Ford Ranger / B-Series :: Uneven Front Brake Wear / Caliper Sticking Slightly
2000 Ranger, see my sig.
Just had to swap out the pads on my truck yesterday. The pedal was pretty mushy and I was getting shaking in the steering wheel when the brakes got warm. Shaking wasn't all the time, only after they had been used quite a bit - say after city use and the brakes had to be applied suddenly. So I popped off the tires and swapped out the pads and replaced the brake fluid - flushed it.
On the driver side front, the pads barely had any real wear and the anti-rattle clip was all messed up. It was installed properly, but it looked like the pads had smashed into it. The rotor appeared to be warped, or at least out of round - but just barely. You could see it wobble slightly in one spot if you spun the hub with the caliper removed. The caliper itself was sticking slightly.
I didn't see any evidence of damage, the brakes flushed just fine although the fluid was incredibly dirty (because I haven't done it in a long while). On the passenger side front, the pads were worn down to the level I would have expected given the mileage. The wear was even.
My question ultimately is this - is the out of round hub the culprit here? Might there be something else going on like a caliper problem? Ultimately I plan on having the rotors surfaced - one of them certainly needs it and with new pads I might as well do it anyway.
Ford Ranger / B-Series :: 2002 - Tire Wear And Squeaking Front End
My '02 Ranger has had tire wear for a while now, and its on the inside of both front tires. I was thinking it was either toe or camber, or maybe both. I havent been able to get an alignment recently. If its the camber, should I get the camber kit from Ford?
As for the squeaking, it first happened last summer, and I sprayed WD-40 on the upper control arm bushing and it went away until last week (obvoiusly temporary). Now its back. Also happens while turning the front wheels.
Camry :: Uneven Tire Wear With 2011 SE
I have a 2011 Camry SE which I leased brand new from a dealership in Ottawa. It has about 35,000 KMs on it. After my last regular maintenance at the dealership (32K oil/filter change with tire rotation etc.), I started noticing a sound coming from the tires. The sound is like low pitch boom boom boom boom. I tool it to the dealdership and they told me there is uneven wear on the tire which is normal for Camry SEs because they have wider tires that easily scallop during hard cornering.
Firstly, I do not buy that explanation because it's not the first car I have driven with a little wider tires. Secondly, I do not drive rough as most of the times I have my kids in the car with me. Lastly, I would think that if you are selling sports tuned cars, you would choose appropriate tires for it so buyers can drive it like a sports car.
I wonder why the situation became noticeable after the tire rotation. According to the rep at the dealership, all 4 tires have uneven wear so should I not have noticed it before the rotation?
Lexus GX 2004-09 :: Clunk When Stopping And Starting - Uneven Tire Wear
Why are My Tires Wearing Unevenly?
View 2 RepliesLexus GS 2013+ :: Front Right Tire Has Uneven Wear On Outer Thread
Any 1 have their tire that have uneven tire wear? Mines is Dunlop and my front right tire has uneven wear on the outer thread. All other tire don't have uneven wear. I'm getting new tire for all 4 rims and check my alignment. My gs is a f sport rwd.
View 3 RepliesFord Ranger / B-Series :: 1998 - Front Brake Lines Kink In Sharp Turns And Wear Out
98 Ranger Front brake lines Too short! they kink in sharp turns and wear out then start to seep then eventually leak and need replacement. Checked parts references and the lines have been considered stock. Not sure if I have a 1/2 year model.
View 1 RepliesGolf/GTI VI :: Uneven Front Brake Pad Wear - What To Do
I noticed this yesterday when swapping out my wheels. What could be the causes?
Pass side
Drivers side
Ford Super Duty (1999-2016) :: 2001 F350 - Extreme Uneven Wear On Rear Pads
Have a 2001 F350 7.3 4X4 with single wheels in rear. Started hearing brakes noise and decided to change both front and rear pads. Front had almost half the pads left. Rear on drivers side had about half the pads left. The passenger side metal to metal on the inboard pad and about half the pad on the outboard side. The slides on the caliper were a little sluggish but moved freely. Don't think there is enough to have them turned so will have to replace the rotors. Why this would happen. Could the caliper get stuck? It was easy enough to compress with a C clamp.
View 3 RepliesCamry :: 2005 SE Gen 5.5 - Getting Squeak / Uneven Brake Pad Wear
2005 I4 SE Camry USA built. Got a squeak from the rears the other day and pulled the tires to check. Inside pads (ones against the caliper cylinder) on both rear wheels were at the metal but the outside pads were still not down to the little stripe down the middle of the pads, let alone the wear indicator clip. I pulled slide pins and there were not stuck. The calipers retracted very easily, so not gunked up or dragging. I ordered a new hardware kit with the new dust boots and rubber slide pin parts. I am using good Permatex disc brake grease. I am going to have to have the rotors turned, but aside from replacing the rubber parts the only other thing I can think of is slide pin replacement.
View 2 RepliesCamry :: Uneven Wear Between Outer And Inner Brake Pads
I just thought I'd mention this observed wear of brake pads...I just replaced all 4 up front after about 128k miles...
@ 114k miles it was observed that 1 of the 2 pads of each front wheel had worn significantly more than the other (the inner more than the outer pad IIRC)....my expert mechanic rotated the two and I got another 14k miles out of them...I could have gotten a LOT more had they been rotated @ 50-80k miles.
I don't know if this is extraordinary, or more typical than I'd have thought...or a function of (failing?) calipers, or just how these (MY) calipers work, or just my driving habits (though I've owned the car for only 30k of the 128k miles on the odometer)....but....
In my case the new pads will get a 50k mile inspection and possible rotation if there is uneven wear between outer and inner pads....
I'd recommend that pads be inspected for (uneven) wear at one of the scheduled tire rotations....rotating the pads isn't much of a job, but it might be something for you to consider to get the most miles from the pads (that and better braking too perhaps).
Passat (B5) :: Pulling To The Right - Tire Inflation?
I'm about to leave on a road trip. I noticed last trip, the car pulled to the right. Can that be improved by tire pressure? If so, would I need more front driver or passenger side and/or rear tires?
View 3 RepliesLexus SC430 :: 2006 Wheel Alignment For Uneven Wear?
I have a 2006 SC 430 with 20,000 miles on it The (run flat) tires are wearing on the inside and the dealer says that they need replacing The local tire shop agrees, and will sell the tires to me for less, and also throw in an alignment He says that alignment is the reason for the uneven wear But the dealer says that the wheel on my 2006 SC 430 cannot be aligned, and that the new ones will probably wear the same way
View 12 RepliesPrius (Gen 3) :: Rear Brakes Gone With Severe Uneven Wear At 55,000 Miles
While in for an oil change, the tech pointed out that my rear brakes were almost metal to metal, and that one pad on each side of the car had severe uneven wear. He noted he had never seen rear brakes go this quickly in a Prius and he had never seen the uneven wear. He said part of the mechanism that allows the pad to slide in and out as the brakes are used had frozen, creating a pivot point, and creating the uneven wear. The front brakes are fine with plenty of meat left.
Parts were ordered, including new shims and other hardware to try to insure this does not happen again, and the brakes were replaced. I contacted Toyota Customer Care and basically got the old line that brakes are a wear and tear item but the issue would be sent onto engineers.
I am the sole driver of the car and use the regen brakes at every opportunity, which is most stops. Since long brake life is one of the benefits of regen brakes, this is disappointing to say the least.
Elantra GD (2013+) :: 2014 GT Rear Tires Wear Uneven
My 2014 Elantra Gt bought in May 2014 and 18000km on it now, the rear tires on both side are worn out pretty bad on the outter side of the tire. I took it to one of the dealer. The mechanic said that's not about the alignment, it's because I drove too hard in the corner..... So, I made an appointment with the other dealership which I bought the GT. I was told that it need the alignment and it's not covered by the warranty. I don't mind to pay for it but just want to make sure they will fix it.
I have the KYB on it right now. should I swap it back to the oem before I go to the dealer??
Camry :: Tire Pressure For 2006 Car - MAX Inflation Is 44 Lbs
Been using the pressure listed on the door jamb which is 29psi since I own the car. But recently I noticed the tires seem to be wearing on the outside part of the tread. I believe this is usually an under- inflation symptom. Am I right to be using 29 psi as the proper amount or should it be higher? The tire says MAX inflation is 44 lbs. which I know would be way over what it should be.
View 9 RepliesCorolla / Matrix 2009-13 :: Uneven Brake Pad Wear About 50% More Than Passenger In Front
I checked my pads today and noticed that the drivers pad is worn about 50% more than the passenger in the front. What could be the problem??
View 5 RepliesLexus ES 2007-12 :: Reset Tire Inflation Indicator?
How to re-set the tire inflation indicator. I just had the tires rotated and properly inflated but the light is still on.
View 1 RepliesLexus IS 2014+ :: Bridgestone Turanza EL400 - Uneven Inner Wear Due To Factory Alignment?
My front driver's side Bridgestone Turanza EL400 (225/40R18) has premature wear such that the steel belt is beginning to show through the center of the tread. The front passenger side tire has no such wear and the alignment is good.
View 14 RepliesLexus RC F 2015+ :: Tire Inflation Dropped To 26 -27 Lbs Due To Extreme Cold
The temperature has dropped to low single digits.
My RC F tire inflation has dropped to 26 -27 lbs. due to the extreme cold, after it has been outside for a while.
After driving for a while the tires heat up and the pressure goes up, returning to normal range.