Ford Ranger / B-Series :: 1985 - Missing At High Acceleration?
85 ranger 2.3 fuel injected misses at high acceleration. Fairly new plugs and wires, just replaced the timing belt, pretty new fuel pump in tank, new fuel pressure regulator and pcv. It idles well, starts up and drives pretty well until you get it in 4th and really bog it down. Could be timing issues but I'm pretty sure I did everything right when I put the belt in. What it could be? I know when the tank fuel pump went out, it did something similar for a while...
View 9 RepliesFord Ranger / B-Series :: 1985 - Bogs And Dies While Driving
I have a 1985 ranger 2.3l efi and it bogs and dies while while driving, it can sit and idle all day long but when you go to drive it, it works great for 3-4 minutes then out of nowhere starts bogging sometimes I can keep it going a little longer but in the end the truck always dies . I know I'm loosing fuel pressure , I hooked a gauge up to it and drive it down the road when the truck died it showed 10 psi , from here I'm lost . It has a new fuel pump in the tank and I can hear the other one running when I click the key on , Also two new fuel filters .
View 3 RepliesFord Ranger / B-Series :: 1985 - Shifter Really Loose / Stuck In Reverse
1985 ranger 2.3L TK5 tranny. Shifter was really loose and the tranny finally got stuck in reverse. I have opened up the bottom cover, but am not sure where to move the shift forks to get it back to neutral. I bought a new shifter, but I need to get the tranny back to neutral before I can install it.
View 2 RepliesFord Ranger / B-Series :: 1985 - Chattering At Startup Which Quickly Went Away After Warmed Up
My ranger has always run pretty good except for a small bit of chattering at startup which quickly went away after it warmed up. Now all of a sudden its much louder and doesnt seem to go away while driving. I read about the oil pickup tube getting blocked and not properly delivering oil and so I performed the superhuman task of dropping the oil pan to check. While I couldnt get the oil pan all the way out, I got it to where I could feel the oil pick up screen and everything seems okay. I have the valve cover off. Are the lifters adjustable? Whats the issue?
View 10 RepliesFord Ranger / B-Series :: 1985 - Died All Of A Sudden And Won't Start Back Up?
I was driving my 85 2.3 liter down the road and it died all of a sudden like and wont start back up. I took out a plug to check for spark and had someone turn it over and I touched it to the big metal part the grill connects to at the top but I got nothing. It IS getting gas. The spark plug was white as if it was really hot and rough-looking for its relative newness. I bought a new distributor cap because it was corroded, but it didnt work. They tested the ignition module at the store and its good, so I am thinking distributor?? Also, could compression issues keep it from sparking? I am a little worried it got over-heated somehow, but don't know....
View 9 RepliesFord Ranger / B-Series :: 1985 - Running Rough - Bogging Out And Stalling
I am fairly new to this stuff but I just got a 85 Ranger 4x4 and its running pretty rough it will be fine then all of a sudden it will bog right out and want to stall so I have to keep my foot planted on the gas and it pops and spudders and eventually runs normal again? Its a 2.8 V6 carb...
View 14 RepliesFord Ranger / B-Series :: 1985 - Location Of Block Connecting EGR Line?
So 85 ranger with 2.3l and A4ld. I can manually shift to get first and 2nd. When i look at the vaccume diagram it shows these 2 blocks on the tranny,one box is connected to the next with a vac line. The other box has 2 lines, one goes to the main vaccume block on the intake and the other T's into a small capped off canister and the egr. I can only find one place for a vac line and its on the pasgr side of the tranny... Where is the block that the egr line connects too located? Its not on the tranny as far as i can tell.
View 2 RepliesFord Ranger / B-Series :: 1985 - Heater Blower Sounds Like A Legion Of Demons
When I turn on my heater full blast the most god awful squealing commences. Where to start spraying the grease?
View 10 RepliesFord Ranger / B-Series :: 1985 - Water In Oil / Small Leak At The Thermostat Housing
So I noticed when I check the oil, there is a very small amount of water at the end of the dipstick and also water mixing with oil around the oil cap. It is not much water at all, but my first thought was head gasket. I was loosing very small amounts of coolant, but found a small leak at the thermostat housing....The truck runs fine, idles fine, no bubbles coming from the radiator at startup, no moisture from exhaust. It seems to be using more oil than normal, but I drive it 100 miles a day still and no major issues other than the perplexing bit of water and oil mixing. Could it be a tiny head gasket leak? What else would cause the water and oil to come together.
View 13 RepliesFord Ranger / B-Series :: 1985 - Electrical Wiring / Brake Lights Not Coming On
85 ford ranger 2.3 efi .. My brake lights still aren't coming on. According to the Haynes manual, the wire that runs from the stop light fuse goes from there to the hazard flasher and then to the brake light switch. Since I have checked everything else, is it possible that the hazards are causing a break in the connection?
View 4 RepliesFord Ranger / B-Series :: 1985 - Brake Lights Out - Fuse Blows Every Time?
So I did alot of electrical work on this truck but never had any problems with the brake lights, now they dont work and the fuse blows every time you pop one in.
View 1 RepliesFord Ranger / B-Series :: 1985 - Truck Simply Quit / No Spark At The Coil / Cranks Just Fine
85 2.0L Dura Ranger.
All of the Idle control wiring and box and sensors have been removed; all else is original. The truck ran just fine after the removal of the above paraphernalia (years). The truck simply quit, no spark at the coil, cranks just fine. All of the wiring has been checked for continuity. The Following components have been replaced with new:
Ignition switch.
Coil.
Dura-spark Box.
Dist coil.
Starter solenoid.
Rotor & Cap.
Plugs and wires.
Correct voltage is present at the coil & D-spark box side of the connector.
Coil tests close to what I think is correct for resistance and the engine ran with it.
I have tested both sides of every connector. I'm not sure what the output side of the D-Spark box (blue tab) voltages should be, and I am unable to test the trigger signal at the coil, however with no output and power in I'm guessing that is the problem...
Ford Ranger / B-Series :: 1985 - Fuel Pump Wires Heating Up Intermittently At Inertia Switch
1985 2.3L... New fuel pump And fuel pump relay, problem was happening before new parts. the wires at inertia switch continue to get hot switch has been removed. The heat continues to under the hood where there is some so rt of connecting link and heat stops.what the is this link for, it doesn't look like A fusible link?? Saw a similar post here about a fuel pump shutting down and wires getting hot. Same problem.
View 9 RepliesFord Ranger / B-Series :: 1999 - Won't Heat Up?
My aforementioned ranger does not seem to heat up. Unless it is 95 degrees in the shade.... I have movement in the dash meter. Some - it will come off of the bottom - to not quite the c - then immediately dive back to less than cold ( which I realize is not possible) - engine seems to run fine. Use 93 octane or it knocks like a diesel. 135 K - I changed the thermostat. Less movement on gauge now than Before. Coolant level is fine. I read something in another post about the blend door. But my engine temperature doesn't even seem to be getting warm so how would the blend door be effecting that? I am an electrician not a mechanic, however I do all my own mechanic in in self defense. Since I cannot afford mechanics.
View 9 RepliesFord Ranger / B-Series :: 1994 - Low To No Heat
1994 ranger 3.0 .. New: water pump, htr. hoses, radiator, thermostat, pulled & flushed htr. core. (2 year time frame) ....
View 5 RepliesFord Ranger / B-Series :: 2007 - Air Flow With AC And Heat Is Low?
The air flow with ac and heat is low on my ford ranger. I can hear the blower change speeds, but on high, it barely comes out. The temp is fine and achanges from cold to hot like it should. i had the ac checked out by a shop that that does free checks - no problems with lines or compressor. I replaced the blower motor. The air changes from defrost to floor and all the positions fine, but the air flow out all the vents just isn't what it should be. It was working fine the first couple of days. I've read about the blend door motor, but I haven't read about people having this exact problem. I am almost to the point of bringing is to the dealer, but would rather fix it myself.
2007 Ford Ranger ... 6 cyl. 3.0 L ...
Ford Ranger / B-Series :: 1998 - No Heat Only Cold Temp?
98 ford Ranger 2.5L.
I have not heat from the vents, doesn't get warm at all. If I idle the enginer in 30 Degree weather it gets to almost the C.
Upper Radiator hose is hot, I have verified the thermostat is new and it opens at 192 degrees as it should. Replaced the Water Pump, Fan spins freely.
I have attempted to burp the system, it isn't kicking out anymore air from the lines that I can tell. I used a large funnel and filled it with Anti-freeze, it filled the radiator, burped the system and the reservoir filled to overflowing. All with the engine hot. (To be specific the funnel was always full of fluid so no air could get sucked backwards)
The heater core hose on the left when looking from the front of the vehicle does not get hot, the one on the right gets warm. I theorize that the heater core is clogged up somehow and that is why that left line doesn't get hot. There is no fluid in the cab of the truck from the core.
Ford Ranger / B-Series :: 2001 - Won't Heat Clicking Noise?
i have a 2001 ranger 4x4 the problem is sometimes it will switch into 4 wheel drive and sometimes it wont just hear clicking noise ,i'm preety sure it doenst have a vaccum.
View 14 RepliesFord Ranger / B-Series :: 2002 - A/C And Heat Blows Through Defrost Only?
I have a 2002 Ford Ranger 3.0L truck that, all of a sudden, has a problem with the HVAC system that blows air only thru the defrost vents even when selecting any other vent levels (defrost, face/middle or floor levels).
I did find a thread on another forum regarding this problem, only it was for the 95-01 Ranger model years, yet they say that the 2002 Ranger is not the same as those earlier models.