Ford Super Duty (1999-2016) :: 2006 F250 - Phaser Knock At Idle In Gear
Ok I bought this truck with a bad engine 5.4 3v had rod knocking. I rebuilt engine got it all back together and in truck. I did replace cam phasers and solenoids. After driving 20 mins or so it would start the phaser knock at idle in gear so I put a oil pressure gauge on it and cold had 55 psi after running 10 mins or so had 15 psi at idle then would drop to abought 9 psi. I am thinking I got bad cam bearings or something for some reason don't know why. I did it but I took oil cap off where you pour in the oil. Had to force it off it was pulling that much vaccum ones cap was off oil pressure jumped up to 25 psi. What could be causing this.
View 2 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Average Cam Phaser Life Expectancy?
I drive a 2008 5.4L F-250. How long do the average cam phasers last. I run full synthetic at 5K intervals and run WIX filters.
View 2 RepliesFord Super Duty (1999-2016) :: 2005 F250 - Cam Phaser Knock / Timing Chain Slap On Start Up And Noisy Lifter
I have 05 F250 SD with 150k on it. The engine has the typical cam phaser knock, timing chain slap on start up and occasionally have a noisy lifter. As long as I use fresh 20-40 oil the engine symptoms are less and the engine runs strong. The motor also doesn't leak or burn oil and the plugs were change out about 20k ago.
The truck is still good and is prefect for my needs so to me it's seems worth fixing the needed repairs. What I would like to figure out how far should I take the motor... just have the chains, guides and phasers replaced or buy a rebuilt motor and swap it? I'm thinking just doing the phases and etc would be 1/2 the cost but may not last as long as rebuilt motor. But realistically I might only put 5-7k miles are year on it anyways.
Ford Super Duty (1999-2016) :: Super Loud Clunk Noise Come From The Door When Car Turned On
So the other day i opened the door and heard a super loud clunk noise come from the door and when I turned the car on and pulled hte window down it wouldn't go down all the way, only about 75% of the way so I assumed like BMW cars the window motor died but oddly it continued to go up and down just now 100% down.
Then 3 days later when I came to drive the car again the window went down to the 75% mark and now its jammed there with no movement even if I tried to lift the window up myself. Usually a broken motor allows this to happen but since it isn't budging I am wondering if its an electrical issue with the power window button more than the motor?
I say this because when i try to lower the passenger window from the driver side it works than out of no where on the 3rd time it wont move at all than 5 minutes later it will move or if it doesn't move I just go and pull the window down from the passenger side then I come to the driver side and try it and it works again than it'll stop again. So maybe its the power window control buttons on the drivers side that's failing?
Ford Super Duty (1999-2016) :: Low Injector Circuit On All 8 Cylinders
2006 6.0 superduty showing low circuit codes on all 8 cylinders so i checked the FICM and it has 48v when key is on and while turning engine over. What to check next?
View 11 RepliesFord Super Duty (1999-2016) :: Loud Squealing Noise Off And On In Front End
I have a 99 f250 4x4 super duty. Just started getting a loud squealing noise off and on in the front end. Changed the ujoints and axle seals on both sides. They where all in bad shape. It still makes the noise off and on while in 2wd. If I lock the hubs in it doesn't. What it could be ?
View 14 RepliesFord Super Duty (1999-2016) :: At 60 - 65 Over Bump Loud Rattle Noise?
I was driving and i was doing about 60 65 and i hit a bump and i heard a loud rattle and it shock the hell out of me then it just stop...
View 2 RepliesFord Super Duty (1999-2016) :: 2008 - Loud Squeaking Noise While Turning
I have an '08 F250 w/ a 6.4. A couple days ago I started getting a loud squeaking when I turn to the right. It only does it under speed, almost like it needs the weight transfer to make the sound. In addition it's only when I turn at a like 45 deg angle, I can turn less or more to make it stop. But it has gotten louder and louder.
View 1 RepliesFord Super Duty (1999-2016) :: Fan Is Loud - Noise Is Related To Engine RPMs
I have a 2004 PSD with 85k miles. The engine fan is all of a sudden loud. You can clearly hear the fan pushing air and it's noise is relative to the engine RPM. I've had this truck since it was brand new and have never heard the fan blades unless I had my head in the engine compartment. Is the fan supposed to turn relative to the engine RPM or is there something wrong? Either way it's now all of a sudden super loud.
View 1 RepliesFord Super Duty (1999-2016) :: 2008 - Code P0201 For Injector Cylinder 1
This is my first Ford. 2008 6.4L 165K miles full delete. Bought this truck at auction already deleted. Found an H&S pod mount instructions in glove box and so I am thinking it had their software loaded to it. I knew it had sat a while, but did fire up no problems. I have already replaced all fuel filters (actually learned I did them backwards, and did not cycle the key) and had no issues re-starting! I've put at minimum 30 minutes but no more than 1 hour run time on this thing post filter change. I'll get to the gritty. . This all started when I pulled a P0201 code for Injector Cylinder 1.
I pulled the valve cover to troubleshoot the injector, following a post I saw few days back. All checked out fine with the #1 compared with #3, and so I cracked loose the fuel line going to the #1 injector. The line was dry and thought it was strange, but I had changed out the FRP sensor prior and remember no fuel came out then either. Before pulling into the garage the truck was running rough but thought this was due to a P0193 code FRP pressure Circuit High (again). So I put the line back on, tightened the darn out of it.
I know these things see a 26K psi at times. I depressed the Schrader valve at the fuel cooler and got only a minute bit of air out. I didn't think this was enough, and so I took the Schrader valve out, hard lesson learned. I re-installed it and I fashioned a homemade tool connected the Schrader valve with a ball valve to cycle the key-on and purge out the air. I have ran the batteries down cranking trying to get it to fire. I am now getting no more air bubbles.
Had to get another diesel pickup to keep juice on the batteries. After 3 hours, 6 hours total, cannot get this thing to fire off! Am I missing something simple? Everything I have done to this point before reading the forum I have done backwards and all has been fine! Could it be that just now I am seeing the effect of the filter change being done backwards? On my scanner I can see the live FRP, it has to be the cmd, it is sitting at 29Kpsi. At this point should I re-pull the filters and start fresh?
Ford Super Duty (1999-2016) :: 2004 F250 - Loud Whine Noise Comes From Under The Hood
I have a 2004 Ford F250 Turbo Diesel, egr delete, headstuds, intake, dual stacks, etc and when i turn my wheel a loud whining noise comes from under the hood, I noticed it put tension in my brakes. When I accelerate it gets louder and when i let off the gas it goes away... i checked my fluid in my steering pump and it was low so i put some more in and the next day it was all sitting under neath the truck.... any quick fix or do i need to replace the whole pump?
View 2 RepliesFord Super Duty (1999-2016) :: 2001 - Loud Howling Noise And Reduced Performance
I have a 2010 6.4L turbo diesel. Without a trailer on a mtn incline I have no issues. She will fly up the hill and she is quiet when I'm not pulling the 10,000 Lb trailer. When pulling the trailer, I have a loud howling noise and reduced performance. I had it at the Dealership and I had them check the engine/turbo and they found no problems? I asked if they tested under load and they said yes?? Someone suggested that the "Waste gate valve" was defective.
View 4 RepliesFord Super Duty (1999-2016) :: Steering Wheel Jerk And Loud Clunk Noise
I took my truck to an alignment shop to have him look over my truck to find a steering wheel jerk and a loud clunk noise. He believes it's in the transfer case driveline. Said to remove the driveline then drive it around and see if it goes away, if it does then that's the problem. So to the question, how to properly take this out? Do I need to make marks with a paint pen anywhere to line things back up or does it matter?
View 14 RepliesFord Super Duty (1999-2016) :: F250 - Engine Making Loud Air Rushing Noise
I drive a 2000 F250 5.4L. Currently has about 168,000 miles on it. I changed the oil the other day and cleaned the air filter. I used what I usually use on the oil change which has never been a problem. But this is first time to clean the K&N filter. A day or so later my engine is making a loud air rushing noise. Under throttle the engine compartment sounds like a wind tunnel. At 3500ish rpms it makes a harsh whistle noise. The air rushing noise doesn't go away once its warmed up or after the engine has been cool. Noise didn't go away with the filter being taken off either.
Could all of this be caused by cleaning and not using k&n air filter oil (but rather WD40 upon Dad's suggestion)? Or is there something else going on?
Ford Super Duty (1999-2016) :: Loud Clicking Noise From Turn Signal Switch?
Example, if I'm turning the wheel to the left with the left turn signal on there will be a LOUD click, click, click ect. sound from the column. The sound is louder than the turn signal relay and can be heard with the radio on.
Today is the third time I've brought it in to have fixed and now they tell me it is "normal". They came to the conclusion that it is "normal" because two other trucks on their lot make a noticeable clicking sound and one is just as loud as mine. However, My truck JUST STARTED making the noise a few months ago and was quiet when I originally bought it.
I know this is not a big problem ,but it is annoying and I want it fixed. Anyways, my Ford dealer had bailed out on me so how do I fix it myself?
Can you hear the column switch clicking ALOUD in your truck?
Ford Super Duty (1999-2016) :: 2006 F250 - Intermittent Loud Chirping Noise
I have a 2006 f250 lariat 192k no mods except k&n filter everything is stock. I have 2" pro comp level kit and a scan gauge 2 nothing fancy! Well the other day I noticed my truck was chirping like a Chirp chirp chirp...... Chirp chirp...... Chirp chirp chirp! It goes up and down with the rpm's but it's comes on and off only when the engine is up to running temps the belt does squeak during warm up but I don't think that's it, it's coming from the back of the engine I'm sure of it because I used a paper towel tube and listed right in the turbo hpop area on top of the engine but it's too hard to tell I can't find exactly where it's coming from, some people I've had listen think it's a belt or pulley or tensioner! But I'm not sure if it is because I've sprayed water, and wd40 on the belt and pulleys with no change!!! I'm afraid it's a lifter or something inside the engine yet it's too loud and pronounced to sound like it's coming from the inside! I'm just lost!
View 8 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Loud Banging Noise When Going Over Bumps
I have a 2000 F250 2wd 6spd with a loud banging noise that has been vexing me for quite sometime now. The bang happens when I go over bumps (even small ones like road reflectors) while driving. I don't think it is suspension related since all the ball joints, front/rear swaybar and endlink bushings have been replaced fairly recently. All the springs and bushings also look okay.
The noise seems to come from the rear, and I notice that if I let off the gas when I go over a bump, it does not make a sound. Conversely, if I am accelerating aggressively and hit a bump, the sound is much louder. Also, if I step on the clutch while keeping my foot steady on the gas, it makes a bang. Jumping up and down in the bed while the truck is parked does not recreate the sound. I have already greased the driveshaft spline joint so I'm thinking the sound might be differential or transmission related. What it could be?
Ford Super Duty (1999-2016) :: 2003 - Blower Motor Loud Rumble Noise?
I have a 2003 super duty V10 4WD super cab long bed.
loud deep rumble noise when turn on the blower. both heat and a/c. removed the blower and seemed to turn ok. blew out all vents. removed heater radiator cover, checked most flaps to see if working. doesn't seem to be obstruction invent. the flap behind blower clear and functioning ok.
When on second speed, almost sounds like blower motor is out of balance. if run on high for 1 minute, smell electrical burning! Think to replace motor will work? will post another issue with radio and power windows
Ford Super Duty (1999-2016) :: Fairly Loud Noise Coming From Just Right Of Center Fold Down Cup Holders
The Truck: 2008 F350 Super Duty, Lariat Crew Cab 6.4 Diesel, Off Road package with just under 90K.
The Noise: It sounds like a cross between Morse code ticking (No Morse code message. I thought of that) and the sound a styrofoam cup makes when it rubs against another cup. The noise is fairly loud. Noticeable at standard conversation speaking levels. Doesn't just go away once it starts.
The Apparent Location Of The Noise: Sounds like it's coming from just right of my center fold down cup holders between the driver and passenger sides of the dash.
Process Of Elimination: No set rule for when it starts to happen but it doesn't happen all the time. SEEMS like it happens after a longer trip.
Air conditioning on or off doesn't make it stop. Fan on or off doesn't change anything. Restarting truck at a stop light doesn't change anything.
Varying truck speed doesn't make a difference. Banging on the dash near the sound doesn't make a difference.