Ford Super Duty (1999-2016) :: 2000 F350 V10 Engine Seems To Have A Miss
I have a 2000 F350 cab and chassis 4X4 with V10 and a 5 speed manual (actually it's a 4 speed with overdrive). My problem is the engine seems to have a miss in it. When I first start it in the morning it usually runs good for 5+ miles till it warms up then if I am not pulling a load I can hear what sounds like a miss but the truck accelerates fine. If I am pulling a load I can also feel a slight steady consistent shudder and I can tell the truck doesn't have the power it should and the gas mileage SUCKS worse than it use to.
I ran a bottle of Lucas deep clean through a tank of fuel and that seemed to work a little but I will still encounter the problem sometime during the day. When the miss seems to be gone I can hear a very slight pinging noise when I accelerate or pull a hill with and/or with out a load. The pinging noise I hear sounds like an engine with a distributor that is getting to much spark advance if you have ever experienced that before.
I purchased this truck used several years ago and I don't know what the PO did but the check engine light is not coming on and it doesn't throw a code. I put 10 new ford coil packs on it about a year ago so I really don't think it's a coil pack, but I could be wrong. To me it sounds like maybe it an injector problem????? I know there are several sensors on this engine and I am thinking maybe a crank position sensor is not working right but I honestly don't know???? Is there a way to test this sensor?
Ford Super Duty (1999-2016) :: 2000 F250 Miss Only At Idle
I have a 2000 F-250 V10 that misses (cylinder 10) at the idle, once you give it gas it runs correctly again. I am at a loss. I have replaced the plug, tried moving coils from one cylinder to another to see if it shifts the miss, and it has new injectors. What this could be?
View 9 RepliesFord Super Duty (1999-2016) :: 2000 F350 V10 No Cruise Control / AC Controls Are Not Powered
My 2000 F-350 SD 4X4 V-10 has no cruise control, and the A/C controls are not powered. Is it possible that both these power option circuits are run through a fuse link, and better yet, through the same fuse link? A/C has been troublesome in the past, but the cruise quit one day without warning. All fuses are good. Tried jumping the A/C pressure switch to recharge it, but no power is present.
View 4 RepliesFord Super Duty (1999-2016) :: 2000 F350 - Electric Vacuum Motor Stays Running
I have a 2000 F-350 diesel and the electric vacuum pump went out. I bought a new one from napa and it would not stop pumping. Checked for leaks and found none. If I unplug the hose from the vacuum can the next day, you can hear it suck air so it seems I am holding vacuum. Problem is I burnt out the new pump in two weeks from running all the time. Bought another one and same problem.
So now I plug the electrical in and let it build up vacuum for a couple of minutes and then disconnect it so it won't burn out and I am good for days on vent controls and 4x4. If there has been a bad batch of pumps out there? I also unplugged the hose from the pump to the holding tank and put my finger over where the pump sucks and it still did not shut off.
Ford Super Duty (1999-2016) :: 2003 V10 - Slight Miss With Pending P0171 Code
I just purchased a 2003 F250 Super Duty with the 6.8L V10 It has really high miles on it as it was a landscaping companies fleet truck. I'm sure that it was pretty well serviced as it has 300K miles on it and it's still running pretty decent.
I picked up the truck and I have to get the smog done soon. It idles with what I can only describe as a slight miss and it runs and drives great. seems to have plenty of power for the miles that's on it.
There is no active CEL on but I scanned the OBDII system and found a P0171 Lean bank 1 code in the pending codes list of the scanner. I guess this year engine doesn't have an EGR Valve or DPFE sensor because I've looked high and low for it and there non existent on this engine.
I've checked for vacuum leaks by spraying brake cleaner or carb cleaner all over the place and it makes no difference and all the vacuum lines and connections look okay.
When it's running It does sound like a vacuum leak right behind the top of the plastic throttle body but I can't find it, I don't know if this big *** engine just sucks that much air or what.
Like I said I need to smog this thing soon and I don't want it to fail if it's missing or has another issue. The fuel injectors look new and one coil pack looks like it's a replacement...
Ford Super Duty (1999-2016) :: 2002 V10 Won't Stay Running / Loss Of Power And Slight Miss
This last April I was towing my trailer back from camping approx 125 miles when I detected a loss of power and a slight miss. I managed to make it home. It wasn't until I made it home that the engine finally started coding. Miss on start, a couple of cylinders missing and output shaft speed sensor circuit failure. So naturally, I decided to do what I felt needed done anyways, change all coils and plugs. Oddly the problem got worse to the point where I almost didn't make it home after test driving it, it kept stalling out and was difficult to keep running.
After some research and advice from others, I started replacing some components; MAF sensor,IAC valve, output shaft speed sensor. Nothing. In fact now the truck wont move, I start it up it idles a little rough, but then I put it into gear and with in seconds she shuts her self down. I've replaced the fuel filter, checked the fuel pressure and it is in specs. I've now had it towed to two mechanics neither of which have any solution. They've put expensive computers up to it and still nothing. I really do not know what to do at this point. Lastly the only code that continues to come up is P0720, output shaft speed sensor circuit failure, I really miss my truck!
Ford Super Duty (1999-2016) :: 2006 F350 - Vacuum Leak When In 4x4
When I put my 06 f350 in 4x4 my ac defaults to defrost. I assume this means a vacuum leak. My question is, is the white tube supposed to be open for air intake or plugged off with something?
View 5 RepliesFord Super Duty (1999-2016) :: 2001 - Miss Over 2000 Rpm?
Got a 2001 F350 diesel auto, 295k miles.
It has miss when over 2000rpm. Below 2000 its smooth.
ICP has oil in sensor, ordered new one. Gonna change oil too.
CPS is new (not sure if its black or the other one). Starts idles and drives good otherwise.
Where should I look?
Ford Super Duty (1999-2016) :: 2004 F350 - Vacuum Pump Not Running
I have a 2004 F-350 diesel. My vent selector is always on defrost so I suspected a broken hose but traced all out and all seem to be fine. I disconnected the line coming from the pump to the tank and no vacuum. The pump doesn't seem to be running but it's hard to tell with the engine noise and vibration. What tells the pump to run and how can I bench check it?
View 8 RepliesFord Super Duty (1999-2016) :: 2005 F350 4x4 - Vacuum Hubs Won't Disengage
I have a 2005 f350 with the power stroke I went through the hole vacuum system all new hubs, seals, vacuum actuator and fixed it all now I'm having the reverse problems everyone has my hubs are locked all the time as soon as I plug in the vacuum actuator the transfer case is still in 2wd and will switch 4x4 and work and disengage but the hubs are always in unless I unplug the actuator ...
View 6 RepliesFord Super Duty (1999-2016) :: 2005 F350 - No Horn Or Steering Wheel Controls
I have a 2005 f350 lariat 6.0. My horn, cruise volume, heat and fan controls on the wheel are not working. The airbag light isn't on. I am thinking that it's the clock spring. The stereo controls were intermittent for a while so I think it's the clock spring. I just want to be sure. Anything I could check?
View 2 RepliesFord Super Duty (1999-2016) :: 2002 F350 - Windshield Wiper Controls Not Working?
On my 02 f350 xlt my turn signals work but not my wiper speed switch, when i put the small fuze in, the wiper go full speed and wont stop unless i pull the fuze out... What could be wrong?
View 3 RepliesFord Super Duty (1999-2016) :: 2005 F350 - Vacuum Leak - Manual Locking Hub?
So I have an 05 f350 5.4 with the shift on the fly and the auto/manual locking hubs.. I already know I have a leak with the vacuum and I just use the hubs manually, then shift on the fly to activate the transfer case.
I went to use the 4wd the other night in a snow storm and I have no 4wd, light on the dash comes on and i can hear the transfer case clicking in when i hit the switch between 2wd and 4wd.
So I got under the truck while it was on the ground and manually locked the passenger side, Then tried spinning the axle and it wont spin freely, so obviously its locked.
Tried the same thing on the driver side and the axle spins freely while the hub is locked, So obviously the locking part of the hub is no good... So i guess my question is, even with just 1 wheel locking in the front, shouldn't I pretty much get 3wd? or am i missing something...will it not engage at all because both sides arent locked?
Ford Super Duty (1999-2016) :: 2008 F350 6.4L - Vacuum Pump Continuously Running
I have a 2008 F350 FX4 with the 6.4l diesel, a couple weeks ago I was reprogramming the ecm and noticed the vacuum pump was running and wouldn't stop, so after a bunch of reading and testing i changed the solenoid vacuum valve. I tested all the vacuum lines and found no leaks.
View 3 RepliesFord Super Duty (1999-2016) :: 2004 F350 - No Stop / Turn Signal?
2004 F350 6.0 Diesel 2WD, Question is my trailor lights running lights work fine also the electric brake, but i have no stop or right or left turn signals the truck signals are all working perfect. The truck came with factory wiring i have checked it at the plug on the bumper with meter to make sure it was not the trailor. Looked for blown fuses and cant find anything what am i missing it should have seperate fuses for trailor lights ??
View 14 RepliesFord Super Duty (1999-2016) :: 2000 F250 V10 Truck Started To Have A Miss Under Normal Acceleration
Question, my truck started to have a miss under normal acceleration, when I really get on it, it clears up? I also noticed a bad sulfer smell at idle. Im thinking the cat is possibly plugged? Truck had 172000ish on it, and the cat is original. I did do a big tune up this past fall, new plugs, coil packs, air and fuel filter. Should I put a new cat on it? And a new oxygen sensor?
View 9 RepliesFord Super Duty (1999-2016) :: 2010 F350 - Reverse Gear Signal Wire
I installed a reverse camera to my new Pioneer in-dash nav head unit this morning. I wired (at the rear of the truck) the power signal lead to the reverse wire at the trailer connector. I also need to wire a reverse signal input into the back of the head unit. I really do not want to run a power lead from the rear of the truck to the cab. Is there a wire under the dash I can tap into, or could I use the wire going to the backup alarm that’s somewhere under the dash (if I can find it). 2010 F350 deisel, crew cab, 4WD, long bed.
View 9 RepliesFord Super Duty (1999-2016) :: 2013 F350 - Right Turn Signal Clicking Through The Speaker
I have a 2013 f350 powerstroke, and the other day i climbed in it noticed that with the right turn signal on that it wasn't clicking through the speakers. Then noted that the arrow wasnt lighting on the dash either. But the lights were still working in the headlight and the tailight. but not the mirror, where to start.
View 2 RepliesFord Super Duty (1999-2016) :: 2005 F350 - Left Rear Stop Signal Not Working
I have a 2005 f350 6.0, my left rear stop signal is not working. I have changed the relay. I only get 5-6 volts at the plug and green-orange wire all the way to the engine bay. Not sure what the problem is????
View 11 Replies