Ford Super Duty (1999-2016) :: Driver Side Window Quit Working In Up Position
I have a 1999 f250 crew cab. About 6 months ago my drivers side window quit working in the up position(lucky me) and last week I got around to fixing it . I just ordered a new window motor instead of the whole regulator and installed it and it worked perfect for 4 days and today it suddenly quit again. What would cause a window motor to go out again so quick? Everything else seems to be fine and there is power to it so I'm assuming it's the motor.
View 2 RepliesFord Super Duty (1999-2016) :: 2001 - Speedometer Needle Jumps From 55 To 70 On Display?
2001 F250 SD, V10, Auto, 155K miles
While driving home from work I noticed the needle jump from around 55 to 70 on the display, then settle back in at 55 ish. First I just caught it out of the corner of my eye, but watched more closely, and it did it again as I drove. The tow/haul override button on the shifter was blinking also, (as if it was "Mad" about something)..
Then I noticed that the jump of the Speedometer needle was linked to when I changed from High to Low on the headlights, and vise-versaI was NOT in cruise mode The voltmeter did not EVER waver. (I thought that the increased current might be causing a temporary problem of sorts). Where to start looking?
Ford Super Duty (1999-2016) :: 2001 - Overdrive Switch On Gear Selector Stopped Working
The switch for turning overdrive off that's located on the auto trans shifter stopped working. I've taken off the column cover to see if the wires have been severed from the tilt wheel, but nothing wrong there. I also checked the fuses, and all is well. Is it possible that the switch is bad at the end of the shifter, or somewhere farther down the column?
View 14 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Tachometer Needle Will Not Always Move The Way It Supposed To
Just had a question about my 00 F250 7.3. I recently have noticed that my tachometer needle will not always move the way its supposed to. Sometimes it will sit at zero until I drive it for a min then all of a sudden pops up to where its supposed to be. I also noticed today that while i was driving it just dropped to zero for a second or two then back up to where it was supposed to be again.
When it does this there is no drivability issues with it or idle issues what so ever. Which is strange to me and I cannot seem to put my finger on what could be causing the issue. As I have searched online for a while to no avail as most of the other issues include drivability and idle issues. Also not that it matters but I have recently replace the cps sensor with a new one OEM of course but i don't think that has anything to do with this problem.
Ford Super Duty (1999-2016) :: F250 - Front Axle Needle Bearing Replacement
I own a 1999 F250 super duty and have the front end apart to service the u joints , I noticed that i have bad axle stub needle bearings on one side. I was wondering what is involved in taking those out and replacing them, it looks like they are held in place with some type of spanner nut. My next question :Would it be worth the cost just to replace the whole bearing hub assembly? The truck has 134000 miles on it.
View 10 RepliesFord Super Duty (1999-2016) :: Changing Instrument Cluster - Removal And Installation Of Needle?
I will change the cluster lights to blue LEDs.
Some "leftover" questions:
How do I get the needles "clear" instead of red?
How to remove and reinstall the needles the "right way" (e.g. calibration)
Everything else I could find here in different posts.
Ford Super Duty (1999-2016) :: Gauge Needle Drops To Below E / Fuel Light Comes On And Beeps
Got to work this morning, sitting at idle for a few minutes in parking lot, all of a sudden fuel gauge needle drops to below 'E' and the fuel light comes on and beeps. I know I have at least 1/2 tank of fuel. What would cause this?
View 3 RepliesFord Super Duty (1999-2016) :: Takes Longer To Start And Needle Doesn't Move Until After Motor Started
It used to be, if I remember correctly, that while turning the key on a cold start the oil pressure gauge needle would show pressure prior to the engine starting, now it takes longer to start and the needle doesn't move until after the motor has started. I had the O-ring kit replaced due to oil leakage, and I wonder if there is an issue with the system. N to watch as they deedo their cold start today...
View 4 RepliesFord Super Duty (1999-2016) :: 22K With Hubs In Locked Position
Its a 2016 F-250, 6.2L gas truck with the electronic shift on the fly transfer case.
I have put right at 22,000 miles on it like this, frequently at 70-80 mph.
What are the odds I have damaged it and is there anything I should do now that I discovered it - other than put them both in "AUTO".
Truck has been to the dealer twice and not once was this noticed. They blamed the squealing on the brakes which I knew it wasn't.
Ford Super Duty (1999-2016) :: No Power In Accessory Position
When the key is switched to the accessory position, none of the things that are supposed to work in accy do. It's been like that ever since I bought the truck, but I never gave it much thought. Other than look for bad wiring, I really haven't tried anything. Where should I start?
View 6 RepliesFord Super Duty (1999-2016) :: Steering Wheel Wobble In Any Position
My truck has developed a wobble in the steering wheel. I don't mean when you are driving down the road, but the steering wheel wobbles around. It wobbles in any position that the Till shaft is set to. How to repair.
View 10 RepliesFord Super Duty (1999-2016) :: 2003 - Second Position Of Blower Switch Does Not Work
I have an '03 F250 and the second position of the blower switch doesn't work. The first, third, and fourth are all fine.
I bought a Motorcraft YH-1670 blower switch, but can't figure out where it's located?
I looked behind the glove box, but didn't see it there. I did not remove the screws to the cover behind the glove box because I wanted to first confirm where the switch is located.
Ford Super Duty (1999-2016) :: P0014 - Exhaust Camshaft Position Timing
Seems like a real problem and not just emissions related. The truck seems to run fine; no abnormal vibration.
Seeing the dealer on wednesday and was supposed to leave for a 2 month trip on sunday.
Bad to go sunday anyway and wait for a dealer on the road?
How likely is it that the dealer will have this fixed on wednesday same day?
Ford Super Duty (1999-2016) :: 2009 F250 - Wipers And Headlights Came On When In Off Position
2009 F250 lariat. While driving down the highway my wipers came on when stalk was in the off position. They would not shut off. Had to remove the relay to get them to shut off. Also, during middle of a sunny day the headlights would temporarily come on and shut off when it was in the automatic position. They would not come on if I put it in the off position though. Since both the wipers and high beams are part of the multifunction switch is it likely that the switch has gone bad vs. a more major issue with the computers. No other issues identified.
View 1 RepliesFord Super Duty (1999-2016) :: 1993 F350 - Clutch Position Switch Fault?
I'm getting a random 'no start' fault which I think is related to a clutch position switch. The dealer tells me the clutch pivot bushing and master cylinder push rod are worn out, which is causing the switch not to close when the clutch pedal is depressed.
1993 F-350 7.3L Diesel 5 Spd 4x4, Std Cab, 8 Box.
Ford Super Duty (1999-2016) :: 2008 F250 - Wipers Came On With Switch In Off Position And Won't Stop
I have a 2008 f250 with 6.4. Was sitting my truck with key on and motor off listening to radio on lunch and my wipers came on by themselves. Switch was in off position and we're in slow speed. If I turn switch they wouldn't change speed til high position. Turned key off and back on and they came on still. Pulled 30 amp fuse in battery junction box to shut them off.
View 3 RepliesFord Super Duty (1999-2016) :: Absolute Silence When First Turn The Ignition Key To Start Position
On my class C motor home, 1999 with V10 engine when I turn the ignition key to the start position I get absolute silence, when I release the key and turn it to the start position again it always starts. I have fitted a new starter motor, new solenoid and new battery but still the problem persists. I'm scared that one time it will not crank over on the second attempt.
View 10 RepliesFord Super Duty (1999-2016) :: Key Won't Move To Off Position After Cylinder Lock Removal And Installation
I have a problem with an 2000 F250 7.3 6spd. Recently, the "key in the ignition" chime kept dinging even when no key was in the ignition. I read in the forums that a wire can be disconnected to stop the chime. The problem is that after I re-install the cylinder lock, I cannot move the key to the off position to remove the key. I can rotate it to start and run, but it won't move backwards to the off or acc position.
The truck has this little lever that normally needs to be pushed to allow key to be released, but even after pushing that, turning the steering wheel back and forth, and messing with the tilt, I still can't get the key into the off position. I have removed the cylinder and it looks good. It rotates properly and I can remove the key, but only when it isn't installed. I tried replacing the ignition switch, but the lock cylinder still doesn't move.
I have an 04 F250 that I've tried swapping the lock cylinders from the 04 to the 00, but it still doesn't turn. What might be the cause/fix? Also, the 2000 F250 has a intermittent chirping/squeaking sound under the dash that happens even when the batteries are disconnected - might this be a malfunctioning vacuum motor? It happens even though the truck hasn't been driven for a week.
Ford Super Duty (1999-2016) :: Wiper Park Position Incorrect / Stop A Little Higher On Windshield
2015 F250 and I'd like to have the wipers stop a little higher on the windshield causing the ice build up. Previous trucks I could pop the wipers off and rotate them and put back on. These are keyed so I can't. Any trick?
View 5 Replies