Ford Super Duty (1999-2016) :: Steering Wheel Wobble In Any Position
My truck has developed a wobble in the steering wheel. I don't mean when you are driving down the road, but the steering wheel wobbles around. It wobbles in any position that the Till shaft is set to. How to repair.
View 10 RepliesFord Super Duty (1999-2016) :: 2010 F250 - Loose Steering Wheel
My 2010 6.4 F250 seems has a loose steering wheel. The steering of the truck hasn't changed nor has there been uneven wear on the tires. It doesn't drift if I let the steering wheel go. Had the front end inspected and was told it's all good under there.
YET, my actual steering wheel is loose. I can grab the wheel and wiggle it front to back and side to side. It FEELS like the bolts that hold the steering wheel to the column are loose. What was the cause/repair? Is this something I can repair myself or a local shop? Or is this a dealer fix?
Ford Super Duty (1999-2016) :: F250 - Steering Wheel Wobbles / Loose
I have a F250 SD with a 6.0 diesel. My steering wheel is loose. I tested and know for sure is not a problem inside the cabin. Fallow the line thru the linkage to the steering box by the left front wheel. I found an adjustable switch there. Just on top of the steering box. It has a lock nut that must be loosen to adjust what it looks like a hex. Very hard to reach. I have watch some Youtube videos but on different vehicles.
View 1 RepliesFord Super Duty (1999-2016) :: Play In Steering Wheel / Loose Front End Suspension Parts
I have a '99 F250 w/ PSD with 165k miles.
When I drive, I move the steering wheel and nothing happens for the first few degrees of turn and then I encounter resistence and it turns. It's the same either way. The vehicle seems to track nicely, doesn't pull to either side, just a lot of slop in the steering wheel.
Is there a way to determine if this is really steering related or is it just loose/worn front end suspension parts making themselves known? My guess is suspension items, but the fact the front end behaves itself when the truck is moving has me doubting that just a bit.
Ford Super Duty (1999-2016) :: 2013 2wd - Steering Wheel Loose / Jerks When Hitting Bumps
Got my new truck last week and the steering is awful. Loose as a goose. Every bump that you hit jerks the steering wheel around. I changed the tires from the factory 80psi down to 60 for the front and 65 for the rear, didn't work much. On some big bumps it acts like I am losing control. It reminds me of the death wobble on my old 05 F250 which was 4wd. I thought that the 2wd independent suspension would be smoother.
It's got a sway bar up front can I add a steering stabilizer? If so who makes one? Everything else about the truck is great. The new 6.7 is quiet as a mouse and powerful. So far fuel economy is the same as my ecoboost. Haven't got to tow with it yet.
Ford Super Duty (1999-2016) :: Faint Clunk In Steering If Rotate The Wheel Back And Forth
So now, what I'm noticing is a bit of a clunk in the steering. It's minor, very minor... but like any problem they usually start that way. The sound is very faint, you can't hear it under the truck, only slightly in the cab but you can feel it in the steering wheel, not so much when driving but when sitting still in a parking spot it's pretty obvious if you rotate the wheel back and forth. You can also feel it in the floor. Sometimes I'll notice this if I hit a bump while I'm driving.
Here's what I know, if you grab the tie rod, either end, you get a slight bit of rotation. Not just one end moving, but the whole thing has a small amount of forward back rotation (I'm not sure if this is normal) I had my girlfriend turn the steering wheel while I checked different components and there didn't seem to be any left right play on the tie rods. The boots look good on the tie rods ends, pic included, looks of similar quality of drivers side.
Then the kicker, here's where I noticed the gobs of grease on the top end drag link, pic also included. This was the last link I looked at, and I guess least expected.
So I guess I'm thinking this drag link is bad, but this is my first stop on the advice train. I wiped off the boot that was covered in grease on the drag link and it looked like its in fine enough condition but I also seriously doubt the shop that added the leveling kit just decided to slob grease all over the outside of this drag link boot. I have my truck oil undercoated before every winter but, that was some bit ago, and this looked more like grease to me.
Truck background: 2012 F250 6.7, I'm at 42,000 miles, 34in tires for most of that, and more recently added a 2 inch leveling kit (40,000 miles) and replaced the suspension all around and added a dual stabilizer. I had some noise coming from the drivers side wheel-well a while back and found that one of the end links on the sway bars was simply loose. Tightened up and all good to go. At 30,000 I got some death wobble. Replaced tires, the stock stabilizer had also gone bad, and had an alignment. Everything good since, but I'm thinking some of these problems now might be remnant of the bad tires.
Ford Super Duty (1999-2016) :: Steering Wheel Jerk And Loud Clunk Noise
I took my truck to an alignment shop to have him look over my truck to find a steering wheel jerk and a loud clunk noise. He believes it's in the transfer case driveline. Said to remove the driveline then drive it around and see if it goes away, if it does then that's the problem. So to the question, how to properly take this out? Do I need to make marks with a paint pen anywhere to line things back up or does it matter?
View 14 RepliesFord Super Duty (1999-2016) :: 2001 - Loose Power Steering When Step On Brakes And Turning The Wheel
Starting about a year ago, "sometimes" when I step on the brakes and am turning the steering wheel, I loose the power steering. I took it to Ford and they said that this is a a known issue but they didn't say what it would take to fix it. Because this problem is intermittent it is very hard to get this fixed unless the mechanic can experience and verify the problem for himself...
View 14 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Clunk In Front End / Felt In The Floor And Steering Wheel
I have a 02 F250 4x4 5.4. As I drive and when pulling into a driveway I hear a clunk that can be felt in the floor and the steering wheel. I've replaced the wheel bearings and seals, shocks, ball joints, sway bar links and bushings, tie rod ends at the gear box and "right hand inner". The other two tie rods are tight and so is the track bar. I cannot duplicate the sound if I jack it up and move parts around with a pry bar. I can however move the steer box sector shaft upwards about an 1/8. I've adjusted the screw but it didn't do anything. Could it be the steer box or the springs? I've even mounted a GoPro underneath but everything moves and I can't tell why it is.
View 14 RepliesFord Super Duty (1999-2016) :: Loose / Binding And Metal On Metal Sound On Steering Wheel Shaft
I have a loose, binding, metal on metal sound on my steering wheel shaft. I have removed the steering wheel, replaced the clockspring, because when I removed wheel clockspring was in pieces and I thought that might be the issue. Guess not, because I'm still having problem. Other than having to remove or replace the whole steering column...
View 2 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Squeak And Clunk / Bearings Are Loose
My rear wheel bearing are a little loose. This afternoon while diagnosing a squeak in the back I found this. While pushing the truck side to side there is a clunk and when you lay your hand on the tire you can feel it, bearings are loose. Nothing during the operation of the truck to give this away, truck runs and drives as it should but I need to check it our before something does go wrong. What I'm looking for is a torque / preload that the rear wheel bearings need to be set at.
View 2 RepliesFord Super Duty (1999-2016) :: Steering Went Out Completely When Driving On A Straight Road
A few weeks ago, my employees were driving home one of my work trucks, a 2001 F350 7.3 4x4 Crew w. 130K miles. They were on a straight road in a small town when the steering went completely out. The truck veered into a telephone pole. No one was injured. The truck has major damage to the front passenger's side.
I finally got the truck back to my shop today. It is quite evident what caused the problem. The gear/splined shaft that protrudes from the steering box and is connected to the pitman arm sheared completely off.
Ford Super Duty (1999-2016) :: 2003 F250 - Steering Is Loose
My steering is "loose", All front end parts are in good shape but I can move the steering wheel 4 or 5 inches back and forth without the wheels moving. Ball joints and tie rod ends are good. Truck only has 185000 miles on it.
View 2 RepliesFord Super Duty (1999-2016) :: 2015 F350 Steering Seems Loose And Squirrely
I recently graduated from a 2010 f150 XLT with F250 tow pkg to a 2015 F350 and am not liking the steering. I have owned the F350 for about 2 months and I have about 2500 miles on it. The more I drive it the more I hate the steering. The steering just seems loose and "squirrely" to me. I even took it to the dealership at a 1000 miles saying something is wrong and they said everything checks out. They, of course told me, it's because I'm used to the steering in my F150. I even told them to check the alignment because it didn't seem right.
I don't know if it's in my mind, but I keep feeling/hearing like something is loose on the front end, especially when I brake on road bumps. I thought maybe it was the ABS kicking in, but I don't think that it. I cannot pinpoint the noise and it's hard to replicate it, so it'll be difficult to get that across to the dealer. Any problems with the steering?
Ford Super Duty (1999-2016) :: Loose Bolt Or Nut On Steering Column - Slipping?
My steering wheel is loose as in moves back and forth if pushed or pulled right at the wheel.. everything else seems tight and still turns and drives fine.. took off the airbag and the center nut is tight.. it's been getting progressively worse since I bought it.. What it could be??? Loose bolt or nut or the steering column?
View 2 RepliesFord Super Duty (1999-2016) :: Massive Pop Or Clunk Coming From Steering Box
I just got my truck back from the dealership where they said they tightened the nut on my pitman arm and now when turning either left or right when I approach full lock there is a massive pop or clunk that comes from the steering box. I have crawled under the truck and watched and felt everything as the wheels turn and the draglink, tie rod, sway bar links and cv joints as well as the front drive shaft are all fine. The noise is definitely coming from the top end of the pitman arm or higher. What it could be or how to fix it? I have an 03 6.0l f250 with a 4 inch lift all new springs and new sway bar
View 3 RepliesFord Super Duty (1999-2016) :: 2008 F350 - Lower Steering Linkage Is Loose
Ok. I wanted to pick the minds to make it easier. In the photos the lower steering linkage is loose (bottom bar with ring on the end connected to knuckle) and needs replacement. To fix this is it just a bushing inside? Is it unscrewing the end like replacing a tie rod?
2008 F350 CC DRW
Ford Super Duty (1999-2016) :: 2008 - Front DS Wheel Binding When Turning And Loose Seals?
I have a 2008 F-450 Lariat 6.4 4x4. I recently started noticing the front driver side wheel (best I can tell) wheel makes a noise as though it's binding uo when turning either direction, and I can feel it as well. 4wd is not activated and the hubs are in auto. When the front end is off the ground, I rotated the wheels and they spun independently unless the hubs were locked. I noticed what appear to be seals on both the driver and passenger side hanging loose (see pics). What this might be? I recently used the 4wd when we visited White Sands National Monument while pulling a 5th wheel RV.
View 9 RepliesFord Super Duty (1999-2016) :: 2007 F250 - Front Wheel Clunk When Turn Sharply In Either Direction
2007 F250 4WD 5.4l ... when I turn sharply in either direction I am getting a light clunk sound similar to when you are in 4WD on blacktop and try turning. The engine also seems to wanna stall when I cut the wheel too sharp.
View 4 Replies