Ford Ranger / B-Series :: 1985 - Won't Getting Any Heat?
I have a 85 Ranger with a 2.3L engine. I'm not getting any heat. The temperature gauge never moves off of C, except when stuck in stop & go traffic. Even then it doesn't come up much. I tried to fix this last year by putting in a new thermostat, but it didn't work.
View 6 RepliesFord Ranger / B-Series :: 1994 - Low To No Heat
1994 ranger 3.0 .. New: water pump, htr. hoses, radiator, thermostat, pulled & flushed htr. core. (2 year time frame) ....
View 5 RepliesFord Ranger / B-Series :: 2007 - Air Flow With AC And Heat Is Low?
The air flow with ac and heat is low on my ford ranger. I can hear the blower change speeds, but on high, it barely comes out. The temp is fine and achanges from cold to hot like it should. i had the ac checked out by a shop that that does free checks - no problems with lines or compressor. I replaced the blower motor. The air changes from defrost to floor and all the positions fine, but the air flow out all the vents just isn't what it should be. It was working fine the first couple of days. I've read about the blend door motor, but I haven't read about people having this exact problem. I am almost to the point of bringing is to the dealer, but would rather fix it myself.
2007 Ford Ranger ... 6 cyl. 3.0 L ...
Ford Ranger / B-Series :: 1998 - No Heat Only Cold Temp?
98 ford Ranger 2.5L.
I have not heat from the vents, doesn't get warm at all. If I idle the enginer in 30 Degree weather it gets to almost the C.
Upper Radiator hose is hot, I have verified the thermostat is new and it opens at 192 degrees as it should. Replaced the Water Pump, Fan spins freely.
I have attempted to burp the system, it isn't kicking out anymore air from the lines that I can tell. I used a large funnel and filled it with Anti-freeze, it filled the radiator, burped the system and the reservoir filled to overflowing. All with the engine hot. (To be specific the funnel was always full of fluid so no air could get sucked backwards)
The heater core hose on the left when looking from the front of the vehicle does not get hot, the one on the right gets warm. I theorize that the heater core is clogged up somehow and that is why that left line doesn't get hot. There is no fluid in the cab of the truck from the core.
Ford Ranger / B-Series :: 2001 - Won't Heat Clicking Noise?
i have a 2001 ranger 4x4 the problem is sometimes it will switch into 4 wheel drive and sometimes it wont just hear clicking noise ,i'm preety sure it doenst have a vaccum.
View 14 RepliesFord Ranger / B-Series :: 2002 - A/C And Heat Blows Through Defrost Only?
I have a 2002 Ford Ranger 3.0L truck that, all of a sudden, has a problem with the HVAC system that blows air only thru the defrost vents even when selecting any other vent levels (defrost, face/middle or floor levels).
I did find a thread on another forum regarding this problem, only it was for the 95-01 Ranger model years, yet they say that the 2002 Ranger is not the same as those earlier models.
Ford Ranger / B-Series :: No Heat But Hoses Are Warm / Hot To The Firewall
1998 Ranger. I have no vacuum to the heater control valve (see link below) and hoses are warm/hot to the firewall. Where to start troubleshooting?
More Information for FOUR SEASONS 74809
Ford Ranger / B-Series :: 1992 - No Heat / Power Steering / AC?
1992 Ranger 4x2 with 2.3L stick shift no AC no power steering. Recently the temp gauge began fluttering in the cold range from far left to just below the normal range. The defrost and heater blows only cold air. I had a professional shop radiator flush done. No change. I changed the engine thermostat out for a new one but no change. The upper radiator hose feels hot, so I assume the thermostat is working.
Questions: Where is the temp gauge sensor located on the engine? Is there another sensor or shutoff before the heater that might not be working? Where do I take things apart to check if the heater blend door is working?
Ford Ranger / B-Series :: 2001 - A/C Compressor Coming On With Heat?
I have a 2001 Mazda B3000. The a/c compressor is coming on while I'm running my heat. The air coming out while the heat is on stays warm. However, when I was running the A/C during the summer the air would start blowing out warm after it had been on for a while. Several people told me it may have something to do with the blend door or blend door actuator but both appear to be working fine. What it could be?
View 1 RepliesFord Ranger / B-Series :: 2002 AC Compressor Kicks In When Turn The Control To Heat
When I turn the control to heat the AC compressor kicks in. If turned to vent it does not kick in. Was this just a design flaw.
View 3 RepliesFord Ranger / B-Series :: New Heater Core / Blower Motor And Resistor Still No Heat?
with a new heater core, new blower motor, and new resistor and no heat, what would be the problem? gonna check the thermostat tomorrow.
View 2 RepliesFord Ranger / B-Series :: Heat Quit Working / Water Coming Out Of Tailpipe With White Smoke
I have a 1997 Mazda b4000 new plugs wires head gasket an I cleaned out the radiator. My question is the truck runs good but my heat quit workin what could it be all fuse look good. Also there is water coming out of my tailpipe with white smoke. Should I be concerned.
View 2 RepliesFord Ranger / B-Series :: 2003 XLT - Compressor Making A Loud Click Noise Engaging Even Though Not Using Heat Or AC
I have a 2003 ford ranger xlt 4.0L and here recently my ac compressor has been making a loud click noise engaging even though i am not using heat or AC, so when it engages the rpms drop and almost wants to stall and it does this in about 10-15 sec. intervals, but when I am driving it acts fine. What is going on here, I recently had a vacuum leak and i found it and fixed it, and now this issue just started.
View 2 RepliesFord Ranger / B-Series :: 1999 Won't Go Into Overdrive
I went to transmission shop today and tech told me c solenoid was showing performance problem when scanned. He took it for drive and said it was commanding shift into fifth gear. It is a 3.0 extended cab 2wd with just over 200000 on truck, transmission was rebuilt just over 25000 miles ago. Fluid is so clean its still clear looking just faint red color. All other gears shift and pull great all electrical clean and hooked up, he crawled under it and said pan adjustments were tight, whatever that means.
View 14 RepliesFord Ranger / B-Series :: 1999 - Miss With A/C On?
My 99 ranger has a strange issue its got a miss when the A/C is on, when going down the road I can feel the engine sorta pulse for a second, gets better the more I drive it, its got all new plugs and wires, not sure where else to look?
View 1 RepliesFord Ranger / B-Series :: 1999 - Sometimes Won't Go When Select 4WD Hi Or LO
Just purchased a 1999 4.0L 4WD, when I select 4WD Hi or LO sometimes it will go, sometimes it won't. Now the 4WD Hi and LO lights are flashing intermittently while I'm driving. At one point the Hi light burned and wouldn't turn off.
View 14 RepliesFord Ranger / B-Series :: 1999 - Won't Run - Programming ECM?
Okay here's the story I bought a 99 Ford Ranger with a bad 4.0 engine. I had a newer 2002 4.0 and tranny out of another Ford Ranger thought it be an easy swap put the newer engine in and it will only run on the original Older ecm (but ruff) and the older ECM is screwing with the transmission (no reverse) unplug connections at tranny and i have reverse. So I buy a ECM from a junkyard for the 2002 and drop it off at the dealership to have the Pats programmed. and the dealership says they can't program it to make it run. They say the Pats are different from 99 to 2002. So I go another route I buy an SCT performance chip and have them disable the Pats. still won't run.
View 14 RepliesFord Ranger / B-Series :: 1999 - 4x4 Does Not Engage
I drive a 1999 ford ranger and can't figure out why my 4x4 won't engage. I have vacuum all the way down to the hubs and when I turn the switch it sounds like the transfer switch is engaging but the 4x4 still doesn't engage. What do you all think could be the issue? I thought about just putting a set of the manual locking hubs on it and just be done with it.
View 1 RepliesFord Ranger / B-Series :: 1999 - CEL On - A/C Stopped Working?
I have a 1999 Ranger 4x4 4.0 5 speed step side...in Jalapeno no less. Anyway, for the past 5 years or so the check engine light has been on. When it came on I did nothing because nothing seemed to change and I was too broke to fix it anyway. Well, just lately the check engine light has started to flicker or go out completely.
When this happens the truck seems sluggish and the A/C will stop working. As long as the check engine light is ON the truck runs like it always has, when it goes off the issues start. If I am stopped with the clutch depressed the idle will drop down to 500 rpms or so.
Kinda hoping it is something I can fix or at least learn about so I can have an intelligent conversation with a mechanic.