Ford Super Duty (1999-2016) :: 2003 F250 - 4 Wheel Drive Is Not Working
Love my 03 lariat Super Duty, King Ranch. Just found out 4 wheel drive is not working. Checked fuses, next going to look at the vacuum system, make sure its working. New to the Diesels but going to work at it and learn at the same time. 2003 F-250 4x4 ....
View 5 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Door Buzzer Location?
2006 F-250 'family Cadillac' ... Where exactly is the door buzzer? I am looking all around under the dash but can't find it. I want to disconnect it.
View 13 RepliesFord Super Duty (1999-2016) :: F250 V10 - 4 Wheel Drive Hubs Are Not Working With The Vacuum
I recently picked up a '99 F250 Super Duty with the 6.8L V10 for a song.
The 4 wheel drive hubs are not working with the vacuum. If I use the manual lock on the hubs all is well. I ordered the Innova 31703 CarScan OBD2 + OBD1/ABS/SRS Scan Tool. It says it does Trans codes. I am hoping it will cover the 4 wheel drive too.
Maybe related, the heat is always on. Meaning I feel heat at my feet when the temp dial is cold and fan is off. I can't find the heater control valve to check the vacuum line.
Ford Super Duty (1999-2016) :: 2002 F250 Diesel - 4 Wheel Drive Just Stopped Working
So one day my 4 wheel drive just stopped working, when I put in 4hi nothing same with low, the light on the dash doesn't even pop up and it doesn't engage. I've done about everything I could think of doing besides replacing the motor for it and the wiring, I hate getting stuck...
View 4 RepliesFord Super Duty (1999-2016) :: 2002 F250 Drives Unusually Rough When In 4 Wheel Drive
I purchased the truck used last summer and this is the second time I've put it in 4wd. The first time was over the summer, and I had a hard time getting it into 4wd, and it made a "clunk" sound initially but drove fine, then went back into 2wd just fine and had driven fine ever since. Today I put it into 4wd, no clunk or any other noises, very smooth, but it drove very rough, almost as if the wheels were out of sync or something. It seemed almost like the wheels were breaking on and off on their own, very weird. When I put it back into 2wd, it did that for a few seconds until it went away. I only drove it in 4wd in my parking garage as I didn't want to risk any more damage to it on the road.
View 14 RepliesFord Super Duty (1999-2016) :: 2006 F250 V10 - Drive Train Disengaged While Towing The Trailer
I have a 2006 f250 superduty crew cab longbed with the v10 gas motor. it has 201000 miles on it and towed great up until last month. I was towing a 5000lb trailer down the interstate at around 68mph,suddenly it was like the drive train disengaged and the motor had nothing left, check engine light on but no overheat condition or lack of oil pressure. we put a new fuel filter and pump on and maf, took trailer out again and same problem, pulled to the side and turned off, immediately restarted and ran fine. It has a cat not cleaning code in it now!
View 14 RepliesFord Super Duty (1999-2016) :: 2001 F250 V10 Won't Start - Solenoid Located?
My 2001 F250 will not start (clicks). I verified its not the battery and even tried to jump start it. I have never replaced a starter- but before I do that I read where there is another solenoid under the hood somewhere. I always thought there was just the one on the starter itself.
Two questions:
1. where is that other solenoid located and should I replace that first?
2. How difficult is it to replace the starter? I am pretty handy.
The issue is that I cannot get it towed easily - I just need to get it started at least once since my plow is still installed and it's hooked up to a trailer..
Ford Super Duty (1999-2016) :: F250 Has P7147 Error - PWM Or Non-PWM Solenoid Pack
99 F250 Super Duty 5.4 has a p7147 error. Traced all wiring cant find any short. Bought reman solenoid pack # are f81p-7g391-cb with green cover my old one in trans is f81p-7g391-ba with blue cover. Are these interchangeable? Have tried to read up on pwm & nonpwm and getting confused.
View 2 RepliesFord Super Duty (1999-2016) :: 2010 F250 - Vacuum Solenoid Not Getting Electricity?
I have a 2010 f 250 super-duty and i cannot get vacuum past the solenoid mounted on top of the radiator. Ford has given me nothing but bad advice. I know i have a vacuum leak after the solenoid and need to replace the lines going to the two hubs but when i switch on the 4wd and hook up a vacuum gauge the vacuum is good up to the solenoid about 12 inches. i constantly have 12 volts going to the center lead but nothing else in the other two leads either in 4 high, 4 low, or 2wd. Am I missing something here? shouldn't there be a voltage change when i turn the switch to 4wd to actuate the vacuum solenoid to let the vacuum pass thru the solenoid? I have tried replacing the solenoid but that did not work. Also use rubber vacuum line and make at down to the hubs?
View 4 RepliesFord Super Duty (1999-2016) :: 2006 F350 - Rattling Sound When Engaged In Front Wheel Drive
This must have been asked before but I couldn't find any thread about it. Have a 2006 F350 that makes a rattling sound when engaged in front wheel drive. Sounds a bit like a loose ball from a ball bearing (or a small stone) rolling around. What might be causing this?
View 3 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Torque Converter Clutch Solenoid
I recently purchased this truck so I don't have any history on it. It's the V10 motor, automatic, 4 wheel drive, with a crew cab. I took it to Advance Auto to have them read codes and it came back with torque converter solenoid fault and 2 other codes related to that part. I didn't get to see the actual code numbers.
I've talked to 2 transmission shops and they said they could throw a solenoid pack into it, but that it might not even fix it. The truck drives fine, shifts fine, the tranny oil looks and smells fine, so I'm tempted to not worry about it until something else happens.
The truck has 217,000 miles on it...
Ford Super Duty (1999-2016) :: 2000 F250 - Code P1746 - EPC Solenoid / Open Circuit
I have a 4r100 in my 2000 f250 7.3. I am getting a P1746-EPC Solenoid, open circuit. Does this mean this particular solenoid in the solenoid body has failed and should i replace the solenoid body?
View 3 RepliesFord Super Duty (1999-2016) :: Front Drive Shaft Spinning While In 2 Wheel Drive
I have a 1999 Ford F250 super duty 4wheel drive, lifted (really a leveling kit but had to lift rear to compensate), 5.4l. Im having a problem with my front shaft turning while in 2 wheel drive. Hubs aren't locked and its in 2 wheel not 4. I've taken hubs off and the bearing spins free soo I know its in auto. Why is the drive shaft still turning???????
View 5 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Smoke Rolling Out From Driver Side Rear Wheel
Got off the freeway today, driving along about 40 or so thought I smelled something hot like something burning. Stopped in a parking lot and smoke was rolling out from drivers side rear wheel. Look under and oil is dripping from inside of the wheel. Figure the caliper was hung up and got so hot it took the seal out. I can't get to it right now and the shop says I can't get in until next week, need my truck now. How long could I get by the way it is IF I take it real easy.
View 9 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Retaining Steering Wheel Controls With Dual Head Unit
Bought a new touchscreen head unit to put in my 06 lariat f250. I have all the controls on my steering wheel for heat and radio and I don't want to lose them with a new radio. This head unit does not have the 3.5mm jack for the axxes unit but has 3 wires labeled swc1 swc2 and swc ground. It supposedly has the converter built in. any views on using a headunit with these wires?
View 3 RepliesFord 6.7L Power Stroke Diesel :: 2013 - Four Wheel Drive Vacuum Pump And Solenoid Location
I have a 2013 6.7 and i cant seem to get my 4wd to work in auto position on hubs i think i have it narrowed down to the solonoid for it but cant seem to find location on it.
View 3 RepliesFord Super Duty (1999-2016) :: Ground Wire Location On F250
Trying to find ground wire location on my 99 f250 super duty with the 5.4 triton I didn't unbolt it myself. Going to be doing the big 3 upgrade soon and would like to use the factory ground spots.
View 13 RepliesFord Super Duty (1999-2016) :: 2005 F250 - Location Of ICP And EBP Sensors?
My 2005 F250 started stuttering, lurching, having wild swings in rpms, nearly dying at stop signs, no pickup when stepping on the gas, then taking off like a bat outta hell. After reading many, many posts here and on other sites, I have concluded that the most likely culprit is the ICP sensor, so I picked one up today (along with a EBP sensor - another story). It appears from the many posts that I have read that Ford/Navistar have frequently changed the location of these sensors. My question is: Where are the ICP and EBP sensors located on the 2005s (actual manufacture date is 07/2004)?
View 6 RepliesFord Super Duty (1999-2016) :: 2005 F250 - PCV Valve Location
I have a 2005 f250 with a 5.4l 3v. Where the pcv valve is located is it in the valve cover or attached to the intake and what does it look like? I have pulled the hoses off both sides but I have not found it let.
View 3 Replies