Ford - Explorer :: 1996 - Speedometer Jumpy And Odometer Quit Working / Shifts Hard
My speedometer is jumpy, odometer quit working at same time. Shifts kinda hard going into 2nd and 3rd gear. I am at wits end. I have replaced both speed sensors, checked all fuses, and also tore dash apart checking the worm gear in the cluster. I don't want to take to the ford dealer. The truck got 172,000 on it but been very well maintained. I just don't think its the transmission. Its got to be something easy.
View 9 RepliesFord Ranger / B-Series :: 1996 - Odometer Work Intermittently?
I have a 96 ford ranger 4cyl 5 spd. I've only had it for a month or so, but I've noticed on cold mornings my odometer won't work. The trip or the total mileage. I can hear the odometer cable clicking. Once the cab gets warmed up it'll start working. It's only happened twice, at about 50 degrees or lower, so I can only imagine what'll happen once winter kicks in. Where to go from here? I was thinking maybe it needs to be re-lubed or something...
View 9 RepliesFord Ranger / B-Series :: Brake Light Quit Working / No Power To Switch At Pedal
What is the likely culprit? No other electrical issues, brake light quit working when brake is depressed, all other lights work including blinkers/running/head. Was going to break out a wiring diagram....
View 7 RepliesFord Ranger / B-Series :: 1989 - Side Wiper Quit Working - Shaft Location?
This morning the passenger side wiper on my 89 Ranger stopped working. I heard a clunk noise and it stopped but driver side still works. What should I check first? I'm guessing a shaft came off but don't know where it is located.
View 14 RepliesFord Ranger / B-Series :: 1999 - 4 Wheel Drive Quit Working - Wiring Diagram?
My son has a 99 ranger and the 4 wheel drive quit working. Traced it to the front hubs not getting vacuum. If I jump around the vacuum solenoid(not sure if that's what it's called), the 4 wheel drive works. Looking for a wiring diagram that shows how this is supposed to work electrically?
View 5 RepliesFord Ranger / B-Series :: Heat Quit Working / Water Coming Out Of Tailpipe With White Smoke
I have a 1997 Mazda b4000 new plugs wires head gasket an I cleaned out the radiator. My question is the truck runs good but my heat quit workin what could it be all fuse look good. Also there is water coming out of my tailpipe with white smoke. Should I be concerned.
View 2 RepliesFord Ranger / B-Series :: 1999 - Electrical Malfunction - Burning Smell - Hard Downshifting - Power Window Quit Working?
I'm having some issues with my 99 ranger. It all started on my way to work one afternoon. Going down the road I started to smell some type of electrical burning smell. I looked at my instrument cluster and seen a trail of smoke come up between the steering wheel and ins cluster from under and gear selector covers. After that the O/D off light started flashing and downshifting hard. My pwr windows and dome light also quit working. Checked fuse #26 and all my fuses before going into work that afternoon, all of them were good and none blown. After shift was over that night going home I needed to use the wipers and they wouldn't work either. Also noticed then that my speedo, odometer and trip odometer not working. I've pulled my dash and steering covers off trying to find or see anything but nothing yet.
View 14 RepliesFord - Explorer :: 1996 4x2 - Odometer And Trip Meter Are Not Working
My new to me 96 4x2 4.0 automatic Explorer has a working speedometer, but the odometer, and trip meeter are not working. I used the search, but found nothing. What should I be looking for to fix this problem?
View 3 RepliesHyundai - Sonata :: Speedometer And Odometer Quit Working Completely
I have a 2007 Hyundai Sonata SE XM (153K miles). The speedometer and odometer have quit working completely. The speedometer doesn't even move from zero, no bouncing around or anything. The odometer also is not logging miles. My transmission shifts gears just fine and the cruise control works as well. I bought an OBD-II scanner and no codes came up. My first thought was maybe the vehicle speed sensor, but everything I've found on that say the car will shift poorly and the speedometer bounces around.
View 4 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Speedometer Quit Working - Stays On 0 And Odometer Stuck
2004 F250 Crewcab 4x4 5.4 automatic.
My speedometer quit working - stays on 0, my odometer stays on 271006.5 miles. Everything lights up, when I do a gauge sweep, the speedometer goes from 0 to full blast then back to zero. On the gauge sweep, my odometer states off all the code stuff like I think it's suppose to.
Anyway, I was lucky enough to get a speeding ticket - driving with the flow of traffic, with the police officer behind me for a mile or more. Pulls me over, explain my speedo just went out, he said he can't let me off but the judge might. So I'm trying to fix prior to a court date.
Here is what I have tried so far.
1. Replaced the VSS in the axle - no change to problem.
2. Replaced the sensors on top of the tranny (2 of them) - no change in problem.
3. Sent the cluster off to a repair shop - they said it worked when it left there shop - no change in problem.
4. Replaced the battery - thought it might have a dead cell. - no change in problem.
5. Unhooked the battery, turned on the headlights, waited 30 minutes, put it back together. (did this probably 5 times) - no change in the problem.
6. Replaced the diff fluid. - no change in problem.
7. Replaced the front left abs sensor on the hub - the existing wire looked like it had rubbed on metal - possible short? - no change in problem.
So far I've just been what seems to be time and money at it with no luck.
Ford Ranger / B-Series :: 1995 - Fixing Broken Odometer?
What are the steps to fix a broken odometer on a 1995 Ranger? I assume it is probably the gears. The truck has 169 k.
View 14 RepliesSanta FE SM (2001-06) :: Speedometer Not Working - Odometer Lit Up But Not Adding Miles
My speedometer decided to quit working this morning. The odometer is lit up but its not adding miles as I drive.
View 11 RepliesFord Ranger / B-Series :: No Speedometer / Odometer After Alternator Changed - Code P0500
1998 Ranger... I started having Speedometer/odometer problems after a power surge when my alternator went out. I knew the alternator was going bad and I tried to limp home another 5 miles rather than pay a tow bill and the alternator overcharged for a few seconds before completely dying. Since that time the only problem I am left with is my Speedometer and odometer have not worked. Scan tool says p0500 and I have replaced the ABS sensor on the differential with an OEM part but still no speedo or odo. I have checked all the fuses and relays associated multiple times. I do suspect that the RABS resistor is bad but there is no ABS light and it doesn't make sense that this one resisitor is the sle key for the whole speed control circuit. It's a manual transmission and RABS only. I swapped out the Cruise Control Servo with no luck as well. I am running out of options before having to take it to a dealer because I have to pass inspection. I have also checked and there is no power coming to 679 (GY/BK) into the instrument panel. I have also checked continuity for the rear harness to the ABS sensor and it is good.
View 2 RepliesFord 6.0L Power Stroke Diesel :: Speedo Quit Working - Needle Dropped To Zero And Stayed There For At Least 5 Miles
So i had been up in the woods for better half of the day. I had been in 4wd a few times, didn't thrash on anything and while driving home about 30mins into the return trip on the pavement i noticed my speedo only showing 10mph. I know i was easily going 50mph. I changed my SGII gauge to show MPH and sure enough i was going way faster. Eventually the needled dropped to zero and stayed that way for at least 5 miles. Then I came to a stop to and made a right turn giving it a bit of throttle and the speedo began to work correctly and did so for the remaining 5 miles. the Odom also during that time wasn't adding mileage. could this be from the rear sensor ontop of the rear diff?
View 6 RepliesFord - Taurus :: 1996 - AC Suddenly Quit / Blower Motor Stopped Working
Well, let me rephrase that, the AC works but blower motor doesn't. When you put your hand up to the vents, they're cold.
Long story short, I ran my AC on MAX on way home from work, driving time of approx. 35 minutes. I got home, showered, and got back into car to go downtown to store. It was then I discovered that the AC wasn't coming on, and it was still on max. I shut it off and turned it back on, but to no avail. I checked all related fuses, or at least what I think is related and checked my "Taurus Bible" the chilton manual. I swapped out a blower motor relay and it didn't work, but i'm not sure that relay was or was not good, it was out of a '96 E-250 at work.
So now I get out my test light. I pulled the connection from blower motor, connect it and turn on AC and light comes on. Vents are getting cooler. So I get my tool and pull the radio and climate control assembly. I pull the plug to the actual fan connection, the part that connects to the fan switch that controld fan speed. I'm getting nothing there.
Is there a relay I don't know of? I know the AC still works because vents are still getting cold, but I can't get air to move. A LONG time ago it did this but "corrected" itself. What is my next step? I'm not sure what to check next and my repair manual is leaving me in a boat with no oars.
More details of car:
1996 Ford Taurus 3.0 V6 Vulcan motor, 8th VIN is UAUTO188,000 miles
White 4 door gray interior 3 car seats
GoodYear Tires inflated to : 33lbs LF34lbs RF36lbs RR35lbs LR
Ford Ranger / B-Series :: 1986 - No Fuel To Rail / Truck Quit On The Way
I have a 86 ranger 2.9 5 speed. A few days a go I replaced the front fuel filter and all seemed ok. Last night on my way home the truck quit and I had to have it towed home. Now I find both pumps don't seem to be working. What would make me loose both pumps??
View 11 RepliesFord Ranger / B-Series :: 1995 - Won't Start At 253k Miles?
I have a 1995 ranger with a 4.0 it cranks just fine wont fire has alot of fuel spark it will crank and crack then it stop and acts like it is going to fire up and stops cranking. This thing has 253k on it.....
View 6 RepliesFord Ranger / B-Series :: 1996 XLT - ABS Not Communicating
My 96 ranger had lost a brake pad coming out of the mountains. I replaced the rotor but the ABS light came on as well as the check engine within a week. Several issues the clock spring was bad, replaced. The cam position Sensor was bad, replaced. I had this at a shop in a small town. While I was there they ran diagnostics.
At first the ABS module was sending data and gave them some info. Suddenly there was no more data stored in the module. They ordered a new ABS module installed it and replaced the LF sensor cable. Both sensors were cleaned prior to this.
The new abs module required a trip to ford to reprogram. At the shop they still could not get the light out. I took the truck home to my ford dealer and they said bad abs. Got a new (rebuilt Mfg discontinued) Installed and ford said this was bad with a code c1102. 4 w 4wd installed needs 4 w 2wd. ordered a new abs. Ford said same code again and the tech said that the ABS is not communicating through the obdii port.
My thoughts are the reader they used at the small shop was defective and either shorted out something or blew a fusible link. I am told this is 4 wheel abs with the rear sensors are on the pumpkin but after looking at the diagrams I do not see a RABS fuse. I have tested all fuses, and the shop replaced several relays. The pcm and ABS diodes check ok. Perplexed.
GMC - Yukon :: 1996 - Cruise Control Quit Working
In 1970 I bought one of the first Chevrolet Blazers. I drove it until two years ago when it finally was just too worn out to drive, at close to 300K miles. I sold it to someone who is in the process of restoring it for show. I knew that I wanted an other 2 door Blazer, but they quit making them in 1995. After a long search I purchased an original 86K miles on a 2 door 1996 GMC Yukon SLE. I love this car.However, I have just experienced my first mechanical failure. I am a fairly good shade tree mechanic. At 70 years old I have worked on every vehicle I have ever owned. So I am trying to figure out what has gone wrong with the cruise control. On a return trip from our lake house in Kansas (yes, there are lakes in Kansas) to my home in Nebraska, as I was going up and down the rolling prairie hills, the cruise control started having trouble going up the inclines. Then it quit working altogether. I checked the fuses and they are ok. My next thought is the control unit has quit working. I looked for a replacement unit and saw the price.... Is there something else that I could check before I replace the control unit? Is there any way that I can verify the control unit is at fault
View 1 Replies