Ford Super Duty (1999-2016) :: F350 - Rear Sits Lower Than The Front

Bought a new truck and had the dealer put a leveling kit (readylift 2.5" kit) on it with bigger tires. The rear now sits lower than the front. Any way to fix this? I want the truck to sit level as much as possible loaded and unloaded. New 2016 F350 KR

I added a pic ....

View 14 Replies

Ford Super Duty (1999-2016) :: Front Axle Sits Out / Gas Pump Always Shutting Off When Filling Up

Just wondering if its normal that my front axle sits out about 1 1/2 inches further on the drivers side than the passenger, also gas pump always shutting off when filling up...

View 6 Replies

Ford Super Duty (1999-2016) :: F250 - Gas Sits Lop Sided

Very noticeable not like things i read on about .5-1" this is like an inch and half to two inch on driver side front and rear... Looks like the bed is twisted but its not frame is intact and by a level sits good... Same in front end. Since there is no coil springs could this be related to the leaf springs or maybe rust caused something I am not seeing to break and give way....this gangsta lean has to be fixed....

View 10 Replies

Ford Super Duty (1999-2016) :: Truck Won't Start After Changing Front Shocks

Last night was changing front driver's side shock on my 2011 F250 PSD. Right front wheel still on ground and needed to turn wheel to right to better access shock mount. Started truck and turned the wheel all the way to the right and took the key out thinking the wheel would lock and I could change the shock easier. But the wheel didn't lock and actually spun itself almost a full turn after I took the key out...I'm assuming because the right wheel was still on the ground providing resistance, but I think the wheel lock may have broken.

Finished the shock and went to start, but nothing. Everything is clicking and buzzing like normal but wouldn't turn over. Checked all fuses that seemed pertinent but none were bad. Wasn't able to check any relays. Gave up and was going to have it towed.

Son and I had to straighten the wheel so I could roll in down the driveway and the dang thing started after the wheel was straight! Thought it was a fluke and parked it. This morning did the same thing so I cranked the wheel to the right and it started again. Now at work and thought I better check again and I can't get it to start for anything. The steering wheel lock seems to be busted and now I'm thinking it could be something in the steering column, but this is a little above my pay grade.

Need to get home tonight and was hoping my description would be enough to make a for sure diagnosis. Otherwise its getting towed to the shop and I'd rather fix it myself if i can.

So went back out and tried starting in neutral again, but this time fiddled with the shifter while turning the key...nothing again. Ran it up into park and tried it again and it started! Last night and this morning I didn't mess at all with the shifter, just manually turned the wheel with the engine off. This is the first time moving the shifter worked and I didn't turn the wheel at all this last time.

View 6 Replies

Ford Super Duty (1999-2016) :: Shaking And Grinding From Front Driver Side Of Truck

My truck has an intermittent shake with a grinding/binding kind of noise. It seems to happen at lower speeds, generally when slowing down and turning. When I apply the brakes or speed up it seems to stop the noise.

The rubber/plastic seal on the back of the wheel hub is loose on both drivers and passenger side but I don't think that is the problem. I'm wondering if it is the u-joints or something.

The brakes look shiny and i don't see any scratches on them so I don't think there is a rock or something in there. I have the wheel hubs in the auto setting, and it is a 4x4. The truck is a early 99 7.3L with a leveling kit and 230k miles.

View 4 Replies

Ford Super Duty (1999-2016) :: 2007 F350 4x4 - Popping Coming Of The Front End Of Truck

I have an 07 350 6.0 was plowing last night toward the end of the night i herd a popping coming off the front end of the truck. My esof does not work so I manually lock the hubs and then turn on the 4x4 from the dash when I want 4x4, ok so after the few pops I heard while slightly turning I straightened out and all seem ok till I pulled outta the parking lot started driving and i had a noise kinda sounded like driving on a flat while at speeds at around 25-35mph so I got out unlocked the hubs drove it and it drives fine unlocked. so what I've done so far is while hubs unlocked climbed under it spun the front driveshaft by hand and spins freely. When the truck is rolling with no issues i locked the hubs left the switch in 2wd turned the wheel and started to make a turn and POP loud and shakes the truck violently it feel likes the steering and the truck is binding when trying to turn.

View 4 Replies

Ford Super Duty (1999-2016) :: Snow Plow Package Makes Front End Of Truck Sit Higher?

I have an f350 and it came with the snow plow package, does this make the front end of the truck sit higher? I was thinking about getting a leveling kit for it but when i measured there is only about 1 inch difference between the front and back.

View 8 Replies

Ford Super Duty (1999-2016) :: Left Front Caliper Is Not Squeezing Hard Enough To Stop The Truck Evenly

Having a problem with calipers again/still seems like always. Replaced all calipers twice in 86K miles on a 2000 f250 crew 4x4 because of stuck calipers. Replaced brake hoses and all hard lines in the rear about 2 years ago. My problem now is the left front caliper is not squeezing hard enough to stop the truck evenly. (pulls to the right) The rotor had some rust from sitting and after driving a for a while the rust is not completely gone as you would expect. Replaced caliper bled a couple of times. Caliper looks to be getting pressure enough to bleed and can see it move when brakes applied when engine not running. I don't have experience with Proportioning Valves but do you think that is the problem and how do I fix it?

View 8 Replies

Ford Super Duty (1999-2016) :: 2002 F250 5.4L - Whistling Noise From The Front Of Truck Until Engine Warms Up

I have a 2002 F250 with 189,000 miles. Im having some very bad issues that im trying to fix. The truck idles rough, with fluctuating RPM's. In certain speed reanges it also shakes and runs rough. If I turn the overdrive off the shaking pretty much stops, but it still accelerates pretty slowly. There is also a whistling noise from the front of the truck until the engine warms up, someone told me it sounds like a bad intake manifold? Does that sound right? What could be going on with my truck? All spark plugs and coil packs have been replaced, as well as the fuel injector rails.

View 2 Replies

Ford Super Duty (1999-2016) :: Truck Turns Over With No Key

Last night I was watching tv when my truck tried to start I thought I hit the remote start on my keys but it didn't start which I found weird. I went down stairs too see if it did anything else and it did it again it would turn over and turn over but never fire all while the keys are in my hand. At the same time the done light was stuck on and the radio went on and off. I'm pretty sure that my GEM got wet through the windshield, also Is the GEM dead or can it dry out and be ok

View 12 Replies

Ford Super Duty (1999-2016) :: Truck Will Bog Down And Sometimes Die When Put It In Gear

I have a 2001 f250 7.3L. I bought it with 192,000 miles and have driven it to 206,000 in the last 6 months. When I put it in gear, the truck will "bog" down and sometimes die. I will have to refill the transmission fluid every 2 weeks but I can't find where it's leaking.

View 4 Replies

Ford Super Duty (1999-2016) :: 2005 Truck Won't Shift In Or Out Of 4Hi

My 05 superduty is in the shop because it won't shift in or out of 4Hi. Ford garage says I need a new transfer case shift motor, and 4wheel drive module. They said the shift motor was full of oil. I am not really up to speed on how the shift motor works, other than it bolts externally to the transfer case, that's why it confuses me about the shift motor being saturated with oil. My truck has never leaked even a drop of any type oil, ever.

View 6 Replies

Ford Super Duty (1999-2016) :: F350 Truck Won't Go In Park

All the sudden got home and now my truck wont go in park. All other gears are fine. My PRNDL on dash has always been off for the last 3 years park has always shown as reverse its never affected anything! I already checked the torq. bolts and that was not it. My shifter is very sloppy so is my steering wheel. I found a 00 whole steering column with wheel and shifter but its not a early 99 will it work or fix my no park. The guy didnt know if it would fit early 99 or my no park problem.

View 2 Replies

Ford Super Duty (1999-2016) :: Truck Would Not Start - No Crank

Last night my truck wouldnt start. Drove fine all day, started up bunch of different times. Went to go home at night. No crank, everything else works, hear the fuel pump prime windows radio everything. smacked the starter a few times but no change. Checked the fuses and relays, all appear good. So im guessing the starter or the starter solenoid, but I cant find one on the truck just something that looks like it could be it attached to the starter.

View 9 Replies

Ford Super Duty (1999-2016) :: 2010 Truck Drifted To The Right

My 2010 6.4 has drifted to the right since I bought it a little over a year ago. I figured it just needed aligning, but knew I would soon have to buy tires so decided to wait and have it aligned when I replaced the tires. Put new tires on last week and had truck aligned but still drifts right. The guy at the tire shop showed me the print out from the alignment and all 4 wheels are within specs. He said he swapped tires around and it's better but still there. Not sure if he swapped front to back or left to right. After reading online, I found that this is a more common problem than I realized. I don't want to screw up a brand new set of tires.

View 6 Replies

Ford Super Duty (1999-2016) :: Truck Lost Acceleration When Got Up To About 35 MPH

I drive a 2000 F250 XL Super Cab LB 2WD 7.3 Powerstroke. i drive like a grandpa. No rompin on the accelerator or anything. I was leaving the house got up to about 35mph and the truck lost acceleration. Motor still running fine. I coasted onto a side road. Put it in park, killed it, started it again and same thing. Will not go into drive at all. However will go into reverse just fine and accelerate in reverse. Desperately wanting my favorite means of transportation back!

View 14 Replies

Ford Super Duty (1999-2016) :: Truck Missing Bad After It Warms Up

One day after my mechanic replaced the heater core my truck started to misfire after the motor warms up and is under load. No codes and nothing pops up when hooked up to o a scanner. It's been cold in the morning and when I start it up it runs like a top. But after it warms up it start to miss a little, then it gradually gets worse especially when under a load at higher speeds. I thought it was a vacuum hose or something got left unplugged.

View 7 Replies

Ford Super Duty (1999-2016) :: How To Leave Truck Idling With No Key

Any such system in which they can take the key out of the ignition while leaving the vehicle running? I'd like to be able to do this for security purposes of my brand new 2015 250 if I have to run into a store or something of the like. I don't like the idea of leaving the key in the ignition and locking the doors as anyone could break the window and drive off with the truck.

View 7 Replies

Ford Super Duty (1999-2016) :: Getting A Shake Throughout The Entire Truck Above 50 MPH

Removing oem aluminum for oem Steel wheels. After going through two sets of tires, having driveshaft rebuilt for no reason, new shocks, new rotors and pads, I'm 100,000.00 percent positive one of the aluminum wheels is out of round. From 50+ MPH I start getting a shake throughout the entire truck, faster you get it gets a little worse. I can't feel it in my steering wheel though? And if I rotate tires it stays the same, my buddy is giving me a really decent set of steel wheels from his 2003 xl f250 work truck and the local powder coat shop told me 100 per Tire for sand blast primer and then my choice of powder coat. Steel will always be stronger and run truer than aluminum and winter shouldn't be a problem since I do upkeep my vehicle. OR just buy a 16x10 aluminum wheels and FINALLY do my 4" lift with 35's and sell my almost new 285 tires...

View 7 Replies