Ford F-150 - 1997-2003 :: Spark Plug Blow Outs / Cylinder 7 Nearly Stripped Out
With the many discussions on F150 spark plug blow outs, is there any consistency in which Cylinders usually go or is it completely random. In my 2003 F150, 4.6, 2wd, I've replaced #3 cylinder with insert and now #2. Currently I'm at 154,000 miles but want to travel cross country with a load. I don't want to stall out on the hwy, would it be wise to go and insert the remaining cylinders - not cheap. My mechanic is willing to inspect with a bore scope the threads and re-torque. Is there a point at which if it hasn't been a problem it won't be. Truck is used primarily for commuting and to pull a single jet ski in the summer. Both blow-outs happened at a stop-light about 20,000 miles apart with no load.
Follow-up. Did inspection, found cylinder #7 nearly stripped out - it was actually pushing up the coil. Funny thing is, this plug had already the small insert which was coming out with the plug. I bought the vehicle new. Was this a factory repair? or did my previous mechanic strip-it when replacing all my plugs at 95,000 miles? Lucking the large inserts my current mechanic uses was able to find some metal and make a good repair. Looking at the cylinder order, I have now replaced 3 of the inter four cylinders (2,3,7) should have I done #6 too, this is probably the next high risk cylinder or not?
Ford F-150 - 1997-2003 :: Spark Plug Blowing Out
I have a 1997 F150 4.6 V8 and as we all know these trucks are notorious for the spark plug blowing out. Although when I bought it I never had an issue until we put motorcraft plugs in. After a couple weeks of having these plugs in the porcelain blew out of the plug with the threads still in the head. The spark plug screws into a threaded insert which then screws into the head. We replaced the plug and nearly a month later the porcelain blew again. Replaced it, same story a week and a half later. Before the motorcraft plugs I had autolites in it, and I never had the slightest spark plug blowout problem. Should I just put an autolite in the cylinder that's blowing them?
View 4 RepliesFord F-150 - 1997-2003 :: Water In Spark Plug Recess
1997 f-150, 4.6, 147K miles. This morning I started the truck and the engine light was on. Felt a miss in the engine. Drove 1 mile and back then checked the wires. Found one not firing. Traced it back to the plug. When I pulled the plug boot off I noticed water in the recess, surrounding the plug. Once I blow out the water, I'll checjk the plug but I would like to know if this is a natural occurrence. I thought the boot would prevent water from filling the recess and sitting there. Or does the water just evaporate when the engine gets hot?
View 14 RepliesFord F-150 - 1997-2003 :: Spark Plug Socket Stuck
i just purchased an '01 expedition with the 5.4. I was told #5 spark plug blew out. Upon examination, it appears to be #6, second from the front driver side. Anyway, as I was looking, it just didn't look right. There was a spark plug socket stuck in the well, with the plug still in place. How to get the socket out? I can get an extension on it and it will turn, but it's tight. But I can't pull the socket out.
View 9 RepliesFord F-150 - 1997-2003 :: Coolant In Spark Plug Hole
Okay so I was getting the misfire in cylinder 3 so I pulled the plug out and it had coolant in it. Does that mean it needs a new intake manifold gasket? That is what the guy told me at the parts store. Also can I drive it like this or will it damage the engine?
View 1 RepliesFord F-150 - 1997-2003 :: 2001 - Oil In Spark Plug Wells
I have an 01 f150 with 5.4 triton. This has been great truck, never really had to do anything to it. It has 195k on it. Week or so ago it started running rough. So I replace the plugs and coils. I noticed some of the plug wells had oil in them. Got done and the truck is running like new.
Not sure where the oil is coming from. Not the piston as the plug was dry on the tip and truck not smoking any. I has began using a quart or so between oil changes. I have always changed it every 3k. Is it just time for new motor. Like I said it is running like new.
Ford F-150 - 1997-2003 :: Fuel In Spark Plug Holes / Gas Smell
I was checking my COPs and the first one I pulled out of my 2002 f150 5.4l had a clearish liquid on the coil boot. I looked down in the spark plug hole and it was filled almost to the top of the spark plug itself. I smelled it and it smelled like gas. Why this would happen and what should be done to fix it?
View 3 RepliesFord F-150 - 1997-2003 :: 2001 - Leak Right To Spark Plug Behind Hose?
I found a leak today on my 2001 Ford F150 Super Crew, 5.4 engine. In the picture, it was leaking to the right of the spark plug, behind the hose. It was bubbling up from the metal. It hasn't been overheating except when I got home and idled with the AC on. What I'm facing?
View 12 RepliesFord F-150 - 1997-2003 :: 2001 4.6L V8 - Spark Plug Blown From Cylinder 3
My son has a 2001 F150 with a 4.6L V8 that's blown a sparkplug from # 3 cylinder. The plug looks as if struck by lightning and has a burn groove as deep as a kitchen match stem the full length of the threads.
How difficult is an engine swap/change using another 4.6L? Neither of us have extensive mechanical backgrounds but plenty of aptitude.
Ford F-150 - 1997-2003 :: Missing And Smell - Spark Plug Has Moisture
This a 02 with 5.4, had codes po306, pulled and checked sparkplug had moisture in it. Fixed that ran ok for a little bit then started again, no codes now and smells a little like rotten egg.
View 1 RepliesFord Super Duty (1999-2016) :: V10 Spark Plug Fully Blow Out
About a week ago I blew #10 spark plug out of my 1999 super duty. I was able to screw it back in, though it only has 2 1/2 threads now, and was able to put 12 ft/lb's of torque on it. I am driving it around and it is running fine but i am wondering if i am sitting on a ticking time bomb thats gonna blow at a random time, and if so what should i do about it. Should i just run it until the plug fully blows out, or is there an easier and cheaper fix that i could do if i fix it before the threads are fully stripped out. I have heard about Time Serts, but without pulling the head i would be scared of having a metal shaving get down into my cylinder and scratch the hell outta it.
View 14 RepliesFord F-150 - 1997-2003 :: Truck Won't Start After Blown Spark Plug Repair
Last weekend my number 4 spark plug blew out while on the highway. The truck stayed on long enough for me to get off the highway and pull over before it died. I towed the truck home. Last night I repaired it with a helicoil and replace the spark plug and coil. Now the truck cranks but won't start. I noticed that my theft light flashes fast and doesn't stop after a few seconds or during cranking. I still haven't tested relays or fuses because it was late after the repair. I will be checking those tonight.
I will be reading and taking suggestions and posting my results tonight while I'm working on the truck. I will be checking the fuel pump and PCM relay tonight. I will also try 2 different keys and checking the Inertia switch on the fuel pump to see if that tripped. The truck is a 2001 F-150 Lariat Supercrew with 150k miles on it. 5.4 liter engine.
Ford Super Duty (1999-2016) :: Spark Plug Blow Out - Few Aluminum Chips Don't Get Removed From Cylinder?
I need to tap a bigger hole and put in an insert for the spark plug. I can see that the piston is far enough down so that it won't get harmed from the process. But if I don't get the intake and exhaust valves shut, and then use compressed air to blow out what chips I can, and then I start the engine for a few seconds to blow out anything else (with the coil unplugged of course) will a few remaining chips, along with some that may have gotten blown into the intake, be a big problem? It's an aluminum head, so I can't see the chips doing much damage before they go out the exhaust or end up in the oil filter. But I am just guessing. I don't have the tool to test when all the valves are shut. Also, is it possible that a valve might be in the way and get damaged from the tap?
View 11 RepliesCavalier - Chevrolet :: 1998 - Number 3 Spark Plug Blow Out
My girlfriend has a 1998 Cheve Cavalier that recently on the way to work completly blow out the number 3 spark plug. It was completly gone and poofs of air now come out of it's place?
View 1 RepliesFord Super Duty (1999-2016) :: 1997 F250 XLT Spark Plug Chamber 2 Blown Out
The spark plug in chamber 2 blew off while the vehicle was in motion (approx 35 mph). Purchased replacement plugs and when I went to install, there was nothing for the plug to grab (i.e. appears that all of the threads on the block/casing are gone . Not sure what my options are.
View 2 RepliesHonda - Accord :: 1997 - Loose Spark Plug Wire
I took a long trip this last weekend and before the return trip I checked the oil and realized I need some. I put two quarts which brought the level just about even with the top mark on the dipstick. the return trip was fine. Next morning I started the car and right away notice that the engine was misfiring. I checked the spark plugs and noticed that one of them was loose and had some oil in it. I checked the oil and now it showed the level to be well above the top mark on the dipstick. Could too much oil cause the spark plug to get dirty, get loose and misfire? This car is a 1997 and has 206,000 miles. This is the first time this has happened. Could the same thing happend with a 1999 Honda Civic?
View 10 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Spark Plug Shot Out?
I have an 03 F250 5.4L
Driving down the highway today, I notice my truck was jerking forward a little, hard to notice almost felt like I was hitting very small pot holes. I revved up a little to see if I could notice any noises and I got a loud pop. after the pop, got a noise like an exhaust leak so I pulled off to the side of the highway and popped the hood (engine still running). Noticed the noise coming from the passenger side most forward spark plug. Then noticed the part that the coil attaches too had broke off from its bracket and was unseated, shut off the engine and pulled it out to find the coil cover had melted to the coil.
The spark plug inside was moving freely so I took it out thinking it stripped from the header. Come to find that the plug had actually separated from its threading completely so just the core part of the plug had shot out from the cylinder, the threading and socket attachment portion still fully attached. I installed a new spark plug and new coil harness and coil. Seems to be running as good as new now. Is there more to this than a simple blown plug that I need to worry about?
Toyota - Matrix :: 2003 - Spark Plug Shot Out
I took my 2003 Toyota Matrix with around 148K miles to a local shop for the 150K work. This is the first time I have not taken it to the Toyota dealership because I wanted to use a local shop that works on Toyotas. I live in Asheville, NC. I spent over $800 for this service, rotating and alignment, plugs changed etc and they checked a engine light and told me I needed a new catalytic converter. I took the car in on November 2nd. On December 23rd I was driving on the interstate and heard a pop and a coughing noise. I was stranded on the side of the highway in Knoxville, TN. I got a tow to the a Toyota dealership where I learned that "the spark plug shot out like a rocket" through the header. I ended up getting a used motor for $4400. I have since spoken with other mechanics, all who have said that this is a problem with Fords. All have said the plug must not have been installed properly. They said it could have been a faulty plug but they don?t know how.
View 19 RepliesPassat (B5) :: 2003 - Spark Plug Gaskets Leaking
Usually the valve cover gasket leaks and causes the usual problems, oil leaks onto manifolds, oil loss. I changed the plugs on my 2003 V6 only to find ALL the gaskets around the plugs are leaking a lot of oil. This explains the slightly unusual amount of oil loss I've been seeing. In one sense that is good cause it means the valve guides and rings may be fine after all.
I bought the gasket set and plan on replacing the 4 of them in the kit but thought I'd ask if others have seen this and can speak of what they experienced as to the cause. It seems fishy that the valve cover gaskets are not leaking at all. The car was smoged a couple weeks ago and it passed the PCV test so does not seem there's a pressure problem from a clogged valve.
The first time I changed the plugs, there was no oil. The engine has 115,000 and runs great, I plan on having the timing belt service done very soon but thought about asking if these gaskets are going to be replaced anyhow in that servicing? 2003 V6 Passat...