was. But now when i start to take off i hear a clunk from the front end and i do not know what it is or could be. It is not the axles there is two brand new ones in it and have been checked. What it could be?
Car is a 2002 MK4 Jetta Wagon 2.0 .....
Golf IV R32 :: Clunking / Knocking Noise Coming From Front Wheel
So i had air-ride installed into my R 2 weeks ago and lately, i've noticed a knocking/thud noise coming from the front wheel well almost. I feel it more at low speeds and when applying the brakes to come to a stop.
View 4 RepliesGolf/GTI VI :: 2013 - Knocking / Clunking Noise Coming From Passenger Side Front
I drive a 2013 4 door gti. Car has 4k miles. Just last weekend myself and my buddies threw my coils in. FK Silverline X plus'. I am not sure on the measurement from fender to ground but I am a finger gap in the front, and fingertips in the rear. After throwing my coils in on saturday, I had an alignment and the rear camber adjusted. Just today, sunday, while driving home I heard a weird clunking/knocking noise. Previously I drove a mk4 and I know the sound of sway bar on axle and this is not the sound. Its coming from the passenger side front.. and I can sort of feel it through my clutch and brake. After pulling the car over I checked everything I could. wheels are all tight, struts seem fine. The noise occurs continuously even on smooth roads. The knocking/popping is pretty loud and can be heard in cabin. My buddy had mentioned the guys the aligned my car might have forgot to tighten something so I am heading back to the shop first thing in the morning.
View 3 RepliesIS F (2008-2014) :: Grinding Noise Coming From Front Brakes When Slowly Coming To A Stop Below 5 Mph
Just got a 2013 IS-F. Loving this car, but discovered an annoying issue. Grinding noise coming from front brakes when slowly coming to a stop below 5 mph. Is this normal?
View 9 RepliesSonata NF (2006-10) :: Clunking Noise Coming From The Front End
I have an 06 Sonata GLS with a clunking noise coming from the front end somewhere. I hear it when I drive over small cracks or bumps in the road, and when I jerk the car from side to side. I have just replaced the front struts, bearing plates, and sway bar links. I've checked the tie rods, ball joints, control arm bushings, etc.. Yet the noise still exists. After a recommendation from a Hyundai Tech, I even re-tighten the subframe bolts using loctite. I am completely lost at this point and do not know what to do to eliminate this annoying noise.
View 17 RepliesPontiac - Grandprix :: 2002 - Clunking Noise Coming From The Front End
I just got a new car three weeks ago and I'm trying to sell my 2002 Pontiac Grand Prix GT myself. Since buying this new car, I haven't driven the Pontiac for 3 weeks. I started it tonight and it started just fine but when I started driving, I heard a clunking noise coming from the front end. I checked the wheels and didn't see anything (though I didn't check too thoroughly). It's definitely the front end. The car has about 158,000 miles on it and before I stopped driving it, it had no issues and did not have this clunking sound. I tried leaving the car running for 5 minutes at a time and then turning it off and then on again thinking it might be that I've just left it sit there but that didn't work.
View 7 RepliesImpreza :: 2010 2.5i - Clunking Noise When Slowly Drive Away
Every time I turn on my 2010 impreza and slowly drive away i hear a clunking sound coming from somewhere in the front. it happens almost every time i start it up, even if it is warmed up.
Went to the dealer (car is 4 weeks old) did a test drive and it only did it once for them of course even though we tried almost 10 times. What it could be and will take it in for a full day to let it get cold.
Also, a slight rumbling when the car is cold and the blue cold engine light is on? I know the car being cold explain that but you'd think that a brand new car would be free from things like that.
Tiguan :: 2012 - Clunking / Rattling Noise Coming From Front Passenger Side Suspension Arm
I just purchased my first VW, a 2012 Tiguan SE in Night Blue Metallic. The level of fit and finish, handling, and general feel are miles ahead of my old '04 Jeep Liberty.
Anyway, I've had the car for about 250 miles and have noticed a clunking/rattling noise coming from what sounds like the front passenger side suspension arm. The noise is fairly quiet but seems to consistently happen when turning left over uneven pavement.
I plan on taking it to the dealer this weekend and it is only a minor annoyance, but a shame since the rest of the vehicle is so quiet and refined.
Ford Super Duty (1999-2016) :: Crunching / Clunking Noise Coming From Passenger Front Suspension
2012 truck, started making a noise today. I cannot tell what it is, but seems to be coming from the passenger front suspension, its a crunching/light clunking sound, happens when going over bumps, when the truck pitches one way or the other turning, and coming to a stop....
Truck has 6k miles, I did a quick visual inspection this afternoon, didn't notice much, but the sway bar endlink looked a bit odd though, not sure if normal, its gota little bend too it and seems to just contact the vac line mounted behind it, seemed unusual...
Maybe its its just one of the crappy rancho branded shocks is junk?
Ford Super Duty (1999-2016) :: F450 V10 - Loud Clicking / Clunking Noise Coming From The Front
I thought there was a v10 specific superduty section like how the psd does, but my thread went in the "performance, engine, troubleshooting" section.
I wanted more exposure than that particular small viewed area.
I don't have a video of the noise, but my 99 f450 v10 5spd has some iffy noise coming from the front. I've read so many threads on this and they either end with "my motor had 1-2-3 bad pistons" or "my flexplate was cracked" and all that dealt with chain tensioners were never finished.
I know what piston slap sounds like (worked on many cobras and lightnings with forged pistons that had it) and have experience with bad wrist pins and broken piston skirts, and this noise doesn't sound like any of it.
Noise is a loud clicking/clunking/Detroit diesel idle noise. When you rev the engine up it doesn't lighten or get better, only worse as rpm goes up. Oil is terrible looking, I'll be getting that changed this week.
Story on truck. I've had this thing for 4 years with blown motor. I got a buddy that acquired a parts truck and he said it ran good. I dropped my truck off and he swapped the engine. I got my truck back running, but with this engine noise. He said it needs to get run some more and change oil.
I think it's timing tensioners, my buddy says it will come out of it, a mechanic friend says it's going to blow up "because they all do" and I don't really want to replace the engine again.
If it's tensioners, how big of a job is it. I have the cam clamps and crank stop and the ford tools to make sure crank and cams don't rotate while apart.
I'm just 650 miles from my truck and may need someone else to do the work. Which sucks.
Golf IV / Jetta IV :: Clunking Noise In The Front On Both Sides
At low speed driving and hitting a small bump I hear a clunking noise in the front on both sides. But when driving at faster speeds and hitting a bump it makes no noise at all. I can't seem to figure out what it is.
View 5 RepliesGolf IV / Jetta IV :: Clunking Noise From Front Suspension
I am trying to find origin of clunking noise, but it is difficult to do as there is no visual signs and no excessive movements in any components.
Little bit of details and video. Noise occurs when moving rapidly steering wheel on stationary car with running engine. Not noticeable when at speed. Wheel is not vibrating and cv joints not clicking. Very tiny free movement in steering wheel about 1mm, but I am not sure if that is related maybe a completely different issue there. Mot tester make an advisory note that steering system slightly rough, but its not that useful to find an issue.
[URL] ....
Golf IV / Jetta IV :: Clicking / Clunking Noise From Front End?
I've been having a problem with a popping/clicking sound coming from my front end for some time now. 2 days ago I replaced the top strut mounts thinking they were worn and this was the source of my problem, however, the noise persists.I have raised the car and have tried to physically move the wheels, up, down, left, right, but I get no play in any direction.
When the sound happens: If I go over small bumps in the road, or depressions, or speed bumps at slow speed I hear what sounds like a metal on metal sound, but muffled, not a clang, but a pop sound. I can induce it by stepping hard on the brakes, as the car lurches forward I get the sound. After stopping, when the weight moves back again I get the sound again.HOWEVER, I do NOT get the sound from acceleration. I have tried putting on the parking break and trying to take off, but I don't get the sound. The sound is their wether or not I'm in gear.
What could this sound be? My possibilities include:T ie-Rods, Axles, Transmission (loose bolts), broken engine mounts, loose subframe, or perhaps my control arm bushings (but they were replaced with poly bushings about 30k miles ago)
Chevrolet - Avalanche :: 2002 - Clunking Noise Under Driver Side When Slowly Taking Off?
I have an 02 Avalanche 1500 4wd z71. It has 173000 miles. Noticed a clunking noise under driver side when slowly taking off. If I floor it there is no sound at all. This only happens when vehicle is on 2wd mode. If I put it on auto 4wd there is no more clunking. The noise sound like two pcs of bare metal are hitting each other. What this could be.
View 6 RepliesSanta Fe (CM - 2007-12) :: Clunking Coming From Front Suspension When Go Over Bumps
I can't find the obd port on my new 2007 SF. Also there is a clunking coming from the front suspension when i go over bumps, what is the most common cause of this?
View 13 RepliesFord - Mustang :: Thumping / Clunking Sound Coming From Front End
When being driven my '66 Stang makes a clunking sound in the front end which seems to be coming from the front toward the passenger side.
I've had the car in to my mechanic twice in the last 30 days for this issue. He took the wheels off, repacked the brakes on one side, but hasn't found the problem. During the test drives the car did not reproduce the noise.
Lately, I've noticed that when I really hear the clunking noise is after I've made a sharp turn, like when driving slowly in a parking lot, and have returned the steering to a straight position. We didn't make any sharp turns during the test drives.
Passat (B5) :: Clunking When Braking Coming From The Front Driver Side
Every time I brake I hear a clunking noise, it happens right before I stop completely. For some reason it does not make the noise when it has recently rained or the car is wet, the noise is coming from the front drivers side. I had a mechanic check out my suspension, and he said everything was fine. I am thinking it could be a bushing, but am not sure.
View 10 RepliesFord Excursion :: Clunking In Front End Coming From Adjustable Track Bar
I have the CaryT V/ modded B 33" kit installed, and re-torqued after 200 miles. But since the install the EX pulls to the left and I have a clunking in the front end. The alignment shop said they have my alignment "dead nuts", and it must be my tires. Well I replaced my tires and wheels and I still have the pulling problem.
The clunking I believe is coming from the adjustable track bar, the torque wrench only goes to 250 ft/lbs so went to 250 and then tightened a little more. I have no way to measure the 396 ft/lbs in the specs.