Subaru - Outback :: Disappearing Coolant No Leaks Visibly Or Under Pressure Test
1998 subaru coolant has disappeared 2 times with highway driving last June and November but it exhibited no leaks visibly or under pressure test. Put fluorescent dye in. Found a hairline crack in neck of radiator under hose and replaced in december. End of february with local driving after siting for 5 days it overheated, sucked up reserve tank and needed a quart of coolant in the new radiator.No leaks under pressure test again and tested ok on turnpike. No smells oil ok. Doing tailpipe heat dye test to see if it's burning coolant and needs head gaskets.
View 9 RepliesFord Ranger / B-Series :: 1984 2.8L V6 - Accelerator Pump Leaks?
I have a 1984 Ford Ranger 4x4 with 2.8L V6, carburetor number E37E-AEA. The accelerator pump diaphragm is perforated.
Small holes are visible when I hold it up to a light. Is this part available anywhere? Is it included in these carb repair kits that I see on a lot of auto parts sites? The sites don't list the contents of their "kits."
Ford Ranger / B-Series :: 1994 - Slow Leaks And Vibrations From Multiple Wheels
'94 Ranger with aluminum wheels.
I have problems with slow leaks and vibrations from multiple wheels. Both problems have persisted through multiple tire changes over the years. The same shop has always done the tire changes and they tell me they've been balancing the wheels and cleaning the inner rims. The vibration went away after putting on my B2 wheels. Then swapping the rears back to the ranger wheels, 2 at a time, the vibration was back for both test drives (hence vibrations from multiple wheels).
The wheels are badly corroded at the rims and valve stems which leads me to believe it's the wheels themselves that are causing the leaks. I haven't heard of excessively old wheels causing vibrations though which is why I ask. I will likely be buying some craigslist or junkyard replacement wheels but wanted to "check in" first.
Ford Ranger / B-Series :: 1988 - Water Leaks Onto Passenger Feet After Heavy Rain
My 1988 Ranger has started leaking a gush of water onto the feet of passengers the first time I accelerate after a heavy rain. I saw the water flowing out from behind the glove box area as I started driving forward. How to fix this leak?
View 5 RepliesFord F-150 - 1997-2003 :: 1998 - Coolant Loss / No Apparent Leaks
I have an 1998 F150 4.6L V8 that is using coolant. I recently replaced the radiator because of a leak in the lower right side. Vehicle has about 190000 miles on it. The vehicle is using some coolant, but no apparent leaks. When I warmed up the engine after replacing the radiator, liquid dripped out of the back of the muffler - rusted out.
View 3 RepliesFord Ranger / B-Series :: 2008 - Foul Smell From Floor Vents?
in my 2008 ford Ranger Sport with a V6. The smell reminds me of one winter when I had stepped in dog and didn't know it until I was four miles down the road and the heater was on full blast. The smell floods the cabin when the heater is first turned on and warms up, but dissipates after a while. (And I don't have dog on the floor boards or on my boots.)
The smell does not come out the AC vents or when the AC was operated this past summer.
Ford Ranger / B-Series :: Crank For Few Cycles But Plugs Are Dry - No Fuel Smell
2000 flex fuel 3.0 4x4 .
I have checked the fuel pressure and it is good.
I have good strong spark to each plug.
I have cleaned each plug. and i have a no start situation.
Does the cam position sensor control the injectors firing? Or does it control the firing order for spark? I can crank her for a few cycles and then pull the plugs and they are dry,with no fuel smell.
The motor has a cam position sensor and a crank position sensor. ijust need to know what each one controls.
Ford Ranger / B-Series :: 1998 - Gas Leak / Smell Whenever Start The Motor
My ranger decided to start leaking fuel somewhere probably a few weeks ago. I can smell it whenever I start the motor, and sometimes while driving with the windows down. Last night, I finally looked into the problem. I took the intake air hose off. The hose, air filter, and whole intake smells like gas. I'm thinking that shouldn't be the case on a fuel injected engine. After seeing some people talk about the Fuel Pressure Regulator go bad, I pulled the vacuum line off of it, and it has a very strong gas smell. I don't see any gas coming out of it, though, even with the motor running. Everything I read says if the regulator is bad, then gas should come out of the vacuum line. Is there another check I can do on it to confirm this is the problem? Is there somewhere else I should be looking? It got two new heads right before this problem started, so its quite possible I knocked something putting it back together.
View 6 RepliesFord Ranger / B-Series :: 2000 - Burning Gear Oil Smell From Right CV Shaft?
In 4 x4 ( 2000 ford ranger 4.0 ) and drive for a while I can smell gear oil burning off the exhaust looks like it's coming out of the right cv shaft? Is there a seal that goes first That's bad?
View 6 RepliesFord Ranger / B-Series :: 2006 - Way To Change Coolant?
I looked for any tips on changing the coolant in my '06 2.3L Ranger but found nada. How to best / easiest way to drain the coolant from this little rig? Is there any need to worry about bleeding any captured air in the system once I go to refill the system?
View 11 RepliesFord Ranger / B-Series :: 1994 - Running Rich / Strong Exhaust Smell
1994 reg cab 4.ol 13ok.. my wife just got it, been doing some small things like replaced dome light, replaced cargo/third brake light, truck starts and seems to run ok. but i get a headache in it which i believe is carbon monoxide, has a leak or something? i text previous owner, he said he replaced 02 sensors, but didnt say if they were bosch or a good brand.. also trucks has a oil pressure and coolant temp gauge fitted on by the gear shift as the dash gauges for those functions are out. Does this mean the CTS may not be working and affecting fuel/air I do not know these trucks i only just found out what this strange silver looking thing was it is the IAC, I Believe, then there is this black plastic vacuum type cylinder by the passenger side firewall, what is that? and right against the drivers side fire wall is a small reservoir type thingy, is this something to do with ABS? i do have an ABS light on, was hoping it was the bulb out on the third brake light or something quirky like that no such luck its still on after starting engine. but i am concerned about this running rich/strong smell as we really cant take it far as is it, its dangerous, may have to get a smoke test? Just got the truck, trying to get caught up..
View 8 RepliesFord Ranger / B-Series :: 1987 - Running Extremely Rough / Exhaust Smell
I have a 87 ford ranger pickup, it is running extremely ruff. You can smell the exhaust and it smells super rich and is even spitting fuel out of he exhaust. when I bought the truck the wires were cut on he oxygen sensor, so I put a new oxygen sensor in it hoping that it would lean out the fuel. The truck has duel tanks on it, but the back one is off and it is draining fuel out of the line when it is running. I don't know if the catalytic converters are plugged too, the truck only has 65,000 miles in it. or maybe its a vacuum line leak?
View 4 RepliesFord 6.0L Power Stroke Diesel :: Oil Temp Overheating But No Coolant Disappearing
The truck has been just terrific, mostly used for towing our travel trailer. Earlier this year i developed a leak and lost 3 quarts of oil before I caught it. I would think with 15 quarts in her this shouldn't have been too big a deal. However, I am now experiencing 10-15 degree swings between ECT and EOT. Before I give the particulars, yes, I have had three new thermostats, two Ford and one brand X.
Anyway, coolant temps are 184-200 depending upon load, terrain, etc. At the same time, oil temps run 205-230. There is no oil cooler to get plugged up. She's got 120K on the clock, doesn't burn oil, no disappearing coolant. I am concerned about blowing a head gasket or other serious damage at these temps, but don't have a clue where to start? Yes, the fan does come on, but still this seems plenty hot.
Ford Ranger / B-Series :: 2002 - Changing Coolant Sensor?
I removed what I could, plastic cover and thermostat housing. Looks like I have to pull the intake to get the little bugger out of there. What's the procedure to remove and replace?
View 2 RepliesFord Ranger / B-Series :: 2002 V6 Slightly Over Heated - Oil In Coolant
My 2002 4.0L V6 Ranger, 4x4 overheated *slightly* this past weekend. I added some water and limped it home with a couple stops, trying not to let it get too hot. I since noticed there is oil in the coolant, so jumped to the first non mechanic's assumption the head gasket was bad. I have had (auto) tranny troubles with this truck in the past and started looking inside today and noticed some red fluid under the truck. I think the tranny fluid cools through the main radiator on this one, yes? If so, do I likely have a bad radiator, or is there another likely possibility?
The only wet areas I can find look like where the hard lines come into the right side (looking from the front) back of the rad. If we can determine that, would I need to replace the radiator, or is there any way to plug the tranny lines and run through a separate cooler? I think this also has a tranny, or oil cooler in front of the main radiator but not sure if that is correct, or what exactly that is. This is my daily driver work truck and will bring work to a stop until I can figure it out.
Ford Ranger / B-Series :: 1990 - Extremely High Oil Pressure / Heavy Smell Of Burning Oil
I own a 1990 Ford Ranger, 2.3 EFI with an 8 Plug setup and 2WD. It uses a dual-coil system an not a distributor if that means anything here.
Okay, so for the last week I have been experiencing extremely high oil pressures. My gauge would read almost as high as the "H" mark. The smell of burning oil was heavy in the cab from the vents. I took it easy, made sure my oil level was good and I had enough oil, the truck drove rough, but drove decent.
Yesterday, I got done sliding in some mud (not crazy bouncing or anything, just sliding). I stopped at a stop sign, turned around and hit the gas, and the truck died. I thought there were other issues not related to oil, however I noticed that the oil gauge now read about an inch left of the "L"ow mark. If I turned the key, to the "ON" position, the gauge pushed the needle to above the left gauge itself pointing towards about the "8 oclock" area.
Now, my truck will not start. It cranks and cranks and cranks with no start. I called a bunch of mechanics and none of them knew what I should do. AutoZone did not know what do, no one did. Some people said that the oil pump itself had gone out and that would cause the truck not to start and would cause gauge issue. Others said that it might be as small as the Oil Pressure Switch. Firstly, I bought a new Pressure Switch. Have not installed it because I cannot find the damn thing.
Where the switch OFFICIALLY is. I have read on Google that it is on the passenger side, at the rear end of the cylinder head. Other posts say it is by the oil filter...
PICTURES:
Without the key in the ignition:
With the key in the ignition, in the "ON" position:
Ford 7.3L Power Stroke (1999-2003) :: Severe Oil Leak And Coolant Disappearing
I was searching for an oil leak forever. In my search for the leak I resealed my hpop, redid oilcooler rings and last week had a friend pull my motor to redo the pan gasket. The leaks were almost down to where I thought we had them beat. Now in the last couple days I'm losing coolant and oil....bad. there is oil on the ground mostly from the cross member. Question is did my oil cooler fix not take? I have read that a nicked of ring can cause this.
View 11 RepliesFord F-150 - 1997-2003 :: 2001 - Coolant Smell - Can't Find Leak?
I have an 01 supercab. 5.4 Triton 135k. I have begun to smell coolant the last couple of days. Have seen nothing leaking and truck doesn't run hot.
Will investigate more this weekend. Where to start looking for this. It has to be leaking somewhere. Windows don't fog and the smell is there all the time. I live in florida so don't use much heat.
Not the heater core. Heat works fine and no smell from the vents.
Ford F-150 - 1997-2003 :: Little Rough On Start Up / Slight Coolant Smell
OK, I have a 1997 F150 2wd 3 door with a 4.2, approximately 130000 miles on it. I am the 2nd owner and have only had it for a couple months.
I noticed it ran a little rough on start up but smoothed out after it warmed up so I wasn't too concerned. CEL was on but it ran fine. I got the truck from my FIL and he said that it just had new hoses put on and the CEL came on after that. I noticed a slight coolant smell and after a big leak by the water pump I discovered that the guy who fixed it didn't have any of the hose clamps as tight as they should have been.
The heat went from really good to non-existent the last few weeks, never had any over heating issues though. Last week I was driving it to work and the temp gage spiked the light came on. I stopped and checked the coolant and it seemed fine. After I sat for a minute or two I checked the temp and it came back to normal. I figured it was because I let some pressure out of the system. It got hot again when I got to work but didn't spike at all driving home. I figured the water pump or t-stat was bad.
I replaced those on Saturday. When I filled the coolant up it ran rough and smoked but stopped and ran fine. Temp was fine but heat was nada. Today same thing, smokes like a steam engine for a few minutes then runs fine. Coolant smell is noticeable. I had the codes scanned and got P0303, P0174, and P0171.
I am thinking intake gaskets, since it seems to be an issue with these engines. I am going to fix it before I get a hydro lock situation, so what would be the next thing to look at before deciding that they need changed? Do I need any Ford specific tools to do this job?