Ford Super Duty (1999-2016) :: 2001 F250 - Tachometer Intermittent / Jumps Up And Down Some Of The Time
The tach in my 01 F250 PSD has become intermittent. It works properly some of the time, not at all some of the time, and jumps up and down some of the time.
Does it get it's signal from the CPS? It has a blue CPS that's about a year old and the truck runs fine?
Ford Super Duty (1999-2016) :: 2001 - Speedometer Won't Working
my speedo doesn't work but, all the other gages do. I just replaced the front hubs, abs sensors, ball joints etc... I put a new sensor in the rear end this morning and still nothing isthere a fuse tied to this somewhere? am I missing something? it's a 5.4l with a 4r100
View 8 RepliesAccent LC (2000-05) :: Speedometer Needle Jumps All Over The Place
When the weather is rainy or just very humid, the speedometer needle in my 2000 Accent jumps all over the place. According to the service dept. at my local dealership it is most likely the speed sensor causing the problem.
View 1 RepliesFord Super Duty (1999-2016) :: 2001 - Speedometer Jump To 12 MPH While Stopped With Foot On The Brake?
2001 PSD ... Had speedometer jump 20 km's (12mph) while stopped with foot on the brake? This has been happening on my 2001 PSD intermittently for the last couple months.
View 1 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Speedometer Stopped Working And Overdrive Light Flashing
I have a 2001 F250, 5.4, 4X4. My ignition key stuck in the start position and when I pulled it back to the run position, everything seemed ok. As I started down the road, my speedometer stopped working and my overdrive light was flashing. Also my turn signals had stopped working and my A/C clutch didn't engage. Figured I burnt a fuse. I looked in both the under dash and power distribution box and all seemed well. I checked the fuse for the turn signals/flasher and it was fine. The flashers worked. Thought I might have fried something so I replaced the ignition lock and switch. Also my service engine light came on throwing a code for the vehicle speed sensor.
Looking for solutions on this forum and the internet, I learned that the turn signal switch could have gone bad and the VSS sensor is on the top of the rear dif and an easy fix. Well replaced the sensor but nothing changed. So I went back to the fuse box. Examined every fuse, big and small and I found a 10a with a small space. This was #24 under the dash. From the manual, "#24, 10A, A/C clutch, Blend Door Actuator, Trailer Tow Battery Charge Relay Coil, Four Wheel Anti-Lock Brake System (4WABS), Turn Signal." Replaced it and everything went back to normal. Turn signals work, A/C clutch works, no flashing overdrive light and speedometer works. All from a 10A fuse. If you have any of these symptoms examine all the fuses carefully. There's a 20A fuse for turn/hazard lamps and this other one buried that's only 10A.
Ford Super Duty (1999-2016) :: 2006 - Vibration / Jumps Up And Down At Certain Speeds
I am yet another sufferer of the 40mph vibration syndrome I commonly read about on this site. I have had my 2006 f350 club cab sd to the dealership about 7 times for this, and now am being told it is a normal characteristic of this truck. They have replaced wheels, tires, vibration machine analyzed, put on a vibration damper, etc., but nothing fixes the problem. It has done it since the day I drove it home.
How many of you out there are upset about their super duty that jumps up and down at certain speeds? Lately, my dealership has had my truck more than me. From the amount of posts I see about this problem, I am certainly not alone. Ford is now trying to brush me under the carpet, yet I have a truck with a built in gyrator that is totally unacceptable. The truck now has about 20,000 miles of bouncy misery on it, and it isn't getting better.
Ford Super Duty (1999-2016) :: Gear Position Needle Not Working?
05 F250 FX4
Gear position needle (little orange line for an automatic) isn't working. It stays in the 1st gear position.
Tired of counting the "clicks" to know which gear I am in. How hard is this to fix?
Ford Super Duty (1999-2016) :: 2003 F250 - Idles For 4 To 5 Minutes RPMs Jumps Few Hundred?
My 2003 F250 6.0 It started about a month ago and got worse. Let truck idle for 4-5minutes and idle will jump a few hundred rpms. Got worse as it idles and cant figure it out. It eventually died and died once while driving but starred right back up.
View 1 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Tachometer Needle Will Not Always Move The Way It Supposed To
Just had a question about my 00 F250 7.3. I recently have noticed that my tachometer needle will not always move the way its supposed to. Sometimes it will sit at zero until I drive it for a min then all of a sudden pops up to where its supposed to be. I also noticed today that while i was driving it just dropped to zero for a second or two then back up to where it was supposed to be again.
When it does this there is no drivability issues with it or idle issues what so ever. Which is strange to me and I cannot seem to put my finger on what could be causing the issue. As I have searched online for a while to no avail as most of the other issues include drivability and idle issues. Also not that it matters but I have recently replace the cps sensor with a new one OEM of course but i don't think that has anything to do with this problem.
Ford Super Duty (1999-2016) :: F250 - Front Axle Needle Bearing Replacement
I own a 1999 F250 super duty and have the front end apart to service the u joints , I noticed that i have bad axle stub needle bearings on one side. I was wondering what is involved in taking those out and replacing them, it looks like they are held in place with some type of spanner nut. My next question :Would it be worth the cost just to replace the whole bearing hub assembly? The truck has 134000 miles on it.
View 10 RepliesFord Super Duty (1999-2016) :: Changing Instrument Cluster - Removal And Installation Of Needle?
I will change the cluster lights to blue LEDs.
Some "leftover" questions:
How do I get the needles "clear" instead of red?
How to remove and reinstall the needles the "right way" (e.g. calibration)
Everything else I could find here in different posts.
Ford Super Duty (1999-2016) :: Gauge Needle Drops To Below E / Fuel Light Comes On And Beeps
Got to work this morning, sitting at idle for a few minutes in parking lot, all of a sudden fuel gauge needle drops to below 'E' and the fuel light comes on and beeps. I know I have at least 1/2 tank of fuel. What would cause this?
View 3 RepliesFord Super Duty (1999-2016) :: Takes Longer To Start And Needle Doesn't Move Until After Motor Started
It used to be, if I remember correctly, that while turning the key on a cold start the oil pressure gauge needle would show pressure prior to the engine starting, now it takes longer to start and the needle doesn't move until after the motor has started. I had the O-ring kit replaced due to oil leakage, and I wonder if there is an issue with the system. N to watch as they deedo their cold start today...
View 4 RepliesFord Super Duty (1999-2016) :: Speedometer Won't Working?
I just bought a 99 f250 sd 5.4. The speedometer doesn't start working until it reaches about 30 mph. The transmission doesn't shift correctly until the speedometer starts working. I cleaned the speed sensor on the rear end but that didn't work. I don't see any sensors or switches on the tranny other than the neutral safety switch. What it is?
View 3 RepliesFord Super Duty (1999-2016) :: Speedometer Stops At 54 Mph
On my '99 F250 PSD 4x4 the speedometer climbs very smoothly (normal) until I hit 54mph and then it just stops going up. Reviewing other posts I have changed the DSS (differential speed/ABS sensor) and the VSS (tranny speed sensor). Disconnected both batteries for several hours to see if it would clear.
Doesn't bounce, peg, go to 0, just won't go past 54mph. No power loss. Tach continues to climb and speed continues to increase. No strange symptoms except this 54mph thing. It is completely repeatable. All fuses under the dash and hood check out ok.
Ford Super Duty (1999-2016) :: Speedometer Is Accurate To Within 1 Mph Or So
I've got a 99 F-250 7.3 with the 6 speed manual. My speedometer is accurate to within 1 mph or so. However when compared to a GPS unit, my odometer is off by about 50%...meaning it registers approximately 1 mile for every 2 traveled.
I was under the impression the mechanism that results in the speed being displayed is the same one driving the odometer and therefore if one was off, the other would be (conversely, if the speedo is accurate, so would be the ODO). How do I resolve this issue?
Ford Super Duty (1999-2016) :: Speedometer Stops At 40 Mph?
I bought a 1999 Superduty 7.3 6 speed and went out to drive it yesterday and noticed my speedometer stops working at 40mph. I saw many posts about this but no fixes. Bad cluster or vss? No abs light on dash. Still runs and shifts good. Only one yellow airbag light illuminated on dash...
View 9 RepliesFord Super Duty (1999-2016) :: Speedometer Not Working At Any Speed
For a 99 F250 7.3 with 6 speed manual..my odometer goes around but the speedometer does not work at any speed. A mechanic said he thinks the problem is in the gauge cluster but I would like to know where to start troubleshooting.
View 2 RepliesFord Super Duty (1999-2016) :: Speedometer Fail With ABS Light On
1999 superduty 7.3 standard ... As I said speedometer fail with abs lite on. When ambient ten above 85F, speedo works abs lite out and cruse control works.
View 1 Replies