Ford Super Duty (1999-2016) :: 2003 F250 - Tire Rubbing Front Brake Line
I noticed yesterday that my tire on the driver's side has rubbed a flat spot on the rubber brake hose. I bent the metal tubing so that it doesn't rub any more, but should this be of great concern? Obviously I'd hate for it to rupture, but it looks as though it's not too bad.
View 1 RepliesFord Super Duty (1999-2016) :: Brake Line Rusted That Runs Along Driver Side Frame Rail
My 2000 SD has a brake line that rusted through. The one that runs along the drivers side frame rail. So I need to get new line to replace it. Since I am nowhere near my truck right now, what is the size of the steel line?
View 6 RepliesFord Super Duty (1999-2016) :: F250 - Noises Coming From Front Driver Side Tire
Cat like noises coming from front driver side tire .. honestly sounds like a cat ..it gets louder the faster I go ... what it could be ?
View 7 RepliesFord Super Duty (1999-2016) :: 2001 F250 4x4 - Getting Noise In The Front Driver Side Wheel
Here's the deal. I have a 2001 F250 4x4 and I am getting a noise in the front drivers side wheel. The noise is not a grind or clunk, but its like a u-joint is rubbing inside an empty cylinder kind of. Anyways, it seems like it does it only with small bumps. I took off my oem hubs and re-installed them and the noise went away for about a week. Now I replaced them with manual locking hubs and the noise is back. One other thing I notice is if i put the switch to 4x4 the noise goes away. I checked all major components for the steering and suspension and nothing was loose. The front end is tight. Is there anything inside the axle that would cause this? I dont know what to check for anymore. Where else to check?
View 4 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Driver Side Front Power Window Will Only Go Down And Not Up
here's the problem. The driver side front power window will only go down and not up. I checked the motor and the master switch with a multimeter and both work just fine. the motor is receiving power and the master switch is sending power. However when i plug the motor back in and re-install it, the window will not go up. Is there some sort of relay that might have gone bad that is not letting the motor raise the window up???
View 5 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Driver Side Mirror Replacement
The driver's side mirror on my '06 250 (tow, heated, power, signal) got cracked... and of course whoever did it didn't stick around!!! Two questions...
Is it possible to replace just the glass? Or am I looking at replacing the entire unit?
Would you have a part number, or a link to a good online catalog?
Ford Super Duty (1999-2016) :: 2008 F250 - Front Passenger Side Brake Rub / Drag
My 2008 ford f250 SD Powerstroke has a bad front passenger side brake rub/ dragging after offroading before off roading just rubbed a little now it drags a lot. what do i need to fix.
View 2 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Frozen U-Joint In Driver Side Front Axle
I have a '01 F250 with a frozen u-joint in the driver side front axle. My question is can I put it together without the axle and drive it?
View 2 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Leak At The Driver Side Exhaust Manifold
I have a leak at the driver side exhaust manifold. Its a little tough getting at it to tell if its a lose bolt, crack or bad gasket. What would be the best way to get at this area? Should i remove the tire and wheel well or is their a better way. If i can get at it i may replace the manifold all together.
View 2 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Exhaust Manifold Leaking On Driver Side
Whats the best way to get at the driver side exhaust manifold? I have a leak and its tough to get at. Should I remove the tire and inner wheel well?
View 1 RepliesFord Super Duty (1999-2016) :: 2003 F250 V10 - Brake Line Burst While Driving
Had the rear passeneger side brake line burst today in rush hour traffic ..wasn't much fun. Is it a easy to do it yourself deal ...it is a 2003 f250 v10 triton .
View 1 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Wind Coming In Around Driver Side Power Window
On my way home today I heard wind coming in around my drivers side power window. Its not seating itself straight in the weather stripping. The window is tilted toward the front of the truck. Do I need a new regulator? Or maybe re- epoxy glass to bracket? The window still operates, its just crooked. Also I haven't had those door panels off before..
View 1 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Smoke Rolling Out From Driver Side Rear Wheel
Got off the freeway today, driving along about 40 or so thought I smelled something hot like something burning. Stopped in a parking lot and smoke was rolling out from drivers side rear wheel. Look under and oil is dripping from inside of the wheel. Figure the caliper was hung up and got so hot it took the seal out. I can't get to it right now and the shop says I can't get in until next week, need my truck now. How long could I get by the way it is IF I take it real easy.
View 9 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Transmission Line Replacement?
I'm having trouble disconnecting the transmission lines to replace them. I can't get them off. I have the tool. Can I replace the fittings in the radiator?.
View 3 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Rear Axle Steel Brake Line Size?
I made a bone head mistake and crunched the steel brake line between the rear axle and the passenger side sway bar mount. Truck is a 2003 F-250 with a 7.3. I would like to go to the auto parts store, get bulk steel brake line and bend it myself. But, I don't know what size the line is or what size the fittings are. Whatare the sizes???
View 3 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Lifted One Side Of 5.4 Motor Now Studs Don't Line Up
So...I'm dealing with a leaking passenger side exhaust manifold on my 2001 F250 SD. (Extended cab, long bed, 5.4 XLT.) Been slowly making progress on getting the manifold bolts off (the ones that weren't broken already at least.) Got all the top row off and the flange free yesterday, today was on to the bottom row.
I undid the 2 bolts on the PS motor mount studs and carefully jacked up the motor to lift that side a bit. I couldn't figure out anywhere else so I put a piece of 2x4 under the oil pan and used that point to lift up with the truck's bottle jack.
Worked well enough, but when I decided to call it a night I lowered it back down. Looking at one of the studs that I could watch as I moved it, the mount came to rest about an inch and a half away from where it started. (Higher up on the slant.)
How much does this matter? If the position is critical, how can I go about getting it back to the starting point?
I have a feeling the fact that I'm working in my uneven, unloved driveway had a lot to do with this. The passenger side is raised slightly and on a jack stand. Just enough to get the wheel on and off for access through the well.
On a positive note, I only have one more bolt to remove to free the manifold, the one right above the mount. I couldn't get anywhere with my nut extractors so I finally started grinding away at the nut with my Dremel. Should be able to get the old manifold off tomorrow and start working to get the studs out.
My Irwin Bolt Grips worked a treat combined with a MAP Pro torch on the others, but not so much on the hardest to reach one. Go figure. For starters there just isn't enough room to get a good solid hammer blow on it to seat it, and to make things way more complicated for some reason that particular location had more exposed stud length, so I couldn't get it all the way on to the nut and still get a ratchet wrench into the other end too.
Ford Super Duty (1999-2016) :: Small Diameter Rubber Hose Dangling From Front Driver Side Brake Housing Area
I was just under my 2000 F250 7.3l crew cab truck and noticed a small diameter rubber hose dangling from my front drivers side brake housing area. It is attached near two other cables which are similar to cables on the passenger side. I don't see a similar hose on the passenger side. The hose is completely deteriorated and broke off up higher towards the engine. I cannot see where it goes. What it may be?
View 4 RepliesFord Super Duty (1999-2016) :: 2013 F250 - Speakers Popping Like Busted When Listening To HD Radio Only
Having problem with the speakers popping like they are busted when listening to HD radio only. I took it by the dealer and they told me to not listen to HD radio.... Really, I paid all this money and now I can only use some of the features....It has the Sony system with Mytouch. Any update or TSB on this. It's really annoying when your trying to jam out and your speakers sounds busted!!!
View 10 RepliesFord Super Duty (1999-2016) :: F250 - Changed Mounting Frame - Passenger Side Seat Fit On Driver Side?
On the F250 trucks, if I changed the mounting frame under the seat, will the passenger side seat fit on the drivers side? Basically, can I turn a passenger seat into a drivers seat?
View 4 Replies