Ford Ranger / B-Series :: 2007 XLT - Cruise Control Light Blinks After Push On And Resume Buttons
My cruise control has been out for awhile and I have run the diagnostic test several times, earlier this year and now again recently. The cruise control light blinks after I push the ON and RESUME buttons, but no blink for the COAST button. I suspect there is a problem in the wiring, but I wanted to get your thoughts before I replace the switches. 2007 Ranger XLT ....
View 1 RepliesFord Ranger / B-Series :: 2000 XLT - Cruise Control Not Working
My 2000 4.0 XLT Ranger has been without working cruise control for several months now. I've checked what appear to be likely related fuses and they're all good. I *DID* have a recent problem with my brake lights but that's been fixed. (The shop that replaced my rear leaf spring hanger brackets pinched a hot wire between the brackets and the frame which eventually shorted. Wire and fuse were replaced.)
A few years back, Ford had a recall related to the Cruise Controls causing fires. I had the recall service performed on this truck. In a nutshell: The switch to disengage cruise when braking is attached to the master brake cylinder, and a leak in the switches diaphragm allows brake fluid into the switch causing an electrical short, causing the wires to heat up, and in some cases causing a fire. Ford, instead of switching to a different switch design (like maybe a mechanical switch on the pedal?) put a fuseable link in the hot wire from the potentially leaky switch.
Well, the truck now has over 150K miles on the factory brake cylinder/cruise control switch. I'm suspecting that my switch finally leaked, shorted and blew the fuseable link. Would Ford fix it? (They should, considering the lame fix for a lame design flaw.)
Ford Ranger / B-Series :: 2002 - Cruise Control Work Intermittently?
I am normally on the super duty side but I have a 2002 ranger 3.0 auto EX cab if that matters with this issue. My cruse control will only come on rarely but when i does it works fine. Most of the time when I hit the ON button the indicator only blinks like a "relay" of some sort is not latching up. Don't know if this is an all solid state system or if there are electro mechanical relays involved as well. When it does work and I hit the brakes it will drop out completely rather than just disconnect from the controller and need to hit the ON button again, usually with no results.
View 8 RepliesFord Ranger / B-Series :: Cruise Control Stuck On And Wouldn't Release
So I'm motoring along a country road with the cruise set at 50 mph and the truck starts to increase speed.
Tap the brake - nothing happens. I'm up to 65 mph! Knock it into neutral and it revs to around 3,500 rpms and then it unsticks.
What in the world is going on with that? After thinking on it, a few miles farther on and I set the cruise again.
It began immediately picking up speed. I hit the brake and nothing happened. Then I hit the off button and nothing happened.
So again I bumped it up into neutral and it did the same thing - revved for a moment and then kicked off.
The dealership where I get my service done can't get to it for several days. So I'm checking in the meanwhile to see possibilities to identify a cause.
Ford Ranger / B-Series :: 1998 - Cruise Control Not Working - Normal?
today my 98 ranger 4.0 would love to have cruise control once again .
I have checked the obvious , fuses connectors etc. I know on my f250 they had an issue with the pressure sensor mounted on the brake master cylinder leaking , I did check that and not leaking yet . I can't even get the system to turn on. So my question to to the forum , is there a common issue with ranger cruise control that I am unaware of ?
Ford Ranger / B-Series :: 2003 - Cruise Control Set Button Broken / Accelerator Stuck
2003 ford edge 3.0 V6 ... I was driving down interstate today going 70, set my cruise control & the button broke. My accelerator was stuck, when I would hit the brakes it would literally shake the whole truck. What happened & why?
View 3 RepliesFord Ranger / B-Series :: AC Clutch / Radio / Cruise Control And Turn Signals Are Not Working
My AC clutch, radio, cruise control, and turn signals are not working. I have checked all fuses and relays that I can find, all good. From what I have read, these are not part of the GEM function. What I need to check next!
View 7 RepliesFord Ranger / B-Series :: 2000 - Cruise Control Switch Broken / Airbag Removal
The cruise control switch on my 2000 Ranger just broke. It looks like you have to remove the airbag to access it. How is that accessed? It looks like there are 2 plugs on the back of the wheel that need to be removed.
View 9 RepliesFord Wiring/Electrical :: 1996 Ranger - Adding Cruise Control?
i have a 96 ranger and want to put cruise control in it. is the wiring there and what other parts do i need to get without going aftermarket.
View 1 RepliesFord Ranger / B-Series :: Missing On Light Throttle / Cruise
4.0. I'm having what feels Like a Miss on Light throttle/cruise. Once warmed up it's fine. Idle is fine too. There is No CEL/Codes.
View 14 RepliesFord Ranger / B-Series :: 1993 - Cruise Will Not Disengage With Brake Pedal
1993 Ranger XLT 4.0 AT. Initially replaced ECM for other problems and then noticed Cruise w/n disengage when brake depressed unless pedal is pushed several times and with more pressure. Put in another ECM and have same problem. Have replaced the brake switch and lights come on as they should. When pedal is pushed the vacuum dump valve on the pedal will dump the vacuum to the servo but when you release the brake pedal the cruise control kicks back in and speeds truck back to set speed.
So this tells me that the dump valve is only a fail-safe feature for when pedal is depressed and does not actually deactivate the servo. Everything else with the cruise works fine: On/Off switch, Set/Accelerate, Resume, Coast. How to proceed next? Like where to find speed control module and how to test it? How to check servo to see if it is getting or dropping voltage that will electrically disengage it, etc? Don't want just throw parts at it. The new ECU's that I used came from ECU Exchange in Florida and there still remains the possibility that they are still the problem.
Lexus RC 2015+ :: Cruise Control Turning Off Every Time
I'm kind of up against the clock. I am sure this answer is in a book in the car. But that book looked pretty thick.
My husband just told me that he did not want to take my car to the ball game because he can't stand the cruise control turning off every time it gets even close to a car (yes, I understand what this may mean, but I'm not driving with him and he is a grown man).
Is there a way to disengage the automatic turn off on the safety cruise control feature? He likes to be the one in control I suppose.
Ford Ranger / B-Series :: AC Compressor Turning On And Off When At Idle
When I am at idle, the compressor keeps turning on and off every few seconds. It seems to work fine while driving. What do I need to do to fix this?
View 14 RepliesFord Ranger / B-Series :: 1984 - Dies While Turning Right?
I didn't really know where else to turn (no pun intended) every time I turn my wheel to the right the truck sputters out and dies, i checked the ignition switch, tightened her up and shes still killing the engine when i turn right. All other power remains on stereo, car charger etc. its not so bad on continuous turns i can just pop the clutch but for stopping and turning its a huge issue. Why turning left is fine but right kills the engine..wondering if maybe the prongs on the ignition switch may be bad?
View 7 RepliesPrius (2004-09) :: Cruise Control Turn On By Turning Steering Wheel To Left?
I have a 2004 Pruis. Lately I have been noticing a problem with the cruise control. Often when I press the button to turn on the CC it will not come on, but if I turn the steering wheel to the left a bit I am able to turn on the cruise, sometimes when I turn the wheel back it will continue to work and other times it will not. I tried to search and found others posts about prius CC but couldn't find anything that included all of my symptoms.
View 6 RepliesFord Ranger / B-Series :: Cab Air Flow Control Direction?
What controls where the air flow is directed in the cab? I've just finished replacing my power steering pump, ac compressor, dryer, and ac hoses. I have air flow to the defrost and some on the floor bu none coming straight out. It worked normally before so I did something. ('96, 4.0, auto tranny, XLT).
View 1 RepliesFord Ranger / B-Series :: 1996 - No Heater Control
I seen on this site awhile ago something about a fix for the heater control door, I have a 1996 Ranger and all I have is Hot heat and cannot cool it down with the temperature control.
View 2 RepliesFord Ranger / B-Series :: Blinker Does Not Deactivate When Turning Right / Left
The blinker in my 98 Mazda B4000 does not deactivate when turning right/left. The multi-function switch was replaced last year with an OEM part.
View 2 RepliesFord Ranger / B-Series :: Dome Light Automatically Turning Itself Off?
How to keep the freaking dome light from automatically turning itself off?? I understand it's a battery life saving function but I find it ANNOYING and would like to stop it.
View 6 Replies