Ford Super Duty (1999-2016) :: 2004 F250 - Power Mirror And Turn Signal / Clearance Light
I did some reading on here this morning and ended up at 1A Auto looking for mirrors. I want to make sure I get the correct thing before ordering. I have a '04 250 with factory tow mirrors that are power mirror and turn signal/clearance light. I want to upgrade to the '08 style. Which of these would work? I would think either, but I'm not sure about the wiring harness?
Search Results for 1AMRP01095 - 1A Auto
2008-10 Ford Mirror Pair - 1AMRP01096 at 1A Auto.com
Ford Super Duty (1999-2016) :: F250 Won't Start Or Turn Over
I have a 2000 F250 with a V10, that won't start or turn over. I replaced the solenoid on the fender well, auto store check the starter 3 times and said it was good, new battery installed and same issue of not starting.
Here is a video of what it does when attempting to start : F250 starting issue - YouTube....
Where and what to look at?
Ford Super Duty (1999-2016) :: 2005 F250 XLT Won't Start And Turn Over?
So, when trying to start my vehicle it doesn't even turn over. Just clicks continuously. Both of my batteries are putting out 12 Volts. I tried the old arcing my solenoid with a screw driver while key is in on position and I got a couple of turns, but it wouldn't completely turnover. My solenoid has power going to it. Checked all fuses that could coincide with this issue. Not sure where to go from here. I have an 05 Ford F-250 XLT.
View 7 RepliesFord Super Duty (1999-2016) :: 2008 F250 Will Turn Over But Not Crank
I have 08 f250 6.4 was driving down the road truck just died. Will turn over but not crank. I've checked oil level, water level, fuses, fuel cut off switch. Still no start.
View 3 RepliesFord Super Duty (1999-2016) :: F250 - Hard To Turn Left
I have a 1999 f250 sd with the 7.3. I'm not sure what is going on with my pickup. When I turn to the right i can turn with one finger, but when I turn left i have to put some muscle into it. Power steering fluid is full. I raised the front end and it turns both ways easy. My ball joints feel fine, there is no tire shake when i have it off the ground. My tie rods feel fine also, nice and tight. I was thinking about replacing the steering sector to see if thats the issue but wanted to get a second opinion first.
View 2 RepliesFord Super Duty (1999-2016) :: 2002 F250 Won't Turn Over / Just Two Clicks Under The Hood
Battery tested good, tried jumping it as well with cables and with portable pack.
I hear two clicks under the hood (NOT a continuous type click you hear when the battery is dead). The first seems to be up near the passenger fender well when the key is turn to the start position, the second click seems to be down under the motor near the passenger side (near the starter I assume, couldn't tell very well) when the key is RELEASED from the start position. The motor doesn't budge, I don't see any belts flinch or pulleys move to indicate that the starter is engaging. I don't hear anything that sounds like a starter engaging to me.
If not, where the starter solenoid is on this thing? is it separate like the other older ford's I've owned or is it now on the starter? Is there any fuse-able links that could cause this? Wiring diagram? Is there a way to jump the solenoid like in the old school days (e.g. with a screwdriver or wrench)? would like to get this home without towing it or fixing what is really wrong with it in the parking lot.
It's in negative to single digit temps here in Indy now, I fired it up in the morning in negative temps, drove it work. Came out to go home, and now this. So something happened between this morning and now and it's not the battery.
Ford Super Duty (1999-2016) :: 2000 F250 V10 Won't Start / Only Click When Turn The Key
My 2000 F-250 V10 won't start has a new alternator and new starter all it does is Click when I turn the key?
View 14 RepliesFord Super Duty (1999-2016) :: 2002 F250 - No 4x4 Lights On In Cluster When Turn The Key
I have no 4x4 lights on in cluster when turn the key in the on position and it doesn't engage when I turn my 4x4 selector. And I don't hear anything in the relays .
View 14 RepliesFord Super Duty (1999-2016) :: 2008 F250 - How Hard Should It Be To Turn Hubs
On my 2008 f250 I can not turn the hubs without a set of pliers...does that mean I need new hubs....
What auto tranny do I have with the 5.4.. is it a six speed...
Ford Super Duty (1999-2016) :: 2006 F250 - Key Will Turn But Not Engage Ignition
Starts fine most of the time. Then suddenly key will turn but not engage ignition. Power OK to everything but ignition. Have replaced starter & ignition module. Still does the same thing. Leave for a while & truck starts fine. 2006 F250 6 litre diesel ...
View 1 RepliesFord Super Duty (1999-2016) :: 2005 F250 Won't Turn Over After STC Fitting Replaced
2005 6.0 F250 SD Powerstroke... Truck died on the road and wouldn't start
The symptoms were... I changed the Radiator and had the cooling system flushed... couple of weeks later it stopped while driving... did some research and talked to a few people and the STC valve seemed to be the issue... So new STC, new intake gaskets, cleaned and new EGR gaskets and I just put in a new Turbo (Ford installed it)... had a stripped bolt under the EGR cooler arm and had to remove the Turbo to get to it.... 14 days later......
Changed STC fitting and gaskets in the high pressure oil pump, IPR screen, exhaust manifold gaskets and Cleaned the EGR and changed gaskets and no start. Tried starter fluid and it turned but wouldn't stay on and the batteries died. Would you all say I'm on the right path?
Ford Super Duty (1999-2016) :: F250 - Front Turn Signals Not Working
1999 F250 super duty. I am having a problem with the front right turn signal not working. The indicator on the dash also does not work but I can hear the relay clicking double time and the rear signal works. I have changed the bulb and fuses and went under the dash and the column to be sure a connection had not come loose. I have looked through the forums to try and find an answer with no luck. What to try next?
View 4 RepliesFord Super Duty (1999-2016) :: 2001 F250 5.4L - How To Manually Turn Over The Engine
I have an 2001 F-250 5.4L.
It has the Triton engine and the problem with spark plugs blowing out. I have a kit with thick inserts that I'm going to install. I need to drill and tap the heads, but first I need to get the piston in the cylinder I'm working on to get close to the bottom and have all the valves shut. But I can't manually turn the engine over. I tried using a long ratchet with a socket that fits the nut on the crankshaft pully, but the nut just seems to tighten more, instead of turning the engine over.
And trying to turn the fan pulley doesn't do it either. Also, using the electric start for a split second at a time still seems to turn the engine over too quickly for me to get the piston where I need it. Do I need to pull all the spark plugs to do this? I really just wanted to work on one cylinder for now, instead of opening up a can of worms.
Ford Super Duty (1999-2016) :: 2002 F250 - Cruise Control Turn On But Sometimes Set Speed
Truck is an 02 F250 Automatic 4X4, 7.3 PSD.
Cruise control will turn on, will sometimes set speed and sometimes will not. If it does set and work it may kick off at any second or it may run fine. I have noticed it seems to kick off mainly after going over a slight bump in the highway or it may just kick off for the hell of it. Truck has 50,000 miles on it, I bought it new. Also having trouble with the throttle position sensor, it seems to have a "dead spot" at about 58 mph that shows up when I romp down on the pedal to pass on 2 lane roads. Can these two symptoms be related? Both are very aggravating. FWIW it does have the power adjust pedals. Truck is 100% stock, no power chips or other upgrades.
Ford Super Duty (1999-2016) :: 2009 F250 - Turn Signal Flasher Location
Exactly where that part is, pictures would be useful. Pretty much just had my whole dash apart with no luck. Switched to leds, and can't stand hyper flash like I thought I could. Trying to pull it to make sure I order the right part to correct it.
View 11 RepliesFord Super Duty (1999-2016) :: 2012 F250 - Rear Heated Seats Won't Turn Off
2012 f250 diesel Lariat 4dr 4x4. He called me today cause he knows I do all the work on my own F250 diesel. He has heated seats in the back and he said that they turn on by them selves and they won't turn off. He had to actually disconnect the wire harness to get the heating elements to turn off so his wife's friends wouldn't burn their bottoms in the middle of august is Texas.. Any ways, he said both sides are staying on and wouldn't turn off using the switch.
I'm not very familiar with the heated seat wiring, especially for the back seats. I told him their may have been a relay that went bad, but now I"m thinking that they much have a controller or something that is acting up. He said that the front seats are acting normal. Also, he has the touch screen and navigation upgrade as well as auto climate control, not sure if this stuff matters for the back seats though...
Ford Super Duty (1999-2016) :: 2006 F250 - Gauges And Radio Turn Off Randomly?
I have an 06 F 250. Recently my gauges and radio have been randomly turning off then back on when I am driving down the road. How I can fix this????
View 3 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Turn Signals Quit Working
I have a 2002 F250, 5.4 extended cab 4x4. Factory lights. I have no turn signals. They were working just fine and without turning off the truck, all 4 corners quit working at the same time, as far as I know. The indicator lights on the instrument cluster don't work. I have checked/replaced all fuses. Replaced the switch lever and the blinker relay behind the dash. The hazards do work and always have. It might be coincidence but I believe the back-up lights quit working at the same time.
View 2 RepliesFord Super Duty (1999-2016) :: 2012 F250 XLT - Passenger Side 4x4 Hub Little Hard To Turn
About a month ago I bought a 2012 F250 XLT. I just had it inspected (PA laws) and found that the passenger side 4x4 hub is a little hard to turn. There is also alot of corrosion on that side. I will be taking care of the corrosion, but have not had a newer 4x4 hub apart yet and was wondering for pictures or any diagrams? I would like to take care of it before winter hits.
View 3 Replies