Ford Super Duty (1999-2016) :: 2008 F250 - Steering Seems Heavy And Won't Return To Center After A Turn
Just bought this '08 F250 CCSB 4X4 5.4 Problem is the steering seems heavy, it tends to wander at higher speeds and won't return to center after a turn. I've searched on here and found a few possibilities (axle u joints, ball joints, steering gear, etc). I have an appointment with the dealer on Friday to fix it under warranty but he is convinced it's the u joints in the steering shaft seizing. When my F150 steering shaft began to seize, it would be hard to turn then break free then be hard then break free and this is not what is happening on the SD. I haven't had a chance to check the front end myself but not sure how you would check the axle u joints if there was no play in them. How would you check to see if they were seizing up.
View 3 RepliesFord Super Duty (1999-2016) :: 2001 F450 V10 - Hydro Clutch Petal Fails To Return
My 01 450 V-10 dump truck had intermittent clutch petal problem. Petal would not return all the way. Had to pull it up then it worked ok for a while. Now it only works occasionally. Could it be the disk is collapsing or the master or slave? Any good how to video for replacement?
View 4 RepliesFord Super Duty (1999-2016) :: 2006 F350 - AC Switches To Defrost Then Takes 2 Min To Return To Vents When Shift Into 4X4
2006 f350 DRW King Ranch diesel with 94,000 miles on it. When I shift in to 4x4 the AC switches to defrost and then takes 2 min to return to the vents. I imagine this is a vacuum leak issue. Where to start hunting? I pulled the dash for another install and all lines were connected. I will say the vacuum pump stays on longer than normal when the ignition is first activated.
View 1 RepliesFord Super Duty (1999-2016) :: 2007 - Tranny Cooler Line Is Return Line?
Have a 2007 V10 and I want to put in a Magnafine tranny filter. Instructions say to plumb it in to the return line. Which one is this, top or bottom?
View 11 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Climate Control / AC Vents To Defrost And Blow Normal Air Through
I have a 2006 F-250 Super Cab with climate control. The last three years when the temp exceeds about 85 degrees outside it acts up. It will switch from the AC vents to defrost and blow normal air through, not ac cold. Then it will switch back, when doing so I can hear the internal deflector shudder. It will do this every few minutes. It is extremely annoying. All other times of the year it works fine. My local dealer had the truck last year, but could not find anything wrong. I have used the search and also Googled and while I find similar problems nothing exactly the same.
View 12 RepliesFord Super Duty (1999-2016) :: 2015 - Normal Range Of Trans Temp?
I was wondering what is the normal range of trans temp in this truck? I was driving home last night and after a couple burst of wot , getting on the freeway, I checked the info display and it showed 200 degrees for Trans fluid. Truck was unloaded with 80 degree Temps.Also I guess how accurate is the dash Guage? does this seem like higher than normal Temps? 15 f350 cc sb 11 k miles ,gas motor. i aslo drove another couple miles coasting around and the temp never dropped past 196 .
View 4 RepliesFord Super Duty (1999-2016) :: 1997 F250 - Cold Engine - Heater Would Blow Either Cold Or Slightly Warm
I can't seem to get the engine temp to middle range on the marker, but yet my heater blows "to me" hot air. Even while sitting in idle for extended amounts of time I cannot get it to "operating" temperature. I would think if my thermostat was stuck open my heater would blow either cold or slightly warm air. I have the 5.4L engine with knn air filter and no cats.
View 14 RepliesFord Super Duty (1999-2016) :: 2003 F550 Truck Died While Running / Temp Gauge On Dash Dropped To Cold
The truck I'm working on is a 2003 f550 with a 6.0, and 382000 kilometers. My service truck died on me couple days ago, while running. As I rolled to a stop, I noticed that my temp gauge on the dash dropped to cold. (Truck was hot). Tried starting, and I have a crank, no start situation.
After towing it to my shop at work, I hooked it up to my scanner, and found that the pcm will not communicate with the scanner (otc genisis). I have no injector buzz with key on, wait to start light comes on for an abnormally long time. I have 48.3 volts on the ficm,(4 screw), and haven't been able to find any chafed wires as of yet.
Ford Super Duty (1999-2016) :: Overheating But Gauge Stays In Normal Operating Temp Range?
Ok so here here goes I have a 1999 f250 super duty with 5.4 triton it seems to be over heating but the gage stays in the normal operating temperature range. I just changed the water pump. Could it be the thermostat and Would it hurt to remove the thermostat until I can get one...
View 8 RepliesFord Super Duty (1999-2016) :: A/C Blow Cold Air When Driving Interstate?
I have an 06 F-250 Lariat with the crew cab. Even though the windows are tinted, the A/C struggles to keep the cab at 70 degrees on any given sunny day oer 80 degrees outside.
As long as you're driving on the interstate, it blows cold, but when slowing down (like a traffic jam or a stop sign) the air gets warmer and has a funny smell (like it's wet).
When I got the truck it had just gotten a new A/C compressor (160k miles). It stopped working last summer (180k miles) so I had the truck at the Ford dealer here and they replaced the A/C compressor, condenser, pressure regulator and dryer...basically all A/C components under the hood.
They tell me its working fine, but I find that hard to believe. No Ford I've ever had has had trouble keeping the cab ice cold even on the hottest days... How are your air conditioners working? Do they keep the cab cold? What I should look at?
Ford Super Duty (1999-2016) :: 2000 F250 - A/C Wouldn't Blow Cold Suddenly
My 2000 F250 SD 5.4 AWD's A/C wouldn't blow cold suddenly the other day. I confirmed the A/C relay (engine compartment, 3rd down from firewall)was "clicking" but compressor clutch was obviously not engaging with dash switch on Max A/C and engine running. When I take of the 2 wire connector to compressor to see if it is getting power, the truck won't start..if I disconnect the A/C compressor plug while running, the engine similarly quits. I have never had another vehicle do this on me before..I could unplug the compressor on my Jeep GC, for instance, measure 12+ volts with A/C ON w/car running and no problem with Jeep engine turning off.
I have searched for A/C wiring schematic w/o success. I checked every fuse in cab/engine for continuity since I don't know which ones might deal with A/C..jumped hi/lo pressure switch connectors with engine running/A/C ON w/o compressor clutch engaging. Clutch turns easily, have banged it a few times, and air gap looks good. More bizarrerly, I hooked the compressor to a 12V/ground via its 2 male prongs and didn't get the clutch to engage.
Ford 6.0L Power Stroke Diesel :: AC Blow Cold For 10 Minutes Until Everything Is Up To Normal Operating Temp
When I fire her up, the AC will blow cold for 10ish minutes until everything is up to normal operating temperature. Then it tends to blow warm, and that last for about 20 minutes, before finally settling back down and being cold AC again. I initially thought it was an issue with my compressor disengaging, but it doesn't seem to be...
View 3 RepliesCamry :: 2010 LE Shaking For Few Second Then Return Back To Its Normal Mode
I have just bought a camry-LE 2010 that has high millage on it which is 120,000mi. when i tested the car, it seemed fine but after long drive I discoverer something. When i am driving at speed 45 - 50 and stabilize the pressing of the accelerator, I feel the car shaking for few second then return back to its normal mode . I do not why I feel something wrong with the engine.
View 3 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Heater Will Blow Cold Air Unless Driving At Highway Speed
I have a 2006 f250 and the heater will blow cold air unless you are driving in like highway conditions. If you stop or drive slow it blows cold air only. What is causing this???
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Return Line Leaking At Fuel Bowl
New to me early 99 (4/98) f350 7.3 6 speed. Truck started acting up a few days after I bought it. Return line at fuel bowl was leaking, so started there and found a bad seal on the Fpr (unrelated to the fuel leak due to disentegrated compression sleeve). Fast forward through a bunch of parts swapping that still resulted in miserable lift pump pressure readings, I pull the sending unit out of the tank, expecting to find a plugged screen.
Well, there was in fact a plugged screen... Attached to the bottom of an in-tank pump. How did that get there?!? Everything I've read says there should only be a pickup tube??? Should I get a new sending unit from a junkyard and do the hutch mod or???
Ford 7.3L Power Stroke (1999-2003) :: HPOP Leaking / Return Line Coming Off
My HPOP was leaking so I pulled it our last weekend along with the fuel bowl and put all new seals in. All my previous leaks are sealed but now this stupid fuel bowl is being a major PIA.
The return line coming off the FPR will not stop leaking! It was slowly dripping when I first replaced the bowl and I thought the leak was between the fuel bowl and FPR housing. I ordered new rings and put it back together.... still leaking.
I wrapped a towel around the fuel fitting and realized that is were the leak is actually coming from. I went to the parker store today and got 3 new 60VL5 sleeves. The first one tore while sling over the fuel line (I was using 2cycle oil as lubricate). The second one leaked even worse.
In a desperate attempt to stop the leak, I slid the sleeve onto the fuel line as far back as it would go. I inserted the fuel line into the bowl and then put a thin coat of rtv on the exposed fuel line. I slid the sleeve over the rtv and then put a light coat of the outside of the sleeve. I tightened the nut up and am waiting for things to dry before trying again.
Why is this fitting giving me such a hard time? I've pulled the FPR housing and it is not cracked so I don't know what the deal is.
Ford 7.3L Power Stroke (1999-2003) :: Regulated Return Fuel Bowl Delete
I want to build a fuel bowl delete/regulated return fuel system for my 2000 f250 . I would like to make a really neat kit and attach all products used so people that want to build their own would have a useful source. I understand that it will probably cost the same but I want to design my own and route it the way I want . I have 3/8 1/2 5/16 and 1/4 stainless tubing as well as a bunch of unions and 90* 45* fittings and a couple tees. What size is the ports for the fuel lines that go into the four corners of the heads . I am a pipe fitter pipe welder by trade so this is basically a mini version of what I do everyday at work. Looking for some size details of the head port sizes so I can get the correct fittings?
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Steering Wheel Wouldn't Return But Had To Bring It Back
Just recently i have noticed my truck acting up. the other day at about 10 to 20 mph i made a 90 degree turn and noticed my steering wheel wouldn't return but i had to bring it back. than this morning the same thing happened. I made a 90 degree left hand turn and it happened again. the truck wanted to keep going left but i kept turning right. it almost feels like my power steering pump is going out. The pump was changed about 4 years 90k miles ago. I'm curious to see what others have to say. What could it be????
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Fuel Return / Supply Hard Line Connection
I am rebuilding the oil cooler and noticed since its removed I have great access to this fuel line pair from fuel bowl to soft lines below. How these disconnect at the soft lines? I happen to have a new set waiting to be installed. Is there a tool required ?
View 3 Replies