Volvo - V70 :: Reverse Gear Non Functional Suddenly
Having my beloved v70 XC SE towed to mechanic today. Suddenly reverse gear was non functioning. No choice. Assume it's time for gear box replacement (whatever that is). Only 133K miles on the vehicle and I LOVE this car. Is it worth the cost to fix transmission or should I just donate or try to sell the vehicle?
View 2 RepliesGolf IV / Jetta IV :: 2002 - Won't Shift After Coolant Pipe Replacement - Got Codes 00281 / 00652?
I have a '02 Jetta Wagon with 180k miles. The plastic coolant pipe on the side of the head had been weeping (as they do) and I decided to replace it last night. The pipe replacement went smoothly and uneventful. When I removed the pipe as usual a normal amount of coolant spilled from the head down onto the trans area. After the replacement, I hosed down the top of the tranny with the garden house. I then took the car out for a drive.
First thing I noticed that my CEL was off (it had been on for a small emissions leak) and that seemed odd. Then about quarter mile down the road I noticed she was not shifting. It would hit maybe 30 at 3000 rpm and just stay there. So I pulled over and turned her off and looked under the hood...all seemed well. Started it back up and the CEL comes on right away. I drive and still stuck in gear.
I get home and run a cheap CEL check and get 00281 and 00652. Which seems to be fault codes for the VSS G68 sensor. So I check my connectors, take apart and make sure they are clean and dry...all seems good. I clear the codes and start it up and codes are right back again and stuck in gear.
It is late so lat thing I do is check the resistance of the G68 and get pins 1-2 800ohm, pins 1-3 800ohm, pins 2-3 1600ohm. I also check pins on G38 and get 1000ohm there.
Golf IV / Jetta IV :: Tranny Replaced, Can't Reverse
This weekend I replaced the transmission in my 2000 12v vr6 5 speed golf. Got In drive around block going through each gear all seemed fine. Then I tried reverse and couldnt find it. Seem like it reverse was more like 5th cause car would try and move forward. I have the new style shifter and the bearing is quite a bit beat up. However if I in engine bay operating the gears directly on shift paddle I still can't seem to find reverse. Is there some kind of lock out or what could I be missing. I tried adjusting the cables but that seemed to make things worse not better.
View 5 RepliesGolf IV / Jetta IV :: 2001 - No Start After G68 Sensor Replaced?
Monday get CEL with codes p0722 and p0322. Car is in limp mode during these codes. Yesterday I change g68 sensor. Cleared codes, rough start but was sitting most of the week. Drove around fine, no limp mode, shifted fine. Started up a few times immediately after. Hours go by I go to leave and it won't turn over though it sounds its wants to. No clue why this is happening or what changing the sensor could have done. This is a 01 GLS 2.0 auto. Not sure where to from here especially since it drove so well afterwards.
View 4 RepliesGolf IV / Jetta IV :: Replaced Knock Sensor Still Sputtering And CEL On?
I replaced the knock sensor because I was getting the p0327 for the front knock sensor. Drove it again and still sputtering and CEL came back. What are other causes of this? N75 solenoid? Low fuel pressure?? It has a spectre air filter kit on it. Didn't know if this would do it. I cleaned maf. Just put new plugs in it too.
View 5 RepliesGolf IV / Jetta IV :: O2 Fault Codes Came Back After Sensor Replaced
Keep getting o2 fault codes. Replaced sensors came back. tried another set of sensors came back. Checked wiring for breaks no luck. Replaced ecu still no luck. So going through wiring again and checking for continuity. Looking for a list of what pins to check for voltages, and what each should be from ecu to sensor connectors. Looking for what wire is signal and how to and what voltages to check for...
View 5 RepliesGolf IV / Jetta IV :: Replaced Primary O2 Sensor - Where To Put Excess Wiring
Had to replace my primary O2 sensor recently. I got the sensor straight from VW and it comes with all sorts of clips and whatnot. Looking for a picture of how the wiring is supposed to be routed and what I'm supposed to do with all of the plastic clip pieces?
View 2 RepliesGolf IV / Jetta IV :: Won't Go Into Any Gear With Car Off Or On Except Reverse?
Have a 20th with the 02m six speed ... Car won't go into any gear, except reverse ... Tried with the car off or on, clutch in and out with no luck ...
I took off the linkage from the engine bay and can only manually get the car to go into reverse ... Feels like it can't change "levels" ... Don't think it's clutch since because the car won't engage a gear even with the car off ...
Tried searching and no luck ... Thinking shift forks but hoping not since don't want to drop the transmission and it could be something else ...
Golf IV / Jetta IV :: No Second Gear Not Reverse
I'm just having a mis-alignment for my gearing reverse is replaced as first and I have no second gear not reverse only 1-3-4-5 gears are being entered what can I do to fix this...
View 2 RepliesGolf IV / Jetta IV :: 2001 GTI VR6 Won't Go Into 1st / 3rd Or Reverse Gear?
So I just replaced my clutch. I have a 2001 Gti vr6. It has roughly 120,000 miles and the clutch went out. I ordered a stage 1 clutch and put it in. Everything went smoothly and now I am stumped as to why I can't shift into first, third, and reverse? Second, Fourth, Fifth all work. Why this happened?
View 8 RepliesGolf IV / Jetta IV :: 2002 VW GL - Hard To Go Into 1st Gear And Reverse
Drove my 02 VW golf GL to the airport, it sat there for 4 days, drove it back home. Next day I noticed that my 1st gear and reverse are very hard to get into. So I kept messing around with it and noticed that if I tried to put it slowly into first gear that there was no way in hell it would go, it felt like the gear was closed.
But if I put it into second gear and push it from second gear into first gear it goes back into first gear about 70% of the time. And it will also go into first gear if I push my stick down as if I'm attempting to go into reverse, and slowly move it into 1st gear.
The reverse is also very hard to get into it feels just like the 1st gear does when you try to do it slowly, it's like it's closed off/blocked. Latest work that was done to the car, replaced the clutch about 4-5 months ago.
Golf IV / Jetta IV :: 1998 - Vibrates On Reverse Gear?
Automatic 1998 Golf 4 1.8L 20V shakes so badly to a point where the engine stops totally when I put it on reverse,and on drive sometimes. What might be causing this.. I recently replaced the gearbox oil with a new one..the car was fine before this change of gear box oil
View 1 RepliesGolf IV / Jetta IV :: CEL Code For Bad Coolant Temp Sensor?
So my check engine light came on in my 04 jetta sw, and when I had the car read, it gave me a code that tracked down to be a bad coolant temp sensor. I bought the replacement part from my local VW dealership, installed it and the check engine light went away. Now about 2 weeks late it came back on, and I am getting a reading of "Coolant temp sensor high voltage". So it goes from needing replaced, then the replacement is running high voltage?
View 3 RepliesGolf IV / Jetta IV :: 2002 GLX V6 Misfiring When Cold - CEL With Cam Sensor Code
I just got this car it a 2002 jetta glx vr6 12v 5 spleed. It has a miss new plugs wires gas and used coil pack. It misses especially when cold check engine light on says cam sensor changed it and still same thing if I clear the code it comes right back.
View 1 RepliesGolf IV / Jetta IV :: Code P1340 - Cam / Crankshaft Sensor Out Of Sequence
So I started up my 12v VR6 the other morning and it sounded like a Subie. Threw the awful code P1340: cam/crankshaft sensor out of sequence, and took it to the shop. I'm being charged $1900 for servicing the timing chains, only. Doesn't include water pump and clutch like every other shop does. Reason for this is because in Montana, no one works on these cars. So I this is my only route. I had to choose this small euro repair shop or the VW dealer.
But, they just recently called me and told me I need to get the timing gears changed or whatever? They want to charge an additional $600 or so to do that. Are these gears a real problem? or are they just trying to F me. I mean, $1900 should make this car flawless as it is so I feel that they are attempting to rip me off even more.
Golf IV / Jetta IV :: MAF Sensor Fault Code - No Crank Or Start
I bought an 05 golf GL with a 2.0 and 5 speed in January for commuting to work.
Well, recently. I was on my way home from work, I'm an engine tech for Cummins Inc, and I notice my CEL came on and the car stalled multiple times at red lights. So I limped it home, connected my scanner and the fault was "Implausible signal from Mass Air Flow sensor". I cleared the fault code and tried to start the car. Nothing, no crank no start. Just an audible click from under the hood.
I disconnected the battery for 5 min reconnected it and it started fine. Drove it to work the next day, no issues. I tried to start it again and nothing, CEL was on again for the MAF sensor. I pop started it, car ran like hell, rough idle, low power, etc. luckily I have a dualy that I can drive in the mean time.
Golf IV / Jetta IV :: Noisy Manual Trans In Reverse / Whining In 1st And 2nd Gear
I have an 04 Jetta 1.8T that I recently acquired and have a problem with a noisy manual tranny. Reverse is a bit noisy (more than usual) and when I get on it in 1st and 2nd gear it sounds like an awful whining noise. I have been told it could be either a bad throw out bearing or input bearing? BTW this thing shift perfect, like butter, no grinding at all.
View 4 RepliesGolf IV / Jetta IV :: CEL On With Camshaft Position Sensor Code And Misfire On Cylinder 3
She is a 1999.5 Golf 2.0 (although, she just has a rabbit symbol on the hatch, is she a Rabbit or did someone remove the Golf badge?) I just bought the car, with less than 160,000 miles. The dome lights work sometimes, Door Ding works intermittently as well, but sometimes will "glitch" in other words it will be making the sound but it kind of stutters? Odd? The horn sometimes works, however it is very silent? Check engine light is on with a camshaft position sensor code and miss on cylinder 3. Someone told me to replace the "109 relay"... could this be the problem or is this the CCM?
View 5 RepliesGolf IV / Jetta IV :: Error Code P0113 - Intake Air Temp Sensor
My 2003 Mk 4 Golf have had a lot of error codes and I have cleared most (O2 sensors, thermostat, and Mass Air Sensor) I now have an error P0113 which is the Intake Air temp Sensor.
So I need to clean the sensor first then maybe replace it, but I can't find the sensor on the intake manifold.
I have looked all through the U-Tube info, but nothing matches my 2003 Golf 2.0L ...