Golf IV / Jetta IV :: Lifter Ticking Noise Around 2500 - 3000 RPM
On my drive home today around 2500-3000 rpm I am getting real bad lifter ticking noise. When I let of the gas it stops but as soon as I get back on it it will start ticking again. I just bought oil for an oil change Mobile 1
0W-40 I'm pretty sure plus a mobile 1 filter. Will this stop the ticking noise or do I need to adjust my lifters?
Golf IV R32 :: Blinking Engine Check Light When Go Past 2500 - 3000 RPMs
I've been getting a blinking engine check light.. I pulled all the codes:
P0050: H02S Bank 2 Sen 1 Heater Circuit
P0155: O2 Sensor Heater Circuit Malfunction Bank 2 Sen 1
P0304: cylinder 4 Misfire detected
P0688: ECM/PCM Power relay sensor circuit
I've had the car sitting for awhile because I lost my job and didn't have any money to roll it around much.
I just changed out the spark plugs and two of these had a white coating on them.. I was hoping this would take care of the misfire after I replaced them. I also bought a new battery because mine had lost charge a few times.
The Car will run with an engine check light, but if I go past 2500-3000 rpms then it will start blinking (which means don't drive it )
The oil has been sitting in it for about 2 months, so I'm about to go change that and I'm hoping this will allow me to drive it without issues.
Any of these codes thrown and know what they could be? Which O2 sensor (like a link to a website that sells them). Trying to get this thing running again.
C/K :: 1999 Chevy 5.7 MT 2500 - Engine Cuts Out While Driving At 3000 RPM
MT 2500 Where are you I've got a weird one. 99 Chevy 5.7 dully dump truck. The engine cuts out while driving at 3000rpms only. If you keep your foot in it it goes away at 3200. Does it in any gear(auto). Also, stopped and in park, it will do it at 4000rpms. Acts like a rev limiter. Fuel pressure does not change (60-62psi) when this happens, does it in open or closed loop. I disconnected the maf and no change. I've installed new cap, rotor, plugs, wires, coil, module(all original with 165K), no change. Runs sensational until 3K rpms.
View 14 RepliesSonata I45 (YF - 2011+) :: Buzzing / Chattering Sound When Engine Revs To About 2500 - 3000 RPM
When the engine is in gears say 1-3 (doesn't seem to work in neutral or park) when the engine rev's to about 2500 - 3000 RPM there's a metallic vibrating noise that almost sounds like a buzzing/chattering sound. When you reach over 3000, it goes away.
Here's the curve ball - it stops doing this when the engine is really warm. It only seems to do it when cold or it's been sitting a while. So - it's limited to an RPM range between gears 1-3, it goes away when it's warm.
I am inclined to think this is related to engine mounts... And here's why. It seems to only happen when in gear and we know that the engine changes it's pitch/stance when in different gears versus in neutral/park. So I think when it's in gears 1-3, the engine is tilted a bit and something is coming into contact with something (maybe my strut bar) more than it used to due to more slop/movement from my worn out engine mounts. As to why it goes away when the engine is really hot (driven for an hour or so) is because maybe whatever it is that's coming into contact with something else is (perhaps a hose and its clamp?) is much more pliable while warm and clears whatever obstruction it was hitting while cold? (a lot of speculation and creative thinking here).
Anyway - after the engine is super warm and I've been driving it I cannot for the life of me get it to do it... It rev's super smooth and not a hint of any bad sound.... 2011 2.0T Limited ....
Elantra MD (2010-15) :: Engine Vibration And Noise When Accelerating At Around 2500 - 3000 RPMs
I recently purchased a 2013 elantra.
I have noticed that there is engine vibration and noise felt in car and pedal when accelerating at around 2500-3000 rpm's before it shifts. Is this normal behavior? It just does not seem as smooth as it should be. I have only put about 600 miles on the car.
It has been very cold, but it does not go away after warming up.
Golf IV / Jetta IV :: Vibration At 2000 - 2500 Rpm From Inside / Under Engine Bay
I am hearing a vibrating sound only between 2000 - 2500 rpm while accelerating from inside/under engine bay. No impact on ride quality and no engine harshness is felt. Only it sounds like some metal sheet is vibrating for a while. After crossing 2500 rpm it simply disappears.
Checked inside the engine compartment by revving the engine while stationery and I don't get that sound. What could it be? Some shield of the exhaust? cat?
Golf/GTI VII :: Light Rattle When Decelerating Between 2000 - 2500 Or So
Light rattle/vibration. Probably won't be able to get a video for a while but it seems to only happen when in gear and decelerating between roughly 2-2.5k. Maybe I'll just take to dealer.
View 17 RepliesGolf V R32 :: Loud Flutter / Rattle When Change Gear Above 2500 RPM
Whenever i start my car and begin to drive, i get a loud flutter/Rattle when i change gear above 2500 rpm. It occurs when i give it about 50% or more throttle. is this normal? or does it have anything to do with cold start? I have a tampa mod resonator on the car.
I have a video to show sort of what it sounds like, but this is with giving it about 30% throttle, not 50%. it gets much louder, and sounds a lot worse when i give it more gas. Listen at 1:07.
GTI 337/20th Anniversary :: Losing Boost - RPM Drops From 3000 To 2500
Don't know if I'm experiencing the dreaded limp mode or not. It seems that SOMETIMES while just digging thru the gears 1-2-3, not hard, when I get to 3000 rpms it's like I'm taking my foot off the gas. Rpm drops from 3000 to 2500. It's like I'm losing boost or something. I have no mods and obviously, no boost gauge.
View 7 RepliesFord Ranger / B-Series :: Extremely High Idle At 2500 To 3000 RPM
Ranger often wants to idle at 2,500 to 3,000 rpm. I'm glad its got a clutch! This is a long term intermittent problem that is getting worse. I have replaced the the IAC twice. I have unplugged the IAC when the engine is in high idle and the engine idles normally. But, starting the car with the IAC unplugged makes car run rough. That makes me think the IAC is not getting the right voltage input from the pmc (eec). Mine is a 2002 with the 3.0 engine. Throttle plate seems to be closed.
What sense inputs does PMC use to determine idle air position? Also replaced TPS sometime ago but that didn't work either. Sometimes turning off the a/c will knock the idle back to normal but not always. Turning the car off completely usually resets idle. But the high idle comes right back after accelerating. Drove the car today and idle would stick and stay high when clutch pushed in coming to a light. However. as the car slowed to a stop the idle would come down when rolling 1-2 mph. ??
Golf IV / Jetta IV :: Crank / Rattle Noise When Accelerating After Engine Warms Up
It happens mostly after the engine warms up. When I accelerate, I hear a weird cranking noise coming from under the hood (sometimes it doesn't happen). I popped the hood to see if there was anything wrong, but i didn't find anything major (there were 3 loose screws that I tightened because I thought they were causing the vibration but the noise persisted).
I doesn't make the sound when I rev the engine, only when I am was driving. It happens roughly between 1500 and 3000 RPM. I read some of the archives to get a few ideas, but the noises people are describing are not like the one I am hearing from my car. The closest thing I found this: [URL] ....
I made a video. You'll hear the noise the loudest when I first start pressing the gas, from a complete stop: [URL] ...
Golf IV / Jetta IV :: Rattle Coming From Back Of Engine Near Intake Manifold When Rev A Little
I have a 01 vr6 mk4 gti. When I bought the car I noticed a rattle but never paid mind to it. But now I just want it fixed. I hear the rattle come from the back of the engine near the intake manifold when I rev it a little. The most rpms the louder the rattle . I been doing some research and came to a conclusion that it could be the shift rod and bad intake bushing. But, I'll like a link on how to replace the shift rod.
View 5 RepliesFord Ranger / B-Series :: Hissing Noises And Idle Fluctuate Between 2500 And 3000 RPMs
Truck: Ranger
Year: 1990
Engine: 2.3 Lima
Trans: 5 Speed Manual
Miles: 83,445
Recently Replaced:Oil Pressure Switch
Oil Pan Gasket
Crank Position Sensor
Spark Plugs
Plug Wireset
Ignition Control Module
Driver Side Coilpack
After I got done with all of this crap on my Ranger, I noticed that it was driving great! But...today I was on my way to school and BAM! My engine idle started hitting (presumably because I do not have a tachometer) about 3000RPM and lowering down to about 2500RPM and from there, every time I am not in gear it decided to fluctuate between 2500RPM and 3000RPM. Crazy style too.
Now, I got to school, and getting closer to it at a stop light the truck basically died. It was almost at 100'ish RPM. I gave it gas, and BAM. I hear a continuous hissing noise from under my hood. Haven't diagnosed it fully yet because I just got home and its 12AM.
Now, every time I stop at a light or in traffic or whatever it may be, I have to give it gas every other second, like a small push on the pedal, to make sure the truck doesn't die. Also, every time I am out of gear and my RPM's are at an 'idle' state, I get continuous hissing from somewhere, I get no power loss or anything, just really weird idle RPM's and hissing when my foot is not on the gas basically. It is strange. I think It is some sort of Vacuum leak but I am not sure.
To get a better picture of the 'hissing' noise, it is the same hissing as you would hear when letting the air out of a tire. That is the best way I could describe it.
Golf IV / Jetta IV :: 1.8T - Hesitation Between 2000 To 3000 Rpm When Motor Is Lugged
I just purchased a 2001 Jetta Wolfsburg with the 1.8T, 5 speed, and 169,000 miles. I need to figure out the engine hiccups. The check engine light is on. The car seems to hesitate between 2000-3000 rpm when the motor is lugged (pulling a hill, passing, etc).
I had the codes pulled at Autozone and came up with the following.
P0172 (Bank 1 System Too Rich)
P0300 (Random Multiple Misfire)
P0302 (Cylinder 2 Misfire)
P0420 (Catalyst System Below)
P0455 (Evaporator Emission)
P0411 (Secondary Air Injector Incorrect)
Golf IV / Jetta IV :: On Acceleration RPM Drops From 5000 To 3000 Without Letting Off The Gas?
My GTI has started to bog out, i guess is the best way to describe... As I am trying to accelerate on the highway my RPMs rev up to 5000 till I get any response to amount of gas I am giving. It will dramatically drop to 3000 without letting off the gas. then gradually will accelerate, untypical to way it use to perform. She respond this way cold or hot.
View 7 RepliesGolf IV / Jetta IV :: 2001 - No Power And Won't Go Past 3000 RPM At 20% Throttle
I made an earlier thread about minor low speed crash and airbag deployment that has sense been fixed.
The engine 2.0 (AZG) will rev to 3000 (3200 sometimes) RPM and stop. This is only if you give it about 20% / 25% throttle. If you give it full throttle it spits and sputters. When I had the airbags installed. The codes were read it and also came up for cam sensor and o2 changed that and now the codes are gone. No CEL and it is exact same issues still. I can't tell if ECU is doing it but it feels like it's not getting enough gas or air since full pedal makes it stall.
Golf IV / Jetta IV :: Motor Ticking Around 2500 - 3500 Rpm
My 1.8t motor is still ticking around 2500-3500rpm. I have changed the oil with 5w-40 mobil1 no even 75 miles on oil change, Brand new oil pump with tensioner and chain. oil pick up tube cleaned and good. new plugs about 75 miles on them as well. Always ran 93 octane (highest I can get at my gas station) Only thing left that I can think of is my cam tensioner is bad.
When I accelerate up to speed it starts ticking but as soon as I let off the throttle it will stop get back on the gas it starts again.
Stockish 2000 gti 1.8t 5 speed. short ram intake.
Is there a way to tell if the cam tensioner is bad? .
Golf IV / Jetta IV :: Stalling In High Gears But It First Start Doing This When Hit Boost (3000 RPMs)
I have a golf mk4 1.8T AGU, about one week after i had my k04-023 turbo on and all the Stuff that comes along it started "stall" (don't know if its the right word??) in the High gears, most 5th gear but it first start doing it when i hit boost (3000rpm)
I runs on Stock n75 valve.. I though i could be a boost problem, maybe the Stock system cant handle it? I did install a boost gauge to see if it was the was the problem, and it dont Seem like it. In first it runs from 1.4 bar and drops to 1.2. Same in second and third. But in 4 and 5th it goes to 1.7 bar and drops to 1.4.. I did wonder it maybe the n75 valve cant handle 1.7 bar??
Golf/GTI VI :: Engine Won't Rev More Than 3000 RPM When Car Is Parked And Out Of Gear
When the car is parked and out of gear, it won't rev more than maybe 3000 rpm. Is this a safety feature? I was trying to hear the exhaust.
View 8 Replies