Golf/GTI VI :: Fault Codes From ABS?
I coded a few things through VCDS (fogs as DRLs, turned up XDS, enabled TSC, etc.) and now I'm getting fault codes from ABS...
I did an autoscan before I started and there were no fault codes before.
Golf V R32 :: Fault Codes After Engine Rebuild
All seems to be going well, drove the car for first 200 meters yesterday! Replacing the faulty parts is always easiest, just need to know if there are any shortcuts for fixing this. What's the engine oil temperature sensor? The one bolted in oil pan?
The intake air temperature is showing -40 degrees celsius.
MAF is plugged correctly.
VAG-COM gives me these following codes:
3 Faults Found:
000406 - Engine Oil Temp. Sensor (G8)
P0196 - 004 - Implausible Signal - Intermittent
000275 - Intake Air Temp. Sensor (G42)
P0113 - 002 - Signal too High - Intermittent
000258 - Mass Air Flow Sensor (G70)
P0102 - 002 - Signal too Low
Readiness: 0000 0000
Golf/GTI VI :: CEL Flashing Then Stayed On - Multiple Fault Codes
Car was taking 3-4 seconds to turn over when I started it one night. After that, flashing CEL and then CEL stayed. Car idles ridiculously rough, thought it was just a coil pack but seems to be a lot more. What is going on with my car?
Performance mods:
APR intake (stage 1&2)
SPM track edition turboback
Stage 2 revo software
R8 coilpacks and NGK plugs put in 9-10k miles ago
Have 52k miles on the car if that matters
Golf IV / Jetta IV :: Getting 20 Intermittent Ground Fault Codes
I am getting 20 intermittent ground fault codes and the kid I bought the car from had an alternator put in. I see a terminal closest to the front of the car on the alternator that has no thick wire attached to it and when I was at the junkyard they had wires connected to them. I cleaned all other grounds on the car that I can access so I think that could be the issue but I don't know where the wire should lead to and how the alternator should be grounded!
View 1 RepliesGolf IV / Jetta IV :: O2 Fault Codes Came Back After Sensor Replaced
Keep getting o2 fault codes. Replaced sensors came back. tried another set of sensors came back. Checked wiring for breaks no luck. Replaced ecu still no luck. So going through wiring again and checking for continuity. Looking for a list of what pins to check for voltages, and what each should be from ecu to sensor connectors. Looking for what wire is signal and how to and what voltages to check for...
View 5 RepliesGolf IV / Jetta IV :: 2004 - Multiple Fault Codes / Random ASR Light Coming On
The vehicle is a 2004 Jetta MK4 1.8t.
Last thing I had replaced about 2 months ago was the Solenoid valve, the MAF and Solenoid hose. Car ran fine for about a month, and bam...engine light came back on, along with the ASR light. At first it was saying "cat converter" so I researched that, and what a surprise, it spoke about being a $1k piece to replace. NOTHING HAS BEEN CHEAP ON THIS CAR, and I'm losing my mind.
The latest adventure happened today coming back from the gym. Car started jerking (which has been normal since every now and then the ASR light will come on, which I'm told is the traction control light. Causing the car to jerk. Simple fix is pulling over, shutting the car off, and turning it back on. That always clears it, and then I'm back on the road.) but instantly it lost power. It wont shift, but the traction control light didn't come on. I plugged my OBD2 tool up, and came back with these fault codes:
P0420: Catalyst System Efficiency Below Threshold (Bank 1)
P0753: Shift Solenoid "A" Electrical
P2637: Torque Management Feedback Signal A
I'm going to go to these guys tomorrow, but I would just like to get an educated guess on what might be going on, so I don't look like a lost dog while they're figuring out what to do next. These guys seem knowledgeable, but they're missing something since I've been in and out of their shop several times and still getting my traction control light on at random times, and now all 3 of these codes.
Does that Solenoid code have anything to do with the Solenoid valve they put in? I was told that cleaning the throttle body and the cat converter might work. Would those be cheaper options to consider, and see if that works?
I also read that unplugging the alternator and plugging it back in, then cleaning the male and female with electrical cleaner might work. I was told about a month ago that my battery barely passed. Could this be causing any of my issues? I also did a log while I was driving, but all that's showing up is a google map document.
Golf IV / Jetta IV :: 2.0 Engine Is Sputtering And Rough Running On Morning Start - No VCDS Fault Codes
I have a 2008 MK4 2.0 with only 53,000kms. At 40,000Kms I put new OEM spark plugs.
Just recently, every morning when I start the engine is sputtering and rough running. The engines want to die but I give a little gas, and run rough like it is only firing on two or three cylinders.
When it gets to the normal operating coolant temperature it runs without any problem and I can use the AC. Its only give me this problem on the first start of the day.
Does not have any MIL light on the instrument panel. I scan it with VCDS-Lite and do not found any fault codes. The only thing that's come to my mind is to change the Green Coolant Sensor.
Golf IV / Jetta IV :: 5 Engine Fault Codes - Cam Position Sensor / Knock Sensor / Secondary Injection Pump And Mass Air Flow
I recently picked up a 2000 jetta vr6 for a very good price its a glx I have owned a vr6 before and done timing chains myself on it this one is a glx , I am having 5 fault engine codes on my vagcom they are cam position sensor , knock sensor, secondary injection pump, and mass air flow it ran fine 100 miles yesterday this morning the epc came on then went off and ran bad can these codes all be related or do I have to replace each sensor individually..
View 9 RepliesPassat (B5) :: ABS / ASR Fault Codes
Can dealership diagnostic tools read ABS/ASR fault codes, or if those codes are even stored?
View 1 RepliesPassat (B6) :: Sputtering And Fault Codes
Driving home car started sputtering like crazy. vag com'd it and this is what i got from the scan!
Friday,06,April,2012,16:16:02:36785
VCDS Version: Release 11.11.2 (x64)
Data version: 20120126
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Chassis Type: 3C0
Scan: 01 02 03 08 09 0F 15 16 17 19 1C 25 42 44 46 52 53 56 62 72
[Code] ....
Intrigue :: Warning Lights Lit Up - No Fault Codes
These warning lights are lit but my code reader (Actron CP9180) shows 'pass' meaning no fault codes. I had a similar thing happen about a year ago Before I had my own reader) and the cause was a faulty speed sensor on one wheel. Since then all 4 hubs have been replaced. Does this sound like the brake module?
View 14 RepliesTouareg :: Fault Codes P0491 And P0492
I was told that these are affiliated to a problem with the air pump (not the one you pump the tire up with) -- Need to locate the air pump? Hoping to find a loose hose or something I can fix.
View 12 RepliesElantra HD (2006-10) :: 2007 - ABS Fault Codes
As far as trouble shooting faults in the ABS - does it store fault codes and how can they be read ?
Daughter's 2007 Elantra has ABS symbol lit for a week, I took it to a car wash and used the high pressure spray to clean the wheel hub areas and that may have fixed the problem but interested if ABS fault codes are stored and can be read.
Ford F-150 - 1997-2003 :: CEL Came On / 5 Different Fault Codes
The check engine light came on in my truck and while I suspected it was a misfire (driving along it will misfire like crazy at certain RPM). What I cannot figure out is exactly which coil is causing the problem. I get these codes:
P0306 - Cylinder 6 misfire --> Easy enough, cylinder 6
P0356 - Ignition Coil F Primary/Secondary Circuit --> Which cylinder is this?
P0356 - Ignition Coil G Primary/Secondary Circuit --> Which cylinder is this?
Assuming that cylinder 1 is the front left (when facing the vehicle) am I right in that cylinder 6 is the 2nd from front on the right (when facing the vehicle)? Would Ignition Coil F also be on cylinder 6? and therefore ignition coil G be cylinder 7?
The other code I am getting are both the same:
P1740 - Powertrain
P1740 - Powertrain - Transmission System Problems
I suspect these 2 are related to one another, the odd piece is it drives fine other than the misfire. Hoping to cure the misfire so that it drives smoothly and I can then figure out the P1740 code.
Lexus RX 2004-09 :: Engine And VSC Lights On - Fault Codes
Picked up my rx300 on Monday. Got engine and vsc lights on. Tried battery off to reset. Worked for a day then back. Got a code reader and reset. Found a p00016 code? Crankshaft potion/camshaft position bank 1 sensor A correlation ?
View 1 RepliesPassat (B6) :: Cannot Get Steering Assist / ABS Fault Codes To Clear
I have followed the process for clearing and resetting the Steering Assist/ABS fault codes. I have done all the steps several times and cannot get the faults to clear, although the VAG-COM indicates all is green during the testing phase.
[URL].................... And the faults will not clear.
Here is the scan results, (non-fault sections removed):
VAG-COM Version: Release 704.1
Data version: 20070422
Sunday,03,June,2007,17:47:17:25986
Chassis Type: 3C0
Scan: 01 02 03 08 09 0F 15 16 17 19 1C 25 36 42 44 46 47 52 53 55 56 62 65 72 76
[Code] ....
Passat (B5) :: 2005 - Airbag Light On / No Fault Codes
I recently sent for a reset my airbag module, yes my car was in a collision, I replaced passenger airbag(only 1 airbag deployed). And reconnected the module. Using the VAG COM, I scanned the airbag module, shows no fault codes, but i still have a light.. now I'm thinking seatbelts and sensors maybe the problem. Where the sensors for a 2005 passat passenger dash airbag are located.
View 2 RepliesElantra XD (2001-06) :: 2003 - 3 Fault Codes Repeated Twice
Connected my obd2 to my car and found 3 fault codes 1 which repeated itself twice.. the codes are P0453 that repeated itself a couple times and the 3rd one is P0133.. I looked them up and see that one can be either bad grounding and also a bad oxygen sensor? and then the other mentions something about fuel and says something about fuel pressure sensor?
View 3 RepliesAccent LC (2000-05) :: CEL Fault Codes P0304 And P0441
Car - 2004 Accent auto.- 1.6l - 97K miles
After battling a few months to get my check engine light - fault code P0304 to go off I finally remedied the problem with 3 bottles/fill ups of STP Gas treatment. This was about 1500miles ago. I go to DMV Inspection station and sat for an hour then wait anther 20minutes for the test to end and was given the big fat rejection sticker, she failed because the check engine light came on with fault codes P0304 & P0441.
Now what the heck happened here? Just bad luck and coincidence or did their test set it off? Anyway the P0441 code is new and researched it is the Evaporative Emission Control System Purge Valve. Okay where is it, the HMA manual is not specific? In relation to the intake manifold where is it? Easy fix? And will this solve my P0304 code?