Golf IV R32 :: Intake Air Temperature Sender Signal Too High / Air Mass Meter Signal Too Low
I drove to the mall and left the car there, when I was done and tried starting, it fired up but the rpms started to fall and CEL came on. CEL are:
-16497 P0113 050 Intake air temperature sender-G42 Signal too high
-16486 P0102 050 Air mass meter-G70 signal too low
And after it died it cranks but never fires up. I called the dealership trying to find out where the IAT sensor is but they said it's in the manifold and not sure where. Where is IAT sensor?
Ford Fuel System :: CEL Comes On Indicating Low Voltage On The Mass Air Meter
I have a 5.0 with the Explorer intake, GT40 heads, RJM harness, E303 cam, and a A9M computer in a '68 Mustang.
When you let off of the throttle the CEL comes on indicating low voltage on the MASS air meter. I changed the MASS from the '89-93 5.0 Fox Mustang meter to a new '94 Cobra style meter, reset the computer and it does the same thing (immediately).
Current intake setup is the Explorer throttle body, an '89-93 Fox 45* elbow, MASS air meter and a double cone Spectra air filter mounted directly on the meter.
I don't really have room to go cold air unless the battery goes in the trunk and since this is my wife's daily driver, I am reluctant to. Car is running open loop at 12mpg.
Golf VI R :: Noisy Dual Mass Fly Wheel?
I have had this basically since i got my car. I brought it up with VW and the best explanation they could offer was the DMF. When i set off, more so at low rpm and under load (like reversing out of a spot and continuing forward) i get a knock from the drivetrain. Its not super loud, but it is certainly noticeable. Everyone i have asked has said it just sounds like the Dual Mass Flywheel making noise, but should i be at all worried? I made sure i have it on record with VW that i noticed the noise and they said its no big deal.
View 4 RepliesGolf/GTI VI :: CEL On - Code For Mass Air Flow Sensor
Need to diagnose an issue with my 2012 GTI its got 39,000 miles its stage 2 Unitronic tune. So I was driving like an idiot coming home one night and i jumped a set of train tracks. Bent my plastics a little and when I cranked my car the next day my CEL was on. I noticed my intake was much noiser than usual. My buddy checked the code and said i needed a new mass air flow sensor. We replaced it and my CEl came back on within 20 minutes of replacing the sensor.
View 5 RepliesGolf IV R32 :: Mass Flow Rate On Healthy MAF - Code 17560
I am throwing a code for long term fuel trim being out of whack (code 17560) and I am trying to determine whether the MAF is causing it.
I pulled several redline runs while logging flow rate in vagcom. According to Ross tech's site they suggest that your flow rate should be around 80% of the engines rated horsepower. So approximately 200 g/s. I did several runs and never broke 100 g/s so what I should be seeing or has run into this code before.
Golf/GTI VI :: 2011 - Mass Air Flow Sensor Wiring Harness?
What is that called? Mass air flow sensor wiring harness? I google 2011 vw gti MAF wiring harness, and i get nothing, or crap thats almost not related to what im looking for. While I was installing my intake, I accidently cut half of the wire to my MAF located behind the battery. Why I was cutting, dont ask, i was impatient. Anyways, what is it called? I want to replace my MAF and the wiring that leads to it.
View 1 RepliesGolf IV / Jetta IV :: Gas Is Leaking Out Where Neck Meets The Mass Of Tank
I was just outside next to my car and smelled gas. look under the car, and gas is leaking out of the tank where the neck meets the mass of the tank...I just filled up and topped off about 2 hours ago...is the neck connected to the rest as a separate piece, or is it just one big mold? really need to fix this or replace the tank before the leak gets any worse, or causes damage to anything else.
For reference, its an 03 GLi 24V....
Golf IV R32 :: CEL P0103 Mass Or Volume Air Flow Circuit High Input
So i got the UM tune done to my car then went and got my TT cams installed. After giving me car the 50 miles to adjust for the cams i get a CEL P0103 Mass or volume air flow circuit high input. Checked the connections around the maf and im noting seeing any broken vac lines or anything out of the ordinary.
Cleaned the maf and cleared the code but the CEL popped back up, got a new maf just because I like spending money on things i dont need and the CEL is still there, low speed or high speed it will pop on.
Is there anything I am missing that could be causing this problem or something i can try other then take to the place that did my cams?
2004 r32
123k miles on it
UM NA tune
carbonio CAI
TT cams
Test pipe and neuspeed cat back exhaust
Golf IV / Jetta IV :: 5 Engine Fault Codes - Cam Position Sensor / Knock Sensor / Secondary Injection Pump And Mass Air Flow
I recently picked up a 2000 jetta vr6 for a very good price its a glx I have owned a vr6 before and done timing chains myself on it this one is a glx , I am having 5 fault engine codes on my vagcom they are cam position sensor , knock sensor, secondary injection pump, and mass air flow it ran fine 100 miles yesterday this morning the epc came on then went off and ran bad can these codes all be related or do I have to replace each sensor individually..
View 9 RepliesSonata I45 (LF 2015+) :: When Left Turn Signal Turned On / Right Signal Will Blink
We have a 2015 Sonata 2.4 Sport that has developed an intermittent turn signal problem. When the left turn signal is turned on, the right signal will blink. When the right signal is turned on, nothing blinks. A new symptom that recently started is sometimes neither turn signal will turn on regardless of the position of the turn signal stalk. I managed to get the car to dealer #1 while the LEFT=RIGHT & RIGHT=NOTHING issue was happening but while troubleshooting it, they ran across an inactivated aftermarket alarm system that dealer #2 that sold me the car had installed. I guess the alarm they install is so cheap, it's not even worth removing if they are unsuccessful in upselling you at the time of purchase.
Since dealer #1 would not troubleshoot any further unless the alarm was removed, I retrieved the car and took it back to the original dealer #2 I bought it from. They removed the alarm and the turn signals started working again, however, this lasted about 2 weeks before the symptoms returned. I booked an appointment at the dealer #1 to bring the car in & half way during the drive there, the turn signals started working again. With nothing to show them, I didn't drop off the car. Now the problem is back. Since it tends to come and go, I have try and time when I can drop the car off so it's happening when they get it.
Ford Wiring/Electrical :: 1972 F250 - Signal Stop Blinking When Put The Left Turn Signal On And Apply Brakes
I have a 72 F250. When I put the left turn signal on and apply the brakes, the signal stops blinking. I checked the bulb and it was fine. What is the likely cause?
View 2 RepliesGolf V R32 :: Intermittent Signal Errors
Mine Door controller started out minor - randomly it would try to roll up the window multiple times when it was already closed, and I'd get "intermittent signal" errors from vagcom. I told the dealer about this, and they didn't want to fix it, and they tried to blame my C2 ECU flash for the door controller problem, possibly because there wasn't anything obvious wrong with it other than the VCDS errors.
Now it has decided to wig out totally - when I open the driver's door, a good 50-70% of the time the car thinks the door isn't open. The MFD doesn't light up, dome light stays off, fuel pump doesn't prime. Open the passenger door and the MFD does display and dome light turns on, but the driver's door will still show "closed" even though it is standing wide open.
If I don't start the car quick enough and I have no passenger, it will re-lock (since it thinks nobody ever opened the door). Weirder still, if I pull the interior handle with the door open, it will usually light up the MFD and show the door open, but only briefly - when I let go of it the door shows closed again. However, sometimes after pulling it a few times it "fixes" and the MFD will show open correctly and the door is fine, for a while...
It has not yet gotten stuck in an "open" position, as that would mean I couldn't lock the car.
Golf IV R32 :: Only One Signal In Each Headlight Blinks?
I have a set of OEM HID's. I noticed that thesignal lights blinked in double time when I had them installed. Only one of the signals out of the two in each headlight blink however. A friend told me that the reason the HID's had 2 blinkers per headlight is because the HID's are so strong they require both signals to work to overcome the headlights. For those of you that have OEM HID's, do both your signals work? Being that mine don't, do you think that is the cause of my signals blinking in double time?
View 12 RepliesGolf/GTI VI :: Transmission Signal Came Up On Instrument Panel
I bought a dsg golf tdi 2011 last week. this week, while i was driving, after a sudden jerk, some kind of transmission problem signal came up on the instrument panel. since then, the car will not pick up the 1st gear after a complete stop (nor other gear). I would have to restart the car to get it going. When i got back i noticed that there is some kind of oily liquid dripping down under the car.
what kind of action should i take? I called the dealer and am towing the car to the shop tomorrow. They are saying they would fix it but i think i deserve a refund or replacement at least. Seeing it break down in a week makes the car untrustworthy. plus, it would devalue the car as well, right?
Golf V R32 :: Light Signal Turned On The Dash
So one of my headlights turned purple, and I get an "light" signal on the dash. It still lights up but it's purple. I have 23,000 miles on the car and I have had it for 1 year and 4 months. Also, should I get both light replaced.
View 8 RepliesGolf VI R :: How To Remove LED Taillight Turn Signal
Was wondering how to remove the turn signal bulbs in the OEM LED taillights.. Ordered Some new bulbs and decided to see how hard it was to change out. Removed taillight and located socket the contained the bulb. Looks like it should twist to unlock but only turns a little. looks like it wants to turn counter clockwise.
View 2 RepliesGolf/GTI VII :: Right Front Turn Signal Is Inoperative
So I was doing the DRL - Dimming on indication mod with the VAGCOM. I used the following steps:
Go to [09] Central Electronics
Go to Security Access and enter 31347
Go to adaptation channels and set the following (they're quite far down the list):
"Leuchte2SL VLB10-Lichtfunktion G 2" to Blinken links active (besides Phasen)
"Leuchte2SL VLB10-Dimmwert GH 2" to 35
"Leuchte2SL VLB10-Dimming Direction GH 2" to minimize
"Leuchte3SL VRB21-Lichtfunktion G 3" to Blinken rechts aktiv (beide Phasen)
"Leuchte3SL VRB21-Dimmwert GH 3" to 35
"Leuchte3SL VRB21-Dimming Direction GH 3" to minimize
Now my right front turn signal is inop. Checked voltage and swapped bulbs left to right. the bulb is good. No sure what I did. Could I have disabled the blinker somehow? Where is the channel for the right front blinker?
Golf IV R32 :: Turn Signal Randomly Click
Just now toward the end of my drive to work the turn signal clicker was possessed and randomly clicks. Still clicks as normal when I turn on the signals.
View 21 RepliesGolf IV R32 :: Turn Signal Beep Keeps On Ticking
The other day this started and hasnt quit. I was driving to work and after i used my turn signal and everything worked correctly and as it shoud except for the noise. The turn signal noise keeps ticking, sometimes at a fast pase, after i make a turn and the signal turns off. And will continue to do so even though i havent even used my turn signals.
View 7 Replies