Ford Wiring/Electrical :: Brake Lights Not Working
My brake lights don't work. Turn signals, tail lights, hazard flashers work, but if I hit the brake, nothing happens. What could possibly be the problem? Could there be a wiring issue?
View 7 RepliesFord Wiring/Electrical :: Brake Lights Not Working
I did lower the steering column, onto the seat. Also lowed the dash and the wiring. Does it sound like the Multifunction switch could be bad? I can put it in drive, so I don't think it's the brake light pedal switch, that's bad.
View 14 RepliesFord Wiring/Electrical :: 2006 E150 - Turn Signal Quit Working / Brake Lights Not Working
Turn signals quit working on my 2006 E-150. Swapped out the relay under the dash and it did nothing. Also noticed the brake lights aren't working. The headlights and taillight a are working. I pulled the fuses under dash for the lights and they tested ok. I did notice the flasher relay was making clicking sounds intermittently even when not touching anything.
View 3 RepliesFord Wiring/Electrical :: Brake Lights / Cruise Control / Rear Hazards Not Working
1991 F250 Supercab Diesel 4X4. I made a mistake while wiring up my trailer lights and ended up grounding out my brake controller, frying it. Along with that, I popped a couple fuses as well (1, 5 and 9 I believe). Replaced all fuses and got my signals (F/R) back at least.
Here's what's NOT working/messed up:
*Brake Lights
*Cruise Control
*Rear ABS light comes on a few minutes after driving.
*Front hazards work, not rear. When I apply the brake, the hazards pause in the on position.
I've tested the brake switch on the brake pedal (Green/Red and Green) and it works properly. So, current is obviously not reaching the rear brake lights.
Another note. The truck is wired with a 7 pin plug in the bed for a goose neck trailer. It also was wired to a 6 pin on the bumper. I replaced the 6 pin with a 7. The signal/brake pins on the plugs (both) and also not receiving power. What's the next thing to check?
Ford Wiring/Electrical :: 2004 F150 - Brake Lights / Turn Signals And Flashers Not Working
My brake lights, turn signals, and flasher are not working in my truck. Is it a fuse and what fuse? Could it be a relay?
View 2 RepliesFord Wiring/Electrical :: Different Color Wires In Cab - Brake Light Not Working - Wiring Diagram?
Need a wire diagram. I have a connector in the cab that has red,blue,lt green,white wires. It's causing my brake lights not to work. I need a wire diagram that shows were they go. I can't find these wires in my Haynes manual.
View 3 RepliesFord Wiring/Electrical :: 7 Pin Trailer Wiring - Running Lights Not Working
Just bought an 04 Super duty with the factory plug 7pin and 4 pin plug. Checked the fuses and finally tracked down the 2 relays under the hood but can't seem to find anything wrong. Everything on the trailer works except for the running lights. Is there another fuse or something I have missed? Trailer works fine on my buddies Duramax and worked fine on my old 97.
View 14 RepliesFord Wiring/Electrical :: OEM Fog Lights Not Working
Truck is in signature. All of a sudden my oem fogs don't work. I took a volt meter to the connection where the bulb plugs in and no juice. Checked the fuse and its good.I get 12 volts or so at fuse for fogs.. The fog light illuminator lights at the switch when I pull the switch. Is there a relay somewhere under the hood. All the relays in the fuse box checked out good and none of them in my truck guide were labeled for the fogs anyways. Looked for 3 hours and cant find a thing. If all else fails how do I cut the wires at the fog lights and run wire to cab with toggle switch? I know I need a relay right? I am not familiar with hooking up relays..
View 14 RepliesFord Wiring/Electrical :: 2002 - Two Brake Lights In The Taillights Don't Come On
I discovered today that I have no brake lights on my '02 Excursion. The center brake light works fine, but the two in the taillights don't come on. Stopped and bought new bulbs on the way home and replaced both, but the ones I pulled out were not blown. Checked the fuse - OK. Taillights and turn signals both work fine.
View 3 RepliesFord Wiring/Electrical :: 1978 F150 - Dash Lights Are Not Working
Dash lights are not working in my 78 F150. The climate control lights come on and are dimable with the headlight switch. I pulled the cluster and the Blue/Red wire has voltage. Which might be the ground? The Seat belt light comes on at start and the left turn signal will blink. What am I missing. Oh the cluster is deteriorating. some of the bulb holes are chipping out.
View 1 RepliesFord Wiring/Electrical :: 1994 - Tail / Turn / Running / Brake Lights Out?
First off my driver side brake light with stop working. I took it apart to try and find the short. In the process I shorted out all my running lights tail lights and brake lights and turn signals I think also. While I was looking for the short, turn signal wire from my tail light touched the frame and grounded out and that's when all the lights died . My tail lights are some cheap trailer lights without reverse lights. I pulled headlight switch from another Ford truck I have. On the harness connector that connects to the switch which wires should read what when I test with a voltmeter?I checked the fuses in the power distribution box under the hood and they were good. Truck has a flat bed so I don't know if that matters with the wiring, I suspect it's different then a normal bed truck. Wiring on the bed is old, maybe from 94. I am unexperienced with electrical.
View 3 RepliesFord Ranger / B-Series :: 1985 - Electrical Wiring / Brake Lights Not Coming On
85 ford ranger 2.3 efi .. My brake lights still aren't coming on. According to the Haynes manual, the wire that runs from the stop light fuse goes from there to the hazard flasher and then to the brake light switch. Since I have checked everything else, is it possible that the hazards are causing a break in the connection?
View 4 RepliesFord Wiring/Electrical :: 1992 - No Left Rear Signal Or Brake Lights
I have no left rear signal or brake lights. The right side works fine and both left/right tail lights work fine, just no left brake or signal. I checked for broken wires and can not find anything. 1992 Ford E50 7.5L.
View 1 RepliesFord Wiring/Electrical :: Both Blinkers / Tail And Parking Lights Came On When Push In The Brake
I just bought my first Ford its an 1996 f250 powerstroke, and I am having issues with it. Every time I push in the brake both blinkers come on and tail lights and upper parking lights on cab, and when I turn on a blinker everything flashes.
View 8 RepliesFord Wiring/Electrical :: Tail / Parking / Dashboard Lights Stopped Working?
My tail lights parking lights and dash board lights stop working my turning signals work my brake lights work and my headlights work fine I checked all fuses are good I even switched out the headlight switch with a new one and nothing. What can this problem be?
View 14 RepliesFord Wiring/Electrical :: 2006 F350 - Radio And Dome Lights Not Working
I was replacing the dome light in my 06 Ford F350. I tested the light and it worked then while screwing it back in, the lights when out and then the radio. I suspect it may be a fuse, but have yet to find the culprit.
View 2 RepliesFord Wiring/Electrical :: 2005 - Rear Turn Signal And Brake Light Won't Working?
I just bought an 05 F250 XLT. I noticed tonight that the rear turn signals and brake lights dont work.
the front turn signals work fine, although they flash fast. I know that usually means a light on its way out. neither taillight flashes though, which puzzles me.
my second issue is that, of the 3 brake lights, only the high mounted light illuminates when I hit the brakes.
Ford Wiring/Electrical :: 1997 - Headlights / Brake Lights Cut Off When Hit High Beam Switch?
So I recently bought a 1997 7.3l F250. It is in fairly good condition, but it has some problems with the lights working. The turn signals and hazards all work, as do the tail lights and headlights. However, when I hit the high beam switch, the headlights cut off entirely. Also, the brake lights do not work at all. Ive checked the bulbs and since they all work Im not sure what the issue is.
View 3 RepliesFord Wiring/Electrical :: 1973 F250 - No Turn Signals / Brake Lights Or Rear Hazards
Dad borrowed truck and wired 7 pin trailer harness. Lights worked on truck/trailer for use but upon return the turn signals didnt work. Hazards and running and brake lights did work. Replaced TS flasher and Haz flasher. Still no signals. Pulled steering wheel and replaced turn signal cam only, not whole switch. Now no brake lights, no rear hazards or turn signals. Losing my marbles trying to follow schematic and using test light and mulit meter. All bulbs and fuses are good. Running lights and head lights working as well.
View 6 Replies