Ford - Explorer :: 1999 XLT - Fog / Driving Lights Shut Off When Turn High Beams On
I have a '99 Explorer XLT and when I turn the high beams on, the fog/driving lights shut off. Is this normal? Is there a way I can keep the fogs on while the highs are on?
View 1 RepliesFord - Explorer :: 1997 - High Beams Don't Work - No Power On Wire At The Bulb Socket
I have a 1997 Explorer XLT. The high beam have not worked since I got it and now living in Virginia they are needed to pass inspection. When turned on (pushed forward) lights go out, high beam indicator comes on. When flash to pass (pulled back) lows stay on and indicator comes on. It does not have auto lamps.
What I have done:
Replaced MFS
Verified power from GRY/ORG wire on MFS when turning high beams on.
Verified power across fuse #33 when switch turned on.
Had bulbs tested, Good.
No power on high beam wire at the bulb socket.
The only thing I have not checked is what several people have referred to as a "splice" I think someone referred to it as S111? Where this is physically located or am I going to have to start the chore of tracing the wires?
Ford F-150 - 1997-2003 :: Low Beams Don't Work But High Beams Do
I recently installed new halo HID headlights in my 2003 f150 with HID bulbs and ballast the passenger side worked and the drivers side didn't nth lights wired exactly the same. I switched everything from the passenger to the drivers side still nothing I switched everything back to passenger side and they don't work now. I tired regular bulbs in the passenger side an it worked then on the drivers side and it worked for a split second and went out and then I retried t on the passenger side and it worked for a split second and went out a now neither are working. I checked all the fuses and their good. What the problem could be?
View 5 RepliesFord Super Duty (1999-2016) :: 2006 F250 - High Beams Will Not Shut Off
I have a 2006 F-250 Super Duty (6 liter diesel). The high beams stay on unless I pull the fuse (fuse 30). It doesn't matter what position the headlight switch is in. It is like the high beam flash on the multi-function switch is stuck. It feels fine, but high beams stay on regardless of position, even with the truck off. The low beams (if in low beam when the truck is shut off) do go out as do the running lights after 15 or so seconds (normal) it's just the high beams. Also the high beam indicator light is on all the time (until I pull the fuse) and the fog lights will not come on until I pull the fuse. Should I replace the multifunction switch or look elsewhere?
View 10 RepliesFord F-150 - 1997-2003 :: 1998 V6 - High Beams And Coolant Gauge Not Working
I just bought a 98 F150 V6 Manual transmission 2wd truck. Its a clean truck and I'm liking it so far but its got a couple minor issues. Whats the point of buying a truck if you don't get to work on it??
The High Beams don't work at all. Low beams are fine. I've put new bulbs in, and fuse 16 in the passenger compartment has continuity. I'm suspecting the multiple function switch, because when I pull out to engage the high beams, nothing happens. The indicator on the dash doesn't come on, and the low beams don't turn off either.
The second issue is the coolant gauge doesn't read. When I turn the key to the on position, the needle on the gauge moves up just a bit, but it never moves after that. Anything to check?
There are a couple other minor things like the e-brake light on the dash doesn't always turn on, but I can deal with that.
Ford Super Duty (1999-2016) :: Truck Only Has Low Beams / No High Beams
My truck only has low beams. When you move the stalk on the colum backwords it changes nothing, when you move it forwards the low beams go out but the high beams do not come on.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: High Beams Only And No Low Beams After Installing New Headlight Bulbs
I have checked fuse 46 and 47, and installed new headlight bulbs. I have high beams, but no low beams. I have searched this topic but no one has the same prob it seems. My headlight switch has broken. Could it be the headlight switch?
In my manual, it says the 2002 has a fuse panel behind the glove box. I took glove box out but it doesn't look like a fuse panel.
Ford Wiring/Electrical :: HID Low Beams But No High Beams
It ford related but I just bought a used car that has hid low beams and when you turn on high beams there is no light at all. The blue light on dash comes on and head lights go off. I just got this car 2 days ago and haven't really looked into it.
View 5 RepliesFord - Explorer :: 2004 - After Thump Shut Down - Oil Was High - Crank Broke Into Pieces?
2004 sport track 4wd. never had issues..no oil burn, leaks, af use..nothing. was a great truck. going to work.heard a thump and truck shut down.
oil was high on dip stick..no AF left..it all went into motor on top. seized up engine and crank broke into pieces...done..
got a new engine put in this week.
Has this been an issue with these engines..or did I just have some bad mojo?
Ford - Explorer :: 1997 - Engine Will Not Shut Off
Have a 97 explorer 4wd xlt push rod. The key will not turn the engine off( when the unit is hot) with head lights on, I turn key off engine runs, i reach over and turn the headlights off engine will shut off. Start back with the headlights off the engine will shut right off, but if I turn the headlights on on while it is running and leave them on it will not shut off, unless i turn headlights off.cold start does fine.. I can turn ign key to the off position radio stops playing, so I know it is not the the switch or rod. I was going down the highway and lost dash lights and taillights the other day I moved the switch a little and they came back on the ign switch worked perfect that day.
View 2 RepliesHeadlights - Chevrolet - Blazer :: 1997 Chevy - No High Beams
I have a 97 chevy blazer, that has no headlights. the daytime running lights, dash and marker lights all work but not the headlights or high beams?
View 4 RepliesPrius (Gen 3) :: 2010 - Only High Beams Works / Low Beams Out
I have a 2010 prius the basic model I turned the lights and both headlights went out they only worked on high beams.
I changed the bulbs no luck they still only work on high beams checked fuses they looked good is there anything else I can check?
Golf IV / Jetta IV :: Low Beams Went Out / High Beams Functional
After spending weeks ordering parts and doing research on this issue all my attempts have not solved the issue. To reiterate the issue, the high beams work, and the low beams do not. Thus far I have attempted the following without the desired result-
1. Changed the headlights out just in case both bulbs burnt at once.
2. Changed the blinker stalk in hopes of a faulty switch.
3. Changed the headlight switch to a brand new OEM Euro style switch.
4. Checked all fuses (did this first actually).
Accent RB (2012+) :: Low Beams Stay On With High Beams
The other night on my way home, I flipped on the high beams and the low beams didn't shut off. Flash to pass still works, and pushing in on the end of the stem turns the low beams off as well.
Having the column switch apart, is it possible this could be fixed without having to pull the steering wheel? Or, am I better off just spending the hundred dollars of so and putting in a new part?
Ford - Explorer :: 1997 - High Beam Indicator Inoperative
The high beam indicator on the instrument panel stopped working. It does illuminate but is extremely dim. I changed the bulb, its one of those tiny little bulbs but that didn't work. I cleaned the connection areas where the bulb holder clicks into the back of the panel with scotchbrite, no luck.
I checked for voltage, this is where it gets interesting. I measured 6 volts. The other side is presumably ground, but my meter went a little crazy when I checked for ground, like it sensed voltage, but there is no voltage. This could be a bad ground, but where is the ground located? Buried somewhere under all those plastic panels, I suppose. And why only 6 volts? Is there some electronic control somewhere? The Chilton manual wire diagram just shows a hyper simple circuit from the high beam lights, through the indicator lamp, then to ground.
I DID replace the check engine light bulb and that works now (sarcastic hurray!). I have never seen it come on, the previous owner must have let it burn out, but the truck is in pretty decent shape for its year.
Ford - Explorer :: 1998 - Low Beams Went Out
Got a 98 explorer eddie bauer and the low beams went out. A search through the console revealed this explore doesn't have the lamp/light out module. So i guess a multifunction switch would be the next place to go? Fuses look good too btw.
View 3 RepliesFord Excursion :: 2000 - High Beams Not Working
Low beams work fine. When I push the Multi-Function lever on the column forward to activate the high beams, I have no lights at all. When it is in low beam (middle) position, low beams work fine. When I pull back for click to pass, only the low beams are active. No high beam indicator in instrument cluster. I have:
1. Replaced both headlight bulbs
2. Replaced the multi-function switch on the column. Checked test pins on switch (MF) they are hot when in either high beam position or click to pass position
3. checked fuses (interior)
#8 - power on both sides of fuse
#16 (15a) High beam headlamps, instrument cluster. ***NO POWER ON EITHER SIDE***
4. checked fuses (engine compartment)
#10 - power on both sides
#21 - Power on both sides
#23 - power on both sides of fuse
Ford F-150 (2004-2008) :: Way To Run Fog Lights And High Beams Simultaneously?
Any way to run fogs and high beams same time?
View 9 RepliesFord F-150 (2004-2008) :: Flashers Don't Work But High And Low Beams Does?
I'm talking about the flash to pass feature, not turn signals.
View 2 Replies