Ford Super Duty (1999-2016) :: 2000 - Transmission Fluid Leaking From Cooler Line
So my 2000 f350 is leaking transmission fluid from the cooler line. It goes to the rear of the transmission, but where does it go to from there?
View 5 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Transmission Cooler Line Start To Leak
I have a 2008 Ford F250 V-10 Superduty and recently I had a transmission cooler line start to leak. I ordered replacement lines and the tool for the quick disconnect. The line that's leaking is from the radiator to the quick disconnect. I was able to replace the one line, however the second line (problem area) has been a nightmare. The line cracked right at the quick disconnect fitting.
The hard line is tight in the fitting and corroded. broke the tool trying to remove from disconnect. The line is flush with the quick disconnect. How to get that out of the fitting? or another method of fix? Its a hard 1/2 line going into connect crimped to rubber line going to transmission.
Ford Super Duty (1999-2016) :: Power Steering Cooler Line Blown / Loss Of Fluid
I blew a power steering cooler line yesterday and lost a bit of fluid. Removed and replaced the line, consequently losing most of the fluid in the system (during line replacement). Re-filled the system and now i have great power steering when driving but none at idle. If I bring my RPMs up about 150-200. I get it back in full force. Could my PS pump be on the way out or might this just be air in the system?
View 3 RepliesFord - Explorer :: Adding Tranny Fluid Using Cooler Line?
I live out in the sticks, and leaked out a lot of tranny fluid. the fill plug in the pan is rusted bad. can I add fluid using the cooler line and a pump? so i can drive it to the repair shop.
View 4 RepliesFord Super Duty (1999-2016) :: Transmission Line Removal?
OK, so I ordered in the new lines and have them. BUT my problem is snaking the factory transmission line out from under the truck. I have pictures to show my struggles.
How do I pull this:
Out of here???
Towards the front of the motor
Front passenger side cab corner
Replacing these lines? I don't care about breaking the old one, but I still need to find a way to install the new one.
Ford Super Duty (1999-2016) :: Transmission Line Removal?
I have replaced both the transmission lines except the one that connects the two. It is the one near the top of the transmission that is about a foot long and goes from the fitting of the one transmission line to the other fitting for the other line. My questions is how do I remove it? It seems to be permanently affixed to the fittings, so those it come attached to new fittings?
View 2 RepliesFord Super Duty (1999-2016) :: Rare Brake Line Leaking?
I have heard that the front brakes are separate, and if the rear brakes have a leak and the line is empty, the fronts should still work. Is this likely to be true? If I drive the truck will I be able to stop with the fronts alone (assuming they will still work?)
I plan to drop the truck off late tonight when there is likely to be no traffic, but thought I would ask.
Ford Super Duty (1999-2016) :: V10 - Run Sea Foam Through Booster Line And Gas Tank?
So my brother swears by sea Foam and has been telling me to run some of it through my truck. Question is,i just put new spark plugs in less then 5,000 miles ago. Will i have to change them if i run sea foam through the booster line and gas tank??
View 8 RepliesFord Super Duty (1999-2016) :: 2001 - After Line Blew No Brakes?
Why on my 2001 Superduty if you blow a line nothing works and you have no brakes? On my older vehicles I think it was called a duel Master Cylinder and if you blew lines in front the back would still work and if you blew a line in back the fronts would still work. When I blow a line on my f250 there are no brakes at all making it quite deadly.
View 3 RepliesFord Super Duty (1999-2016) :: Cannot Get The Trans To Line Back Up After Clutch Replacement
I pulled the trans to replace the clutch and now I cannot get the trans to line back up! I am using a trans jack then two floor jacks with a 4x4 across them to support the transfer case. I am about four inches from the block and either side is either 2 inches high or low. The truck is 1999 f250 7.3 4wd.
View 10 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Transmission Line Replacement?
I'm having trouble disconnecting the transmission lines to replace them. I can't get them off. I have the tool. Can I replace the fittings in the radiator?.
View 3 RepliesFord Super Duty (1999-2016) :: Transmission Cooling Line Leaking - New Radiator?
My transmission cooling line is leaking. It leaks where it connects to the radiator. Im not sure how I go about removing the connection from the radiator. It is tough to tell from the rust on the connection weather or not I can use a wrench on it. I have read here that there are cooling lines in this part of the radiator for the transmission. Is it serviceable or do I need a new radiator. I dont want to touch it until I know what I'm looking at.
05 F250 5.4L 4x4
[URL]......
Ford Super Duty (1999-2016) :: Coolant Disappearing / Level On Minimum Line
I filled my coolant yesterday after driving to the "max" line. Today when I awoke it was right at the "min" line. I didn't see any noticeable liquid below the truck, except under each front fender but I think this was water from the dew evaporating/condensing and running off the truck. What happened to the coolant or did it just cool down and condense. It got pretty cool last night (mid 40s). I have an 02 f250 5.4L ... I feel like there is a leak somewhere, any link to or a procedure they can explain for finding it?
View 10 RepliesFord Super Duty (1999-2016) :: 2000 - Rear End Vent Line Leaking?
This is something to check, I found the vent line pinched closed on my 2000 F350 when I was trying to find out why it was leaking. When I was under my 2013 installing the hitch I checked it and found the same problem. The clip doesn't pinch it closed right away but it will happen if you don't move the clip.
View 8 RepliesFord Super Duty (1999-2016) :: Brake Line Failure / Pedal Went To The Floor
First, I am fortunate that I was only going 25 mph when some turned in front of me causing me to slam on the brakes. The pedal went to the floor, but did slow the truck enough to miss the jerk. Had I been on the highway, it would have been very bad.
Anyway, what I found is still hard for me to believe for two reasons. It find it hard to believe it failed, but more important that I am getting the last national inventory of 2 of the 3 lines in this picture (according to my Ford dealer).
The three lines are almost directly under the front end of the master cylinder between the block and frame. These are as I found them. The larger one goes to the rear feeding both rear brakes while the two smaller run to the front brakes. The spring looking part below is just a plastic protector. The line which failed goes to the front left.
I think anyone with a 2005 SuperDuty which uses the same or similar parts should take a very close look at the flex sections. The parts I have ordered are: 6C3Z-2B523-BA, 6C3Z-2263-BA, and 6C3Z-2264-BA (rear, right, and left).
How long a manufacture is required to maintain inventory? I thought 7 years, but someone suggested 17. I'm at 8 years, but I would have expected more than 1 each of the fronts to be available. Do they changed parts on the '06 or '07?
My 350 spent 2 winters in the Chicago area and has been resting in Florida since 2006. No work was done in this area, but the closest work was the main fuel pump (frame mounted) replaced 2 years ago, but that is almost 2 feet to the rear.
Ford Super Duty (1999-2016) :: 2004 - Transmission Line From Bottom Radiator Leaking?
So this is my major problem, leaving for a camping trip tomorrow afternoon. It's just 15 miles away, easy flat drive. What has happened is the trans line coming out of the bottom of radiator is leaking next to the fitting about an 1/8 ' out, So I can't cut off and splice in hose for the trip. I worked on it for about an hour, rusted on, tried some heat and now have some PB Blast on it and all I am doing is starting to round off the head of fitting. Is there any way to bypass this just to get the camper to campground and then get to a shop while we are gone Don't care if I have to splice and cut, will get new lines later.
2004 f250SD 5.4 83000miles
Ford Super Duty (1999-2016) :: Rusted Brake Line - Truck Started Leaking
I replaced a rear rusted brake line a couple of years ago. It rusted where the line met the bracket. I'd never done this before but bought a flare (flaring?) tool and fixed it.
This week the longer line that runs down the length of the truck started leaking. It looks like the line was once held in place by a small bracket just in front of the rear wheel but it wasn't in that bracket anymore. I guess it rubbed against the metal and water/sand rusted it out.
A local garage said they'd need to drop the fuel tank and estimated that it would be several hours (and hundreds of dollars) to do the job. It looks like I might be able to cut the old one out and then fish the new line up through there and replace it.
Also, what is the diameter of the line? It is a 2004 F350. I can certainly cut it out first and then take a piece of it to the local auto parts place to get the replacement line.
Ford Super Duty (1999-2016) :: 2001 - Stalls While Slowing Down / At 15 Mph - Vacuum Line Burnt?
I have a 2001 F-250 7.3 diesel with an automatic trans. Over the last couple of months it has stalled 3-4 times while driving, always when slowing down but even at speeds of 15 mph or so. I did find a burnt vacuum line the other day. It comes out of some type of relay box located behind the battery and in front of the starter solenoid relay and is mounted on the fender. It has an electrical plug in the top and two vacuum lines at the bottom. I am hoping this is the cause of the truck dropping off of the idle circuit? But I don't know what the unit is so I cannot order the correct replacement lines.
View 9 RepliesFord Super Duty (1999-2016) :: Brake Line Going To Rear Right Wheel Has A Rusted Hole
On my '97 F250 the rear brake line going to the rear right wheel has a rusted hole. It measures 50" total. Instead of bending a new metal line. I see they have a "poly armor" line that can be bent by hand( no tools needed). I see Autozone has them.
View 14 Replies