Ford Super Duty (1999-2016) :: Front Axle Seal Leaking?
I noticed the other day after my truck was parked on a bit of a angle there was diff oil from the passenger side on the ground. reading a bit on here i learned the axle seals are way in the front housing close to the front diff. and yesterday driving a heavy load around my front brake driver side got stuck on a bit and over heated and was smoking, couldn't even touch the rim it was so hot. anyway about this axle seal i got the hub off right now but cant seem to pull out the axle assembly through the knuckle but i see i have to pry and most likely wreck that seal. Looking for a link of piuctures or how to replace the axle seals in the housing.
View 11 RepliesFord Super Duty (1999-2016) :: Right Front Axle Seal Leaking Continuously?
99, F250, 4X4, V10, 72,000 miles. I have had the front axle seals replaced three times in the past 3000 miles, and the right continues to leak. My mechanic screwed up three times?
View 6 RepliesFord Super Duty (1999-2016) :: 2011 F350 - Pinion Seal Leaking?
Pinion seal on my truck is leaking. At auto parts store they gave me National seal part number 4278. It does not fit it is too small.I went back and other seal they have is too big. What is the part number?
View 11 RepliesFord Super Duty (1999-2016) :: Sunroof Leaking / Entire Seal Inside Is Damp
I have my 03 F350 which unfortunately has a sunroof...which now appears to be leaking. Around the entire seal inside is damp about 1/2" out into the headliner. I looked up top and didnt see anything out of the ordinary..but the back of the sunroof is flush with the roof and the front is about 1/4" down, and if you press on it...it sinks about another 1/4". My questions here are...how do i fix this leak, is there a seal that needs to be replaced? and is that play in the sunroof normal or is something wrong?
View 8 RepliesFord Super Duty (1999-2016) :: Rear Hub Outer Oil Seal Leaking / Replacement Part?
The rear hub outer oil seal on my 05 350 is leaking. The 350 Super Duty Twin Cab was never imported into the UAE so can I use the same seals as the Excursion or another Ford vehicle?
Failing that do we know the name and part number of a seal manufacturer whom I might be able to source from in Dubai? Ford don't make the seals them selves so there must be an alternate source for these things surely?
Ford Super Duty (1999-2016) :: F250 - Engine Rear Main Seal Leaking
Changing out the rear main oil seal on my 1999 F250 Super Duty. I have a 7.3L diesel with 6 spd manual trans. with 98K miles. This past week it has developed a very slow engine oil drip where the engine meets the transfer case. Is it necessary to remove the engine or just the transmission? What does a transmission/transfer case combo weigh? What special tools would I need?
View 1 RepliesFord Super Duty (1999-2016) :: Overfilled Transfer Case Or Leaking Transmission Output Seal
I just changed transfer case fluid on my father's F-350 for the first time in 13 years. (over 230k). Removed fill plug first and fluid gushed out of the fill hole unexpectedly. Did not have catch pan ready, so made a mess. I thought it was just over filled form the factory, but too much was coming out to be simple overfill. Almost 2 qt came out of the fill plug.
Did some google search and found many Ford trucks have failed transmission output shaft seal and transmission fluid leaks out to transfer case, causing transfer case to overfill. I am yet to check transmission fluid level, but considering how much came out of it that probably is the case.
Now, how bad of the problem this really is? Will overfilled transfer case cause some serious problem? 4x4 is rarely used (once or twice a year in winter) on this truck and from what I understand transfer case doesn't really do anything in 2WD other than just passing output from transmission through.
There are no fluid leaking outside and repairing the seal would be a too much of work for me.
Also changed rear differential fluid for the first time and I was surprised how clean the fluid was. There were thin layer of black sticky residue (sludge?) covering everything, but the fluid itself looked clean and no visible metal shavings. I guess that is why Ford said it does not require change under normal condition.
Ford Super Duty (1999-2016) :: 2009 F250 - Rear Diff Fluid Change / Pinion Seal Leaking
I just picked up an 09 F250 a couple of weeks ago and I was planning on replacing all the fluids since I'm not sure when everything had been done in the past, but it did pull a camper 5th wheel. It has about 93000 Km/57000mi on it
One thing I noticed when reading the manual is that a rear diff fluid change is not necessary on these rear axles unless they have been submerged in water or repaired etc..
Just after I got it I noticed the pinion seal was leaking. It was fixed under warranty but the dealer did not replace the diff fluid as they said Ford will not pay for it.
My question is do you think I need to replace the diff fluid or should it still be good, given the relatively low mileage.
Ford Super Duty (1999-2016) :: Right Front Axle Seal Continues To Leak?
99, F250, 4X4, V10, 72,000 miles. I have had the front axle seals replaced three times in the past 3000 miles, and the right continues to leak. My mechanic screwed up three times?
View 10 RepliesFord Super Duty (1999-2016) :: Installation Of New Outer Dust Seal - Use 3 Jaw Pulled?
Earlier this week I pulled out my right axle shaft and found the outer portion of the Spicer two piece seal attached to the axle, the part number on the seal is 52148. The axle tube is dry, no signs of the seal leaking. I need to remove that seal from the shaft to install a new outer dust seal. Can that seal be removed with a 3 jaw pulled then get reinstalled, or can I get a new 53148 and install that portion with out removing the carrier. I am not set up where I sit right now to pull both axles.
View 2 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Rear Hub Seal Leak?
I have a 2000 F250 4x4 7.3 - About a month ago I drove across town and then noticed a strong hot brake smell from the rear of the truck. When I drove home about 2 hours later it was gone and didn't return until today. Today I stopped at a light with my window down and got the same hot brake smell, looked in the mirror and saw smoke coming from my drive's side rear wheel.
I carefully drove home (the smoke was now gone, all i did was cycle the parking brake release a couple of times) and pulled the wheel off. Rotor was really hot but smooth and clean. Brake caliper and pads looked great (no sign of the pads glazing or dragging, dry as a bone). The inside of the rotor was wet with oil. The brake shoes and components were soaked with the same fluid/oil.
Does this sound like a typical hub seal issue? Excuse my ignorance since I haven't had the rear hubs apart before but does the gear oil in the rear diff go into the axle tubes? I know the front tubes are dry but I didn't know if the rears are different. The amount of fluid on the brakes seems to be more than the little bit that is inside the hub. I need to pick up the parts and rent/purchase a couple of tools to replace the seal so I want to be as sure as possible that I'm on the right track...
Ford Super Duty (1999-2016) :: 2003 F250 - Knuckle / Axle Seal Replacement
Replacing the knuckle/axle seal due to my hub not holding a vacuum. I finally got the seal off the axle after several minutes of beating, but it finally came off. During the beating the metal shield that was in back of the seal took a beating as well and can not be reused. Is it really needed?
In this thread the pictures show that the shield was not installed after the seal was replaced. The shield does serve a purpose to keep crap out of the seal though.
Ford Super Duty (1999-2016) :: 2003 Excursion - Outer Axle Seal Installment
Do I need a special tool to put the outer axle seal on a 2003 excursion? I could make one if I new how far down it needs to be. I'm replacing the needle bearings in the back of the hubs and it looks like the last seals were not on far enough and the hub tore them up....
View 13 RepliesFord Super Duty (1999-2016) :: Slow Leak Coming From Rear Main Seal
If I use ATP AT-205 stop leak to stop a slow leak coming from the rear main seal, will it last a long time? And if it stopped working eventually, would adding more stop the leak again?
Also, I'm going to have the transmission out anyway, so how many hours would it probably take to just replace the seal at that point? And someone told me some seals were two halves that fit together as one, and others are just all one piece. Is that true? It would seem to me that a two piece seal like that would start leaking prematurely.
Ford Super Duty (1999-2016) :: Parking Brake Not Working - Burning Axle Seal?
Will leaving the parking brake on burn up the axle seals? My parking brake isn't working well at the moment. I need new ones from all the fluid my bad seals leaked on them. So, at the moment they just scrub a bit while its engaged. However, today I found out that my parking brake light for one reason or another is not working and I got in a hurry and didn't release the brake. by the time I got to where I was headed (about 15 miles), I could smell gear fluid burning and my driver side rear was smoking. I'm hoping its the fluid that was already soaked into the shoes. I did find a drop of fluid on the bottom of my brake caliper.
View 5 RepliesFord Super Duty (1999-2016) :: Rear Wheel Seal And Bearing Part Number Check
Replacing the backing plates on my rear end, figure get new inner bearings and seals in there. Bearings seem fine but cheap insurance, dont wanna pull it all off again.
When i pulled my hub off, the hub seal stayed on the housing shaft, this is normal? Just gotta pry it off there somehow?
Then new seal-TIMKEN 370247A just tap it into the back of the hub? Also is this the right inner bearings? TIMKEN NP114036
Ford Super Duty (1999-2016) :: 2001 F250 - Transmission Leak - Replace Bearing / Seal?
I have a 2001 F250 Super Duty 5.4 Triton motor with a Transmission Leak. I have drained the Transmission, replaced the Transmission pan gasket and filter. The auto parts store also had me purchase the Torque Converter bearings/seal along with enough transmission fluid and a bottle of Lukas Transmission fix. Do I really need to replace the bearings/seal if I have everything else already ?
View 2 RepliesFord Super Duty (1999-2016) :: 2015 F350 - Rear Axle Pinion Seal Leak
I was looking underneath the truck yesterday and saw that the rear end pinion seal was leaking. Looked like it had been for a while. Truck has 35,850 miles on it. Unscrewed the fill plug and a lot of pressure is released. So I'm assuming the breather is clogged somewhere along the line. I have an appointment at the dealer on Friday to see whats wrong. What is supposed to be at the end of the breather tube? Mine has a barbed 45ish degree fitting on the end of it. Its a SRW by the way.
View 5 RepliesFord Super Duty (1999-2016) :: 2006 - Run 10 Miles Then Die With No DTC?
I have an 06 6.0. I have replace icp and ipr. I had a car tube with an hole so I replaced the tube connectors. No dtcs are present. The truck will crank and run fine but after thirty minutes of running it dies, it dies faster if I put it in gear and drive it, if I move it back to neutral it starts running ruff and I lose throttle response sometimes completely and sometimes on a minute or two. I also fixed a fuel leak around the 6mm plug on pump, replaced both fuel filters.
View 8 Replies