Ford Ranger / B-Series :: 2001 - Airbag Light Stays On And Blower Is Not Working
The air bag light stays on & the blower in not working. I checked the fuses good.
View 2 RepliesElantra XD (2001-06) :: Electrical Systems Not Working When Left The Keys In Ignition Overnight
My 2004 Elantra is having electrical problems. I left the keys in the ignition one night, and now systems within the car do not work. The car no longer responds to remote controls (lock/unlock). The lights in the cabin do not work. The digital clock and radio displays are blank. The gauges are also reading incorrectly when I start the car (all of them move up and freeze for a few seconds at 4000 RPMs, 70 mph, Hot Engine, then come back down to correct readings).
The car starts fine, and I have checked all fuses. I tried letting the car run to charge the battery, and also tried a jump start from another car to recharge the battery.
Remember, this all started when I left the keys in the ignition over night
Ford Ranger / B-Series :: 1999 - CEL On - A/C Stopped Working?
I have a 1999 Ranger 4x4 4.0 5 speed step side...in Jalapeno no less. Anyway, for the past 5 years or so the check engine light has been on. When it came on I did nothing because nothing seemed to change and I was too broke to fix it anyway. Well, just lately the check engine light has started to flicker or go out completely.
When this happens the truck seems sluggish and the A/C will stop working. As long as the check engine light is ON the truck runs like it always has, when it goes off the issues start. If I am stopped with the clutch depressed the idle will drop down to 500 rpms or so.
Kinda hoping it is something I can fix or at least learn about so I can have an intelligent conversation with a mechanic.
Ford Ranger / B-Series :: ABS Light And Speedometer Not Working
I have the infamous ABS light & speedo not working on my 2000 Ranger. I replaced the ABS Speed sensor on the rear diff as has been suggested on many posts, but it didn't solve the problem. Did I get a bad part or is there something else I should go after?
View 7 RepliesFord Ranger / B-Series :: 1997 - Radio Not Working?
I have a '97 Ranger 4.0 4x4 5 speed, as the title says... my radio does not work. It has an original cd radio and I had installed an aux cord. After I installed it I could only get a select amount of radio stations, last week I had went out of town so I didn't drive it at all, I came back and there was what seemed to be no power to the radio at all. No display, no sound. Only the lights on the radio controls (pre-sets, volume, seek, etc.) I have checked the fuses, pulled the radio and checked everything from behind and still nothing. Could the radio its self be bad? What else should I check?
View 1 RepliesFord Ranger / B-Series :: 2010 - AC Always On / Working All The Time
I recently got a 2010 Ranger sport 4x4, and the a/c seems to be working anytime the cold air is selected and any vent position.
View 3 RepliesFord Ranger / B-Series :: 1999 - Heater Fan Not Working?
My wife's 99 Ranger's heater fan is not working. It was working off and on until now. The fuse is fine. I went out this morning and tested the blower motor for power in --had voltage. Assuming the motor was bad, I pulled it. Before wasting $ and a trip to town, I bench tested it --it works. Now my question: what do I do next?
View 6 RepliesFord Ranger / B-Series :: 1998 - Speedometer Not Working
so heres whats happening. My 98 ranger speedometer has not been working since I owned it (I am the second owner who got it from a grandpa) and I've replaced the vss sensor two times, got a new connector and gave that a try and still nothing. Yes I've looked for cracks in the wire or any exposed copper, I've looked through many forums and cant figure it out. At first before replacing the vss, my abs and check engine light weren't lit up until i put a new vss sensor on that i got from o'reillys, so then i got another one thinking it was just a bad sensor and still no luck. another thing is when its cold in the morning and i get in my pickup to go to work it will start working once i go over 30 and fluctuate between that and 20 but if i don't accelerate it will not bounce all over the place.
View 4 RepliesFord Ranger / B-Series :: 1999 - Gas / Temp Gauges Not Working
Just purchased this truck and noticed the gas and temp guages neither work. Where do I start/ How about fuse box?
View 5 RepliesFord Ranger / B-Series :: 1988 - Turn Signals Not Working
I have an 88 ranger with the 2.9l. The headlights work and the markers do to. The brights don't though. and also none of the turn signals work, the brake lights work though but i don't think the reverse do, I can't see them. Do the turn signals and brights share a fuse on there own? How to diagnose it or what it may be?
View 9 RepliesFord Ranger / B-Series :: Rear Drum Brakes Not Working
Received the truck, 1989 Ranger XLT long bed single cab from my mom. It had been used by my younger brothers for some years, and then sat at mom's for a couple years.
It needed new front brakes badly, so replaced rotors, and pads. No unexpected problems there.
Looked at replacing the rear. Both adjuster cables were initially broken, so they obviously weren't adjusting, or braking. Replaced with a hardware kit, and shoes, and drums. Its the 9" drums, BTW.
Still not actually braking. I can tell this, when at a stop sign in the winter, with the brake pedal held down, and the backs will still spin, with the tranny in D. Even on gravel or grass, this'll happen.
One shop told me this is because the axle seals are leaking. THey've never leaked badly, and the axle fluid isn't low, by and shade of the imagination. Also, this theory falls apart, when the parking brake works just fine, right? Its just hydraulically that they don't work.
I've since replaced the wheel cylinders, the brake line from the frame to the rear axle, and the master cylinder. No change. Bleeding them doesn't seem to be a problem; i.e. no lack of or little fluid witnessed, it seem fine.
Also have bypassed the RABS valve for about a year or so, and its made no difference. Last fall I pulled the drums off, and manually adjusted them, and it didn't seem much better either.
Ford Ranger / B-Series :: 2000 XLT - Cruise Control Not Working
My 2000 4.0 XLT Ranger has been without working cruise control for several months now. I've checked what appear to be likely related fuses and they're all good. I *DID* have a recent problem with my brake lights but that's been fixed. (The shop that replaced my rear leaf spring hanger brackets pinched a hot wire between the brackets and the frame which eventually shorted. Wire and fuse were replaced.)
A few years back, Ford had a recall related to the Cruise Controls causing fires. I had the recall service performed on this truck. In a nutshell: The switch to disengage cruise when braking is attached to the master brake cylinder, and a leak in the switches diaphragm allows brake fluid into the switch causing an electrical short, causing the wires to heat up, and in some cases causing a fire. Ford, instead of switching to a different switch design (like maybe a mechanical switch on the pedal?) put a fuseable link in the hot wire from the potentially leaky switch.
Well, the truck now has over 150K miles on the factory brake cylinder/cruise control switch. I'm suspecting that my switch finally leaked, shorted and blew the fuseable link. Would Ford fix it? (They should, considering the lame fix for a lame design flaw.)
Ford Ranger / B-Series :: 1990 - TC Lockup Was Working Now Won't Lock
Just picked up a 90 Ranger last night, 4.0 EC, good ole A4LD, from a recipt I found has 70K or so on rebuild, was driving it today and the TC unlocked, and now it won't lock back up. I checked fluid and it was a little low, topped it off and drove it, and it was the same thing. I'm kinda new to thease A4LDs I know they can have issues, but can be good too. Just want to know whats going on so I can fix it! No codes were found when I scanned it. Trans otherwise shifts fine, you can feel it go into OD but no lockup.
View 13 RepliesFord Ranger / B-Series :: 1991 - AC Suddenly Stopped Working
I have a 91 Ranger that the A/C was working great in but all of a sudden it stopped working even the fan. I turned it of and back on and it started again but then just stopped for good I can get the fan to work sometime, but no cold air. What it might be?
View 2 RepliesFord Ranger / B-Series :: 1990 2WD - Speedometer Stopped Working
I have '90 Ford Ranger 2wd standard cab long bed. A few days ago the speedo stopped working. What is the more likely cause? The gauge itself or a relay/cable. And if it is the cable/relay are they hard to remove & replace.
View 1 RepliesFord Ranger / B-Series :: Dome Light Not Working And 5 Beeps
I have a 1999 mazda b2500 and unable get my dome light to work. Replaced the light bulbs so not issue.
Issue #2 When I start truck I get 5 beeps for 5 times and after truck running for extended periods beeps again.
How do I repair these issues?
Ford Ranger / B-Series :: 1992 - Both Power Door Locks Won't Working?
So I've got this 1992 Ranger extended cab with power door locks and neither side is working. It has power windows too and they work fine. I checked the 30amp fuse under the hood for the power door locks and it's good and checked it with a test light and it's good. What's most likely the cause that both sides don't work? Is there a way to troubleshoot with a test light to trace down the problem as a bad switch or actuator?
View 10 RepliesFord Ranger / B-Series :: 1996 - Odometer Quit Working But Sometimes Will Run A Few Miles
My odometer has quit working but sometimes will run a few miles. The truck has about 100,000 miles on it and the speedometer works fine.
View 14 RepliesFord Ranger / B-Series :: 1997 - Interior And Brake Lights Won't Working?
Just Bought 97 Ranger 2.3L 5 speed. Everything worked except interior cab light and cab brake light. Also the wipers and A/C blower only work on highest speed when I bought it. I assumed there was a problem with the switches, bulbs and/or fuses. But when I picked it up last evening I noticed the dash lights were very dim on the way home. Then when I got home I shut everything off and removed the key. I then opened the drivers door and touched the brake pedal and the dash lights and the parking lights came on along with the "key in ignition" bell alarm each time I touch the brake pedal. If I close the door the dash and parking lights come on but the key in ignition does not sound. With so many things malfunctioning I don't know where to start.
View 7 Replies