Ford F-150 (2004-2008) :: 2006 - Coolant Leak At Intake Manifold
I have a 2006 F150 screw 4.6 auto 116k miles that has evidence of a small coolant leak where the intake manifold joins the head. This is on the drivers side directly under the thermostat housing. The t-stat housing is dry and the hoses all appear dry. It's just wet right at the gasket where the manifold joins the head. Reservoir is still normal so it's not leaking too much just yet.
I searched this site and youtube but didn't find any other posts. Lots of problems with older trucks with composite manifolds but nothing for this one. It looks like a part of the bottom of the manifold is plastic but the entire top and where it is leaking is all aluminum.
It seems odd that this would start in the winter time just driving back and forth to work (no load). And, yes the antifreeze is good. Just wondering if this is a known issue with this truck. Is it just a matter of replacing the gaskets or is there some other flaw I should be concerned about?
Ford F-150 (2009-2014) :: Intake Manifold Swap?
Will an intake manifold from a new mustang 5.0 fit on a 2014 F150 5.0?
View 3 RepliesFord F-150 (2009-2014) :: Exhaust Leak At Manifold Collector?
I currently own a 2009 F-150 XLT, ext. cab, 4X4, 4.6l, 6R80 trans. Surprise, Surprise I have just developed an exhaust leak at the manifold collector. After some careful investigation, I separated the pipe from the manifold and the sealing surface is totally rotted away. I cleaned it up as best as I could and slathered some muffler cement inside the joint to seal the leak. It is about 80% better but will get worse again I'm sure.
I visited my local Ford dealer and talked to a friend I have working there and he said Ford has known about quality issues with manifolds for years and he was surprised that the manifolds lasted 70k miles.
I am hoping to use the truck as is through the winter and in the spring I am going to install these headers:JBA Headers - Reviews on JBA Cat4ward Exhaust Headers - Stainless, Ceramic & Chrome Finishes
This intake:K&N 63 Series AirCharger High Flow Cold Air Intake Kits Best Price & Reviews
This tuner:Bully Dog Triple Dog GT Tuner (49-State Legal) - Bully Dog GT Tuner Reviews on Gas Programs for Dodge, Chevy, Ford & Nissan Trucks
I already installed a Flowmaster American thunder catback exhaust system about a year ago...
Yaris/Scion & Vitz :: 2009 - Coolant Leak On The Top Hose Coming From Radiator
I just bought a used 09 yaris, 5 speed manual tranny. There seems to be a small coolant leak on the top hose coming from the radiator, the one that connects to a plastic flange or adapter and then go's to the engine block. The car does not get hot and it drive fine except it leaks at that spot. I try using a regular hose clamp and still leaked. Is the thermostat not opening up or is the water pump intermittent stopping? or something like that. Or maybe the hose itself is bad. Since this is a used car who knows what the previous owner did, I might change out the hose over the weekend and replace all the coolant to the correct Toyota long life system. to be on the safe side.
View 3 RepliesFord F-150 - 1997-2003 :: 4.2L V6 - Intake Manifold Gasket Leak?
I've got a 1997 F150 with the 4.2L V6. Before I got it last summer I did some research, but apparently missed the issue with the intake manifold gasket leaks on these early engines. It seems to be a very slow leak, but obviously I want to get it fixed. I called Ford to see if it had had the recall work done on it, but all they could tell me is that there wasn't an open recall on my truck (with the exception of the recent fuel tank strap recall). Their system apparently only goes back 10 years, so they couldn't even see the freakin' recall. So, I've got a few questions:
1) I know I didn't post much info, but does this seem like an intake manifold leak?
2) Are there any special tools needed to change out the gasket myself?
3) Can you all recommend any replacement gaskets? I found a few different manufacturers of gaskets, but I'm sure some are better than others.
4) Can this issue cause the computer to throw the loose gas cap code (P0455 if I recall correctly).
5) Would it be worth it to just get a new truck? I really wanted a diesel in the first place, but I also hate to give up on a nice truck with only 115,000 miles.
Ford :: Escape - Coolant Spilled On Upper Intake Manifold / White Smoke On Startup
Coolant spilled on my upper intake manifold. I washed it off to the best of my ability but when i started the car white smoke came from tge exhaust. What my next move should be?
View 3 RepliesFord Ranger / B-Series :: Antifreeze Leak - Tightening Intake Manifold Fasteners
I am mixed up in which fasteners I have to tighten to stop my antifreeze leak. For this, I got some pictures. Do I have to tighten these bolts? Or these? Is this the upper intake intake manifold?
I am just really lost and want to tighten the right bolts and find the torquing specs of the bolts. In the first picture, we can clearly see there is a leak there of what must be antifreeze. The stuff I have been loosing slowly over months.
Ford - Expedition :: 1999 - Engine Started Losing Coolant / Intake Manifold Gaskets Leaking
I have a 1999 Ford Expedition. A couple of days ago The engine started losing coolant as soon as the engine cooled. I replaced the coolant only to lose it again when the engine cooled. I was told that it is more likely the intake manifold gaskets leaking. It seems they are right. What is the cost to repair if I take it to a mechanic?
View 1 RepliesFord F-150 - 1997-2003 :: 2001 - Leak Where The Water Transfer Connects To Intake Manifold
I have a 2001 F150 Super Crew 5.4. I had a leak where the water transfer connects to the intake manifold. I decided to get a new manifold rather than trying to repair it. The new manifold from Dorman came and the gaskets were built into the manifold. I torqued the manifold to specs. I replaced everything and it starts fine.
I can hear what sounds like a leak, but can't find anything. I checked every hose that is connected and they are all snug and connected. I had the check engine light checked and it said it was running lean on both sides (p0174, p0171). Also a p0122. I thought something might have damaged the Throttle Body Position Sensor, so I replaced it...but no change.
I'm still driving it everyday because I need to. It won't change gears so smoothly sometimes. The most noticeable problem is that the A/C doesn't work. It just blows hot air. And the worst part about it is...it does it even when the air isn't turned on! I just go around with the windows down...in 95+ degree heat...with hot air blowing!
This is my first time to attempt a manifold change out. What I should check?
Dodge - Charger :: Can Oil Leak Out Of Intake Manifold?
Can oil leak out of Intake Manifold? i have Oil around lower intake manifold gasket. is this serious issue?
View 11 RepliesFord Ranger / B-Series :: 1994 - Sputtering Started Suddenly - Vacuum Leak Behind The Intake Manifold
I have a 94 ranger and all of a sudden it started sputtering, i can hear a vacuum leak behind the intake manifold found what appears to be a pcv valve not hooked up is that the way it's supposed to be?
View 2 RepliesPassat (B5) :: 2003 - Major Oil Leak Under Intake Manifold
My friend and I are working on her '03 1.8t and I noticed a huge oil leak under the intake manifold. It looks like there's a tube that has broken off and is now just spewing oil all over the place. I tried to get pics the best I could, so here they are....
I'd imagine its something that needs to be fixed asap.
Grand AM :: 2000 GA 3.4L SE (base) Sedan With Intake Manifold Coolant Leakage
I have a 2000 Pontiac Grand Am SE sedan (base model) with a 3.4L engine at 142Kmi that was just diagnosed with an intake manifold coolant leak by an independent shop.
I've done some googling and found that this is a known problem with this engine (including a class action suit). So far the leak is just external; no coolant in the oil and no oil in the coolant.
Ford F-150 (2009-2014) :: Coolant Leak In Middle Lower Tube Area
2014 fx4 6.2. Had a coolant leak. Brought to dealer for warranty work. Found a leak in middle lower tube area. Said they replaced radiator part # BL3Z-8005-D. It sure looks like my old radiator still under the hood complete with squished bugs. Am I missing something?
View 2 RepliesPassat (B6) :: Small Internal Leak From Emissions Canister Into Intake / Manifold
When I got my 60K service last weekend, the dealer called me and explained that I had a "very small internal leak fro an emissions canister that was leaking into the intake/manifold". He said something like that. He also said that it doesn't do anything to the performance of the car, but that the leak will increase over time and will throw a MIL.
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: Persistent Coolant Leak At The Thermostat Outlet
The truck has been a dream for several months and I had a coolant leak at the thermostat outlet. Changed the fitting and thermostat and sealed with lots of blue monkey snot. It's been perfect for a couple months but a week ago it started leaking again. Exactly the same as last time. I cleaned the mating surface of the water pump with a plastic scraper to remove the old sealer and then finished it with fine scotch brite. I looked at several parts breakdowns and none of them showed a gasket.......
View 14 RepliesFord F-150 - 1997-2003 :: Coolant Leak At Manifold
My 2003 f150 4x4 w/5.4 has 220k miles and only minor issues until a few days ago. I now have a coolant leak at the mating surface (both sides left and right) of the aluminum crossover coolant manifold (holds thermostat on one end). I have most of the bolts out to remove the crossover manifold but there is one bolt on the RH side that comes from the underside. All things equal, main question is... Can that crossover mainfold be removed independently from the intake? My thought is that in order to get to that last single bolt (there may be others I am not aware of yet) that I will need to remove the intake.
View 1 RepliesFord F-150 - 1997-2003 :: 2002 - Coolant Leak On Driver Side Front Right Near The Thermostat Housing
I'm trying to figure where the coolant leak is. Appears to originate on the driver's side front, right near the thermostat housing. Since the engine tilts back the entire drivers side is wet. The thermostat gasket appears to be OK, but it does have a lot of miles on it.
If it's not the thermostat then can coolant leak from the cross over tube. And is the cross over removable without taking off the intake. There appears to be a bolt coming up from underneath on the passenger side.
Also, does coolant flow through this plastic intake. If it does, then the leak could be some where else, if not, then it's probably the thermostat.
Golf IV / Jetta IV :: Coolant Leak From Behind Thermostat Cover So Soon?
02 Jetta 2.0L that I changed the thermostat. o-ring, and cover on when I first got the car about a year and a half ago.
I see dry g12 coming out from behind the cover and my coolant bulb had dipped quite a bit in recent weeks requiring a refill. What is most likely the problem here in such a short period of time? I've only put like 10k miles on the car in that period. O-ring couldn't have seated wrong because wouldn't the problem have been apparent immediately back when I did the job? Maybe I need to re-torque the cover? Cracked cover?