Ford Super Duty (1999-2016) :: Engine Swap 2006 F250 5.4 To 1000 7.3 Trans?
My dad has a 2006 F-250 5.4 3v that spun a rod bearing at 107,383 miles. He's never been thrilled with the performance of it (told him he should have gotten the 6.0 when he bought the truck new, but why listen to a 15 yr old ). We've been throwing around a couple different ideas for engine swaps since the 5.4 is dead. We scored a 5.4 2V Lightning engine, but after trying to figure out transmission controllers or if we'd be able to tune the stock PCM for the 2v, we've put the project on hold.
Recently, I've been trying to convince him to do a diesel swap over the L-motor. I have a friend selling a cheap 99 7.3 with trans, PCM, harness, intercooler, piping and other misc stuff. Would that harness generally be plug and play with the body of the 06? Would it be more worthwhile to try to find a 6.0 from 05-07 and swap everything over?
I've also been considering a Cummins swap, although I haven't gone much past looking at complete engines on eBay and Craigslist. Would this be the better route, and just get a standalone controller for the 5R110?
So I'm looking for other's opinions. Should we go 7.3, 6.0 or Cummins? Should we stick with gas over diesel? Try to make the Lightning motor work? Or just go back with a stock 5.4 3V? I should say, he won't sell the truck for whatever reason, so he's not worried about resale or anything. We're in Michigan, so we don't have to worry about emissions. And we're fairly mechanically inclined, so I'm not too worried about doing the swaps, however my knowledge on diesels is limited.
Ford Super Duty (1999-2016) :: 2003 F250 - Front Seat Repair?
2003 F250 super cab, 335,000 miles. the seats are all in good condition except the drivers seat bottom, no rips or tears but the outer bolster area is worn. Looked at new replacement and no go. Is there a decent cover or a aftermarket replacement that looks good? The truck is not worth high end stuff, just would like it too look better
View 10 RepliesFord Super Duty (1999-2016) :: Center Console For Jump Seat Swap
Looking to swap out my center console for a center jump seat in my 2014 F350 xlt. Mines has gray cloth interior. Can this be done? Need to swap their seat for a console?
View 5 RepliesFord Super Duty (1999-2016) :: 2008 - Center Console Swap For Middle Seat
I am considering the purchase of an 08 Super Duty, however the truck I am looking at has a center console between the front seat. I need seating for six and like to swap a leather middle seat with fold down armrest for the console that I can't use. I don't want to buy this particular truck if I can't somehow get the seating issue corrected. You can view the truck at this link. 2008 Ford F-250 ...
View 9 RepliesFord Super Duty (1999-2016) :: 2003 - Rear Bench Seat Swap To Captain Chair?
I have seen plenty of the king ranch models that have the rear Captains chairs. My question is, I have a 03 Lariat Crew Cab w/ a bench seat, however, I would like to remove the bench and put 2 captains chairs in the back. Is this possible without lots of interior body modifications?
View 14 RepliesFord Super Duty (1999-2016) :: 2008 F350 - Swap Middle Jump Seat For Sender Console
I have a jump seat in my 08 f350 and am looking for a center console. My interior is black and tan and the jump seat is all black.
View 3 RepliesFord Super Duty (1999-2016) :: Axle Swap 3.73 To 4.30 In A 2011 F250 6.2?
Love my '11 f250 SD 4WD CC SB. 6.2 with 3.73 e-locker. I've got 5 Star tunes in it, and the truck is a joy to drive empty, and tows my current 7k camper fine, though on steep inclines I wish I had the 4:30 gears.
Well, we just bought a bigger trailer, dry weight is an addtl 2400+ at 9400, so I'll need to do something.
I don't want a different truck, don't want (another trouble-prone) diesel. I think with 4:30s and the tune, I should be fine towing that trailer (with gear and passengers, probably 11-11.5k loaded). Not doing mountains here, just Michigan hills.
What's the best way to "do" a gear swap? I know if I buy a set of gears and a shop screws Em up, it's gonna whine/hum and still cost 2k to do (truck is 4wd)
I'm up in the boonies and finding a shop to swap the gears will be a problem. Getting Em done right will be even MORE trouble.
Can I just find 4:30 axles ans have them swapped (anything in t-case or sensors need to be touched?). I don't care if I lose the e-locker, I never use it.
Ford Super Duty (1999-2016) :: 1997 Van 7.3L Engine Swap To 2004 F250?
Is it possible to put a 7.3 ltr from a 1997 van in my 2004 f250.....6.0 has cost me my fair share and would like to swap, 7.3 was giving to me because body is smashed i know engine is good , runs and drives
View 3 RepliesFord Super Duty (1999-2016) :: 2007 F250 - ABS Light On After Gear Swap
I just went from 3.73 to 4.30 gears on my 2007 f250 6.0. It has the standard Sterling 10.5 rear and Dana 60 front. My mechanic friend who did the swap said the ABS light came on during his test drive but the truck drove fine. I was of the understanding that the truck would not need to be recalibrated for proper speedometer and transmission function, but what about the ABS?
View 7 RepliesFord Super Duty (1999-2016) :: 2008 F250 Cab Swap Onto 2003 F350?
I was wondering if this is possible, I have a 2008 F-250 6.4L and a 2003 F-350 both crewcab longbox, the 08' F250 has a ruined engine & great cab/box, my 03' F-350 is fine except it has substantial body damage - Is it possible with some welding & magic to get a 2008 cab onto a 2003 6.0L F-350?
View 4 RepliesFord Super Duty (1999-2016) :: 2005 F250 XLT To Lariat Dash Swap
I have a 2005 F250 6.0. Its an XLT Trim but i want the features of a Lariat. would a Dash Swap Work or is it pointless?
View 2 RepliesFord Super Duty (1999-2016) :: 2005 F150 Steering Wheel Swap To F250?
So I have a 2005 f250 Super Duty 6.0 diesel it is the xlt with leather. So I don't much care for the steering wheels on this truck so i purchase a 05 f150 steering wheel. The splines and everything match up but the plug for the cruise control does not, need a wiring diagram or have done the swap and can tell me what wires connect where.
View 1 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Front Bumper Removal?
i've done some searching but haven't found any how-to's or instructions on how to remove the front bumper on my 06 f250. Any link on how to do it?
View 2 RepliesFord Super Duty (1999-2016) :: Automatic Transmission Swap 2000 F250 To 2003 Model?
I have a 2003 f250 4x4 with a 5.4 motor the automatic trans is shot. I can get a replacement trans from 2000 f250 4x4 with the v10 motor. I tried my best to research it bell housing supposed to be the same so it should fit. But I'm not sure what they changed in those years internally or electronically.
View 2 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Front Driver Side Brake Line Busted
So I'm away from home on vacation also away from my tools. Any ways my front drivers side line busted almost causing me to crash earlier today in my 2006 F250 6.0 diesel 4x4. So basically my question is: what tools are needed to do this job? I've already picked up the part now tomorrow morning I will be changing the part...
View 2 RepliesFord Super Duty (1999-2016) :: 2005 F250 4wd - Clunk Under The Driver Seat
I have a 2005 f250 that has a wander and a clunk what feels like under the drivers seat. The driver side bushing in the radius arm has no dirt and looks like wear on it compared to the passenger side which is completely covered in dirt. My question is, bushing wear out will cause wander and a clunk. Is it hard to replace?
View 3 RepliesFord Super Duty (1999-2016) :: 2012 F250 - Rear Seat Removal?
I would like information how to remove the rear seat back on a 2012 F250. I want to remove the head rests and from what I can find out they are bolted solid to the rear panel. I asked the same question earlier and got a reply for 2011, would that be the same? Is there any place I could get a schematic, a picture is worth a thousand words.
View 5 RepliesFord Super Duty (1999-2016) :: F250 - Stripped Seat Bolt Won't Tighten Up
2016 F250, took out the seats to remove the console and install the jump seat and upon installation I stripped the bold housing for the front left corner of the drivers seat. Now it won't tighten up. Am i going to have to tap the hole and get a bigger bolt now?
View 12 RepliesFord Super Duty (1999-2016) :: 2014 F250 - Rear Seat Back Removal?
I've got a 2014 f250 xl super cab and can't for the life of me figure out how to remove the back seat back.
View 2 Replies