Ford Ranger / B-Series :: Truck Started On Its Own / Wouldn't Shut Off And Starter Engaged In Park

So I turned off my truck the other day, got out, and it started again on its own. Confused, I looked in my hand to see my key. I got back in, and tapped the brake thinking the command start had engaged, even though I did not have the remote with me. It continued to run. So I put the key back in the ignition, turned it to ON and back OFF. It still ran. I had to run inside for a half a minute so I left it running.

Came back and drove away with no issues. When I stopped again about 2 minutes later and shifted to PARK, the starter engaged making it's terrible 'hey stupid, I'm already running' sound. I tried shutting it OFF quickly but it still ran and made it's skinning crawling noise. So I quickly shifted back to DRIVE. All the gears worked fine but PARK and NEUTRAL had the starter engaging. I also could not shut the truck off from DRIVE as the key would not turn.

I drove over to a local garage and called them from the truck as I was effectively trapped in the truck with my foot on the brake, unable to shift to PARK or turn it OFF. No supporting staff. So I drove back to work where I had a co-worker remove the battery cable at which point I was able to shift to PARK and turn OFF the truck. I let it sit like that for about 10 minutes and haven't had a problem since.

What happened?? And for the record I can put gas in the tank and changed my own oil, but that is the extent of my vehicle knowledge.

View 14 Replies

Ford Ranger / B-Series :: 2003 - Truck Wouldn't Start Again After Parked

My 03 Ranger 4.0L has become a mystery that has baffled every one I know. Everything was fine and I ran home to something from my house was in there maybe 10 minutes came out and the truck wouldn't start. it doesn't even crank over. out of the clear blue. I had a friend who works for a garage check it and he thinks timing chain. Since then I have been told it wouldn't just fall off sitting there with no indication at all there was a problem.

Thought maybe PATS system. Its in order. Put in on a computer from auto-zone and it shows a check engine light but the reading is there is no codes in the computer on file. I am at a loss. Its been months and I really cant afford to take it to a garage right now. Its the strangest thing ever no crank, no stalling just nothing I hit the switch it lights up like its ready to start and nada.

View 3 Replies

Ford F-150 (2004-2008) :: Truck Wouldn't Start Now Won't Shut Off When Pulled Key Out Of Ignition

What happened is I went to get in the truck I opened the door and the gauges and blower motor came on by itself like the ignition is in the on position. I put the key in the ignition and the truck didn't do anything. No crank or anything and I did notice the anti theft light blinking really fast. I unplugged the battery and plugged it back up then the truck started but I went to shut it off and pulled the key out the ignition and truck stayed running. But also the blower in the truck and the gauges are still staying on. People keep saying it's my key but why would the stuff cut on by itself inside the truck when I just opened the door?

View 9 Replies

Ford Super Duty (1999-2016) :: 2006 F250 Truck Shut Down Wouldn't Start Back

Ok truck shut down wouldn't start back. Put fuel filter o. Frame cranks but won't start. Was told has high pressure oil leak in engine?

View 8 Replies

Ford Ranger / B-Series :: 2.3L Mazda B2300 Died And Wouldn't Start Back Up

I am working on a 96 Mazda b2300 auto 2wd for a friend. His son was driving it when a loud noise, it died and wouldn't start back up. He had it towed to my house, I started to tear into to it and found it slipped the timing belt. So a rebuilt head, gaskets, timing belt, fuel injectors, water pump, thermostat, plugs, and fluids; tried to start it and nothing. Started troubleshooting and found the primary coil pack was out of spec, replaced and still nothing.

Changed out the CKPS still nothing? I have spark, I have fuel, I'm going to check compression tomorrow but the way the cylinders and pistons looked I don't think that is the issue but I going to check anyway, rechecked the timing marks they all lined up. Checked the fuel inertia switch not tripped. Could the PCM, or ICM cause a no start, and still be able to get spark and fuel?

View 2 Replies

Ford Ranger / B-Series :: 1994 Truck Will Shut Off When Slowing Down And Push On The Clutch

I have a 1994 Ford Ranger Supercab with 180,000 miles, 4.0ltr 6cyl and it is in relatively good condition. When I bought the truck the check engine light was on. The previous owner said that it was something in the gas tank that has gone bad but it was not a big deal and the truck could be driven with no problems.

My mechanics have tried several times to read the error code but their diagnostic tool won't tell them what is wrong.

I have noticed over the past few days that when I am slowing down and riding the clutch (I was making a u-turn this morning) that the truck will shut off. It starts right back up but it keeps happening.

I have been considering replacing the IAC, new spark plugs, rotor and wires and fuel filter but I am not 100% this will fix my problem. I am NOT a mechanic but know plenty of them so it will be a situation where I buy the parts and a buddy puts them in.

View 9 Replies

Ford Ranger / B-Series :: 1996 Truck Idles From 500 RPM And Randomly Jumps Up To 2 - 3000 RPM Then Back Down

I have a 96 ranger with the l4. Right before I bought my newish truck last December, it's started miss firing and running really bad. I replaced the spark plug wires, most of the spark plugs, and both coil packs. Didn't work at all. Then I bought my new truck and parked. Fast forward to now. Fired it up, ran REALLY bad. We changed the wiring order from the 96 order to the 99 order.

But the truck idles from 500rpm (barely running) and randomly jumps up to 2-3000rpm and then back down. Driving it has NO power, rev it and it stays at 2-3000 for quite awhile. Sometimes it randomly dies. REALLY need to get it running quick and cheap. Getting ready to sell my daily driver to find something else and I need something to drive while I hunt for another truck.

View 1 Replies

Ford Ranger / B-Series :: 2002 - No Start When Shut Off

I have a 02 ranger..3.0 standard trans 4x4.... Started running crappy, cleared up and when shut off, now wont start... Good spark and good gas pressure... Seems to want to try, but just doesn't go. No codes or pending codes.

View 8 Replies

Ford Ranger / B-Series :: 1992 - Shut Down And Won't Start?

I have a 92 ford ranger. About a year ago it shut down on me as I was pulling out of a parking lot. I replaced the Cam sensor which IS NOT located on the engine block by the fire wall. It is located on the front of the engine just above the primary cam which is just above the crank shaft and its sensor. It fired right up.

Then the oil pump went out and I just replaced it the other day and the pressure gauge/needle went past the half way mark even at idle. I drove around a bit, maybe 10 miles, then got in it to go to the gas station and got about 50ft from the house and it just died again and will not crank back up.

I am thinking its that darn cam sensor again. But, just like the oil pump was, it's a pain to get to and replace. How to test it. Oh, it is a 2.3 4 cyl. double overhead cam. I do have fuel pressure, I checked that already.

View 14 Replies

Ford Ranger / B-Series :: 1996 - Won't Start And Crank Even?

I have a 1996 Mazda B2300 & I heard that it is similar to the Ford Ranger.

Well the thing won't crank or start.

This is what I have done so far. I wanted to put a RPM meter on it. I followed YouTube videos on how to do it. I cut the Tan wire w. the yellow stripes & try to connect the wire to thr RPM meter. Then it won't start soo idk what to do. I also took put the PCM too. (I was looking for the wire) Now be honest, I talked to a mechanic, he said thag I might have blown my PCM or Blown another fuse. But when i put the key in to crank, it won't start ot click at all. The lights come on & it wants to start but won't start.

Then my mechanic tried to start it by the... Idk what it is called but you can start it & it wont evet start. It will crank like crazy but will not start at all.

View 1 Replies

Ford Ranger / B-Series :: 2000 Does Not Want To Start After Shut It Off - Backfiring

I'm having problems with my 2000 ranger 4x4 off road edition it has 262,000 miles when it runs for about a half an hour shut it off try to start it in 20 minutes or so doesn't want to start sounds like it's backfiring to the throttle body replace the crank positioning sensor replace the ignition coil still doing it.

View 3 Replies

Silverado :: 1996 - No Start After 3 Or 4 Block Drive And Shut Truck Off For 1/2 Hour Or So

1996 1500 4.3 19k - After a 3 or 4 block drive I shut truck off for 1/2 hour or so. Went to start and got this no start situation acting like it was either flooded or vapor lock. New battery, new alternator...did act like a flat spot in starter a couple of tries but otherwise normal starter action.

I let it sit for about another fifteen minutes...tried and it started right up? I have been told this is a problem with the distributor cap & rotor going bad and is a common problem. Is this correct? If so, how is this corrected. Does the whole distributor have to be replaced? Rebuilt? Does just the distributor cap and rotor need replaced?

Batt and Alt less than three months old.

View 9 Replies

Ford Ranger / B-Series :: B3000 Shut Off At Red Light Now Won't Crank Over Or Start

My mazda b 3000 shut off while at a red light i t turned over initially 3-4 times now nothing. changed EGR, ECM, CRANKSHAFT AND CAM SHAFT SENSOR three weeks ago. brand new battery, took alternator in and it was bad so i replaced. theft light is blinking rapidly?

View 2 Replies

Ford Ranger / B-Series :: 1996 - Start If Turn The Key To On And Jumping The Solenoid

I have a 1996 Ford Ranger XLT Automatic with a 4.0... A few months ago I went to start it and it would not start. All the lights were on and working, the radio worked etc. I figured it was the fender solenoid so I replaced it. Didn't fix it. I jumped the solenoid and it spun up. The only way I can start the truck is by turning the key to on, and jumping the solenoid. I replaced the ignition switch that is under the instrument panel, and the ignition cylinder that the key goes in to. I have reason to think that it may be the neutral safety switch, but I do not want to go out and buy the part and it not be the issue.

View 14 Replies

Ford Ranger / B-Series :: 1996 - Crank 4 To 5 Times To Start Intermittently?

i have a 96 ranger with a 2.3l engine sometimes it will start right up and sometimes it has to crank 4 or 5 times to start i just gave it a tuneup and changed the oil and filter. should i run sea foam through the oil system,it sat for about seven years and i need to convert the idiot gauge to a real gauge.

View 2 Replies

Ford Ranger / B-Series :: 1996 Won't Start - Strange Engine Sound?

I just received this ranger and have never heard an engine sound like this before.

[URL]....

View 14 Replies

Ford Ranger / B-Series :: 1996 - Turns Over But Just Doesn't Want To Fully Start Up

So I just finished redoing my head gasket. Everything is hooked back up the way it was prior to the tear down. I'm getting spark, fuel, compression, timing was set correctly according to Haynes, turns over but just doesn't want to fully start up.

View 3 Replies

Ranger :: Truck Stopped Running Suddenly, Now Won't Start

I was driving along as happy as could be, and suddenly lost power. 2000-2001 Ranger, 5 speed. After I got it home, I plugged in a charger, tried jumping it and all. I was getting a few turnovers, now I only get a click. Wipers, Lights and fans all work so there is some power at least.

I finally found my Ohm Multimeter and checked the current from battery to power box.

battery + to - 12.96

battery - to power - 0.00

battery - to power + 12.96

battery + to power - 0.00

battery + to power + 0.00

Now that just seems insanely odd to me.

View 1 Replies

Ford Ranger / B-Series :: 1995 Truck Will Not Start With The Key

I have a 95 Ranger with the 2.3L and it is a five speed. I am having a starting issue. I have replaced the ignition switch, clutch position switch, starter relay and had the starter tested. The truck will not start with the key. I can jump across the relay and it starts fine but will not even click with the key.

View 3 Replies