Ford Super Duty (1999-2016) :: 2015 - Normal Range Of Trans Temp?
I was wondering what is the normal range of trans temp in this truck? I was driving home last night and after a couple burst of wot , getting on the freeway, I checked the info display and it showed 200 degrees for Trans fluid. Truck was unloaded with 80 degree Temps.Also I guess how accurate is the dash Guage? does this seem like higher than normal Temps? 15 f350 cc sb 11 k miles ,gas motor. i aslo drove another couple miles coasting around and the temp never dropped past 196 .
View 4 RepliesFord Super Duty (1999-2016) :: Trans Not Getting Up To Temp
I have noticed that in the past 1-2 months my trans probably has just get to 150*. Even on warm/hot days. Lately its just been 120-140 all day every day.
Can this cause any problems? It used to go up to 150-170 when warm, now it takes a hot day to get there.
I assume its fine, but just checking because I have, admittedly, neglected my trans fluid.
Ford Super Duty (1999-2016) :: Overheating But Gauge Stays In Normal Operating Temp Range?
Ok so here here goes I have a 1999 f250 super duty with 5.4 triton it seems to be over heating but the gage stays in the normal operating temperature range. I just changed the water pump. Could it be the thermostat and Would it hurt to remove the thermostat until I can get one...
View 8 RepliesFord Super Duty (1999-2016) :: Linking Trans Temp To Scangauge 2
I put in the X codes and it doesn't show. The icon is on the screen but no reading for temp shows up. The truck is a 2008 with the 3V V10. Maybe verify the codes for me?
View 6 RepliesFord Super Duty (1999-2016) :: Trans Temp Upper Parameters
I recently purchased a ScanGuage II and installed it in our '09 F-250 SD 5.4 slush-a-matic with 4.30's and 31 1/2" tires. This unit is primarily used for towing and I wanted to keep an eye on the trans fluid temp. By the way, I really like the ScanGuage II. It gives me real time fuel mileage, coolant temp and accurate trans fluid temp, among many other things.
My question for you guys that pull your trucks hard on a regular basis is this, what is the maximum trans fluid temp that I should allow the slush-a-matic to rise to? I towed our 9000# 5ver 200 miles one way to Indy for the 500 over Memorial Day weekend and the highest TFT was around 180 to 185 max. It was under 180 most of the time.
What are the upper parameters of TFT that his tranny will endure and still live a long trouble free life?
Ford Super Duty (1999-2016) :: 2002 F250 - Trans Temp Sensor Location
I have noticed my trans temp gauge needle is dead center of the gauge even on a cold start. I thought my sensor was under the pan so I pulled it and did not see any sensor at all. Is there a external sensor?
View 5 RepliesFord Super Duty (1999-2016) :: 2008 F350 - Trans Temp Sending Unit Replacement?
The trans temp guage on my '08 F-350. V-10 started acting erratically, and the wrench icon popped up on the display. i crawled under the truck to look for the sending unit and it's lead. i assume that i found the lead. it is encased in a corrugated sleeve, and appears to be a vaccuum type tube and boot connector? the boot still had a small round gray cap plugged into it. it appears that the cap was never glued (go figure) upon assembly. i have tried to reach up on top of the trans to find the sending unit to figure out the best angle of attack. i can barely touch it with the tip of my finger. going with mechanical guages is out of the question at the moment, so i'm wondering can it be driven any distance this way, AND any schmooze tricks developed to get at the sucker without dropping the cross member or exhaust????
View 3 RepliesFord Super Duty (1999-2016) :: 2001 F350 - Trans Temp Sensor 4r100 Installation?
I have an isspro sensor that I need to install on my 4r100. I have it all installed except for the actual sending unit. My question is where is the best place to put it?
I've watched multiple YouTube videos and it seems a lot of people use the test port on the driver side above the linkage. I found out the hard way that it is a very poor choice of location. A lot of people say that the best way is to drop the pan drill a hole and weld in the bung? I was wondering would it be possible to put it on the "out" line on the transmission oil headed to the cooler? 01 f-350 7.3
Ford Super Duty (1999-2016) :: 2001 F350 Manual Trans 4x4 - Temp Gauge Not Working
I replaced the sensor on top of the water pump and the gauge still doesn't work. I tested the gauge by unplugging and grounding out the wire and the gauge goes all the way up. What I can try next. I didn't get a Motorcraft sensor so I'm going to go get one of those tomorrow hoping the duralast wasn't correct even though it looked 98 percent identical to the original. 7.3 lite diesel.
View 1 RepliesFord Super Duty (1999-2016) :: 2006 F350 - No Crank - Engine Sensor Data / Trans Temp Error
I have an '06 F350 dually with a 6.0 diesel. I bought this used about 5 years ago and for the most part have loved it. i would always smile on the inside when i heard people bash the 6.0...i thought i got lucky....until today.
140k miles. recent oil change. all is swell...until this morning. Stick in key and turn it. glow plug indicator comes on...all lights come on for a few second....wrench, abs, dtc etc....wrench shuts off...glow plug light comes on...4 or 5 seconds later wrench light comes back on....turn key and NO CRANK.
All fuses are fine...starter cranks if i jump the solenoid...but it won't start. Miles to empty and everything else is just dashes hit the OBD and it says "engine sensor data error"/ "trans temp error" ...
Ford Super Duty (1999-2016) :: CC Displays On Right - No Outer Temp And Temp Setting?
My CC display shows all icons on the right regardless of settings (see pic). The temperature setting and outside temp will not come on.
The second issue is that my front blower starts to lose velocity and sounds strange on long road trips.
Ford Super Duty (1999-2016) :: 4x4 Low Range Does Not Engage
What are some simple checks, my 4x4 low range does not engage, just stays in 4 hi. 2003 f350 screw v10.
View 5 RepliesFord Super Duty (1999-2016) :: 2000 - Rattle Around 2k Rpm Range
2000 super duty v10 with 92,000 miles. Getting that common rattle around 2k rpm range that goes away if I give it gas or let off. I originally thought it was the inspection plate on the transmission so I removed it and went for a drive to verify. The sound is still present so the only thing I can think of is the catalytic converter is worn out??
View 10 RepliesFord Super Duty (1999-2016) :: ESOF 4X4 Engages But Not No Low Range
After doing a test drive after installing an 8" lift on my 2000 6-speed manual diesel F-250, I noticed that while the 4X4 engages, it won't shift into Low. I've had this truck 7 years and know the drill: complete stop, foot on the brake, clutch to the floor, transmission in neutral, and it usually takes a couple seconds. I've tried different combinations of backing up first, going straight from 2WD to 4Low, etc and still no 4Low.
As far as I know the ESOF transfer case is all electronic and vacuum doesn't play a role. I don't recall ever seeing a vacuum line coming out of it anyway.
Ford Super Duty (1999-2016) :: 2006 F250 Locking Into Low Range
I have an 06 F-250. I have had this truck since Oct 2013 and had never use 4 wheel drive here in southern Alabama, so my question is i lock my hubs, turn my selector to 4 high and it works. Now selecting to 4 low and I get nothing.
View 9 RepliesFord Super Duty (1999-2016) :: F450 - OD Light Flashing When Truck Is In Low Range
I have a 99 f450 and the od light flashes when the truck is in low range. I have to shut the truck off when I put it back in high range to get it to stop. It won't flash again till I use low range again. whats going on?
View 1 RepliesFord Super Duty (1999-2016) :: 2006 - Rough Idle - Mid Range Misfire - Low Compression
2006 F53 (motorhome) with 6.8L V10. Rcently noticed rough idle and midrange (under load) mis fire. Had codes on 2 coils. Replaced coils and put new spark plugs in. Did not improve and now detecting mild back fire.
Just completed compression test. 1=207psi, 2=200, 3=210, 4=190, 5=197, 6=200, 7=200, 8=170, 9=202, 10=208.
put some oil in #8 and retested at 225!
Other observations on #8. Engine has ticking noise chased with stethoscope to #8. THE new plug with 200miles, insulator going to electrode tip and everything inside combustion chamber is black. All 9 other plugs still look new out of box.
With the ticking noise I was suspecting valve but the compression test with oil jumped way up.
Ford Super Duty (1999-2016) :: 2003 F250 - Poor Keyless Entry Range
I have the factory keyless entry on my '03 F-250 SuperCab. I have always had to be within about 5'-8' of my cab to get the doors to lock/unlock. I thought it was normal for the longest time, but recently learned it's not. I am out of warranty now so I need to try and fix this myself. What is the location of the receiver module, and what it looks like? Also, is there an external antenna w/ the factory keyless entry, and where is it at? Transmitters are fine, as is battery power. Only think it could be is receiver/antenna.
View 14 RepliesFord Super Duty (1999-2016) :: 2000 F250 V10 - Vacuum Loss Prevent 4x4 Lo Range Engagement
2000 6.8 v10 F250 supper duty crew cab. 4x4 high switch's on (manual lock hubs installed) but 4x4 low will not engage. Brake input/out put tested good. Trans switch Park/"N" both test good. PCM reads switch output in all modes, (dash 4x4 selector). The only other issue I am having is the Vacuum is bad ( defrost default no blend door operation). Would vacuum loss prevent 4x4 lo range engagement (with manual hubs ) or should I go to the solenoid, relays on the case/ right fender?
View 4 Replies