Ford Super Duty (1999-2016) :: 2000 - Front Axle - Hub Makes A Slight Metallic Grinding Noise About 1/2 Way Around
I am in the process of replacing the front hub seals so my ESOF works again. I tested both front hubs with a mityvac and neither one of them holds any vacuum at all. All the lines are good, and the pump and solenoid seem to be working fine.
I have the driver's side apart and I have a couple of questions.
What's a good source for the vacuum seal? I've checked rockauto, riff raff, and diesel o-rings. Diesel o-rings has it, but the description says it's only for 2003+ Excursions so I didn't order it.
There is no yellow o-ring anywhere on the hub. I assume that someone forgot to put this o-ring back in and this is why I don't have ESOF? I guess what I really want to know is that there isn't some 2000-specific thing where there's no o-ring, right?
After I got the hub off, I spun it around on my workbench and it doesn't sound good at all. It makes a slight metallic grinding noise about 1/2 way around. I assume this isn't normal? AFAIK these are all original parts - but the missing o-ring means to me that someone already had it apart.
There was a lot of water intrusion and rusty colored grease but nothing was dry, the needle bearings were intact and the shaft isn't scored at all where the bearing rides. I'm hoping new seals and good cleaning and it should be good as new. And then it's off to the next side.
Ford Super Duty (1999-2016) :: Strange Pop Noise Coming From The Transmission Area
I've got a 2016 250 6.2l and am getting a popping sound coming from the transmission area. the following is what i have figured out so far. the noise is made just before a complete stop, just as the tranny down shifts to 1st and can be felt through the manual floor shifter 100% of the time and heard roughly 90% of the time. sound ranges from not audible to loud and is random in how loud it is. the only way it does not do this is if i come to a stop in neutral or i go slow enough as not to have the tranny shift out of first from my last stop. the only other way is if i do one of those long, slow rolling stops. truck only has 6600 miles on it. i will be taking it in at 7500 for first service and have them look at it ...
View 1 RepliesFord Super Duty (1999-2016) :: 2001 - Replaced Hub Bearing / Noise From Suspension Area?
I have a 2001 f250 v-10 4wd with 117,000 miles. I just replaced drivers side front hub bearing assy and not sure if it's the new bearing or what but now I keep hearing this crazy noise from suspension area. It has had bangs and pops for a while now. It almost sounds like abs motor going off but louder. Does it going slow fast or whatever. Brakes on or off. Trucks ball joints were done about two months ago and new shocks, trac bar replaced this summer only thing not done was tie rod ends and all bushings. Brakes are good new rotors and pads this summer also. It's like taking two inflated balloons and rub them together real fast. It may be the timken bearing maybe bad from get go.
View 14 RepliesFord Super Duty (1999-2016) :: Grinding / Rattling Noise In Clutch Or Trans Area
I have a grinding/Rattling noise coming out of the front area of the transmission when the clutch is disengaged (up), noise stops when clutch is pushed in. 99 (6/98) F-350 7.3, manual, 4x4, 192xxx mi. Just came out of the shop with the following done to it:
New Power Force clutch kit, twice.
Transmission Rebuilt twice.
Different rebuilt transmission.
Rear main seal r/r.
After first time in shop the noise was apparent. about 3,000 miles were driven with no change, brought back to shop, where transmission was gone through again as well as a new clutch set, same noise still present! Another transmission was rebuilt and installed, same noise!!!
Ford Super Duty (1999-2016) :: 2011 F350 - Buzzing Noise Coming From Dashboard Area
I've got a 2011 F-350, when i'm on the driving over 60 mph i hear this humming or buzzing noise coming from around the dash. It kind of comes and goes depending on the wind direction or if I'm passing a semi. Thinking it may be coming from around the windshield seal.
View 4 RepliesFord Super Duty (1999-2016) :: 2012 - Rear Suspension Blocks?
I have a quick question, but thinking of changing out my stock OEM rear axle blocks for the 2012 F350 SD 4x4 SRW type.
Does it matter what the wheelbase is?? Model being a CC, SC, etc?
Or...are all 2012 F350 SRW rear axle blocks the same?
Ford Super Duty (1999-2016) :: F250 - Rattling Noise Coming From Front Left Wheel Area
My 99 F250 has just recently started making a "rattling" noise. The noise sounds like its coming from the front left wheel area. The noise is constant while driving down the road, its NOT created by bumps or anything, its a constant noise while moving.
View 3 RepliesFord Super Duty (1999-2016) :: 2012 - Drive With Rear Driveshaft Removed?
I want to and went to buy a new 2012 F350 leftover - everything is good except that Ford.com says the truck was initially put into service In September of 2012 and therefore my warranty will expire in September of 2015 instead 2016.
Dealer says it's an error and will be corrected AFTER I buy the truck, so far I have been unable to get a straight answer from Ford.
Any information about being able ot change the original date a vehicle is put into service ?
Ford Super Duty (1999-2016) :: 2012 F250 - Rear Blocks Removal
I want to know if there are any issues when removing the rear block, also do I have to put a new block in or can I just leave it out ....
View 12 RepliesFord Super Duty (1999-2016) :: 2012 F250 - Rear Seat Removal?
I would like information how to remove the rear seat back on a 2012 F250. I want to remove the head rests and from what I can find out they are bolted solid to the rear panel. I asked the same question earlier and got a reply for 2011, would that be the same? Is there any place I could get a schematic, a picture is worth a thousand words.
View 5 RepliesFord Super Duty (1999-2016) :: Loud Knocking Noise Coming From Left Valve Cover Area Occasionally
I just picked up a 2001 F350 with the 5.4L with 200k miles. When I test drove the thing the engine sounded fine. I got it home and noticed that it occasionally has a loud knocking noise that is coming from the Left Valve cover area. It sounds like an old Chevy 6.5L Diesel ...
It comes and goes, Hot or Cold. It seems like it usually goes away when driving with RPMs above 1500 or so, however I took off with it yesterday and the noise would not go away, it seems like it might be low on power when the noise comes on, but then again it always feels low on power, so who knows.
I have changed the plugs, oil, and verified there are no exhaust leaks at the manifolds.
Here is a video of the noise: YouTube....
I dont think it is the timing chain, as it seems like its coming more from the center of the cover, when placing my hand on the cover near the timing set there is no vibration or anything that would lead me to believe its the chain.
All of my searching so far turns up 3V stuff, and little info on the 2V engines. The valve cover looks like a nightmare to get off, who have to work on these things (including me).
Ford Super Duty (1999-2016) :: 2012 F250 - Rear Heated Seats Won't Turn Off
2012 f250 diesel Lariat 4dr 4x4. He called me today cause he knows I do all the work on my own F250 diesel. He has heated seats in the back and he said that they turn on by them selves and they won't turn off. He had to actually disconnect the wire harness to get the heating elements to turn off so his wife's friends wouldn't burn their bottoms in the middle of august is Texas.. Any ways, he said both sides are staying on and wouldn't turn off using the switch.
I'm not very familiar with the heated seat wiring, especially for the back seats. I told him their may have been a relay that went bad, but now I"m thinking that they much have a controller or something that is acting up. He said that the front seats are acting normal. Also, he has the touch screen and navigation upgrade as well as auto climate control, not sure if this stuff matters for the back seats though...
Ford Super Duty (1999-2016) :: 2012 F250 - Rear View Camera Activation Wire?
I'm putting a new double din stereo w/ backup camera in my truck, I have everything wired except the violet/white wire (from the stereo) that needs to be hooked to a wire (on the truck) that will activate the camera when you put it in reverse. I cannot figure where this wire is on the 2012 for the life of me.
View 3 RepliesFord Super Duty (1999-2016) :: 2012 F250 XLT - Power Sliding Rear Window Install
I am trying to change out my solid back glass for a power slider that's oem... My question that ford could not answer is, is the wiring all in place minus the switch for the install.. I have a 2012 F250 XLT. I am not even sure where the switch to move the window would go either...
View 2 RepliesFord Super Duty (1999-2016) :: 2012 - Rattle Noise When Hit A Pothole?
So I drive a 2012 F250 6.2L and recently I've been hearing this rattling noise, kinda like a bag of washers being tossed about. I thought it was the snap brackets for the fog lights cause I removed my fogs and the brackets were loose enough to jingle so I zip tied them and it seemed like the rattle stopped, however, coming home the other day I hit a pothole and the rattle jingle noise happened again. I've checked most of the front end making sure all is tight which it is
Update: There were some lose snap bolts and brackets I'd missed so I took them off but no luck. I have come to the conclusion however the noise only occurs when the suspension is compressed. I figured this out by having my 300lb friend stand on the bumper and then I hit the coils with a mallet and I could hear the rattling noise and no I was not mistaking the coil vibration for the rattle noise.
Ford Super Duty (1999-2016) :: 2012 - Strong Wind Noise After 60?
I have a 2012 250 Lariat and seem to be experiencing a lot of wind noise. The noise doesn't seem to start until about 60 mph and then from there it gets much worse. If I am driving about 70 sometimes you can hardly carry on a conversation in the truck. I am wondering if this is normal for these trucks and if the noise usually comes from the windshield or the side windows, it is hard to tell where the noise is coming from here.
View 10 RepliesFord Super Duty (1999-2016) :: Driver Side Rear Brakes Making Popping Noise - Bad Rotors / Rear Wheel Bearings?
99 F-250 Ext cab 4x4 7.3 285,000 miles.
I got home today opened my door and got snaked in the face with the smell of brakes. I got out of the truck then I heard the drivers side rear brakes popping as they are cooling down. I reached down to touched the wheel and it's crazy hot. Opened the garage and went to retrieve the infared thermometer. The rotor/caliper was 350 degrees, hub was 150 degrees, axle tube was 90 degrees.
I took the wheel off and inspected stuff. The rotors do have some heat spots, the caliper visibly looks okay but not 100%. The pads look like even wear. I am guessing that the caliper either is hanging up or I have a wheel bearing going? The passenger side was like 80 degrees on everything. There is a slight shimmy while driving which to me feels to me like the beginning of warped rotors. I don't hear anything to me that screams wheel bearing noise wise.Brakes or bearings?
Ford Super Duty (1999-2016) :: Extra Metallic Rubbing Sound When Letting Off The Throttle
Got some snow tonight and was driving home from work around 35-40 mph in 4x4. You can tell that everything is engaged by the feeling and noise. Just not sure if this is abnormal. When letting off the throttle there's an extra metallic rubbing sound that goes with the drivetrain speed. Not sure if I'm just hearing the driveshaft from being in 4x4 of if something is up?
View 14 RepliesFord Super Duty (1999-2016) :: 2008 V10 - Consistent Metallic Buzz On Moderate Acceleration?
Over the past couple of weeks my truck has developed a pretty consistent metallic buzz on light/moderate acceleration. At first I thought it was a heat shield rattling, but I've been under it a dozen times and can't find anything loose to make the metallic buzz that I'm hearing... I can pound on several places in the exhaust system with my palm and it seems solid/connected everywhere. V10 truck??
View 6 Replies