Ford Ranger / B-Series :: 2004 - Steering Wheel Is Locked - Tumbler Is Out
My 04 ranger edge steering wheel is locked the tumbler is out but the little gear box on the tumbler is broke off and still in the assembly how do I get it out to install a new tumbler?
View 2 RepliesFord Ranger / B-Series :: Rear End Clunk Almost Sounds Like A Wheel Is Loose
I have a noise in my rear end, if I grab the bed of the truck, and rock the body back and forth, I hear a clunk, almost sounds like a wheel is loose, but checked them, all good, also checked the U-joints, and pulled the driveshaft to grease the spindle. Thinking it could be in the third member, maybe the Differential pinion shaft, or the lock bolt......
View 3 RepliesFord Excursion :: Front End Pop / Clunk Through Steering Wheel
On my way home from work I was turning a corner and felt a pop / clunk from the front end through the steering wheel, and the steering wheel was no longer centered going in a straight line.
With the truck not moving, when I turn the wheel left and right, I can hear and feel a pop / clunk through the steering wheel. I'm assuming this is a ball joint failure?
Ford F-150 (2009-2014) :: Intermittent Clunk In Steering Wheel
Having intermittent clunk felt in the steering wheel? It happens at random and not necessarily over bumps. You don't hear it as much as feel it in the wheel.
View 3 RepliesFord F-150 (2009-2014) :: Clunk In Steering Wheel While Driving Straight
I have a 2014 FX4 Ecoboost with 2K miles. While driving in a straight line on smooth roadway I feel a slight 'clunk' in the steering wheel. Feels a bit like slack or something. It only happens when the steering wheel is in perfectly neutral position ( straight up) with no turn to either side. Oddly I feel it more when I hold the steering wheel in the lower half as opposed to the upper side. Could it be 4X4 play or splines or loose something in chassis?
View 14 RepliesFord F-150 - 1997-2003 :: 2000 XLT - Clunk / Squeak In Steering Wheel
I have a 2000 Ford F150 XLT 4X2 that has a "clunking/squeaking" noise in the steering wheel, intermittent happens driving straight down the road, hitting bumps, breaking. It is very annoying! changed out lower ball joints tightened wheel bearings, greased idler/pitman arm thinking that was the problem and it became worse. Had someone look at it and stated that the steering shaft was welded?!?! Why would the steering shaft be welded what am I looking at in replacing it (cost for parts and labor time) and are there any other additional parts that will have to be replaced as well?
View 1 RepliesPassat (B5) :: Slight High Pitch Tick That Only Occurred When Steering Wheel Slightly Tilted Left
My brakes were terrible and finally got roders and pads for front yesterday ... well the pad on passenger side was like not there anymore almost metal on metal and driver side was not close to being that bad but like driving down road there was a slight hi pitch tick that only occured when steering wheel was slightly tilted left (counter clockwise).
We redid front pads and roders (did bad not to long ago) and now there a terrible rubbing sound and it only occurs when again wheel tilted left or making a left hand turn cant figure it out thought it was the wire clip to hold caliper in place but that's clearing rim .... it sounds like metal on metal and driving me nut was driving last night and after awhile it did go away but i have feeling it going to happen again when i drive it today ...
Ford Super Duty (1999-2016) :: Faint Clunk In Steering If Rotate The Wheel Back And Forth
So now, what I'm noticing is a bit of a clunk in the steering. It's minor, very minor... but like any problem they usually start that way. The sound is very faint, you can't hear it under the truck, only slightly in the cab but you can feel it in the steering wheel, not so much when driving but when sitting still in a parking spot it's pretty obvious if you rotate the wheel back and forth. You can also feel it in the floor. Sometimes I'll notice this if I hit a bump while I'm driving.
Here's what I know, if you grab the tie rod, either end, you get a slight bit of rotation. Not just one end moving, but the whole thing has a small amount of forward back rotation (I'm not sure if this is normal) I had my girlfriend turn the steering wheel while I checked different components and there didn't seem to be any left right play on the tie rods. The boots look good on the tie rods ends, pic included, looks of similar quality of drivers side.
Then the kicker, here's where I noticed the gobs of grease on the top end drag link, pic also included. This was the last link I looked at, and I guess least expected.
So I guess I'm thinking this drag link is bad, but this is my first stop on the advice train. I wiped off the boot that was covered in grease on the drag link and it looked like its in fine enough condition but I also seriously doubt the shop that added the leveling kit just decided to slob grease all over the outside of this drag link boot. I have my truck oil undercoated before every winter but, that was some bit ago, and this looked more like grease to me.
Truck background: 2012 F250 6.7, I'm at 42,000 miles, 34in tires for most of that, and more recently added a 2 inch leveling kit (40,000 miles) and replaced the suspension all around and added a dual stabilizer. I had some noise coming from the drivers side wheel-well a while back and found that one of the end links on the sway bars was simply loose. Tightened up and all good to go. At 30,000 I got some death wobble. Replaced tires, the stock stabilizer had also gone bad, and had an alignment. Everything good since, but I'm thinking some of these problems now might be remnant of the bad tires.
Ford Super Duty (1999-2016) :: Steering Wheel Jerk And Loud Clunk Noise
I took my truck to an alignment shop to have him look over my truck to find a steering wheel jerk and a loud clunk noise. He believes it's in the transfer case driveline. Said to remove the driveline then drive it around and see if it goes away, if it does then that's the problem. So to the question, how to properly take this out? Do I need to make marks with a paint pen anywhere to line things back up or does it matter?
View 14 RepliesCamry :: Faint Clunk Through Steering Wheel
I've noticed lately that I have a slight clunk that I can feel through the steering wheel, normally at very low speeds as when first moving. I can sometimes feel it at higher speeds but it tends to fade into the road noise and vibration. Acts as if it is not brakes but either a u-joint in the steering column itself or ball joint or tie rod end. Car is an 07 V6 with roughly 43k miles...
View 3 RepliesFord Super Duty (1999-2016) :: Clunk And Wheel Stayed In Same Position / Steering Completely Loose
While I was trying to park, I heard a clunk, wheels stayed in the same position. The steering wheel is loose as hell, it literally feels like its buttered up and wont turn the wheels at all, what to buy to fix it? I am thinking I just need a new gearbox....
View 6 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Clunk In Front End / Felt In The Floor And Steering Wheel
I have a 02 F250 4x4 5.4. As I drive and when pulling into a driveway I hear a clunk that can be felt in the floor and the steering wheel. I've replaced the wheel bearings and seals, shocks, ball joints, sway bar links and bushings, tie rod ends at the gear box and "right hand inner". The other two tie rods are tight and so is the track bar. I cannot duplicate the sound if I jack it up and move parts around with a pry bar. I can however move the steer box sector shaft upwards about an 1/8. I've adjusted the screw but it didn't do anything. Could it be the steer box or the springs? I've even mounted a GoPro underneath but everything moves and I can't tell why it is.
View 14 RepliesPrius (2010-12) :: 2011 - Getting Steering Wheel Clunk / Vibration Lately?
Lately I've noticed a momentary clunk or vibration in the steering column when turning the steering wheel while leaving a parking spot. It's not the same as hitting the end points of the steering range. It feels like some looseness in the coupling of the steering column.
It seems to happen when maneuvering in a parking lot, like after backing out of a parking space and then straightening out the wheels to go forward. It is random when it happens, only a couple of times a week so far. Should I take this in to be checked?
Sonata I45 (YF - 2011+) :: Clunk Noise When Turning Steering Wheel
A few weeks ago I noticed a 'clunk' noise when turning the steering wheel. It only did it the first turn on a trip. Over time it has gotten worse - the sound is the same, but it happens for several turns, maybe 10 or so, before it stops. After the car sits, turned off, for a while, the cycle starts again.
I replaced the rubber coupler on the MDPS, but my old one looked fine, and it made no change in the noise.
Pontiac - G6 :: Clunk Sounding Noise When Turn The Steering Wheel
This car has a V6 engine with 50000 miles. Nearly every time you turn the steering wheel you hear a clunk sounding noise. This has been going on for quite some time now. A mechanic said this is a common problem with this car. 2008 Pontiac G6....
View 2 RepliesIntrigue :: Clunk While Driving - Steering Wheel Locked And Would Not Turn Left
A while back as I was driving, I heard some sort of clunk, and the steering wheel locked and would not turn left. It then unlocked after a few seconds. Ever since then, it has been very hard to turn to the left (and right, at slow speeds and on sharp turns, but much easier than turning left). This happened a few days after I replaced both front end struts and inner tie rod ends, and got an alignment - they were cheap quick struts (entire assembly), but seem to be of fairly good quality.
Initially after some consultation I thought it was the power steering pump, so I replaced that. It became easier to turn right, but still very hard to turn left. I took the front end off the ground and turned the wheel all the way left and right, no problem or resistance. I am nearly certain it is not the pump.
At this point, I am fairly certain it is either the steering gear or some part of the rack and pinion. I am planning on getting the assembly replaced. The fastest and cheapest way is apparently to just buy the entire steering gear/r&p assembly. Would bad strut mounts ever cause an issue like this? Any other possibilities besides the steering linkage?
Camry :: 2006 XLE Has Steering Wheel Clunk / Shaft Making The Noise?
Not a huge deal, but my '06 XLE has a steering shaft clunk, I'm assuming that it's the collapsible shaft making the noise. I notice it, I don't dare mention it to my wife who drives the car. I'm at about 60K and I have read about the problem before, I was just wondering if there was ever a TSB on it.
View 8 RepliesSonata I45 (YF - 2011+) :: Clunk / Thud Sound When Turning Steering Wheel
I'm a 2nd owner of a 2011 Sonata, and am currently at 99,800 miles. I have an extended warranty (so I've been told) that covers powertrain I believe until 100,000? When turning the wheel to the right then left, or vice versa, theres a clunk/thud sound produced from the steering column.
I am assuming this is not normal. Will my hyundai dealer cover this since it seems to be a common annoyance on these cars. Is it dangerous to not get it fixed?
Prius (2004-09) :: Moderate Pitch Whine In Front End Only When Steering Or Turning Right
Have a moderate pitch whine in front end only when steering or turning to right. Gets louder w higher speeds but pitch is about the same. Thought it was a left front wheeling bearing. Also needed new pads and rotor. While doing the job noticed grease all over the lower ball jt. Discovered a tear in the outer axle boot. Net net replaced pads, rotor, axle hub assembly and axle complete. To my chagrin the noise has changed one bit. The noise also doesn't change when I put the car in neutral while traveling downhill. With the hope that I replaced the wrong bearing I have ordered a new one for the right passenger side. When I tried the 6-12 wheel rocking test on the right there did not appear to be any looseness.
View 5 Replies