Golf IV / Jetta IV :: Shifter Got Stuck And Won't Budge Out Of 5th Gear?
I'm having an issue with my clutch and I'm really in a hole. Two days ago I was driving my car and everything was fine. Later in the day the shifter got stuck and would not budge out of 5th gear. Eventually it popped out. Driving like normal again and then yesterday I was on my way home from work and all hell broke loose. I was a mile away from my house and the car would not shift into any gear without a fight.
I also at this time lost my clutch pedal. It went really soft but did come back up.. it would not engage however. Limped it the rest of the way home and took a look at it. What I came across was a full brake/clutch reservoir, no leaks around the slave, and I didn't see any leaks around the master. I will say that after the car sat for about 10 mins the pedal felt normal again but quickly went soft after a few pumps.
2.0 AEG 5spd. Trans code DZQ if any of that would be relevant..
Golf IV / Jetta IV :: Clutch Pedal Stuck To Floor With Fluid Underneath Car
I have a 2003 Jetta GLI. Thus morning driving into work my clutch pedal stuck to the floor. I was able to pull it back it and make it to work, but when i got to work i noticed fluid dripping from underneath my car.
View 4 RepliesGolf IV / Jetta IV :: 2004 - Have To Hold The Shifter Until Clutch Is Engaged For 3rd Gear Position
I picked up a 2004 GTI not long ago for pretty cheap because it had a few issues. I am working my way through them. However, having 3rd gear issue.
All other gears are perfectly fine but there is way less play in the shifter in the 3rd gear position and I have to hold the shifter in position until the clutch is engaged (pedal up) to avoid the gear grinding. Once the clutch is engaged it stays in 3rd gear fine. It doesn't matter if I am moving from 2nd to 3rd or 4th to 3rd. Same deal. I have aligned the shifter several times using to proper procedures with no effect.
It never grinds 3rd with the clutch disengaged (so the synchro is fine?) and it will bang shift no problem. Oh and the clutch is less than a year old. It was installed by a shop before I bought the car. It's not really a big deal, but I would like to fix it. If I have to swap the trans that's fine, but need to figure out if it is a trans or linkage issue first.
Golf/GTI VII :: Squeak Like Noise When Clutch Engages In 2nd And 3rd Gear
Currently driving a GTI mk7 autobahn 6MT, this is my first manual transmission i have owned.. and have a question about a squeak like noise i hear when the clutch engages in gear 2 and 3.
This does not happen all the time, however i noticed that some / most of the time when i slowly let the clutch out in gear 2 and 3, right after the clutch engages and i let it out the rest of the way, it makes a squeak kinda sound.. almost like springs contract / retracting, i can also slightly feel it in the pedal.
Question is ...is this some what normal? i have never owned a MT car, and cant remember if such a thing happened while driving friends / family MT in the past..
Subaru - Forester :: Clutch Gets Spongy And Starts To Catch Lower And Lower To The Floor
1998 Subaru Forester with a weird clutch problem. Clutch works fine in cold weather, but for the last 3 summers when driving in city traffic, the clutch gets spongy and starts to catch lower and lower to the floor. Car has about 125,000mi bought it 2 years ago and don't know when or if the clutch was ever replaced.
View 4 RepliesGolf VI R :: Clutch Pedal Stuck To The Floor On Several Occasions
So over the weekend my clutch pedal stuck to the floor 2 times and would not come all the way up on several occasions. It has since then stopped doing it. I am wondering if I should bleed my clutch or not. Flush and change fluid?
Just concerned it may turn worse.
Ford Transmission :: 1996 F150 - Pedal Goes Almost To The Floor Before Clutch Engages
1996, f150, 300, 4x4, 5 speed, 296,000 miles... My pedal goes almost to the floor before the clutch engages and about a half inch, maby less, of travel back out the clutch disengages. I think it is about time for a new clutch. My question is what is the best clutch to put in my truck?
while i have the transmission slid back to replace the clutch i am planning on replacing the slave cylinder while im in there as well. Any particular brand better than the next on that item? Are there any other items that I should think about replacing while i have the transmission slid back to do the clutch?
Golf IV / Jetta IV :: 02 - Clutch Went Out / Shifter Knob Is Super Sloppy
I have my GTi, a week ago I broke an axle. I was then convinced by friends the clutch went out. So I said screw it and bought a Southbend Stage 2 Daily. When I get it I go to install it, then find out I have a Broken half shaft. So after taking the tranny out to install the clutch anyways and everything goes alright for the most part. (250k miles so that's why I never returned new clutch)
SO I get everything together. Tires spins. Car goes all is good.
Clutch is super spongy as I need to bleed it. But my problem is the shifter knob is super sloppy. Feels like is a whole section lower. It's hard to engage second as I have to double tap it in with a good throw. Everything is right on the shift tower. And seems like it clicks right into all the gears. But the physical knob feels super sloppy and out of place. First, third and 5th are all super far up and seems like it double clicks after putting it into gear. Like if there was a gear above. Kinda weird to explain. I've done the home alignment on the tower and nob, but only have a bolt that was 4.71 mm. So the cables should be really close to being aligned right. But I can't grab second at high Rpms.
I also need to do my drain and fill. So would it be a drain and fill and clutch bleeding will fix my sloppy shifter? Before I did everything it was tight. Felt right.
Golf IV / Jetta IV :: Car Stuck In Park / Couldn't Move The Shifter
2000 VR6 automatic. Yesterday my car was stuck in park couldn't move the shifter . Figured it was the brake sensor switch when the brake is engaged food pedal lights do not go out, I replaced it this morning but still won't work I've been driving it around in limp mode?
View 4 RepliesGolf IV R32 :: Clutch Pedal Went To The Floor When Get It Into Gear
So my clutch has been acting up lately. When it sits for a few hours the clutch engagement point seemed to creep down but over the course of 35 minutes of driving would work its way back up again. Today it was unusually low and wouldn't let me get it into gear. I tried pumping it a few times and realized it wasn't coming back up all the way, I pulled it up and then tried again and it just dropped right to the floor where it now sits. Fortunately I was at work and can hang here until my ride arrives, and will just wait until late tomorrow night to drive it to my shop without stopping...
My guess is I need a new clutch master cylinder. I have plenty of fluid in there although its a bit old so I'll be changing that when I change the cylinder. Could it be the slave cylinder? If so is it a bear to change that? (do I need to drop the trans?)
Golf IV / Jetta IV :: 2001 VR6 Clutch Petal Just Goes To The Floor
I have a 2001 jetta with a Vr6 the clutch petal just goes to the floor. No return. What's could be wrong?
View 2 RepliesGolf IV / Jetta IV :: Shifter Would Not Go Into Any Gear
The issue with the car is that the tranny won't go into any gear. With clutch in or out. I had very little play left or right or up and down. Not sure what could be wrong. The car has 120k miles and no mods.
View 2 RepliesGolf IV / Jetta IV :: 2003 - Clutch Pedal Sticks To The Floor
2003 Jetta, 1.8T, 5spd, stock, 129k miles. I am working on a friends car and his complaint is the clutch pedal occasionally sticks to the floor and during this sequence it is hard to shift gears. I removed knee bolsters to inspect under the dash and found all linkage straight, all plastic parts/springs in place and no fluid leaks, I removed slave cylinder from bell housing and found smooth operation and no leaks. I guess I could replace both but I am wondering if there is a common issue. My searches have found broken plastic parts, bent push rods and leaking cylinders.
View 4 RepliesGolf IV / Jetta IV :: 2010 - Key Stuck In Ignition - Shifts Out Of Park Without Pressing Shifter Button?
So I have a 2010 jetta 2.5 and my key is stuck in the ignition has been for a couple weeks also don't know if it's related but when I start the car I can pull the shifter out of park without pressing shifter button just have to press brake and after I shut the car off if I take it out of park and put it in gear it just freely rolls only stops if it's in park. NOT A DSG
View 3 RepliesGolf IV / Jetta IV :: Wobbling Of Shifter While In Gear
I have the 20th anniversary GTI with the 6-speed manual at 90k miles
I have the Dieselgeek Short shifter installed so for the most part my shifter is nice and tight/precise. However, I have some play in the shifter while it is in gear and I understand that this is normal for a car as it ages. But I assumed that the Dieselgeek would've solved all the gear slop in my shifter, and I was wrong.
So is there a part I can replace to tighten it back up?
Golf IV / Jetta IV :: Hard To Get Shifter Into Gear
When the car is in gear it's great! Or at least it seems great. However, trying to place the Shift Lever in the car into the gear "slots?" is troublesome.
It feels as though there is a wall in the way for each gear, and i have to force my way through the wall. It's not absolutely Terrible, for i've been driving like this for months. But i want a smother shift! I want to be able to just slide the Shift Lever into gear without any hangups or major resistance.
Double Clutching seems to work, however it might just be from the small loss of RPMs through the process of double clutching.
Personally I would rather not have to double clutch just to see a slight improvement. I have big feet and they constantly are rubbing on the floor mat as well as the plastic above the pedals, so double clutching always feels like i'm wedging my foot into a hole, then back out and in, before i can go into another gear lol.
The problem is only a real issue when i'm in higher RPMs giving the car more gas. I.E. after a fast launch in first, shifting even around 5500 puts a WALL up on second gear making it impossible for me to get it into second gear, after not getting it into second i usually throw it in third, and essentially lose all the acceleration i had from the first gear launch.
As well is there anyway to make the clutch a little stiffer? She grabs fine, i just like stiffer clutch, it requires less of me trying to wedge my huge foot on the pedal.
It's an un-molested MKIV Jetta VR6 with 167k.
Golf IV / Jetta IV :: Shifter Pops Out Of 3rd Gear When Let Off The Gas
My problem is that it pops out of 3rd gear when I let off the gas. I have had this problem before so any tips on setting my shifter linkage?
View 5 RepliesGolf IV / Jetta IV :: 2003 - Clutch Pedal Went Straight To The Floor With No Resistance?
So last evening, I went to start my car and the clutch pedal went straight to the floor with no resistance. Car started and was extremely hard to get into every gear. Felt like the only thing pushing the clutch pedal back up was the spring underneath the pedal itself. Clutch pedal was 100% just the day before. Got the clutch line bled (vacuum bleeder) and it worked fine again.
Any clue as to what could caused this overnight?
Its a AWP 1.8t jetta with ASR.. I believe I came across something about a revision in the hydraulic line but I'm not sure.
Golf IV / Jetta IV :: 03 - Shifter Stopped Engaging 1st Or 2nd Gear
My03 GLI will not engage first or second gear.
This morning, i was having some issues getting the car in reverse, but it eventually engaged and is fine now. I drove to the barbershop, and on the way home, the shifter stopped engaging 1st or 2nd gear. it moves freely into position (TOO FREELY) and all other gears will engage. common sense tells me that the clutch is fine and the problem is with the shifter.