Ford Wiring/Electrical :: 1989 F250 - Horn And Cruise Control Not Working
I have an 89 f250 7.3. horn has not been working for the longest time the relay clicks but still nothing. It doesn't matter weather the key is in the on or off position. I know it might be a grounding problem because the cruise control does not work any more (even though recently it was working just fine). I didn't see any bad fuses.
View 6 RepliesFord Wiring/Electrical :: F250 - Intermittent Cruise Control / Running Self Test?
F250 6.8L .. So Ive read a lot of posts about intermittent cruise control issues. I understand that the most common failure is the brake switch on the master cylinder. My concern is that I am unable to run the cruise control self test I keep reading about. Does this test not work on my model year. I have tried even when the cruise control is working and still the cc light does no come on.
View 2 RepliesFord Wiring/Electrical :: 1997 F250 HD Manual Trans - Cruise Control Inopertive
1997 F250 HD 7.3L It is a May build so is mainly 1996 parts. Came from the factory with auto transmission but PO did manual swap. Truck had factory cruise control but never worked after the swap. I found clutch safety switch missing so installed that and now it works as far as truck only starting with clutch in and other pins ohm good but it didn't fix the no cruise issue. All the diagrams I can find are wrong so I am stumped.
Horn works and steering wheel brushes appear to be functional.
Brake switch has 12V in and out so I think it is ok.
Brake switch on master cylinder has power in and out so I believe it is ok.
All brake lights work since I read that diagrams don't show it but they are somehow tied into the cruise.
I believe the issue is in the clutch safety switch (CPPS) wiring as I only have power on one wire however my colors don't match my Haynes or online diagrams. Also, no where can I find if this circuit runs on hot 12V or ground. Some wrong diagrams show hot 12V coming in on the light green wire from the brake switch but others show a hard ground on the red/Blu wire.
Most diagrams say I should have red/LtBlu, Red/LtGrn, LtGrn, Gray/Yellow. I actually have Red/Blue, White/Red, Tan/Blue, White/Brn. The White/Brn has power coming into the switch.
The connector for the automatic transmission column shifter is disconnected and the shifter was removed. I read that this needed to be jumpered to the tan/blue wire after a conversion on the CPPS but only on 2002 and up trucks so I don't think this affects me. That plug is for overdrive cancel.
Looking for a good diagram for a manual shift, diesel cruise control circuit that shows my color wires on the CPPS? I have had this truck 2 months and have fixed everything except this and will be making a long trip soon so cruise would be nice to have functional but I am stumped.
Ford Wiring/Electrical :: Wiring For Cruise Control Switch
Looking for wiring diagram for the older Ford cruise control switches. I'm wanting to add an aftermarket system but use the factory switches. It's for a 99 ranger with the steering wheels like the mark 8s, older mustangs, explorers, and many others, had.
View 1 RepliesFord Wiring/Electrical :: 1996 Ranger - Adding Cruise Control?
i have a 96 ranger and want to put cruise control in it. is the wiring there and what other parts do i need to get without going aftermarket.
View 1 RepliesFord Wiring/Electrical :: Speedometer And Cruise Control Not Working / Fuse 18 Keeps Blowing
I have a 1994 f150 5.0 engine and automatic transmission. Problem I am having is speedometer, cruise control is not working. Overdrive light is flashing and number 18 fuse keep blowing. horn is still working...
View 1 RepliesFord Wiring/Electrical :: Dark Blue Wire Connects To Cruise Control?
I have a wire that i think belongs to my Cruise control and I can't find out were it connects. It is dark blue/green stripe. It is in a wiring bundle with the oil sending wires ( two wires blk/w and y/o ).
I also get a code ....no sig from clutch neutral switch.
I just got done putting new heads on my little 2.9 and can't wait to use this as my daily drive. These two wiring issues are keeping my truck from running well enough to drive.
Ford Wiring/Electrical :: 1985 F150 - Location Of Cruise Control Amplifier
Where is the cruise control amplifier located on an 85 F-150? The Chilton manual just says "behind the instrument panel". No pic or further description. Just looking up from the bottom of the dash I see a "black box" with 2 wires going into the top of it located just between the steering column and the wiper switch.
Is this it?
Ford - Electrical-wiring - Brakes - F150 - Sensors :: 1990 - Cruise Control Quit
I recently changed out the power boost canister for the brakes on a 1990 f-150 2wd. It was successful but now i have no cruise control. I double checked my plugs, all good. I checked my brake lights, all good. brake pedal seems fine and completely raised when not in use. i looked for a fuse and can't find it for that system, seems odd. it's not in fuse jct under dash, can't find a fuse jct under hood, seems odd also. No check engine light has lit.
View 3 RepliesFord Wiring/Electrical :: Brake Lights / Cruise Control / Rear Hazards Not Working
1991 F250 Supercab Diesel 4X4. I made a mistake while wiring up my trailer lights and ended up grounding out my brake controller, frying it. Along with that, I popped a couple fuses as well (1, 5 and 9 I believe). Replaced all fuses and got my signals (F/R) back at least.
Here's what's NOT working/messed up:
*Brake Lights
*Cruise Control
*Rear ABS light comes on a few minutes after driving.
*Front hazards work, not rear. When I apply the brake, the hazards pause in the on position.
I've tested the brake switch on the brake pedal (Green/Red and Green) and it works properly. So, current is obviously not reaching the rear brake lights.
Another note. The truck is wired with a 7 pin plug in the bed for a goose neck trailer. It also was wired to a 6 pin on the bumper. I replaced the 6 pin with a 7. The signal/brake pins on the plugs (both) and also not receiving power. What's the next thing to check?
Ford Wiring/Electrical :: 2001 F250 - Auto To ZF6 Swap Cruise Not Working
I have a 2001 F250 with 7.3. We swapped the auto for a zf6 manual. We left the auto's shift position sensor tied to the frame and left in neutral. I did install a pcm from a manual transmission pickup. Also have the clutch position switch hooked up. I have an Edge Evolution CTS2 reprogrammer, and on the display the gear indication always shows P. I suspect that is why my cruise doesn't work. For interests sake, I tried manually adjusting the shift position sensor through all gears, and the reverse lights come on when in reverse but the Edge's display always shows P. My question is with a manual transmission, how does the pcm know that it is in gear? The only sensor that I am aware of is the reverse sensor on the zf6.
View 4 RepliesFord Wiring/Electrical :: 2007 F250 - Power Out On Cabin Temp Control Panel
Well I've had her just 1 week, used, and today I turned it on and the power is out on the A/C n Heater /Fan Control ASSY. It worked the last 900 miles from FL to OH. And today worked this morning, but 2nd time I got in the truck today there was No Lights in the Air Control Assy. I didn't get an Owners Manual, so what fuse to check.
View 3 RepliesLexus GS 2006-11 :: 2007 GS350 Speed Just Drops Off / Cruise Control Not Working
I just noticed the other day that my cruise control stopped working.
The cruise light will come on, but when I try to set it...nothing. The speed just drops off.
Ford Wiring/Electrical :: 2006 F250 - Driver Side Window Does Not Operate
I've got an 06 F-250 and out of nowhere the drivers side window does not operate. I don't hear the motor operating (or trying to operate.) So I opened the trim piece and removed and reinserted the plug for the two forward switches, no change.
Surprisingly we are expecting more rain in So Cal in the middle of April tonight and I'm wondering how to by pass the switch, to at least get the window in the up position to keep the weather and the natives out.
Ford Wiring/Electrical :: 2006 F250 - Dome Lights Stay On All The Time
Have a 06 and the dome lights stay on all the time. I had to pull the bulbs out of all of them. They would come on during the night and run my battery dead. The lights just come on while driving down the road and won't go off either. I can hear a clicking in the dash while driving where they are coming on and off from a really or something. Sounds to me like it's coming from the instrument cluster.
View 5 RepliesFord Wiring/Electrical :: 1997 F250 - Rear Tail Lights Wiring
I have a 97 F250 HD. Wiring the rear tail lights. When we bought it the had cut off the wires going to both sides of the rear lighting assemblys and I was wondering what wire went to what i have the left turn signal working just can't seem to get the brake/back up light to work on that side and i can't figure out how to get the right side going either.
View 8 RepliesFord Wiring/Electrical :: 1999 F250 - Door Courtesy Light Wiring Diagram
I am trying to add courtesy lights to the existing reflectors in the front doors of my supercab. I can't find a wiring diagram that shows where to connect the light sockets. 1999 F250 SD...
View 2 RepliesFord Wiring/Electrical :: 1990 F250 Hard To Start - Glow Plug Controller Relay Wiring
I just bought a hard to start 1990 F250. Per the board, just replaced all 8 glow plugs with Motorcraft. Still wouldn't start (it turns over but will only start if you use either). I attempted to install a new BWD brand (Borg Warner I believe) glow plug connector relay today...I removed the old no problem, but am unsure what wires to plug where....the only connection that I'm sure about is the blue wire that works the WTS feature...it plugs in easily but I don't know if there are other connections that need to be made or not? All the wires run from the posts and into the bottom of the unit.
View 2 RepliesElectrical-wiring - Engines - Gasoline :: 1997 Toyota - While In Gear And Driving Speed Slowly Drops
I have a 1997 Toyota Hilux (unleaded, not diesel) and I'm looking for input as she keeps breaking down but no one is able to figure out the problem. While in gear and driving, the gas stops engaging and the speed slowly drops. The car stutters while slowing down but then if I switch gears or rev the engine it will stop. After some time this continues to happen more frequently (at all speeds) until the car eventually stops and dies. Try to restart and the engine will turn over but not start. After sitting for a night or so, though, she starts up and runs just fine. Thus no mechanics have been able to solve the issue!
Could be a fuel problem as the exhaust pipe makes a banging sound when this happens, but it could also be electrical.