Ford F-150 - 1997-2003 :: Spark Plug Blow Outs / Cylinder 7 Nearly Stripped Out
With the many discussions on F150 spark plug blow outs, is there any consistency in which Cylinders usually go or is it completely random. In my 2003 F150, 4.6, 2wd, I've replaced #3 cylinder with insert and now #2. Currently I'm at 154,000 miles but want to travel cross country with a load. I don't want to stall out on the hwy, would it be wise to go and insert the remaining cylinders - not cheap. My mechanic is willing to inspect with a bore scope the threads and re-torque. Is there a point at which if it hasn't been a problem it won't be. Truck is used primarily for commuting and to pull a single jet ski in the summer. Both blow-outs happened at a stop-light about 20,000 miles apart with no load.
Follow-up. Did inspection, found cylinder #7 nearly stripped out - it was actually pushing up the coil. Funny thing is, this plug had already the small insert which was coming out with the plug. I bought the vehicle new. Was this a factory repair? or did my previous mechanic strip-it when replacing all my plugs at 95,000 miles? Lucking the large inserts my current mechanic uses was able to find some metal and make a good repair. Looking at the cylinder order, I have now replaced 3 of the inter four cylinders (2,3,7) should have I done #6 too, this is probably the next high risk cylinder or not?
Passat (B5) :: 2000 - Oil In Spark Plug Holes On Front Two Cylinders
My dad was changing his plugs today (2000 passat 1.8t) and he found some oil down in the holes for the plugs on the front two cylinders (closest to the front of the car) and also on the plugs themselves, and needless to say hes a little concerned. he doesn't think there should be any there. headgasket?? He has 105k miles...
View 5 RepliesThunderbird :: 1989 Ford V6 Turns Over But No Spark
I've got a 89 ford Thunderbird that I've replaced coil and all other things i can think of but still no spark. I pulled the plug which connects to the coil pack and tested the positive side of plug and not hot with key on then i went to back side of plug and got a hot.
View 1 RepliesFord Super Duty (1999-2016) :: Stripped HPOP Fill Plug
I have stripped my HPOP fill plug. Any experience on getting one out? And a part # for a new one?
View 10 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 - Injector Fuel Drain Plug Stripped?
I am currently doing my injectors. Just a quick question. I was trying to get the fuel rail drain plug out but it stripped, actually not on the driver side stripped. I know there is the drain plug on the back of the cylinder. If I drain that and turn the crank over by hand will that drain all the oil and fuel that has drained into the cylinder? I'm really not trying to bend a rod when I turn this thing over. It's A 2001 7.3
View 5 RepliesThunderbird :: 1978 Intermittent Stall - No Spark
It had no spark when I put a spark tester on, a few minutes later it started and runs fine. This has happened several months ago. Is their a way to test the spark control module.
View 3 RepliesDodge - Grandcaravan :: 2000 - Oil Pan Drain Plug - Threads Can Become Stripped?
I have a 2000 Grand Caravan and had a Chrysler dealer change the oil in July....just took it in today for another oil change and they told me the oil drain plug just turns - either the plug is stripped or the threads on the pan are stripped....I said that they were the ones who changed the oil last time so if anything happened then they did it....they are saying that over time the threads can become stripped - suggesting that if the threads on the oil pan are stripped then I will have to buy a new oil pan.....I said that I had not touched the oil pan so if something is wrong then they are responsible - the threads don't just strip themselves.
View 19 RepliesFord - Escort :: 1999 - Weak Spark On Cylinders 2 And 4
My problem started five months ago and was very intermittent until now. The engine would run rough at start up either cold of hot and then run fine after about two or three miles. Now it runs rough all the time. I have installed a new ignition coil, new spark plug wires and new spark plugs. The engine starts ok but it runs rough and when I pull the spark plug wires one at a time,while it is running, the spark is very weak on cylinders 2 and 4. The spark on the other two cylinders looks good. I have checked the connector on the powertrain control module, which is a EEC-V, and there doesn't seem to be any bad connections there.
View 6 RepliesFord Ranger / B-Series :: Getting Good Spark From All Cylinders But Not Starting
I just finished rebuilding my 1990 2.9 and it wouldn't start. When we did the initial start up, the truck needed ether to start and ran decently while stumbling. I found out that the spout connector was removed from the previous owner so I spliced it but still no starting ...
I installed a new fuel filter, fuel pump, cleaned the injectors, spark plugs, spark plug wires, distributor cap, rotor, air filter and cleaned the MAF. ..
Its not a spark problem because I'm getting good spark from all the cylinders and yes the timing was set correctly. It sounds like it wants to start but just doesn't have something to make it boom. There are also no codes...
Taurus :: 2006 Ford - No Spark On Two Cylinders - Code P0352 / Bad Coil
Have a 2006 Ford Taurus that has two dead cylinders. Cylinder 3 and 4. Code says bad coil. I replaced with new coil and plugs. Same problem. Replaced wires and same problem.
Car has 65K. What is causing both cylinders to be dead? Pulled wires off while running and no spark on 3 and 4.
Ford Ranger / B-Series :: Coil Is Sending Spark But Cylinders 4 / 5 And 6 Not Firing
Al right i have a 94 ranger 4.0 4x4 auto 186k ... The truck has new bosch double plat plugs gaped .054, new wires, MAF, TPS, FPR, O2 sensors, ECTS and I checked the intake air charge sensor and is fine ....
My issue is cylinders 4,5 and 6 dont fire... the coil is sending a spark, i can pull the plugs one at a time and watch them fire (strong blue spark)... All fuel injectors do not leak and spray a perfect cone out of all 4 holes and noid light test is good ...
The truck runs like crap back firing and no power under 4k and i can pull off all 3 wires for bank one and it make no difference and when i unplug the injectors no more back fire....
Mercedes :: 1994 C280 No Spark In Cylinders 1 And 6
1994 Mercedes C280, Cylinder 1 & 6 no spark. Changed 3 coil packs, changed wires and spark plugs. Engine wire harness look fine. Cylinders 2,3,4,5 have spark. Coil number 3 Controls Cylinder 1& 6; and I use multi-meter to check for voltage. 11.70 volts with key on position, 13.80 volts with ignition on. I need to figure out could it be a sensor or the ECU( Computer) or Engine?
View 1 RepliesLeSabre :: 1989 Buick Not Starting / No Spark On 4 Cylinders
I need getting my Buick to start. It is a 1989 LeSabre Limited with a series 1 3800 engine. I only have spark on cylinders 3 and 6 (paired on ignition coil). I have run tests to see that I have that I have 12 volts to the ignition module, 12 volts out to the crank sensor, signals coming from the crank sensor. I pulled the coil pack and found that I only have a signal on the blue wire supplying 3 and 6. I don't get a signal on the green and yellow wires supplying the other 4 cylinders. My tests would indicate that the ICM is bad. I replaced the ICM and out of desperation the coil pack and I still have the exact same problem. I cleaned the aluminum surface to make sure I have an excellent ground.
View 7 RepliesFord Excursion :: Spark Plug Replacement?
OK, this technically isn't for the Ex (since it's a diesel), but I do need to replace the spark plugs in a Ford V8 soon. Problem is I've been running diesels for a long time and haven't really kept up with spark plugs.
Seems like there's lots to choose from now. Regular old fashioned, double tip, triple tip, platinum, kryptonite, thermo-nuclear tip, etc. Is one spark plug really any better than another, or is it all just marketing gimmicks? Is it worth spending extra for some fancy sounding spark plug?
Ford Excursion :: Spark Plug 10 Blew Out
I'm 2 hours from home #10 spark plug blew out I pulled the injector cable and coil cable is it safe to drive home that way?
View 14 RepliesEscort :: 1996 Ford - Spark Plug Removal
I want to remove the spark plugs but unable to loosen them. How I can easily loosen them up without breaking them?
View 2 RepliesFord F-150 (2004-2008) :: Spark Plug Sleeve Came Out
Had a spark plug sleeve come out, the part with the hex head to turn the whole thing. Wonder if JB Weld put on the inside of this sleeve and placed back over the plug will hold enough to turn the plug and get it out after some more pb blaster?
View 4 RepliesFord F-150 - 1997-2003 :: Spark Plug Blowing Out
I have a 1997 F150 4.6 V8 and as we all know these trucks are notorious for the spark plug blowing out. Although when I bought it I never had an issue until we put motorcraft plugs in. After a couple weeks of having these plugs in the porcelain blew out of the plug with the threads still in the head. The spark plug screws into a threaded insert which then screws into the head. We replaced the plug and nearly a month later the porcelain blew again. Replaced it, same story a week and a half later. Before the motorcraft plugs I had autolites in it, and I never had the slightest spark plug blowout problem. Should I just put an autolite in the cylinder that's blowing them?
View 4 RepliesFord F-150 - 1997-2003 :: Spark Plug 3 Blow Out
I had a plug blowout last Thursday on the freeway. I wasn't sure of what happened with my truck, it was a shutgun going off. I had to towed to my local Firestone.
My truck is a F-150 4.6 2003 with 206,000 miles.
The short of the story, plug #3 blowout. It trashed the coil and I needed a new plug. They used a Helicoli and I have been reading that they shouldn't have used a Helicoli. They should have used a Time-set.
What's wrong with the Helicoli's? Is this fixed going to last for awhile? They said the helicoli worked well. The truck had 7 NGKs and 1 motorcraft. It has all new motorcrafts now.