Ford Ranger / B-Series :: 1985 - Brake Lights Out - Fuse Blows Every Time?
So I did alot of electrical work on this truck but never had any problems with the brake lights, now they dont work and the fuse blows every time you pop one in.
View 1 RepliesFord Wiring/Electrical :: 1985 - Driver Side Brake Light And Turn Signal In The Back Quit Working
85 f150. My driver side brake light and turn signal in the back quit working. The tail light works tho which is a different filament. The bulb is good and I changed the flasher relay...the circle thing in the fuse panel. Everything else works just fine. looking for a starting point.
View 7 RepliesFord Wiring/Electrical :: 1985 - After TPS Sensor 0 Volts?
I have an 85 bronco ii 2.8l, carb, with around 109K on it , ran pretty good, some stubles here and there but found out how to read codes and went from there.... Retreived codes 23, 31 and 84. Checked TPS, had voltage to sig return pin but was low, pulled the carb, bought a rebuild kit while i was at it and redid most of the gaskets but did not take the inner parts of the carb out, put on a new TPS, installed the carb, unhooked battery for about half an hour and noticed it idled very high. Once you were moving the rpm's would drop but at idle would climb again. I ran the codes again and got 31, 63 and 84. checked volts from black to vref i have 4.9 and from black to sigrtn i have 0. i have traced all 3 wires through the bundle and did not see any breaks i know that the green wire goes to the ECM? but i do not know what to check from this point.
View 2 RepliesFord Wiring/Electrical :: Brake Lights Not Working
My brake lights don't work. Turn signals, tail lights, hazard flashers work, but if I hit the brake, nothing happens. What could possibly be the problem? Could there be a wiring issue?
View 7 RepliesFord Wiring/Electrical :: Brake Lights Not Working
I did lower the steering column, onto the seat. Also lowed the dash and the wiring. Does it sound like the Multifunction switch could be bad? I can put it in drive, so I don't think it's the brake light pedal switch, that's bad.
View 14 RepliesFord Wiring/Electrical :: Brake Lights Not Working?
i have an 85 f150. the brake lights are not working. i checked the bulbs, both filiments are working. i have running lights, turn signals, and hazards, just no brake lights. i am confused as to why i have everything else except brake lights. need to figure out what to do next to figure this out.
View 14 RepliesFord Wiring/Electrical :: 1985 F150 - Hot Wire The Truck To Start?
My 85 f150 5L is parked to far in into my alley.. the last time i saw my keys i moved it up to water the plants that it was tucked almost on top of.
ive been looking for the keys for 2 months.. the truck isnt being driven at all but i think my neighbors are getting mad at it being out so far.
I can get in the engine bay, and i have jumped the starter on our big trucks at work before.. but what wires do i have to join to put the ignition into the run position?
Ford Wiring/Electrical :: 2002 - Two Brake Lights In The Taillights Don't Come On
I discovered today that I have no brake lights on my '02 Excursion. The center brake light works fine, but the two in the taillights don't come on. Stopped and bought new bulbs on the way home and replaced both, but the ones I pulled out were not blown. Checked the fuse - OK. Taillights and turn signals both work fine.
View 3 RepliesFord Wiring/Electrical :: 1985 F150 - Location Of Cruise Control Amplifier
Where is the cruise control amplifier located on an 85 F-150? The Chilton manual just says "behind the instrument panel". No pic or further description. Just looking up from the bottom of the dash I see a "black box" with 2 wires going into the top of it located just between the steering column and the wiper switch.
Is this it?
Ford Wiring/Electrical :: 1994 - Tail / Turn / Running / Brake Lights Out?
First off my driver side brake light with stop working. I took it apart to try and find the short. In the process I shorted out all my running lights tail lights and brake lights and turn signals I think also. While I was looking for the short, turn signal wire from my tail light touched the frame and grounded out and that's when all the lights died . My tail lights are some cheap trailer lights without reverse lights. I pulled headlight switch from another Ford truck I have. On the harness connector that connects to the switch which wires should read what when I test with a voltmeter?I checked the fuses in the power distribution box under the hood and they were good. Truck has a flat bed so I don't know if that matters with the wiring, I suspect it's different then a normal bed truck. Wiring on the bed is old, maybe from 94. I am unexperienced with electrical.
View 3 RepliesFord Wiring/Electrical :: 1992 - No Left Rear Signal Or Brake Lights
I have no left rear signal or brake lights. The right side works fine and both left/right tail lights work fine, just no left brake or signal. I checked for broken wires and can not find anything. 1992 Ford E50 7.5L.
View 1 RepliesFord Wiring/Electrical :: Both Blinkers / Tail And Parking Lights Came On When Push In The Brake
I just bought my first Ford its an 1996 f250 powerstroke, and I am having issues with it. Every time I push in the brake both blinkers come on and tail lights and upper parking lights on cab, and when I turn on a blinker everything flashes.
View 8 RepliesFord Wiring/Electrical :: Interior Lights Coming On Dimly And Relay Buzzing
I have a 2000 F350 7.3. I started out with my batteries dying after a few days of sitting. I found the interior lights were coming on dimly, and the relay buzzing. great, got it. I pulled the fuse and ordered the dimmer/light switch. I came back next week and the batteries are dead again. Charged them, drove the truck, and then the radio starts coming on without the key on. Pulled the radio.
Next day the truck starts fine, but now the seatbelt noid is going off all the time and the tranny overdrive is blinking "off" but still shifts fine, and goes into overdrive. The speedometer also works erratically... I read a post about the marker lights leaking, I looked and that's a definite possibility. My question is are all these related back to the GEM or BCM? or more problems?
Ford Wiring/Electrical :: Tail And Side Running Lights Take 10 To 20 Seconds Coming On
The front running lights come on immediately, but the tail and side running lights take their time coming on (usually 10 to 20 seconds later. 95 Ford E-350. Is their a relay that could cause this issue?
View 1 RepliesFord Wiring/Electrical :: 1997 - Headlights / Brake Lights Cut Off When Hit High Beam Switch?
So I recently bought a 1997 7.3l F250. It is in fairly good condition, but it has some problems with the lights working. The turn signals and hazards all work, as do the tail lights and headlights. However, when I hit the high beam switch, the headlights cut off entirely. Also, the brake lights do not work at all. Ive checked the bulbs and since they all work Im not sure what the issue is.
View 3 RepliesFord Wiring/Electrical :: Brake Lights / Cruise Control / Rear Hazards Not Working
1991 F250 Supercab Diesel 4X4. I made a mistake while wiring up my trailer lights and ended up grounding out my brake controller, frying it. Along with that, I popped a couple fuses as well (1, 5 and 9 I believe). Replaced all fuses and got my signals (F/R) back at least.
Here's what's NOT working/messed up:
*Brake Lights
*Cruise Control
*Rear ABS light comes on a few minutes after driving.
*Front hazards work, not rear. When I apply the brake, the hazards pause in the on position.
I've tested the brake switch on the brake pedal (Green/Red and Green) and it works properly. So, current is obviously not reaching the rear brake lights.
Another note. The truck is wired with a 7 pin plug in the bed for a goose neck trailer. It also was wired to a 6 pin on the bumper. I replaced the 6 pin with a 7. The signal/brake pins on the plugs (both) and also not receiving power. What's the next thing to check?
Ford Wiring/Electrical :: 2008 - Instrument Cluster / Interior Lights Coming On While Driving
I have a 2008 Ford F-150 xlt with stock instrument cluster. I need a new instrument cluster due to my interior lights coming on while driving. I would like to make it look better and not go stock. Id like to have digital shift screen and good looking LED's. What all are my options?
View 2 RepliesFord Wiring/Electrical :: 2004 F150 - Brake Lights / Turn Signals And Flashers Not Working
My brake lights, turn signals, and flasher are not working in my truck. Is it a fuse and what fuse? Could it be a relay?
View 2 RepliesFord Wiring/Electrical :: 1973 F250 - No Turn Signals / Brake Lights Or Rear Hazards
Dad borrowed truck and wired 7 pin trailer harness. Lights worked on truck/trailer for use but upon return the turn signals didnt work. Hazards and running and brake lights did work. Replaced TS flasher and Haz flasher. Still no signals. Pulled steering wheel and replaced turn signal cam only, not whole switch. Now no brake lights, no rear hazards or turn signals. Losing my marbles trying to follow schematic and using test light and mulit meter. All bulbs and fuses are good. Running lights and head lights working as well.
View 6 Replies