GTI 337/20th Anniversary :: 2002 - Check Engine Light Came On / Failed Clutch Vacuum Vent Valve Switch
I have an 2002 Volkswagen GTi 337 edition with the 1.8t engine in it. My check engine light came on so I went to my local autozone to check the code and that's what code it threw on the ODBII sensor. It says my problem could be a "failed clutch vacuum vent valve switch". It also revs about 100-200 rpms extra in between shifts and I'm not a mechanic but know a little about cars. I just don't know if I should replace the OEM clutch safety switch or what I should do about this.
View 19 RepliesGTI 337/20th Anniversary :: Clutch Pedal Would Stick At 3/4 Of The Way Up
I recently got the GTI 1.8L 337 with 64,000 on it. It had been sitting, with daily start-ups, for about 8 months until the ALT was replaced. I've been driving it for a month with no problems until last week. At first I noticed the clutch pedal would pause on the way up for a split second then tap the bottom of my shoe. I thought maybe it needed adjustment but nothing serious. A few days ago the pedal would stick at 3/4 of the way up, and stay there most of the time unless I raised it with my foot, till the car warmed up a bit. Yesterday and today the pedal started to stick 1/4 of the way up, unless raised with my foot, at the morning start-up and will only come up 3/4 when warm. It also wont go into reverse at initial start-up until it gets really warmed up, shifting into other gears is fine. I've had no problems or real sounds shifting into any other gears, though out of 1st has been a little jumpy.
View 3 RepliesGTI 337/20th Anniversary :: Clutch Won't Return - Could Not Put It Into Gear
Today I went to start my car and let it warm up and everything worked fine and it started regularly but when I went to go drive the car and put the clutch in the pedal didn't return and I could not put it into gear, need to identify the problem.
View 4 RepliesGTI 337/20th Anniversary :: 2004 - Clutch Won't Go Into Any Gear
My wife was driving home and was exiting the freeway, downshifted and then no response from the clutch or gearbox. It would move left to right but not go into any gear with the car on. No real pressure in the clutch pedal either. With the car off you are able to find all the gears but when you start the car in gear with the clutch down it just jumps forward and dies. No smoke or burning smells either way and the pedal does come up by itself. Pushed the car into the driveway and its goin to the shop tomorrow morning.
With the search button so far: master/ slave cylinder, full clutch problem, air in brake/clutch lines, shifter linkage bracket
I don't think it's the slave cylinder as the pedal is NOT stuck to the floor, but I am not handy with cars, only motorcycles. First thing I checked was the linkage bracket, which seemed to be fine and as I stated, I was able to get in gear while car was off. Brake fluid was almost full but i know that doesnt rule out air in the lines.
GTI 337/20th Anniversary :: Clutch Pedal Went Soft?
We were headed home the clutch pedal went soft... Ok, I thought it's either the clutch master or slave. I get it home and replace the master and after bleeding I had good pedal feel.
Great I thought, I got lucky and it was only the master. Drive it around for a bit and get on the highway and just as I was about to downshift the pedal went flat to the floor again.
Well after pumping the pedal until it had good feel again I got it home and bleed it a couple more times just to make sure I got all the air out. Drove it again. Same thing, after a little while the pedal gets soft again.
Now before I go and replace the slave is it possible I have a faulty master? Having issues after replacing the master?
GTI 337/20th Anniversary :: Clutch Grinding When Go Into Second Gear
So I am pretty sure its my clutch that is the problem, here's what happens: When I go into second gear, it doesn't really grind.. but its tough to get it into gear and its only with second gear. sometimes it will go right in and others i have to double clutch. when i double clutch it goes in smooth every time. now I don't think it would be syncros because I am pretty sure if it was that it would do it every time I shift? It only does it while its cold or hasn't been drove in awhile.. but after i drive it around its fine so I am pretty sure its the clutch. Second thing, what is an upgraded clutch that is good for these 6 speed transmissions?
View 2 RepliesGTI 337/20th Anniversary :: Clutch Is Starting To Slip
Noticed recently that my clutch is starting to slip. It only seems to happen when I'm cruising in 6th and floor it. When the boost spikes, the revs will shoot up ~750 rpm and then settle back down before the car starts to pull. It is chipped Unitronic Stage 2 with some other bolt-ons.
What I'm wondering is, should I just drive it like this until it really starts to go, or should I replace it now? And what are my options for a new clutch? I don't want to big turbo this car, so the most it could get is a few more bolt-ons. I'd like a stock feeling clutch.
GTI 337/20th Anniversary :: No Clutch When Going To Put Car In Gear / Just Grinding
I just put a stage 1 clutch in my 20th anniversary. When i was taking the transmission out, i dropped the hydraulic clutch line and all of the fluid spilled out. I got the whole thing done, and bled the clutch line and topped off the reservoir. I started the car and the clutch pedal had, what felt like the right amount of pressure. More than the stock, but not significantly. When i went to put it in gear, its like there is no clutch, just grinding and it doesn't go in to anywhere. I can cycle through the gears with the car off and like i said, the clutch has the right pressure and everything.
View 10 RepliesGTI 337/20th Anniversary :: Clutch Pedal Trim Is Coming Off?
Noticed the other day my clutch pedal trim is coming off... What did you do to fix it?
View 8 RepliesGTI 337/20th Anniversary :: Accidently Went Past 3rd Gear, Clutch Went Out
I recently was driving home from a buddy's house, when at the light i go to put the car in 1st gear and it was way harder than normal. I kept driving just to try and get home but it was so bad that i never went past 3rd gear.. I'm pretty sure the clutch went out, since it was extremely hard to get the clutch to engage to get it from gear to gear, and i basically have to turn the car off to get it to stop so.....
I'm pretty new too the vw game, and don't know of any good companies as far as clutch kits. Im looking to buy somethings either oem like or a little better but with the same feel. also, just a Pressure plate and clutch. I doubt the flywheel is damaged.
GTI 337/20th Anniversary :: Clutch Pedal Is Soft At First And Then Gets Harder
I keep finding air every time i bleed my clutch. I am not losing fluid but i can not figure out whats causing my problems. The pedal is soft at first and then gets harder and it sometimes needs pumped before i change gears or to even get into gear. I am afraid its the slave but i also just may have air in the system.
View 8 RepliesGTI 337/20th Anniversary :: Clutch Disengagement - Cannot Go Into Gear While Driving
So after replacing my shift forks in my 20th, installing a new clutchmasters fx100 clutch kit with a LWFW I've become a victim of the typical clutch disengagement issue.
In a nut shell car doesn't go into gear while the car is running. System is fully bled with no leaks and a brand new slave installed supplied by CM.
My understanding is the early FML code o2ms in the 20ths can not make use of the NLS shim kit and a stainless line is not a 100% fix.
Who's solved their disengagement issues and how?
GTI 337/20th Anniversary :: Clutch Replaced - No Pressure In Pedal
I just replaced my clutch and have put everything back together, and bled my clutch line, but I have absolutely no pressure still in my pedal. I read that u need to make sure your brake fluid reservoir is filled to the max, but following the clutch line, I dont see it going to the reservoir? I also read that the master cylinder is behind the clutch pedal, does the master cylinder hold any fluid that maybe I lost during the bleeding? I'm at a loss right now.
View 12 RepliesGTI 337/20th Anniversary :: Clutch Went To The Floor And Stayed There When Stepped On It
Just got in my car and the clutch went to the floor and stayed there when I stepped on it. What are the steps to diagnose this problem? I'm assuming my slave cylinder went kaput!
View 11 RepliesGTI 337/20th Anniversary :: Clutch Stuck To The Floor On The Highway
50k Miles on my clutch. Was driving a couple weeks ago on the highway and clutch stuck to the floor. At first I thought it was my Slave cylinder. Got the trans out this weekend to find the mess (below) inside my bell housing. Obviously need a new clutch now and will still replace the slave while I am in there.
Cars setup is around 375ish whp. I know I could spend 1300 bucks and call it a day for a clutch master or south bend but was seeing if there is a cheaper alternative.
Also If I were to buy an OEM clutch or an upgraded one that was not rated for up to 400~whp would it drive and pull the same as a fully upgraded one just not last as long?
6 Speed ...
GTI 337/20th Anniversary :: Clutch Is Beginning To Slip In 6th Gear
So I was on the free way in 6th gear and decided to get on it, the rpm's shot up and I barely picked up speed. It's only a slight clutch slip tho only really noticeable in 6th gear so I was wondering what clutch I should go with because I was planning on going BT eventually.
View 3 RepliesGTI 337/20th Anniversary :: RPMs Fluttered - Clutch Slipping?
Yesterday I was driving my car on the highway, and stepped on it in, and the rpm's fluttered, felt like something was slipping. What this could be?? Could this be my clutch slipping?
View 7 RepliesGTI 337/20th Anniversary :: Clutch Pedal Stuck In Place - Could Not Put It In Gear
So last night I was driving home from work, and at a red light while i was waiting to go i had my clutch down when light turned green i tried to go and noticed i could not put it in gear and that my clutch pedal was stuck in place. i didn't know what to do so I checked my shifter plate everything looked fine so went to look at the pedal and i pulled it forward and it came lose. I started it up everything was fine and back to order. This morning going to work same thing happened again, I don't know what is going on and what could be the cause?
View 5 RepliesGTI 337/20th Anniversary :: Loud Clunking Noise When Release The Clutch
Car was great this weekend, then on saturday, every time I shift my car clunks right near the tranny when I release the clutch. Its a loud noise. Clutch was done around 2500 miles ago. South Bend stg 1 with a LWFW (I know, wish I stayed with a DM). And if I drive in first and second and come off the gas without shifting, it also knocks once really loud. It isn't a back fire or anything it almost feels like the dogbone mount is bad? Also, over 4000 rpm my car sounds deeper sounding than before.
View 7 Replies