Ford - Ranger :: 1994 - New Ignition Key Lock Cylinder / Steering Wheel Not In Locked Position
I easily removed the key lock cylinder but when I went to put the new one in I cannot get it to turn all the way back to lock the pin in place. The steering wheel is not in the locked position nor can I get it to lock. I have turned the steering wheel as far left and right as I could go with no success on getting it to lock or on getting the ignition key lock cylinder to turn back securing the actuator pin. The old key lock cylinder won't go back in either. What am I doing wrong?
View 3 RepliesFord Ranger / B-Series :: 2002 - Knocking Felt In Steering Wheel
I have a 2002 Ranger 2.3L 5spd w/ 16,000 miles. Have noticed this problem for 6 months, been to dealer 3 times now. They say nothing is wrong. What I am "feeling" more than hearing, is a slight knock in the steering wheel, particularly when driving over dips and mild to moderate bumps. This is usually when moving in a fairly straight line, not much tension on the wheel.
It reminds me of problems I had on much older cars/trucks when there was a loose shock/strut or play in a ball joint or tie rod. It is annoying because it feels like something is wrong. Dealer can't find anything. Perhaps something not installed properly that loosens and bumps/knocks into other components thereby transferring vibrations through the steering column?
Ford Ranger / B-Series :: Steering Wheel Slightly Turned To The Right When Going Straight
I had a friend do an alignment on my truck yesterday. Afterward, we tried to center the wheel the best we could in the shop. But when I drove it home I noticed that when going straight, the steering wheel is ever-so-slightly turned to the right. Is there and easy way to adjust this without me going back to the guys' shop and bugging him again? I know the alignment is dead nuts, but the wheel is just a tad off.
View 4 RepliesFord Ranger / B-Series :: 1997 - Removal Of Speed Control From Steering Wheel
My speed control has not worked in years and I do not use them any more any way. I want to remove the control area on each side of the steering wheel, the covers are all messed up so I would like to make it look like it came without them. Can I do this and if so how?
View 1 RepliesFord Ranger / B-Series :: Steering Wheel Lock Damaged - Popping Noise When Turning
While in the locked position, the steering wheel was purposely jerked hard to disable the mechanism on a 1996 Ranger. Now the truck will not steer easily or smoothly and a popping noise is evident when turning. I'm not concerned about having the wheel lock, but would like to be able to return driveability to normal.
The same guy who caused this damage also damaged the ignition. No key is needed to turn the switch now.
I'm lost as to how the steering locking mechanism works and wondering if I need to tear apart the column or if maybe there is a locking pin accessible that needs to be removed to regain driveability.
Lexus RX 2004-09 :: 2007 - Steering Wheel Locked And Key Won't Turn?
I've got a 2007 rx 350. The steering wheel is locked and the key wont turn. I've tried everything, forcing the steering wheel left and right, forcing the gear shifter to neutral and moving the car. I even tried to spray some wd-40 on the key and then trying it.
View 14 RepliesFord Ranger / B-Series :: One Hub Locked In 4X4
Hello. I never did this before but could you lock one hub in 2wd and leave the other unlocked. Also can you leave one hub locked while in 4wd? I was thinking if you have one hub locked would all the power would go to that wheel? Or will this do damage?
Thanks
Lexus RX 2004-09 :: 2008 RX350 - Steering Wheel Locked On Turning Key Ignition
I have a 2008 RX 350 and I am experiencing issues with turning the key ignition and having the steering wheel locked. It gets locked and after several attempts at jimmying the key it eventually starts. My concern is that if I keep this practice up I will damage my key. I have addressed this issue to the dealership and I was naive and trusted them with fixing the problem with my last maintenance visit. Thinking the the problem was solved I started to experience the same problem again. I was first told that it is possible the my key chains are too heavy which could of caused the problem but I lightened the load and still have this problem. I've read about this problem with other people but there doesn't seem to be a solution.
One thing I have noticed is that I tend to experience this problem during the cold weather. During warmer weathers I don't have issues with the key ignition being locked but now that it's cold I am having the problem again (not sure if this has to do with anything). Do I need to change a part out to fix this? I've also read that there can be dirt in the ignition which needs to be cleaned out. Will this work and if so how do I do clean it?
Ford Ranger / B-Series :: 2004 - 4 Wheel Drive Vibration At 40 MPH
I recently replaced the oil seal on the front differential where the front drive shaft connects to the diff. I believe it is called the pinion oil seal. I had to remove the drive shaft to do the job. Got the oil seal in place and then slipped the u-joint yoke on and hand threaded the retainer nut on to get it started. I did mark the relative position of the drive shaft to the front yoke and the rear yoke. I had previously noted that the retaining nut, before I took it off had about 2.5 threads showing. I had to remove it with an impact wrench.
So...I used the impact wrench to put it back on with about the same number of threads showing. I then reinstalled the little short fronmt drive shaft...the one that comes out of the transfer case. I got the front of it on to the pinion output on the front diff...and then had to reattach it to the transfer case end which, by the way an interesting affair with a sort of metal cone that is attached by 6 8mm fine threaded bolts about 2.5 or 3 inches long. Got all that done with much grunting an groaning - I'm laying on the ground - SO the oil, leak is fixed but now ...
There is a vibration at around 40 mph and higher. like something is out of balance. did i damage the front diff pinion bearing by using an impact wrench? this vibration occurs in 2 wheel drive. as i understand it the front drive shaft doesn't even turn when in 2 wheel drive. my question is does the front diff gears spin when in 2 wheel drive? perhaps the u-joint is bad on the front drive shaft? just a bit baffled. when the speed drops to below 40mph the vibration goes away...
Ford Ranger / B-Series :: 2004 - 4 Wheel Drive Kick In And Out When Driving
My 2004 Ford Ranger has 220,000 miles, runs great, and when I bought it this summer the 4 wheel drive worked great. Starting when the weather got cold when I engage the 4 wheel drive (no lockouts electronic engagement). I will drive and it will kick in and out of 4 wheel drive when it starts to slip or I have to accelerate.
When the 4 wheel drive kicks out I will let off the gas then it will engage again on its own, but will slip out again when on ice or I start to slip. When the 4 wheel drive engages it does NOT make any strange sounds, no clunking or nothing, it engages smoothly, and disengages properly.
What it could be? a connection? Any way to fix or diagnose the problem? I have been told that it probably is not the transfer case, because if it were it would not engage or stay in 4 wheel drive at all.
Ford Ranger / B-Series :: 2004 - Hard To Turn - No Power Steering?
My Daughters 2004 Ranger has about 195K the power steering reservoir is full it turns to the left as it should (assisted power steering) turning to right there is no power steering (manual Rack) I am thinking the issue is most likely in the steering rack..
View 2 RepliesFord - Ranger :: 2004 - Low Pitch Clunk Through The Steering Wheel
I own a 2004 Ranger 4x4 V6 4.0 Liter engine with 118,000 miles. This summer it has been experiencing a clunking/knocking noise for the first time. The noise only happens during days where temps are above 90 degrees and I've been driving for at least 10 minutes. I can hear and also feel the low pitch clunk through the steering wheel. It is more pronounced if I hold the bottom of the steering wheel. I park on concrete and have not seen any fluid leaks under the engine. The power steering fluid is not low. I've jacked up the truck to test tires. The tires do not wobble. A Ford mechanic has inspected the suspension and cannot find anything wrong. Of course when I took the truck to the mechanic is was a cooler morning.
View 8 RepliesFord Ranger / B-Series :: 1995 - Truck Would Not Start / Starter Locked Up
I have a 95 Ford Ranger 2.3L with a five speed. I recently had a starting issue were I parked the truck, went into a store came back out and the truck wouldn't start. Figured it was the solenoid as I couldn't jump across it to get the truck to start. Replaced the solenoid. Still no go. Found a fuse in the starting circuit blown. Replaced the fuse and got it started and drove home. Next morning, I go to leave for work and the truck would not start. Got a ride to work came home and checked it over and found the starter locked up. I replaced the starter. Truck started for a few days and now I am having problems again.
Here is the problem I am having now. Starter is good. Proved that as I can start the truck by jumping across the starter relay. Checked the solenoid with a voltmeter and it is doing what it is supposed to do when the truck starts normal. Here is where I am scratching my head. I can start the truck sometimes and it starts just fine. Next time I try to start it, the fuse will blow.
Replace the fuse and it might work for a couple of starts and then the fuse will blow again. I jumped pass the fuse with a piece of wire for diagnostic purposes. Out of 20 starts, it only started normally 4 or 5 times. I have checked every wire I can see under the dash and have not found any obvious issues. I am at a point where I am so frustrated that I just want to push this 400k mile truck into the back forty and put it out of its misery like a lame horse.
Ford Ranger / B-Series :: Transmission Locked Out - Truck Would Not Move When Put In Drive
Last night I backed up out of a parking space and when I put it in drive it wouldn't move. It seemed like the transmission was locked up. What happened? The truck was running fine. It's a 2002 Ford Ranger 3.0 with auto transmission. Getting it serviced? I'm tempted to go to a dealer. What the problem is? Repair costs? The fluid looks good - no burning smell.
View 5 RepliesFord Ranger / B-Series :: Transmission Abruptly Locked Up In Traffic In 5th Gear
1991 Ranger, standard cab, 2wd, 2.3L engine, 5 speed
Transmission abruptly locked up in traffic, in 5th gear, brought the truck to a halt. Got it towed home, searched the forum for information on how to remove the transmission, and tackled the task today. I've done transmissions and clutches before - how hard can this be?
Well, I've gotten everything loose and am ready to brace the trans and remove the cross brace to gain access to the top bolts - I have seen them, but haven't tried to reach them. I've been hung for about the last 3 hours trying to get the two top side bolts - heads facing forward. I can feel them, have gotten a socket on them, but have NOT been able to get a wrench up to them to break them loose. Feels like there is a reinforcing flange or something right adjacent that prevents access. I've tried extensions, flex joints and box ends - I just can't seem to find the right combination.
2nd question - do I need to break the exhaust system loose before I allow the engine/transmission assembly to tilt downwards? Looks to me like it needs to be disconnected to allow the assembly to drop.
Ford Ranger / B-Series :: Loud Screech / Grind - Transmission Locked In 5th Gear
Last night, on my way home, I suffered a catastrophic transmission failure in my 1991 2.3L 5 speed. Stepped on the clutch on an exit ramp from the freeway and was rewarded by a LOUD screech/grind, a stopped vehicle, and a transmission "locked" in 5th gear. The local HERO service pushed me out of traffic and I got towed home. Looks like a transmission transplant is in my immediate future. So - the question is, what year manual transmissions match up to a 1991 2.3L 4 cylinder, standard cab, 2WD? I need to start searching salvage yards.
View 3 RepliesFord Ranger / B-Series :: 1990 - Rear Brakes Locked Up When Hit The Brake Pedal Hard
I have a 1990 4x4 ford Ranger, the little truck was purchased in early 2008 as a work truck but has ended up becoming my main vehicle, it has been a good truck for the most part but know I am having some brake issues, well have been having for some time but they seem to come and go. Usually it happens when I have to hit the brakes hard, the rear brakes lock up, I replaced the master cylinder months ago and thought that fixed it, then a month later it happened again. The last time it happened was friday, the time before that was in march 09'.
I have searched this online and found numerous try this but the original poster never comes back to say if the problem is fixed or what fixed it. My ABS light DOES NOT come on when this happens, it does function properly, it illuminates when the key is turned on then goes off. My parking brake no longer works either but I think that is from me "driving thru" the locked up rear brakes. I plan on replacign both drums and shoes within the next week but would like an option to repair the locking up issue.
Ford Ranger / B-Series :: 1999 XLT - Rear Door Locked From Upper Side / Lower Looks Free
I have a 1999 XLT and i had a bad moment yesterday. I always put the toolbox in the back side of the cabin, while doing maintenance i tried to open the rear door and I couldn't. I noticed its locked from the upper because the lower looks free. The other thing i noticed the two wires going to the handle to open it feels loose. First time happened to me and i really use that door often.
View 2 RepliesFord Super Duty (1999-2016) :: F350 - Steering Wheel Is Locked
The steering wheel is locked on my 99 F-350. I messed around with the stupid thing for quite a while this evening and it won't budge! I need it to haul hay tomorrow....
View 13 Replies