Ford Fuel System :: PCV Causing Vacuum Leak
So I was was tired of trying to tune my Holley 650 and finally threw in the towel and got a 600 Edelbrock. When the holley was on there the engine had the slightest surge but I was never able to pin down a vacuum leak. The PCV valve made quite the racket while running.
Now the edelbrock is on there and no matter what I did I could not get the idle below 750 (4 speed truck). I checked the carb, manifold, hoses, and boosters and no vacuum leaks. I disconnected the PCV port at the carb and plugged it and it immediately stalled.
I went down to the local speed shop and got a new PCV grommet that has a small opening (restricting) and some foam filter material in it. Got home and popped it in and the idle dropped right down to a near stall. Adjusted the screw and she's running fine.
Now for the question. Did I fix the problem or just band aid it? Has anyone heard of having to restrict the PCV circuit?
Ford Fuel System :: Vacuum Control On EFI Regulator
I have an Accel Gen vll EFI setup on a 59AB and plan on using a pressure regulator but it has a vacuum inlet fitting. I'm assuming it's to allow for more pressure on acceleration. When the vacum drops more fuel will be allowed into the fuel rail is my guess.
View 3 RepliesFord Fuel System :: 2100 Choke Vacuum Control Frozen?
I picked up a renamed 2100 for my '72 and I found out choke vacuum control on the back of the carb is frozen. Are these parts still produced and if not is there another way to make it work?
View 10 RepliesFord Fuel System :: 2100 Choke Vacuum Control On The Back Of Carb Is Frozen
I picked up a remaned 2100 for my '72 and I found out choke vacuum control on the back of the carb is frozen. I can't find anyone who carries it, let alone knows what it is. Are these parts still produced and if not is there another way to make it work?
View 13 RepliesFord Fuel System :: Significant Vacuum Leak Around The Throttle Shaft On The Driver Side
I was using the method of spraying starter fluid around the intake and found a pretty significant vacuum leak around the throttle shaft on the drivers side. The carb is a 2 barrel holley. What are some different ways to seal a throttle shaft vacuum leak? Could I take it apart and seal it with a plastic O-ring for now?
View 2 RepliesGolf V R32 :: Air Leaking Noise When Car Is On - Vacuum Port?
I noticed this on my A3... This weekend I was working on the car and heard air leaking somewhere when the car was on. I pinpoint the leak on the upper left side of the engine where to my guess is a vacuum port. This hose leads to the brake booster. Apparently it's a plastic hose and it had split open near the port. I cut out a section of it and used some coolant hose I had laying around from my MKIV gti. Just thought I let you 3.2's know in case you want to check it out.
What is the function of this? is it to provide vacuum to the brakes? I pulled the hose while the engine was running and it wanted to die just to see if it would cause any issues. Also I may add that before this I've had some engine stuttering at idle where the rpm needle would fluctuate from like 600 rpm to 500 rpm and back up at times and that after replacing that bad section of hose it seems to have corrected that issue as well. I know there have been some stuttering issues around here and have heard that replacing the battery has worked at times.
Taurus :: P0193 - Can't Find Port On Fuel Rail To Get Fuel Pressure
I cant find the port on fuel rail to get a fuel pressure reading.it is nothing like my tarus.saw astem sticking up on front right of rail but it has some kind of covering over it. It is a 2005 freestar with the 3.9 motor.
View 5 RepliesFord Fuel System :: Location Of Check Valve That Maintains Fuel Pressure On The System?
I have a '99 E-350 6.8L. Where is the check valve that maintains fuel pressure on the system?
I have been experiencing a starting issue when the engine is hot. Cold starts are usually fine. I've replaced the in-tank fuel pump (pump only, not the assembly) to no avail. I was out of town and didn't have access to a fuel pressure gauge when the problem started so I couldn't say what I had prior to replacing the pump. But now, with a new pump, when I check pressure, I get about 40 psi when I first cycle the key on, but it drops right back to zero as soon as the pump shuts off. If I cycle the key on a few times, sometimes I can get it to hold pressure at about 32 psi, and it starts fine. When I shut if off, it goes back to zero psi, sometimes gradually, like a bleed down, and sometimes immediately.
My conclusion from this was that the check valve was bad. I was told it was part of the in tank fuel pump assembly. Since I didn't replace the entire assembly, this made sense. So I just dropped the tank back down, but I don't see anything as part of the pump assembly that serves as a check valve. There is a rubber nipple on the end of the return line, but I don't see how that can hold any significant pressure.
So, before I go out and spend another couple hundred bucks on the complete fuel pump assembly, which apparently can't be purchased without the actual pump, I thought I'd ask. Where is the check valve that holds the pressure in the fuel system?
BTW, I also have replaced the fuel rail pressure regulator, but it made no difference (I went there first since that was much easier than dropping the fuel tank a second time).
Civic - Honda :: 1994 - Won't Start Until Gas Is Pumped - Fuel Pump / Distributor?
I have a 94 honda civic. It's been having problems starting. When it won't start you have to pump the gas a lot and it will then start. You can smell a lot of fuel when this happens so unsure if it is the pump. Maybe it's a combination of several things. Replaced spark plugs, new wires connecting to battery. And just put in a new fuel filter. All seemed to slightly work for a minute. But now driving today went to start the car and it wouldn't stay running if I let go of the key. Finally got it to stay on seemed fine then as I was driving and wasn't pressing on the gas peddle the car started losing power so I pressed the peddle it sputtered (kinda sounded like something clogged in tail pipe) and regained power.
View 19 RepliesPrius C (Audio/Electronics) :: Multi USB Port Will Work If Plugged Into Single Port?
Plugging a multiple USB port into the single USB port? Does it work? For example a plugging a USB drive and an IPod?
View 4 RepliesFord A/C :: System Completely Discharged / Does Not Hold Vacuum
I have a leak in my A/C system. It is completely discharged. I bought some o-rings from my Ford dealer, but the system does not hold a vacuum. Is there an o-ring kit available somewhere so I can replace all of the o-rings in my a/c lines?
View 14 RepliesFord F-150 (2004-2008) :: Small Vacuum Leak In 4WD System
Long story short, I have a small vacuum leak in the 4wd system. I disconnected the lines going to the hubs to prevent grinding them to pieces as they are brand new. This, of course lock the front hubs in and disengages the X-fer case in 2wd.
It is not engaging in 4wd unless I select it, so I don't imagine it hurting anything in the X-fer case or anything. Other than the extra rolling mass, is this okay to operate at until I resolve my vacuum issue, provided I close all openings and places for trash to get in?
Ford Fuel System :: Gas Went Bad - Cleaning Fuel System
I went to move the 2000 yesterday and it will not start because the gas went bad. It has been sitting about 6 months, since it did not snow this past winter. How do I go about cleaning the fuel system? I was thinking suck the gas tank empty with an electric fuel pump, and blowing out the lines with air. Does this sound right?
View 7 RepliesFord Fuel System :: E350 - Fuel Tank / Pump Noise After Cutoff
This van has had a couple of fuel pumps, no surprise there, and i need to look through my paperwork and find out how many miles the current one has on it, but it has the STRANGEST habit I've ever had on any vehicle. Starts fine, runs fine, no fuel pump noise when van is running, and when you turn it off, the fuel pump creeks on and off for several minutes.
I mean a strange creaking noise almost like a shorted electrical device or a vehicle's brakes when you park it on a hill and the breaks creak as it settles into place. I'm probably doing a lousy job of describing this but i don't know how else to describe it!
ALSO, if you lay under the van and wait til it stops creaking, you can tap the bottom of the tank and it will creak for a few more seconds. You can tap repeatedly and make it creak more. Is it about to explode? Can i trust it on a road trip?
Ford Fuel System :: 4180c - Fuel Coming Out Of Primary Vent Tube
I have a F-250 4WD with 7.5L which has a MC/Holley 4180c sitting on top. It was getting very poor mpg (like 5-6 miles/gal) and then was getting harder and harder to start. This progressed rather quickly to not starting with fuel coming out of the primary vent tube. I suspect it has to do with the primary float stuck open. I was considering rebuilding the carburetor. Is this over reaction prematurely or is there something like float adjustment that may rectify all of the symptoms described. If a rebuild is in order what is the information I would need to ensure getting the correct rebuild kit. Info that I have so far from research is it is Motorcraft ID #E5HE-9510-MC.
View 6 RepliesFord Fuel System :: Stumble And Die After A Short Highway Run At 70 MPH / Fuel Injection Flooding Out?
What would make a FI engine act like its flooding out and dying after a short run on the freeway?
Details:
1994 F-350 351W (just overhauled this winter)
has new TPS, ICM(?).
Dual exhaust dumps right before the tires
new filters in tanks, new fuel filter on frame rail
All fuel lines have been opened and blown out from the tank to the engine compartment fitting near firewall.
Fuel pumps hold good pressure when tested.
Symptoms:
smells like its running rich most all the time
after a short hiway run @ 70MPH it will stumble and die when returning to surface streets.
fuel smell near engine sometimes, but no obvious puddles or leaks anywhere.
May be related?:
When on a longer highway run, I can't use the FWD tank for a long period without the engine stumbling and cutting out or popping at times. But I can swap to the rear tank for a bit then run the FWD tank again for a while. driving up hills it seems to be worse, but I'm in the panhandle of TX right now..good grief!
I am having to drive this truck for work long distances. While I dont expect a vast fuel range, it would be nice if I could go a couple hundred miles on 20 gallons of gas....
Ford Fuel System :: 1991 F250 XLT - Fuel Pump Will Not Stop Running
I just bought another 1991 Ford. This one is a 1/2 ton XLT Lariet with the 302 and for the first time I own a short bed. I also have a 1991 F-250 XLT with a 460 and a 8' bed.
Here is the problem, ( I think) it will not run or at least not for long. The fuel pump, which I am guessing is in the rear tank will not stop running. On the F-250 the pump stops running after a few seconds after I turn on the key.
Where should I start to find out my problem with the fuel system?
Ford Fuel System :: 1995 - Stalls - Now Stop Moving - Fuel Filter?
I have a 95 F150 4x4 reg cab long box with a 302 V8 and dual tanks... I was driving around yesterday when my truck started to lung and then the motor stalled... when I stopped moving I tried starting the truck and it started with no problem, so as i kept on my way, about 5 minutes later the same thing happened and it stalled again, (I have an automatic by the way). but this time before it stopped moving i pump the gas a few times and it fired back up and then stalled again... i switched from my front take to by back maybe thinking it could me my fuel pump in the tank but it did the same thing again about same time later... Would it be my fuel filter on the frame (like in line fuel filter) or why is it doing that? its EFI by the way.
View 14 RepliesFord Fuel System :: 1976 F150 - Fuel Draining All The Way Back To Tank
My vehicle:
1976 F150 2wd Extended cab
390 4bbl
c6 transmission
4BBL Edlebrock Carb
Dual fuel tanks, only rear main tank connected
My problem: For the first year I owned the truck, everything ran fine and it started up really quickly even after it sat for a few days or a few weeks. I have since, for about the last year or so, had to crank it for 30-45 seconds to get it to start. This all started around the time my fuel pump went out. I replaced it with an Airtex fuel pump from Autozone. I also installed a glass in line filter before the carb in front of the distributor.
I noticed that after about 4-6 hours, the fuel had drained out of the filter and that's when I would have to crank it forever to get it going. It also seems like there is no fuel in the carb as it doesn't even try to start when it first gets cranked. I thought this was a bad pump, so I bought a new one last week and tried it again. Sure enough after about 4-6 hours, everything is empty again and it takes forever to start it. So it's not a bad pump, or so I think.
The other day I backed it into my driveway and left it, something I never do. I checked about 4 days later and there was still fuel in the filter. This makes me think that gravity is making it drain back to the tank.
Is there something that would cause this? Also I have found a one way fuel check valve online that is supposed to remedy this type of problem. Do they work for this situation? Or is there something else I should be doing to fix this? It has taken a bit of a toll on my starting system having to crank so long all the time. I have so far had to replace my starter, starter solenoid, and all the battery cables, starter cable, terminals, etc. due to excessive wear.
The valve I found is here : [URL] .....